Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal of Modern Optics

Signal Enhancement by Optical Amplification in Autocorrelation Measurements

Michael Harris, R. Loudon, Terence J. Shepherd, J. Michael Vaughan

Published Apr 1, 1991• 5 citations
Publisher

Abstract

The effect of optical amplification on the signal-to-noise ratio of autocorrelation measurements has been investigated experimentally. A light signal containing correlation information was amplified by an inverted population (phase-insensitive) optical amplifier. The data clearly show that the amplification may either degrade or enhance a subsequent autocorrelation measurement, depending on the experimental conditions. In particular, enhancement is possible when the detector quantum efficiency is low, or its noise is high. However, when all the signal photons are already being detected with no extra noise, then any optical amplification will inevitably lead to degradation of the data quality, due to addition of amplified spontaneous emission noise (ASE) from the amplifier itself.

DOI
10.1080/09500349114550631

Related papers

Reduction of signal-spontaneous noise in optical amplifiers

G. Du, Scott Roger Shepard, A. Wright

The beat between an amplified optical signal and the amplified spontaneous emission (ASE) noise is typically the primary limitation to the performance of optical fiber amplifiers. A filtering technique which might reduce this beat noise by 3dB creates a paradox since the noise figure's quantum limit of 3dB could then be reduced to 0dB implying noiseless amplification, which is impossible. The conjecture that this paradox might be resolved by different attenuations of the quantum and semiclassical descriptions of signal-spontaneous noise has been experimentally rejected . Herein, we present a variation of that experiment and telecommunication' applications of this filtering technique are discussed.

IEEE International Midwest Symposium on Circuits and Systems (MWSCAS)•Nov 11, 2002•0 citations

Laser-amplifier gain and noise

R. Loudon, Michael Harris, Terence J. Shepherd +1 more

A theoretical study is presented of the gain and the noise spectra of laser amplifiers at pumping rates both above and below the oscillation threshold. The theory is valid for both class-A and class-B laser systems, where the decay rate of the collective atomic dipole moment greatly exceeds the decay rates of the atomic population inversion and the laser cavity. The gain and the noise properties are shown to be strongly influenced by a four-wave mixing of the signal and image frequencies via a modulation of the population inversion. Particular attention is paid to the residual noise flux that persists in the laser output above threshold and to the typical characteristics of a second-order phase transition displayed by the gain in the threshold region. The results for the above-threshold laser amplifier are compared with experimental measurements of both gain and noise for the argon-ion (class-A) and ${\mathrm{CO}}_{2}$ (class-B) lasers. The signal-to-noise ratios for both heterodyne and direct-detection measurements are evaluated, and the conditions are determined under which optical amplification can lead to an enhancement of sensitivity.

Physical Review A•Jul 1, 1993•37 citations

Classical model for the noise properties of distributed optical amplifiers

Philippe B. Gallion, Virginie Dallot, Edouard Bridoux

Adopting a new classical approach, the additive noise power generated in optical amplifiers is calculated in terms of power spectral density. The classical formalism used combines a coruscular approach to a phase-amplitude description of the optical field. The noise contributions of the input field fluctuations, including zero-point fluctuations, and of the electron momentum fluctuations at optical frequency linked to the amplifier itself, are clearly identified. The excess of noise associated to coupling or built-in losses is determinated. The well-known result of the Amplified Spontaneous Emission (ASE) is obtained for the laser amplifiers. This description is applied to linear phase-insensitive amplifiers and to inhomogeneous, nonlinear phase-insensitive Raman amplifier, pointing out the effects of gain compression and gain distribution. This new approach makes possible the treatment of the squeezed-state of light and the quadrature reduced noise amplifications.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Oct 17, 2001•1 citation

Noise in optical amplifiers

Gianfranco Cariolaro, Roberto Corvaja, Pierluigi Franco +2 more

This article presents an application of a recently published probablistic model for traveling wave optical amplification. Both optical signal and amplified spontaneous emission (ASE) noise are modeled as bunches of photons traveling along the amplifying region with size varying according to simple random rules. The results of the theory enable one to obtain a complete and accurate characterization of the signal and noise counting at the amplifier output. On the basis of the above statistics, we find a realistic evaluation of the limits imposed by both quantum and ASE noise on the performances of a receiver including an optical amplifier at a preamplifier stage.

Fiber & Integrated Optics•Jan 1, 1994•2 citations

Quantum noise properties of a nonlinear amplifier

Roy S. Bondurant

We propose and analyze a nonlinear optical amplifier that is phase insensitive but has no additive noise. When the input field is in a coherent state, the noise figure is -6 dB when the gain is high. However, unlike conventional linear amplifiers with -3 dB noise figures, the detectibility of the amplified signal is not degraded. The amplifier is constructed simply, in principle, by the same type of nonlinear interferometer used in photon number quantum nondemolition measurements.

