We investigate dispersion effects in dynamically tuned, coupled-resonator delay lines. Provided that the system is tuned to a zero-bandwidth state, a signal can be delayed indefinitely with almost no dispersion. We present a theoretical analysis of such a light-stopping system and verify the results using numerical simulations.
Dynamic tuning of systems of microresonators coupled to waveguides allows a rich range of physical effects. Periodic resonator arrays can be tuned to stop and store light pulses, theoretically allowing for tunable delay devices in which the delay is limited neither by bandwidth nor by dispersion. For two-resonator systems, adjustable delays can be obtained from tuning a narrow transparency resonance. Similar behavior is also predicted in a quite different physical system, that of a single photon interacting with dynamically-tuned quantum bits.
We theoretically propose a light-stopping process that uses loss and gain dynamical tuning in short coupled-resonator delay lines. The structure is made of four resonators and is optimized to avoid pulse distortion in the passive regime. The loss and gain modulations allow the resonant structure to be isolated from the access waveguide and the pulse to be stored. We demonstrate via numerical simulations the pulse storing process and show that this active delay line also induces nonlinear effects leading to pulse compression. This last property could be useful for pulse dispersion tailoring.
The possibility of slowing down or storing light holds interests in classical or quantum optical communications. Different schemes have been proposed; among them, active resonator-based devices seem to provide a scalable and low loss solution for this purpose. This paper will be devoted to the theoretical and experimental studies of active coupled resonator delay lines. High-quality (Q) factor resonators are strongly dispersive systems which can be used to control the group velocity of light. As it is the case for atomic systems the dispersion properties of these artificial media is dependent on their absorption or optical gain. Moreover by coupling several resonators it is also possible to tailor their transmission or high dispersion orders . For these two reasons, active coupled resonators may be of high interest for optical dispersion or delay lines. In the aim of practical applications, the first step consists in defining an experimental protocol allowing a resonator complete description to be obtained. Cavity ring down spectroscopy method can be adapted to obtain the essential parameters such as gain/absorption and dispersion. The method has been validated using a model system made of Er3+ doped optical fiber resonators and applied to various high-Q whispering gallery mode resonators including resonators under modal coupling. It is possible to find coupling configurations allowing the dispersion of coupled active resonator systems to be tailored by changing the optical losses or gain of each resonator. In particular these systems may be used as tunable transparent delay lines or for dispersion compensation. This last configuration can be used to enhanced or actively control the quality factor of passive cavities. Finally the dynamic control of dispersion or resonance properties via the gain control of active coupled microresonators could find some applications in optical buffering.