We characterize single-mode vacuum squeezing generated by a SNAIL Parametric Amplifier (SPA) operated under conditions representative of practical sensing and qubit-readout experiments. Motivated by prior expectations that Kerr-induced distortion limits squeezing in degenerate parametric amplifiers, we varied external flux and pump power to explore operating points where Kerr nonlinearity is theoretically minimized. We find that for practical applications where the squeezing frequency is fixed, the Kerr was variable by about a factor of two and the achievable squeezing showed no significant dependence on Kerr. Theoretical modeling supports this observation and indicates that baseline Kerr values in state-of-the-art SPAs are already too small to impose a practical limitation. Instead, squeezing was dominated by internal resonator loss and insertion loss in the microwave chain. These results indicate that, in practical SPAs, reducing loss, rather than suppressing Kerr, is the primary route to improved squeezing performance.
We characterize single-mode vacuum squeezing generated by a SNAIL Parametric Amplifier (SPA) operated under conditions representative of practical sensing and qubit-readout experiments. Motivated by prior expectations that Kerr-induced distortion limits squeezing in degenerate parametric amplifiers, we varied external flux and pump power to explore operating points where Kerr nonlinearity is theoretically minimized. We find that for practical applications where the squeezing frequency is fixed, the Kerr was variable by about a factor of two and the achievable squeezing showed no significant dependence on Kerr. Theoretical modeling supports this observation and indicates that baseline Kerr values in state-of-the-art SPAs are already too small to impose a practical limitation. Instead, squeezing was dominated by internal resonator loss and insertion loss in the microwave chain. These results indicate that, in practical SPAs, reducing loss, rather than suppressing Kerr, is the primary route to improved squeezing performance.
Traveling wave parametric amplifiers are promising sources of broadband microwave squeezing for quantum technologies. Recent studies suggest that, in addition to loss, spontaneously generated spurious spectral tones may limit the achievable squeezing performance. Motivated by this, we experimentally investigate pump-induced spurious tones generation in a traveling wave parametric amplifier based on the sign-reversal of the Kerr nonlinearity phase matching. By measuring the output spectrum as a function of pump frequency and magnetic flux bias, we identified operating regimes with improved spectral purity. We found that increasing the pump frequency suppresses both the number and the amplitude of parasitic spectral tones in the device under test, resulting in wider operating regions with minimal unwanted spectral content. Complementing existing studies on spurious tones generation, these results provide practical guidelines for optimizing the operating conditions of this family of amplifiers for future squeezing experiments and other quantum applications.
Single-mode squeezing of the electromagnetic vacuum is a key resource for mode-selective noise reduction in quantum measurements. At microwave frequencies, single-mode squeezing is typically obtained by using Josephson and Traveling-Wave Parametric Amplifiers designed for three-wave mixing operation. In single-pump degenerate four-wave mixing, the coincidence of pump, signal, and idler frequencies complicates separation of the squeezed field from the strong pump. A dual-pump configuration enables degenerate operation while keeping both pumps spectrally separated from the squeezed mode. Here, we demonstrate single-mode squeezing in a flux-tunable, dual-pump Traveling-Wave Parametric Amplifier, employing reversed-Kerr phase matching. By independently calibrating the single-pump gains, we find that the strongest squeezing occurs along approximately balanced-gain trajectories, while the optimal squeezing does not necessarily correspond to the highest dual-pump gain. At flux biases Φext/Φ0=0.0 and 0.5, the minimum quadrature noise levels reach −2.48±0.18dB and −1.62±0.20dB relative to vacuum, respectively. These results establish the proposed architecture as a platform for single-mode squeezing in microwave continuous-variable quantum technologies.
Recent demonstrations of squeezing generation using Traveling Wave Parametric Amplifiers (TWPAs) have opened the way for the application of broadband microwave squeezing in quantum sensing, quantum-enhanced detection, and continuous-variable quantum information. Here we demonstrate vacuum squeezing generation via residual three-wave mixing (3WM) in a Josephson TWPA based on superconducting nonlinear asymmetric inductive elements (SNAILs) with alternated magnetic flux polarity. By investigating competition between four-wave mixing (4WM) and 3WM nonlinearities, we prove that vacuum squeezing generation via residual 3WM is possible when a careful choice of the operating flux point is adopted. Our study provides valuable insights on the impact of competing nonlinearities on TWPA squeezers, potentially extending the range of applications in the framework of microwave photonics.
