Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Transactions on Aerospace and Electronic Systems

Detection of Coherent Light after Nonlinear Amplification

C. Bendjaballah, Guy Oliver

Published Sep 1, 1981• 3 citations
Publisher

Abstract

Numerical results on the performance of quantum amplifiers in an optical communication system show that because of the spontaneous emission, the probability of error is not improved by the introduction of such devices. It is also concluded that nonlinearity, which is known to reduce the relative fluctuations, will not help to enhance the probability of detection.

DOI
10.1109/taes.1981.309092

Related papers

Statistical properties of coherent radiation in a nonlinear optical amplifier

Guy Oliver, C. Bendjaballah

The differential equation for the photon conditional probability distribution in a nonlinear amplifier is numerically solved, using the continuous approximation. Saturation effects on the development of fluctuations in the amplification of coherent light are studied. They are compared with the results obtained by solving the moment equations.

Physical Review A•Aug 1, 1980•10 citations

Phase noise in photonic communications systems using linear amplifiers

J. P. Gordon, L. F. Mollenauer

Spontaneous emission noise limits the capacity and range of photonic communications systems that use linear optical amplifiers. We consider here the question of phase detection in such systems. Amplitude-to-phase-noise conversion occurs owing to the nonlinear Kerr effect in the transmission fiber, resulting in optimal phase noise performance when the nonlinear phase shift of the system is approximately 1 rad. Error-free state-of-the-art systems that use phase detection at multigigabit rates are thereby limited to a range of a few thousand kilometers.

Optics Letters•Dec 1, 1990•654 citations

Signal Enhancement by Optical Amplification in Autocorrelation Measurements

Michael Harris, R. Loudon, Terence J. Shepherd +1 more

The effect of optical amplification on the signal-to-noise ratio of autocorrelation measurements has been investigated experimentally. A light signal containing correlation information was amplified by an inverted population (phase-insensitive) optical amplifier. The data clearly show that the amplification may either degrade or enhance a subsequent autocorrelation measurement, depending on the experimental conditions. In particular, enhancement is possible when the detector quantum efficiency is low, or its noise is high. However, when all the signal photons are already being detected with no extra noise, then any optical amplification will inevitably lead to degradation of the data quality, due to addition of amplified spontaneous emission noise (ASE) from the amplifier itself.

Journal of Modern Optics•Apr 1, 1991•5 citations

Quantum theory of a saturable optical amplifier

N. B. Abraham

The intensity fluctuations in the output of a saturable optical amplifier are studied as the amplifier length is increased. Characteristics are determined by calculation of the diagonal elements of the density matrix of the optical field. Saturation affecting both upper-state and lower-state atomic populations is considered. Spontaneous emission distributed along the amplifier causes the "photon-number" distribution to approach a Bose-Einstein distribution during linear amplification if the input field is not Bose-Einstein. The onset of saturation reduces the relative fluctuations of the optical field both by introducing nonlinear gain and by reducing the spontaneous emission. Limiting solutions show that strong saturation leads to a major reduction in the fluctuations causing the photon-number distribution to approach a Poisson distribution.

