Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)

Trapping induced frequency shifts by comparison of two Sr optical lattice clocks at the 10−17 level

Jérôme Lodewyck, Philip G. Westergaard, L. Lorini, M. Zawada, Eric A. Burt, Mikhail Gurov, P. Lemonde

Published May 1, 2011• 0 citations
Publisher

Abstract

We present a comprehensive study of the frequency shifts associated with the lattice potential in Sr lattice clocks. By comparing two such clocks with a frequency stability better than 5.10-17after one hour of averaging time, and varying the lattice depth up to U0= 900 Erwith Erbeing the recoil energy, we evaluate lattice related shifts with an unprecedented accuracy.

DOI
10.1109/fcs.2011.5977853

Related papers

Lattice-Induced Frequency Shifts in Sr Optical Lattice Clocks at the 10−17 Level

Philip G. Westergaard, Jérôme Lodewyck, L. Lorini +5 more

We present a comprehensive study of the frequency shifts associated with the lattice potential in a Sr lattice clock by comparing two such clocks with a frequency stability reaching 5×10(-17) after a 1 h integration time. We put the first experimental upper bound on the multipolar M1 and E2 interactions, significantly smaller than the recently predicted theoretical upper limit, and give a 30-fold improved upper limit on the effect of hyperpolarizability. Finally, we report on the first observation of the vector and tensor shifts in a Sr lattice clock. Combining these measurements, we show that all known lattice related perturbations will not affect the clock accuracy down to the 10(-17) level, even for lattices as deep as 150 recoil energies.

arXiv:1102.1797•Physical Review Letters•May 23, 2011•140 citations

OPTICAL LATTICE CLOCK WITH Sr ATOMS

Philip G. Westergaard, Arnaud Lecallier, Jérôme Lodewyck +1 more

We review the recent progress at LNE-SYRTE on an optical lattice clock using Sr atoms. We discuss the required lattice depth to cancel motional effects in such a clock and show that a relatively small lattice depth is sufficient provided the lattice is oriented vertically. We also demonstrate an accurate frequency measurement of the Sr clock transition with accuracy in the low 10 -15 range. Finally, we describe a new non-destructive method to detect the atoms in the clock and discuss the expected associated improvement in the frequency stability of the clock.

Symposium on Frequency Standards and Metrology•May 1, 2009•0 citations

Higher-order shifts of a clock frequency in Sr, Yb and Hg atoms trapped in an optical lattice

Vitalii D Ovsiannikov, Vitalii G Pal'chikov, Hidetoshi Katori

The recent progress in designing optical frequency standards with an uncertainty at a level of 10-17-10-18 requires unprecedented accuracy in estimating the role of higher-order uncertainties of optical clocks. In this paper, we systematically evaluate the multipole, nonlinear, anharmonic contributions to uncertainty of the optical-lattice-based clocks of alkaline-earth-like-atoms Sr, Yb and Hg.

European Frequency and Time Forum•Jun 1, 2014•0 citations

Optical lattice clock with atoms confined in a shallow trap

P. Lemonde, Peter Wolf

We study the trap depth requirement for the realization of an optical clock using atoms confined in a lattice. We show that site-to-site tunneling leads to a residual sensitivity to the atom dynamics hence requiring large depths [$(50\text{--}100){E}_{r}$ for Sr] to avoid any frequency shift or line broadening of the atomic transition at the ${10}^{\ensuremath{-}17}\text{--}{10}^{\ensuremath{-}18}$ level. Such large depths and the corresponding laser power may, however, lead to difficulties (e.g., higher-order light shifts, two-photon ionization, technical difficulties) and therefore one would like to operate the clock in much shallower traps. To circumvent this problem we propose the use of an accelerated lattice. Acceleration lifts the degeneracy between adjacents potential wells which strongly inhibits tunneling. We show that using the Earth's gravity, much shallower traps (down to $5{E}_{r}$ for Sr) can be used for the same accuracy goal.

arXiv:physics/0504080•Physical Review A•Sep 16, 2005•120 citations

Optical lattice clocks and frequency comparisons

Hidetoshi Katori

To date, optical clocks based on singly trapped ions and ultracold neutral atoms trapped in the Stark-shift-free optical lattices are regarded as promising candidates for future atomic clocks. Since 2006, “optical lattice clocks” have been evaluated close to the Cs clocks' uncertainty limit internationally. One of the essential experimental challenges in the development of “optical lattice clocks” is to find out the better lattice geometries as well as interrogated atom species (including their quantum statistics) that bring out the potential performance of the clock scheme, taking into account the collisional frequency shift, the Black body radiation (BBR) shift, the atomic multipolar and hyperpolarizability effects.

