Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Physical Review A

Quantum theory of a saturable optical amplifier

N. B. Abraham

Published May 1, 1980• 12 citations
Publisher

Abstract

The intensity fluctuations in the output of a saturable optical amplifier are studied as the amplifier length is increased. Characteristics are determined by calculation of the diagonal elements of the density matrix of the optical field. Saturation affecting both upper-state and lower-state atomic populations is considered. Spontaneous emission distributed along the amplifier causes the "photon-number" distribution to approach a Bose-Einstein distribution during linear amplification if the input field is not Bose-Einstein. The onset of saturation reduces the relative fluctuations of the optical field both by introducing nonlinear gain and by reducing the spontaneous emission. Limiting solutions show that strong saturation leads to a major reduction in the fluctuations causing the photon-number distribution to approach a Poisson distribution.

DOI
10.1103/physreva.21.1595

Related papers

Amplified-spontaneous-emission intensity fluctuations

N. B. Abraham, John C. Huang, David A. Kranz +1 more

Intensity fluctuation characteristics of amplified-spontaneous emission are found using intensity rate equations and the noise-amplifier approximation for saturation coupling between two and four competing modes. The existence of more than one mode leads to the retention of relatively large fluctuations in each mode even as the amplifier gain is saturated, an operating regime which by contrast has been shown to reduce significantly the fluctuations when only a single beam is present. The noise-amplifier approximation is found to be an adequate approximation of the effects of the spontaneous emission distributed along the length of a laser amplifier. The intensity fluctuations in all cases approach limiting distributions functions as the amplifier becomes heavily saturated. Characteristics of these limiting distributions are found for one, two, and four beams; for combinations of beams copropagating and counterpropagating; in the presence and absence of loss; for differences in gain; and for saturation of the sources due to high intensities.

Physical Review A•Nov 1, 1981•14 citations

Quantum-statistical properties of pulse amplification in optical fibers with gain saturation

Gokalp Kahraman, B.E.A. Saleb

We studied the quantum-statistical properties of pulse amplification in erbium-doped fiber amplifiers (OFAs), including saturation of the atomic population inversion and pump depletion. We use a fully quantum theory to describe the atom-field interaction as wed as the light propagation. The generating function of the output photon number distribution (PND) is determined as a function of time during the course of the pulse, with an arbitrary input PND assumed. For input light with Poisson PND, the output PND is shown to be the Laguerre distribution with parameter 1 at all times smaller than the coherence time /spl tau//sub c/, even in the presence of nonlinear effects. An expression for the photon count moment generating function is found for counting times T/spl Gt//spl tau//sub c/. The mean pulse shape is shown to be altered by the nonlinear amplification. The variance is similarly altered, and the excess amplifier noise is greater at the leading side of the pulse.>

Journal of Lightwave Technology•Jun 1, 1995•2 citations

Statistical analysis of nonlinear optical amplifier in high saturation

Sergio Ruiz‐Moreno, Gabriel Junyent, M. J. Soneira +1 more

In the work, analytic expressions describing the behaviour of a strongly saturated nonlinear optical amplifier are deduced. These expressions make possible the calculation of the mean and variance of the amplified light photon number. Results are compared with those obtained by the numerical resolution of the photon density matrix equation, and good accordance is observed in the strong saturation regime. The results numerically obtained enable us to make conclusions about the statistical fluctuations of the optical power at the nonlinear optical amplifer output.

IEE Proceedings J Optoelectronics•Jan 1, 1988•6 citations

Intrinsic spontaneous emission-induced fluctuations of the output optical beam power and phase in a diode amplifier

Alexander P. Bogatov, Alexander E. Drakin, N V D'yachkov +1 more

Output optical beam intensity and phase fluctuations are analysed in a classical approach to describing the propagation and amplification of spontaneous emission in the active region of a laser diode with a gain saturated by input monochromatic light. We find their spectral densities and dispersion and the correlation coefficient of the two-dimensional probability distribution function of the fluctuations.

Quantum Electronics•Aug 22, 2016•1 citation

Properties of the Optical Quantum Amplifier

R. Loudon, Terence J. Shepherd

The properties of a linear optical amplifier or attenuator in which the input light is coupled to a collection of non-saturable atoms are considered. The photon-number factorial moments and probability distribution of the amplifier output are derived for arbitrary input statistics. Relations are obtained between the output and input variances in photon number, phase-angle cosine, and electric-field magnitude. The effects of amplification and attenuation on signal-to-noise ratio are obtained for both direct and homodyne detection. Particular attention is paid to the extents to which the non-classical properties of photon antibunching and squeezing are preserved by amplification and attenuation. It is found that both properties can at best survive only twofold intensity amplification.