Physical Review A•May 1, 1980•12 citations

Optical amplifiers for coherent lidar

R. L. Fork

We examine application of optical amplification to coherent lidar for the case of a weak return signal (a number of quanta of the return optical field close to unity). We consider the option that has been explored to date, namely, incorporation of an optical amplifier operated in a linear manner located after reception of the signal and immediately prior to heterodyning and photodetection. We also consider alternative strategies where the coherent interaction, the nonlinear processes, and the amplification are not necessarily constrained to occur in the manner investigated to date. We include the complications that occur because of mechanisms that occur at the level of a few, or one, quantum excitation. Two factors combine in the work to date that limit the value of the approach. These are: (1) the weak signal tends to require operation of the amplifier in the linear regime where the important advantages of nonlinear optical processing are not accessed, (2) the linear optical amplifier has a -3dB noise figure (SN(out)/SN(in)) that necessarily degrades the signal. Some improvement is gained because the gain provided by the optical amplifier can be used to overcome losses in the heterodyned process and photodetection. The result, however, is that introduction of an optical amplifier in a well optimized coherent lidar system results in, at best, a modest improvement in signal to noise. Some improvement may also be realized on incorporating more optical components in a coherent lidar system for purely practical reasons. For example, more compact, lighter weight, components, more robust alignment, or more rapid processing may be gained. We further find that there remain a number of potentially valuable, but unexplored options offered both by the rapidly expanding base of optical technology and the recent investigation of novel nonlinear coherent interference phenomena occurring at the single quantum excitation level. Key findings are: (1) insertion of linear optical amplifiers in well optimized conventional lidar systems offers modest improvements, at best, (2) the practical advantages of optical amplifiers, especially fiber amplifiers, such as ease of alignment, compactness, efficiency, lightweight, etc., warrant further investigation for coherent lidar, (3) the possibility of more fully optical lidar systems should be explored, (4) advantages gained by use of coherent interference of optical fields at the level of one, or a few, signal quanta should be explored, (5) amplification without inversion, population trapping, and use of electromagnetic induced transparency warrant investigation in connection with coherent lidar, (6) these new findings are probably more applicable to earth related NASA work, although applications to deep space should not be excluded, and (7) our own work in the Ultrafast Laboratory at UAH along some of the above lines of investigation, may be useful.

•Feb 1, 1996•0 citations

Quantum optical state comparison amplification of coherent states

Ross J. Donaldson, Luca Mazzarella, Robert John Collins +3 more

As light propagates through a transmission media, such as an optical fiber, it experiences a length-dependent loss which can reduce the communication efficiency as the transmission distance increases. In conventional telecommunications, optical signals can be transmitted over inter-continental distances, due to deterministic all-optical amplifiers. However, quantum communications are still limited to transmission distances of typically a few 100’s km since deterministic amplifiers cannot be used to amplify quantum signals. The use of deterministic amplification on a quantum signal will introduce noise that will mask the original quantum properties of the signal, introducing uncertainty or errors to any measurement. Nondeterministic methods for amplifying quantum signals via post-selection can be used instead, providing a solution to create a low noise quantum amplifier. Several methods for nondeterministic amplification have already been experimentally demonstrated. However, these devices rely on “quantum resources” which makes implementation challenging. Here we present an overview of experimental demonstrations for amplifying coherent states using a method called state comparison amplification. This is a nondeterministic protocol that performs amplification of known sets of phase-encoded coherent states using two modular stages. The outcome of each stage is recorded using single-photon detectors and time-stamped electronics to enable post-selection. State comparison amplification is a relatively simple technique, only requiring “off-the-shelf” components. The presentation will show several demonstrations of state comparison amplification including an amplifier which has high gain, fidelity, and success rate with the added advantage of being robust to channel noise and easily reconfigurable. Finally, we will discuss the effect of introducing a feedforward mechanism allowing for unsuccessful state amplifications.

