Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE

Dynamically-tuned microresonator complexes

Michelle L. Povinelli, Sunil Sandhu, Jung‐Tsung Shen, Mehmet Fatih Yanik, Shanhui Fan

Published Feb 8, 2007• 0 citations
Publisher

Abstract

Dynamic tuning of systems of microresonators coupled to waveguides allows a rich range of physical effects. Periodic resonator arrays can be tuned to stop and store light pulses, theoretically allowing for tunable delay devices in which the delay is limited neither by bandwidth nor by dispersion. For two-resonator systems, adjustable delays can be obtained from tuning a narrow transparency resonance. Similar behavior is also predicted in a quite different physical system, that of a single photon interacting with dynamically-tuned quantum bits.

DOI
10.1117/12.714597

Related papers

Stopping and manipulating light using a short array of active microresonators

Yannick Dumeige

We theoretically propose a light-stopping process that uses loss and gain dynamical tuning in short coupled-resonator delay lines. The structure is made of four resonators and is optimized to avoid pulse distortion in the passive regime. The loss and gain modulations allow the resonant structure to be isolated from the access waveguide and the pulse to be stored. We demonstrate via numerical simulations the pulse storing process and show that this active delay line also induces nonlinear effects leading to pulse compression. This last property could be useful for pulse dispersion tailoring.

Europhysics Letters (EPL)•Apr 1, 2009•18 citations

Dynamically tuned coupled-resonator delay lines can be nearly dispersion free

Sunil Sandhu, Michelle L. Povinelli, Mehmet Fatih Yanik +1 more

We investigate dispersion effects in dynamically tuned, coupled-resonator delay lines. Provided that the system is tuned to a zero-bandwidth state, a signal can be delayed indefinitely with almost no dispersion. We present a theoretical analysis of such a light-stopping system and verify the results using numerical simulations.

Optics Letters•Jun 12, 2006•35 citations

Storing light with microresonator arrays or active microresonator chains

Yannick Dumeige, Stéphane Trebaol, Patrice Féron

We theoretically analyze the light-storing process in optical microresonator arrays. We propose a passive and an active schemes to strongly slow light. The two mechanisms rely on microresonator chains whose high order dispersion is optimized. The unit cell of the systems is a short sequence of two or four resonators. In the passive process we show that the cancellation of the third order of dispersion allows the propagation of short pulses with no significant distortion in a microresonator array. The second process needs the use of active microresonators whose loss and gain are dynamically tuned. The structure is made of only four resonators and is optimized to avoid pulse distortion as it is the case in the passive scheme. The loss and gain modulations allow the resonant structure to be isolated from the access waveguide and optical pulse to be stored.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Feb 1, 2010•0 citations

Dynamically-tuned coupled-resonator delay lines can be nearly dispersion free

Sunil Sandhu, Michelle L. Povinelli, Mehmet Fatih Yanik +1 more

We investigate dispersion effects in dynamically-tuned, coupled-resonator delay lines. Provided that the system is tuned to a zero-bandwidth state, a signal can be delayed indefinitely without dispersion. We present a theoretical analysis of such a light-stopping system and verify the results using numerical simulations of an example system.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Feb 9, 2006•1 citation

Active coupled resonator delay lines

Yannick Dumeige, Stéphane Trebaol, Patrice Féron

The possibility of slowing down or storing light holds interests in classical or quantum optical communications. Different schemes have been proposed; among them, active resonator-based devices seem to provide a scalable and low loss solution for this purpose. This paper will be devoted to the theoretical and experimental studies of active coupled resonator delay lines. High-quality (Q) factor resonators are strongly dispersive systems which can be used to control the group velocity of light. As it is the case for atomic systems the dispersion properties of these artificial media is dependent on their absorption or optical gain. Moreover by coupling several resonators it is also possible to tailor their transmission or high dispersion orders . For these two reasons, active coupled resonators may be of high interest for optical dispersion or delay lines. In the aim of practical applications, the first step consists in defining an experimental protocol allowing a resonator complete description to be obtained. Cavity ring down spectroscopy method can be adapted to obtain the essential parameters such as gain/absorption and dispersion. The method has been validated using a model system made of Er3+ doped optical fiber resonators and applied to various high-Q whispering gallery mode resonators including resonators under modal coupling. It is possible to find coupling configurations allowing the dispersion of coupled active resonator systems to be tailored by changing the optical losses or gain of each resonator. In particular these systems may be used as tunable transparent delay lines or for dispersion compensation. This last configuration can be used to enhanced or actively control the quality factor of passive cavities. Finally the dynamic control of dispersion or resonance properties via the gain control of active coupled microresonators could find some applications in optical buffering.

•Nov 4, 2009•0 citations

Stopping and Storing Light in Semiconductor Quantum Wells and Optical Microresonators