Optica Acta International Journal of Optics•Nov 1, 1984•105 citations

Laser Amplifiers

Bahaa E. A. Saleh, Malvin Carl Teich

A coherent optical amplifier is a device that increases the amplitude of an optical field while maintaining its phase. If the optical field at the input to such an amplifier is monochromatic, the output will also be monochromatic, with the same frequency. The output amplitude is increased relative to the input while the phase is unchanged or shifted by a fixed amount. In contrast, an amplifier that increases the intensity of an optical wave without preserving the phase is called an incoherent optical amplifier. This chapter is concerned with coherent optical amplifiers. Such amplifiers are important for various applications; examples include the amplification of weak optical pulses such as those that have traveled through a long length of optical fiber, and the production of highly intense optical pulses such as those required for laser-fusion applications. Furthermore, it is important to understand the principles underlying the operation of optical amplifiers as a prelude to the discussion of optical oscillators. Light transmitted through matter in thermal equilibrium is attenuated rather than amplified. This is because absorption by the large population of atoms in the lower energy level is more prevalent than stimulated emission by the smaller population of atoms in the upper level. An essential ingredient for achieving laser amplification is the presence of a greater number of atoms in the upper energy level than in the lower level, which is clearly a nonequilibrium situation. Achieving such a population inversion requires a source of power to excite (pump) the atoms into the higher energy level. Although the presentation throughout this chapter is couched in terms of “atoms” and “atomic levels,” these appelations are to be more broadly understood as “active medium” and “laser energy levels,” respectively. The properties of an ideal (optical or electronic) coherent amplifier are displayed schematically. Real coherent amplifiers deliver a gain and phase shift that are frequency dependent, typically in the manner illustrated here. The gain and phase shift constitute the amplifier's transfer function. For a sufficiently high input amplitude, furthermore, real amplifiers may exhibit saturation, a form of nonlinear behavior in which the output amplitude fails to increase in proportion to the input amplitude. Saturation introduces harmonic components into the output, provided that the amplifier bandwidth is sufficiently broad to pass them. Real amplifiers also introduce noise, so that a randomly fluctuating component is always present at the output, regardless of the input. An amplifier may therefore be characterized by the following features: ▪ gain; ▪ bandwidth; ▪ phase shift; ▪ power source; ▪ nonlinearity and gain saturation, and ▪ noise We proceed to discuss these characteristics in turn in this chapter. The theory of laser amplification is developed, leading to expressions for the amplifier gain, spectral bandwidth, and phase shift. The mechanisms by which an amplifier power source can achieve a population inversion are examined. Gain saturation and noise in the amplification process, are discussed respectively. This chapter relies on material presented in Chap. 12.