SPIE Quantum Technologies•May 29, 2018•0 citations
Numerical results on the performance of quantum amplifiers in an optical communication system show that because of the spontaneous emission, the probability of error is not improved by the introduction of such devices. It is also concluded that nonlinearity, which is known to reduce the relative fluctuations, will not help to enhance the probability of detection.
Spontaneous emission noise limits the capacity and range of photonic communications systems that use linear optical amplifiers. We consider here the question of phase detection in such systems. Amplitude-to-phase-noise conversion occurs owing to the nonlinear Kerr effect in the transmission fiber, resulting in optimal phase noise performance when the nonlinear phase shift of the system is approximately 1 rad. Error-free state-of-the-art systems that use phase detection at multigigabit rates are thereby limited to a range of a few thousand kilometers.
The effect of optical amplification on the signal-to-noise ratio of autocorrelation measurements has been investigated experimentally. A light signal containing correlation information was amplified by an inverted population (phase-insensitive) optical amplifier. The data clearly show that the amplification may either degrade or enhance a subsequent autocorrelation measurement, depending on the experimental conditions. In particular, enhancement is possible when the detector quantum efficiency is low, or its noise is high. However, when all the signal photons are already being detected with no extra noise, then any optical amplification will inevitably lead to degradation of the data quality, due to addition of amplified spontaneous emission noise (ASE) from the amplifier itself.
The intensity fluctuations in the output of a saturable optical amplifier are studied as the amplifier length is increased. Characteristics are determined by calculation of the diagonal elements of the density matrix of the optical field. Saturation affecting both upper-state and lower-state atomic populations is considered. Spontaneous emission distributed along the amplifier causes the "photon-number" distribution to approach a Bose-Einstein distribution during linear amplification if the input field is not Bose-Einstein. The onset of saturation reduces the relative fluctuations of the optical field both by introducing nonlinear gain and by reducing the spontaneous emission. Limiting solutions show that strong saturation leads to a major reduction in the fluctuations causing the photon-number distribution to approach a Poisson distribution.
We examine application of optical amplification to coherent lidar for the case of a weak return signal (a number of quanta of the return optical field close to unity). We consider the option that has been explored to date, namely, incorporation of an optical amplifier operated in a linear manner located after reception of the signal and immediately prior to heterodyning and photodetection. We also consider alternative strategies where the coherent interaction, the nonlinear processes, and the amplification are not necessarily constrained to occur in the manner investigated to date. We include the complications that occur because of mechanisms that occur at the level of a few, or one, quantum excitation. Two factors combine in the work to date that limit the value of the approach. These are: (1) the weak signal tends to require operation of the amplifier in the linear regime where the important advantages of nonlinear optical processing are not accessed, (2) the linear optical amplifier has a -3dB noise figure (SN(out)/SN(in)) that necessarily degrades the signal. Some improvement is gained because the gain provided by the optical amplifier can be used to overcome losses in the heterodyned process and photodetection. The result, however, is that introduction of an optical amplifier in a well optimized coherent lidar system results in, at best, a modest improvement in signal to noise. Some improvement may also be realized on incorporating more optical components in a coherent lidar system for purely practical reasons. For example, more compact, lighter weight, components, more robust alignment, or more rapid processing may be gained. We further find that there remain a number of potentially valuable, but unexplored options offered both by the rapidly expanding base of optical technology and the recent investigation of novel nonlinear coherent interference phenomena occurring at the single quantum excitation level. Key findings are: (1) insertion of linear optical amplifiers in well optimized conventional lidar systems offers modest improvements, at best, (2) the practical advantages of optical amplifiers, especially fiber amplifiers, such as ease of alignment, compactness, efficiency, lightweight, etc., warrant further investigation for coherent lidar, (3) the possibility of more fully optical lidar systems should be explored, (4) advantages gained by use of coherent interference of optical fields at the level of one, or a few, signal quanta should be explored, (5) amplification without inversion, population trapping, and use of electromagnetic induced transparency warrant investigation in connection with coherent lidar, (6) these new findings are probably more applicable to earth related NASA work, although applications to deep space should not be excluded, and (7) our own work in the Ultrafast Laboratory at UAH along some of the above lines of investigation, may be useful.
As light propagates through a transmission media, such as an optical fiber, it experiences a length-dependent loss which can reduce the communication efficiency as the transmission distance increases. In conventional telecommunications, optical signals can be transmitted over inter-continental distances, due to deterministic all-optical amplifiers. However, quantum communications are still limited to transmission distances of typically a few 100’s km since deterministic amplifiers cannot be used to amplify quantum signals. The use of deterministic amplification on a quantum signal will introduce noise that will mask the original quantum properties of the signal, introducing uncertainty or errors to any measurement. Nondeterministic methods for amplifying quantum signals via post-selection can be used instead, providing a solution to create a low noise quantum amplifier. Several methods for nondeterministic amplification have already been experimentally demonstrated. However, these devices rely on “quantum resources” which makes implementation challenging. Here we present an overview of experimental demonstrations for amplifying coherent states using a method called state comparison amplification. This is a nondeterministic protocol that performs amplification of known sets of phase-encoded coherent states using two modular stages. The outcome of each stage is recorded using single-photon detectors and time-stamped electronics to enable post-selection. State comparison amplification is a relatively simple technique, only requiring “off-the-shelf” components. The presentation will show several demonstrations of state comparison amplification including an amplifier which has high gain, fidelity, and success rate with the added advantage of being robust to channel noise and easily reconfigurable. Finally, we will discuss the effect of introducing a feedforward mechanism allowing for unsuccessful state amplifications.