Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1005.5394 · Applied Physics Letters

Reduced frequency noise in superconducting resonators

R. Barends, N. Vercruyssen, Akira Endo, Pieter de Visser, T. Zijlstra, T. M. Klapwijk, J. J. A. Baselmans

Published Jul 19, 2010• 57 citations
arXivHTMLPDF

Abstract

We report a reduction in the frequency noise in coplanar waveguide superconducting resonators. The reduction of 7 dB is achieved by removing the exposed dielectric substrate surface from the region with high electric fields and by using NbTiN. In a model-analysis the surface of NbTiN is found to be a negligible source of noise, experimentally supported by a comparison with NbTiN on SiOx resonators. The reduction is additive to decreasing the noise by widening the resonators.

DOI
10.1063/1.3467052

Related papers

Noise in NbTiN, Al, and Ta Superconducting Resonators on Silicon and Sapphire Substrates

R. Barends, H. L. Hortensius, T. Zijlstra +4 more

We present measurements of the frequency noise and resonance frequency temperature dependence in planar superconducting resonators on both silicon and sapphire substrates. We show, by covering the resonators with sputtered SiOxlayers of different thicknesses, that the temperature dependence of the resonance frequency scales linearly with thickness, whereas the observed increase in noise is independent of thickness. The frequency noise decreases when increasing the width of the coplanar waveguide in NbTiN on hydrogen passivated silicon devices, most effectively by widening the gap. We find up to an order of magnitude more noise when using sapphire instead of silicon as substrate. The complete set of data points towards the noise being strongly affected by superconductor-dielectric interfaces.

IEEE Transactions on Applied Superconductivity•Jun 1, 2009•45 citations

Contribution of dielectrics to frequency and noise of NbTiN superconducting resonators

R. Barends, H. L. Hortensius, T. Zijlstra +4 more

We study NbTiN resonators by measurements of the temperature dependent resonance frequency and frequency noise. Additionally, resonators are studied covered with SiOx dielectric layers of various thicknesses. The resonance frequency develops a nonmonotonic temperature dependence with increasing SiOx layer thickness. The increase in the noise is independent of the SiOx thickness, demonstrating that the noise is not dominantly related to the low temperature resonance frequency deviations.

arXiv:0804.3499•Applied Physics Letters•Jun 2, 2008•108 citations

Temperature dependence of the frequency and noise of superconducting coplanar waveguide resonators

Shwetank Kumar, Jiansong Gao, Jonas Zmuidzinas +3 more

We present measurements of the temperature and power dependence of the resonance frequency and frequency noise of superconducting niobium thin-film coplanar waveguide resonators carried out at temperatures well below the superconducting transition (Tc=9.2K). The noise decreases by nearly two orders of magnitude as the temperature is increased from 120to1200mK, while the variation of the resonance frequency with temperature over this range agrees well with the standard two-level system (TLS) model for amorphous dielectrics. These results support the hypothesis that TLSs are responsible for the noise in superconducting microresonators and have important implications for resonator applications such as qubits and photon detectors.

arXiv:0802.4268•Applied Physics Letters•Mar 24, 2008•81 citations

Minimal resonator loss for circuit quantum electrodynamics

R. Barends, N. Vercruyssen, Akira Endo +6 more

We report quality factors of up to 500×103 in superconducting resonators at the single photon levels needed for circuit quantum electrodynamics. This result is achieved by using NbTiN and removing the dielectric from regions with high electric fields. As demonstrated by a comparison with Ta, the crucial sources of intensity-dependent loss are dielectrics on the surface of the metal and substrate.

arXiv:1005.0408•Applied Physics Letters•Jul 12, 2010•142 citations

Reducing intrinsic loss in superconducting resonators by surface treatment and deep etching of silicon substrates