Wiley eBooks•Aug 14, 1991•2 citations
The intensity fluctuations in the output of a saturable optical amplifier are studied as the amplifier length is increased. Characteristics are determined by calculation of the diagonal elements of the density matrix of the optical field. Saturation affecting both upper-state and lower-state atomic populations is considered. Spontaneous emission distributed along the amplifier causes the "photon-number" distribution to approach a Bose-Einstein distribution during linear amplification if the input field is not Bose-Einstein. The onset of saturation reduces the relative fluctuations of the optical field both by introducing nonlinear gain and by reducing the spontaneous emission. Limiting solutions show that strong saturation leads to a major reduction in the fluctuations causing the photon-number distribution to approach a Poisson distribution.
Intensity fluctuation characteristics of amplified-spontaneous emission are found using intensity rate equations and the noise-amplifier approximation for saturation coupling between two and four competing modes. The existence of more than one mode leads to the retention of relatively large fluctuations in each mode even as the amplifier gain is saturated, an operating regime which by contrast has been shown to reduce significantly the fluctuations when only a single beam is present. The noise-amplifier approximation is found to be an adequate approximation of the effects of the spontaneous emission distributed along the length of a laser amplifier. The intensity fluctuations in all cases approach limiting distributions functions as the amplifier becomes heavily saturated. Characteristics of these limiting distributions are found for one, two, and four beams; for combinations of beams copropagating and counterpropagating; in the presence and absence of loss; for differences in gain; and for saturation of the sources due to high intensities.
We studied the quantum-statistical properties of pulse amplification in erbium-doped fiber amplifiers (OFAs), including saturation of the atomic population inversion and pump depletion. We use a fully quantum theory to describe the atom-field interaction as wed as the light propagation. The generating function of the output photon number distribution (PND) is determined as a function of time during the course of the pulse, with an arbitrary input PND assumed. For input light with Poisson PND, the output PND is shown to be the Laguerre distribution with parameter 1 at all times smaller than the coherence time /spl tau//sub c/, even in the presence of nonlinear effects. An expression for the photon count moment generating function is found for counting times T/spl Gt//spl tau//sub c/. The mean pulse shape is shown to be altered by the nonlinear amplification. The variance is similarly altered, and the excess amplifier noise is greater at the leading side of the pulse.>
In the work, analytic expressions describing the behaviour of a strongly saturated nonlinear optical amplifier are deduced. These expressions make possible the calculation of the mean and variance of the amplified light photon number. Results are compared with those obtained by the numerical resolution of the photon density matrix equation, and good accordance is observed in the strong saturation regime. The results numerically obtained enable us to make conclusions about the statistical fluctuations of the optical power at the nonlinear optical amplifer output.
The properties of a linear optical amplifier or attenuator in which the input light is coupled to a collection of non-saturable atoms are considered. The photon-number factorial moments and probability distribution of the amplifier output are derived for arbitrary input statistics. Relations are obtained between the output and input variances in photon number, phase-angle cosine, and electric-field magnitude. The effects of amplification and attenuation on signal-to-noise ratio are obtained for both direct and homodyne detection. Particular attention is paid to the extents to which the non-classical properties of photon antibunching and squeezing are preserved by amplification and attenuation. It is found that both properties can at best survive only twofold intensity amplification.
A coherent optical amplifier is a device that increases the amplitude of an optical field while maintaining its phase. If the optical field at the input to such an amplifier is monochromatic, the output will also be monochromatic, with the same frequency. The output amplitude is increased relative to the input while the phase is unchanged or shifted by a fixed amount. In contrast, an amplifier that increases the intensity of an optical wave without preserving the phase is called an incoherent optical amplifier. This chapter is concerned with coherent optical amplifiers. Such amplifiers are important for various applications; examples include the amplification of weak optical pulses such as those that have traveled through a long length of optical fiber, and the production of highly intense optical pulses such as those required for laser-fusion applications. Furthermore, it is important to understand the principles underlying the operation of optical amplifiers as a prelude to the discussion of optical oscillators. Light transmitted through matter in thermal equilibrium is attenuated rather than amplified. This is because absorption by the large population of atoms in the lower energy level is more prevalent than stimulated emission by the smaller population of atoms in the upper level. An essential ingredient for achieving laser amplification is the presence of a greater number of atoms in the upper energy level than in the lower level, which is clearly a nonequilibrium situation. Achieving such a population inversion requires a source of power to excite (pump) the atoms into the higher energy level. Although the presentation throughout this chapter is couched in terms of “atoms” and “atomic levels,” these appelations are to be more broadly understood as “active medium” and “laser energy levels,” respectively. The properties of an ideal (optical or electronic) coherent amplifier are displayed schematically. Real coherent amplifiers deliver a gain and phase shift that are frequency dependent, typically in the manner illustrated here. The gain and phase shift constitute the amplifier's transfer function. For a sufficiently high input amplitude, furthermore, real amplifiers may exhibit saturation, a form of nonlinear behavior in which the output amplitude fails to increase in proportion to the input amplitude. Saturation introduces harmonic components into the output, provided that the amplifier bandwidth is sufficiently broad to pass them. Real amplifiers also introduce noise, so that a randomly fluctuating component is always present at the output, regardless of the input. An amplifier may therefore be characterized by the following features: ▪ gain; ▪ bandwidth; ▪ phase shift; ▪ power source; ▪ nonlinearity and gain saturation, and ▪ noise We proceed to discuss these characteristics in turn in this chapter. The theory of laser amplification is developed, leading to expressions for the amplifier gain, spectral bandwidth, and phase shift. The mechanisms by which an amplifier power source can achieve a population inversion are examined. Gain saturation and noise in the amplification process, are discussed respectively. This chapter relies on material presented in Chap. 12.