We demonstrate the use of a single trapped ion as a sensor to probe electric-field noise from interchangeable test surfaces. As proof of principle, we measure the magnitude and distance dependence of electric-field noise from two ion-trap-like samples with patterned Au electrodes. This trapped-ion sensor could be combined with other surface characterization tools to help elucidate the mechanisms that give rise to electric-field noise from ion-trap surfaces. Such noise presents a significant hurdle for performing large-scale trapped-ion quantum computations.
We probe electric-field noise in a surface ion trap for ion-surface distances
d between 50 and 300 \textmu{}m in the normal and planar directions. We find the noise distance dependence to scale as ${d}^{\ensuremath{-}2.6}$ in our trap and a frequency dependence which is consistent with
1/f noise. Simulations of the electric-field noise specific to our trap geometry provide evidence that we are not limited by technical noise sources. Our distance scaling data is consistent with a noise correlation length of about 100 \textmu{}m at the trap surface, and we discuss how patch potentials of this size would be modified by the electrode geometry.
Electric-field noise is a major limiting factor in the performance of ion traps and other quantum devices. Despite intensive research over the past decade, the nature and cause of electric field noise near surfaces is not well understood. This dissertation reports the high- temperature dependence of electric-field noise above an Al-Cu surface using a trapped 40Ca+ ion as a probe.We employ a novel setup with a surface ion trap mounted on a heater for studies of the temperature dependence of electric-field noise. To characterize the Al-Cu material, we explore the effects of heat treatment through ex situ annealing followed by inspection in a scanning electron microscope. To calibrate the temperature of the trap, we demonstrate the use of thermal imaging for monitoring the temperature of an ion trap in vacuum.The temperature and frequency dependence of electric-field noise above the surface is measured using the heating rate of a single ion in a surface-electrode Paul trap. We find that the heating rate saturates at temperatures greater than 450 K. We find that the frequency dependence shows a 1/f behavior, and has a lower frequency scaling exponent at high temperatures than at room temperature. We show that these results are a reflection of the surface-related noise by eliminating other possible sources of noise.Building on historical data for resistance fluctuations in thin films, we develop the thermally-activated fluctuator model to describe the results. We find that a broad distribution of fluctuators with energy barriers peaked around 0.5 eV accurately models both the temperature and frequency dependence of the electric-field noise measured. We present the interpretation of this model as a way to infer that the cause of electric-field noise in the trap is likely defect motion in the metal surface, connecting the problems faced in ion trapping to a large body of work in solid state physics.