While the squeezing of a propagating field can, in principle, be made arbitrarily strong, the cavity-field squeezing is subject to the well-known 3 dB limit, and thus has limited applications. Here, we propose the use of a fully quantum degenerate parametric amplifier (DPA) to beat this squeezing limit. Specifically, we show that by simply applying a two-tone driving to the signal mode, the pump mode can, counterintuitively, be driven by the photon loss of the signal mode into a squeezed steady state with, in principle, an arbitrarily high degree of squeezing. Furthermore, we demonstrate that this intracavity squeezing can increase the signal-to-noise ratio of longitudinal qubit readout exponentially with the degree of squeezing. Correspondingly, an improvement of the measurement error by many orders of magnitude can be achieved even for modest parameters. In stark contrast, using intracavity squeezing of the semiclassical DPA cannot practically increase the signal-to-noise ratio and thus improve the measurement error. Our results extend the range of applications of DPAs and open up new opportunities for modern quantum technologies.
Squeezed light is an essential nonclassical resource for quantum sensing, continuous-variable quantum information processing, low-noise optical communication, and new photonic computing systems. However, to make practical use of it, we need compact, low-power squeezed-light sources that can fit on a chip. In this work, we introduce a theoretical model of a dual-pump microring optical parametric amplifier for squeezed-light integrated photonics. The model outlines cavity-enhanced Kerr four-wave mixing among two pump fields, a signal mode, and the conjugate idler sideband. We use a linearized quantum Langevin approach under the undepleted-pump assumption. We derive the frequency-domain inputoutput relation and assess the output quadrature noise based on several factors: external coupling rate, intrinsic loss, pump power, signal detuning, nonlinear coefficient, and dispersion. First, we analyze a dispersion-engineered silicon nitride microring that operates in the telecom band. It shows that moderate external coupling offers the best trade-off between intracavity field enhancement and squeezed-field extraction. With the right pump detuning, the simulated silicon nitride resonator achieves over 10 dB of quadrature noise reduction at milliwatt-level input pump powers. We also compare AlGaAs and InP microring platforms, demonstrating that the squeezing performance is influenced not only by the nonlinear coefficient but also by the combined effects of material nonlinearity, cavity quality factor, loss, coupling, dispersion, and detuning. This framework gives design guidelines for low-power, chip-scale squeezed-light sources aimed at future quantum and AI-oriented photonic integrated circuits.
Superconducting parametric amplifiers (SPAs) are critical components for ultralow-noise qubit readout in quantum computing, addressing the critical challenge of amplifying weak quantum signals without introducing noise that degrades coherence and computational fidelity. Unlike classical amplifiers, SPAs can achieve or closely approach quantum-limited performance, specifically the Standard Quantum Limit (SQL) of half a photon of added noise for phase-preserving amplification. The core principle of SPAs relies on parametric amplification, where energy is transferred from a strong pump tone to a weak input signal through non-dissipative nonlinear mixing processes. This is enabled by intrinsic nonlinearities in superconducting materials, primarily kinetic inductance in thin films (e.g., NbTiN, Al) and, more significantly, the Josephson effect in Josephson junctions. These nonlinear elements facilitate frequency mixing (three-wave or four-wave mixing) and can operate in phase-preserving or phase-sensitive amplification modes, with the latter allowing for noise squeezing below the SQL. This chapter emphasizes the significant role of resonator design in determining critical SPA performance metrics such as gain, bandwidth, and noise characteristics. It details both lumped-element (LC) and distributed-element (coplanar waveguide, CPW) resonators, discussing their unique properties, suitability for different frequency ranges, and the importance of achieving high-quality factors (Q) for efficient energy storage and minimal loss. A practical design and simulation of a meandered quarterwavelength CPW resonator coupled to a feed line is presented, illustrating how precise control over geometric parameters optimizes resonant frequency, coupling strength, and quality factor for high-fidelity qubit state discrimination.