Alessandro Bruno, G. de Lange, Serwan Asaad +3 more

We present microwave-frequency NbTiN resonators on silicon, systematically achieving internal quality factors above 1 M in the quantum regime. We use two techniques to reduce losses associated with two-level systems: an additional substrate surface treatment prior to NbTiN deposition to optimize the metal-substrate interface and deep reactive-ion etching of the substrate to displace the substrate-vacuum interfaces away from high electric fields. The temperature and power dependence of resonator behavior indicate that two-level systems still contribute significantly to energy dissipation, suggesting that more interface optimization could further improve performance.

arXiv:1502.04082•Applied Physics Letters•May 4, 2015•254 citations

Characterization and reduction of microfabrication-induced decoherence in superconducting quantum circuits

Chris Quintana, A. Megrant, Z. Chen +18 more

Many superconducting qubits are highly sensitive to dielectric loss, making the fabrication of coherent quantum circuits challenging. To elucidate this issue, we characterize the interfaces and surfaces of superconducting coplanar waveguide resonators and study the associated microwave loss. We show that contamination induced by traditional qubit lift-off processing is particularly detrimental to quality factors without proper substrate cleaning, while roughness plays at most a small role. Aggressive surface treatment is shown to damage the crystalline substrate and degrade resonator quality. We also introduce methods to characterize and remove ultra-thin resist residue, providing a way to quantify and minimize remnant sources of loss on device surfaces.

arXiv:1407.4769•Applied Physics Letters•Aug 11, 2014•128 citations
We report a reduction in the frequency noise in coplanar waveguide superconducting resonators. The reduction of 7 dB is achieved by removing the exposed dielectric substrate surface from the region with high electric fields and by using NbTiN. In a model-analysis the surface of NbTiN is found to be a negligible source of noise, experimentally supported by a comparison with NbTiN on SiOx resonators. The reduction is additive to decreasing the noise by widening the resonators.
We present measurements of the frequency noise and resonance frequency temperature dependence in planar superconducting resonators on both silicon and sapphire substrates. We show, by covering the resonators with sputtered SiOxlayers of different thicknesses, that the temperature dependence of the resonance frequency scales linearly with thickness, whereas the observed increase in noise is independent of thickness. The frequency noise decreases when increasing the width of the coplanar waveguide in NbTiN on hydrogen passivated silicon devices, most effectively by widening the gap. We find up to an order of magnitude more noise when using sapphire instead of silicon as substrate. The complete set of data points towards the noise being strongly affected by superconductor-dielectric interfaces.
We present measurements of the temperature and power dependence of the resonance frequency and frequency noise of superconducting niobium thin-film coplanar waveguide resonators carried out at temperatures well below the superconducting transition (Tc=9.2K). The noise decreases by nearly two orders of magnitude as the temperature is increased from 120to1200mK, while the variation of the resonance frequency with temperature over this range agrees well with the standard two-level system (TLS) model for amorphous dielectrics. These results support the hypothesis that TLSs are responsible for the noise in superconducting microresonators and have important implications for resonator applications such as qubits and photon detectors.
We present microwave-frequency NbTiN resonators on silicon, systematically achieving internal quality factors above 1 M in the quantum regime. We use two techniques to reduce losses associated with two-level systems: an additional substrate surface treatment prior to NbTiN deposition to optimize the metal-substrate interface and deep reactive-ion etching of the substrate to displace the substrate-vacuum interfaces away from high electric fields. The temperature and power dependence of resonator behavior indicate that two-level systems still contribute significantly to energy dissipation, suggesting that more interface optimization could further improve performance.
Many superconducting qubits are highly sensitive to dielectric loss, making the fabrication of coherent quantum circuits challenging. To elucidate this issue, we characterize the interfaces and surfaces of superconducting coplanar waveguide resonators and study the associated microwave loss. We show that contamination induced by traditional qubit lift-off processing is particularly detrimental to quality factors without proper substrate cleaning, while roughness plays at most a small role. Aggressive surface treatment is shown to damage the crystalline substrate and degrade resonator quality. We also introduce methods to characterize and remove ultra-thin resist residue, providing a way to quantify and minimize remnant sources of loss on device surfaces.