Physical Review Letters•Sep 13, 1993•4 citations

Amplifier Noise Based Optical Steganography with Coherent Detection

Ben Wu, Matthew P. Chang, Naomi R. Caldwell +2 more

Abstract We summarize the principle and experimental setup of optical steganography based on amplified spontaneous emission (ASE) noise. Using ASE noise as the signal carrier, optical steganography effectively hides a stealth channel in both the time domain and the frequency domain. Coherent detection is used at the receiver of the stealth channel. Because ASE noise has short coherence length and random phase, it only interferes with itself within a very short range. Coherent detection requires the stealth transmitter and stealth receiver to precisely match the optical delay,which generates a large key space for the stealth channel. Several methods to further improve optical steganography, signal to noise ratio, compatibility with the public channel, and applications of the stealth channel are also summarized in this review paper.

Coherent Phenomena•Jan 23, 2014•6 citations
The effect of optical amplification on the signal-to-noise ratio of autocorrelation measurements has been investigated experimentally. A light signal containing correlation information was amplified by an inverted population (phase-insensitive) optical amplifier. The data clearly show that the amplification may either degrade or enhance a subsequent autocorrelation measurement, depending on the experimental conditions. In particular, enhancement is possible when the detector quantum efficiency is low, or its noise is high. However, when all the signal photons are already being detected with no extra noise, then any optical amplification will inevitably lead to degradation of the data quality, due to addition of amplified spontaneous emission noise (ASE) from the amplifier itself.
The beat between an amplified optical signal and the amplified spontaneous emission (ASE) noise is typically the primary limitation to the performance of optical fiber amplifiers. A filtering technique which might reduce this beat noise by 3dB creates a paradox since the noise figure's quantum limit of 3dB could then be reduced to 0dB implying noiseless amplification, which is impossible. The conjecture that this paradox might be resolved by different attenuations of the quantum and semiclassical descriptions of signal-spontaneous noise has been experimentally rejected . Herein, we present a variation of that experiment and telecommunication' applications of this filtering technique are discussed.
A theoretical study is presented of the gain and the noise spectra of laser amplifiers at pumping rates both above and below the oscillation threshold. The theory is valid for both class-A and class-B laser systems, where the decay rate of the collective atomic dipole moment greatly exceeds the decay rates of the atomic population inversion and the laser cavity. The gain and the noise properties are shown to be strongly influenced by a four-wave mixing of the signal and image frequencies via a modulation of the population inversion. Particular attention is paid to the residual noise flux that persists in the laser output above threshold and to the typical characteristics of a second-order phase transition displayed by the gain in the threshold region. The results for the above-threshold laser amplifier are compared with experimental measurements of both gain and noise for the argon-ion (class-A) and CO2{\mathrm{CO}}_{2}CO2​ (class-B) lasers. The signal-to-noise ratios for both heterodyne and direct-detection measurements are evaluated, and the conditions are determined under which optical amplification can lead to an enhancement of sensitivity.
Adopting a new classical approach, the additive noise power generated in optical amplifiers is calculated in terms of power spectral density. The classical formalism used combines a coruscular approach to a phase-amplitude description of the optical field. The noise contributions of the input field fluctuations, including zero-point fluctuations, and of the electron momentum fluctuations at optical frequency linked to the amplifier itself, are clearly identified. The excess of noise associated to coupling or built-in losses is determinated. The well-known result of the Amplified Spontaneous Emission (ASE) is obtained for the laser amplifiers. This description is applied to linear phase-insensitive amplifiers and to inhomogeneous, nonlinear phase-insensitive Raman amplifier, pointing out the effects of gain compression and gain distribution. This new approach makes possible the treatment of the squeezed-state of light and the quadrature reduced noise amplifications.
This article presents an application of a recently published probablistic model for traveling wave optical amplification. Both optical signal and amplified spontaneous emission (ASE) noise are modeled as bunches of photons traveling along the amplifying region with size varying according to simple random rules. The results of the theory enable one to obtain a complete and accurate characterization of the signal and noise counting at the amplifier output. On the basis of the above statistics, we find a realistic evaluation of the limits imposed by both quantum and ASE noise on the performances of a receiver including an optical amplifier at a preamplifier stage.
Abstract We summarize the principle and experimental setup of optical steganography based on amplified spontaneous emission (ASE) noise. Using ASE noise as the signal carrier, optical steganography effectively hides a stealth channel in both the time domain and the frequency domain. Coherent detection is used at the receiver of the stealth channel. Because ASE noise has short coherence length and random phase, it only interferes with itself within a very short range. Coherent detection requires the stealth transmitter and stealth receiver to precisely match the optical delay,which generates a large key space for the stealth channel. Several methods to further improve optical steganography, signal to noise ratio, compatibility with the public channel, and applications of the stealth channel are also summarized in this review paper.