Conference on Precision Electromagnetic Measurements•Jun 1, 2010•0 citations

Minimizing the required trap depth in optical lattice clocks

P. Lemonde, Peter Wolf

We study the trap depth requirement for the realization of an optical clock using atoms confined in a lattice. We show that site-to-site tunnelling leads to a residual sensitivity to the atom dynamics hence requiring large depths (50 to 100 Erfor Sr) to avoid any frequency shift or line broadening of the atomic transition at the 10-17- 10-18level. Such large depths and the corresponding laser power may, however, lead to difficulties (e.g. higher order light shifts, two-photon ionization, technical difficulties) and therefore one would like to operate the clock in much shallower traps. To circumvent this problem we propose the use of an accelerated lattice. Acceleration lifts the degeneracy between adjacents potential wells which strongly inhibits tunnelling. We show that using the Earth's gravity, much shallower traps (down to 5 Erfor Sr) can be used for the same accuracy goal

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)•Jan 18, 2006•0 citations
We present a comprehensive study of the frequency shifts associated with the lattice potential in Sr lattice clocks. By comparing two such clocks with a frequency stability better than 5.10-17after one hour of averaging time, and varying the lattice depth up to U0= 900 Erwith Erbeing the recoil energy, we evaluate lattice related shifts with an unprecedented accuracy.
We present a comprehensive study of the frequency shifts associated with the lattice potential in a Sr lattice clock by comparing two such clocks with a frequency stability reaching 5×10(-17) after a 1 h integration time. We put the first experimental upper bound on the multipolar M1 and E2 interactions, significantly smaller than the recently predicted theoretical upper limit, and give a 30-fold improved upper limit on the effect of hyperpolarizability. Finally, we report on the first observation of the vector and tensor shifts in a Sr lattice clock. Combining these measurements, we show that all known lattice related perturbations will not affect the clock accuracy down to the 10(-17) level, even for lattices as deep as 150 recoil energies.
We review the recent progress at LNE-SYRTE on an optical lattice clock using Sr atoms. We discuss the required lattice depth to cancel motional effects in such a clock and show that a relatively small lattice depth is sufficient provided the lattice is oriented vertically. We also demonstrate an accurate frequency measurement of the Sr clock transition with accuracy in the low 10 -15 range. Finally, we describe a new non-destructive method to detect the atoms in the clock and discuss the expected associated improvement in the frequency stability of the clock.
We study the trap depth requirement for the realization of an optical clock using atoms confined in a lattice. We show that site-to-site tunneling leads to a residual sensitivity to the atom dynamics hence requiring large depths [(50–100)Er(50\text{--}100){E}_{r}(50–100)Er​ for Sr] to avoid any frequency shift or line broadening of the atomic transition at the ${10}^{\ensuremath{-}17}\text{--}{10}^{\ensuremath{-}18}$ level. Such large depths and the corresponding laser power may, however, lead to difficulties (e.g., higher-order light shifts, two-photon ionization, technical difficulties) and therefore one would like to operate the clock in much shallower traps. To circumvent this problem we propose the use of an accelerated lattice. Acceleration lifts the degeneracy between adjacents potential wells which strongly inhibits tunneling. We show that using the Earth's gravity, much shallower traps (down to 5Er5{E}_{r}5Er​ for Sr) can be used for the same accuracy goal.
To date, optical clocks based on singly trapped ions and ultracold neutral atoms trapped in the Stark-shift-free optical lattices are regarded as promising candidates for future atomic clocks. Since 2006, “optical lattice clocks” have been evaluated close to the Cs clocks' uncertainty limit internationally. One of the essential experimental challenges in the development of “optical lattice clocks” is to find out the better lattice geometries as well as interrogated atom species (including their quantum statistics) that bring out the potential performance of the clock scheme, taking into account the collisional frequency shift, the Black body radiation (BBR) shift, the atomic multipolar and hyperpolarizability effects.
We study the trap depth requirement for the realization of an optical clock using atoms confined in a lattice. We show that site-to-site tunnelling leads to a residual sensitivity to the atom dynamics hence requiring large depths (50 to 100 Erfor Sr) to avoid any frequency shift or line broadening of the atomic transition at the 10-17- 10-18level. Such large depths and the corresponding laser power may, however, lead to difficulties (e.g. higher order light shifts, two-photon ionization, technical difficulties) and therefore one would like to operate the clock in much shallower traps. To circumvent this problem we propose the use of an accelerated lattice. Acceleration lifts the degeneracy between adjacents potential wells which strongly inhibits tunnelling. We show that using the Earth's gravity, much shallower traps (down to 5 Erfor Sr) can be used for the same accuracy goal