Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE

Dynamically-tuned coupled-resonator delay lines can be nearly dispersion free

Sunil Sandhu, Michelle L. Povinelli, Mehmet Fatih Yanik, Shanhui Fan

Published Feb 9, 2006• 1 citation
Publisher

Abstract

We investigate dispersion effects in dynamically-tuned, coupled-resonator delay lines. Provided that the system is tuned to a zero-bandwidth state, a signal can be delayed indefinitely without dispersion. We present a theoretical analysis of such a light-stopping system and verify the results using numerical simulations of an example system.

DOI
10.1117/12.660190

Related papers

Dynamically tuned coupled-resonator delay lines can be nearly dispersion free

Sunil Sandhu, Michelle L. Povinelli, Mehmet Fatih Yanik +1 more

We investigate dispersion effects in dynamically tuned, coupled-resonator delay lines. Provided that the system is tuned to a zero-bandwidth state, a signal can be delayed indefinitely with almost no dispersion. We present a theoretical analysis of such a light-stopping system and verify the results using numerical simulations.

Optics Letters•Jun 12, 2006•35 citations

Stopping and time reversing a light pulse using dynamic loss tuning of coupled-resonator delay lines

Sunil Sandhu, Michelle L. Povinelli, Shanhui Fan

We introduce a light-stopping process that uses dynamic loss tuning in coupled-resonator delay lines. We demonstrate via numerical simulations that increasing the loss of selected resonators traps light in a zero group velocity mode concentrated in the low-loss portions of the delay line. The large dynamic range achievable for loss modulation should increase the light-stopping bandwidth relative to previous approaches based on refractive index tuning.

Optics Letters•Nov 12, 2007•35 citations

Dynamically-tuned microresonator complexes

Michelle L. Povinelli, Sunil Sandhu, Jung‐Tsung Shen +2 more

Dynamic tuning of systems of microresonators coupled to waveguides allows a rich range of physical effects. Periodic resonator arrays can be tuned to stop and store light pulses, theoretically allowing for tunable delay devices in which the delay is limited neither by bandwidth nor by dispersion. For two-resonator systems, adjustable delays can be obtained from tuning a narrow transparency resonance. Similar behavior is also predicted in a quite different physical system, that of a single photon interacting with dynamically-tuned quantum bits.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Feb 8, 2007•0 citations

Tunable slow-wave optical delay lines

Francesco Morichetti, Andrea Ivano Melloni, Cristina Canavesi +3 more

Tunable delay lines exploiting slow-light in directly-coupled ring-resonators are presented. Time delay can be tuned from zero to maximum. Experimental results showing delays of 300ps and slowing factor of 7.5 over 3GHz bandwidth are reported.

Slow and Fast Light (SL)•Jan 1, 2006•8 citations

Stopping and manipulating light using a short array of active microresonators

Yannick Dumeige

We theoretically propose a light-stopping process that uses loss and gain dynamical tuning in short coupled-resonator delay lines. The structure is made of four resonators and is optimized to avoid pulse distortion in the passive regime. The loss and gain modulations allow the resonant structure to be isolated from the access waveguide and the pulse to be stored. We demonstrate via numerical simulations the pulse storing process and show that this active delay line also induces nonlinear effects leading to pulse compression. This last property could be useful for pulse dispersion tailoring.

Europhysics Letters (EPL)•Apr 1, 2009•18 citations

Active coupled resonator delay lines

Yannick Dumeige, Stéphane Trebaol, Patrice Féron

The possibility of slowing down or storing light holds interests in classical or quantum optical communications. Different schemes have been proposed; among them, active resonator-based devices seem to provide a scalable and low loss solution for this purpose. This paper will be devoted to the theoretical and experimental studies of active coupled resonator delay lines. High-quality (Q) factor resonators are strongly dispersive systems which can be used to control the group velocity of light. As it is the case for atomic systems the dispersion properties of these artificial media is dependent on their absorption or optical gain. Moreover by coupling several resonators it is also possible to tailor their transmission or high dispersion orders . For these two reasons, active coupled resonators may be of high interest for optical dispersion or delay lines. In the aim of practical applications, the first step consists in defining an experimental protocol allowing a resonator complete description to be obtained. Cavity ring down spectroscopy method can be adapted to obtain the essential parameters such as gain/absorption and dispersion. The method has been validated using a model system made of Er3+ doped optical fiber resonators and applied to various high-Q whispering gallery mode resonators including resonators under modal coupling. It is possible to find coupling configurations allowing the dispersion of coupled active resonator systems to be tailored by changing the optical losses or gain of each resonator. In particular these systems may be used as tunable transparent delay lines or for dispersion compensation. This last configuration can be used to enhanced or actively control the quality factor of passive cavities. Finally the dynamic control of dispersion or resonance properties via the gain control of active coupled microresonators could find some applications in optical buffering.

•Nov 4, 2009•0 citations
We investigate dispersion effects in dynamically-tuned, coupled-resonator delay lines. Provided that the system is tuned to a zero-bandwidth state, a signal can be delayed indefinitely without dispersion. We present a theoretical analysis of such a light-stopping system and verify the results using numerical simulations of an example system.
Dynamic tuning of systems of microresonators coupled to waveguides allows a rich range of physical effects. Periodic resonator arrays can be tuned to stop and store light pulses, theoretically allowing for tunable delay devices in which the delay is limited neither by bandwidth nor by dispersion. For two-resonator systems, adjustable delays can be obtained from tuning a narrow transparency resonance. Similar behavior is also predicted in a quite different physical system, that of a single photon interacting with dynamically-tuned quantum bits.
We theoretically propose a light-stopping process that uses loss and gain dynamical tuning in short coupled-resonator delay lines. The structure is made of four resonators and is optimized to avoid pulse distortion in the passive regime. The loss and gain modulations allow the resonant structure to be isolated from the access waveguide and the pulse to be stored. We demonstrate via numerical simulations the pulse storing process and show that this active delay line also induces nonlinear effects leading to pulse compression. This last property could be useful for pulse dispersion tailoring.
The possibility of slowing down or storing light holds interests in classical or quantum optical communications. Different schemes have been proposed; among them, active resonator-based devices seem to provide a scalable and low loss solution for this purpose. This paper will be devoted to the theoretical and experimental studies of active coupled resonator delay lines. High-quality (Q) factor resonators are strongly dispersive systems which can be used to control the group velocity of light. As it is the case for atomic systems the dispersion properties of these artificial media is dependent on their absorption or optical gain. Moreover by coupling several resonators it is also possible to tailor their transmission or high dispersion orders . For these two reasons, active coupled resonators may be of high interest for optical dispersion or delay lines. In the aim of practical applications, the first step consists in defining an experimental protocol allowing a resonator complete description to be obtained. Cavity ring down spectroscopy method can be adapted to obtain the essential parameters such as gain/absorption and dispersion. The method has been validated using a model system made of Er3+ doped optical fiber resonators and applied to various high-Q whispering gallery mode resonators including resonators under modal coupling. It is possible to find coupling configurations allowing the dispersion of coupled active resonator systems to be tailored by changing the optical losses or gain of each resonator. In particular these systems may be used as tunable transparent delay lines or for dispersion compensation. This last configuration can be used to enhanced or actively control the quality factor of passive cavities. Finally the dynamic control of dispersion or resonance properties via the gain control of active coupled microresonators could find some applications in optical buffering.