Jacob B. Khurgin, R.S. Tucker

There is a wide variety of proposals for implementations of slow-light effects, and many of them are described in the various chapters of this book. The physical implementations vary from system to system, and so do the mathematical formalisms used to describe the specific physical systems. However, it is also possible that one has two completely different physical slow-light systems, yet the mathematical framework describing the slowing and stopping of light is very similar. In this chapter, we present an example falling into this category. The two physically different slow-light systems are (1) semiconductor multiple quantum wells (QWs) (more specifically: Bragg-spaced multiple QWs, or BSQWs [1-16]) and (2) optical resonators (more specifically: side-coupled integrated spaced sequence of resonators with two waveguide channels, or two-channel SCISSORs [17,18]). In Figure 13.1, BSQWs are schematically shown as a sequence of thin semiconductor QWs, spaced by a distance a with a dielectric of refractive index nb between the wells. SCISSORs are sequences of ring-shaped dielectric optical microresonators coupled to two waveguides (Figure 13.2). Clearly, these are very different physical systems, and so onemay wonder in which sense slow-light concepts (i.e., the concepts for delaying, stopping, storing, and releasing light) can be similar or almost identical in these systems. The answer to this question lies in the fact that both systems can be viewed as physical realizations of one-dimensional resonant photonic bandgap structures (RPBGs). RPBGs differ from conventional (nonresonant) photonic bandgap structures in that each unit cell in the photonic lattice exhibits an optical resonance with a resonance frequency that is identical or at least close to the Bragg frequency characterizing the optical lattice. In QWs, the optical resonance is taken to be the heavy-hole exciton resonance, while in SCISSORs we take one of the optical resonances of the microrings.

CRC Press eBooks•Oct 8, 2018•0 citations
Dynamic tuning of systems of microresonators coupled to waveguides allows a rich range of physical effects. Periodic resonator arrays can be tuned to stop and store light pulses, theoretically allowing for tunable delay devices in which the delay is limited neither by bandwidth nor by dispersion. For two-resonator systems, adjustable delays can be obtained from tuning a narrow transparency resonance. Similar behavior is also predicted in a quite different physical system, that of a single photon interacting with dynamically-tuned quantum bits.
We theoretically propose a light-stopping process that uses loss and gain dynamical tuning in short coupled-resonator delay lines. The structure is made of four resonators and is optimized to avoid pulse distortion in the passive regime. The loss and gain modulations allow the resonant structure to be isolated from the access waveguide and the pulse to be stored. We demonstrate via numerical simulations the pulse storing process and show that this active delay line also induces nonlinear effects leading to pulse compression. This last property could be useful for pulse dispersion tailoring.
We theoretically analyze the light-storing process in optical microresonator arrays. We propose a passive and an active schemes to strongly slow light. The two mechanisms rely on microresonator chains whose high order dispersion is optimized. The unit cell of the systems is a short sequence of two or four resonators. In the passive process we show that the cancellation of the third order of dispersion allows the propagation of short pulses with no significant distortion in a microresonator array. The second process needs the use of active microresonators whose loss and gain are dynamically tuned. The structure is made of only four resonators and is optimized to avoid pulse distortion as it is the case in the passive scheme. The loss and gain modulations allow the resonant structure to be isolated from the access waveguide and optical pulse to be stored.
The possibility of slowing down or storing light holds interests in classical or quantum optical communications. Different schemes have been proposed; among them, active resonator-based devices seem to provide a scalable and low loss solution for this purpose. This paper will be devoted to the theoretical and experimental studies of active coupled resonator delay lines. High-quality (Q) factor resonators are strongly dispersive systems which can be used to control the group velocity of light. As it is the case for atomic systems the dispersion properties of these artificial media is dependent on their absorption or optical gain. Moreover by coupling several resonators it is also possible to tailor their transmission or high dispersion orders . For these two reasons, active coupled resonators may be of high interest for optical dispersion or delay lines. In the aim of practical applications, the first step consists in defining an experimental protocol allowing a resonator complete description to be obtained. Cavity ring down spectroscopy method can be adapted to obtain the essential parameters such as gain/absorption and dispersion. The method has been validated using a model system made of Er3+ doped optical fiber resonators and applied to various high-Q whispering gallery mode resonators including resonators under modal coupling. It is possible to find coupling configurations allowing the dispersion of coupled active resonator systems to be tailored by changing the optical losses or gain of each resonator. In particular these systems may be used as tunable transparent delay lines or for dispersion compensation. This last configuration can be used to enhanced or actively control the quality factor of passive cavities. Finally the dynamic control of dispersion or resonance properties via the gain control of active coupled microresonators could find some applications in optical buffering.
There is a wide variety of proposals for implementations of slow-light effects, and many of them are described in the various chapters of this book. The physical implementations vary from system to system, and so do the mathematical formalisms used to describe the specific physical systems. However, it is also possible that one has two completely different physical slow-light systems, yet the mathematical framework describing the slowing and stopping of light is very similar. In this chapter, we present an example falling into this category. The two physically different slow-light systems are (1) semiconductor multiple quantum wells (QWs) (more specifically: Bragg-spaced multiple QWs, or BSQWs [1-16]) and (2) optical resonators (more specifically: side-coupled integrated spaced sequence of resonators with two waveguide channels, or two-channel SCISSORs [17,18]). In Figure 13.1, BSQWs are schematically shown as a sequence of thin semiconductor QWs, spaced by a distance a with a dielectric of refractive index nb between the wells. SCISSORs are sequences of ring-shaped dielectric optical microresonators coupled to two waveguides (Figure 13.2). Clearly, these are very different physical systems, and so onemay wonder in which sense slow-light concepts (i.e., the concepts for delaying, stopping, storing, and releasing light) can be similar or almost identical in these systems. The answer to this question lies in the fact that both systems can be viewed as physical realizations of one-dimensional resonant photonic bandgap structures (RPBGs). RPBGs differ from conventional (nonresonant) photonic bandgap structures in that each unit cell in the photonic lattice exhibits an optical resonance with a resonance frequency that is identical or at least close to the Bragg frequency characterizing the optical lattice. In QWs, the optical resonance is taken to be the heavy-hole exciton resonance, while in SCISSORs we take one of the optical resonances of the microrings.