We have shown via explicit analysis as well as numerical simulation the design of two large angle interferometers employing two-photon pulses. The first one uses the technique of adiabatic following in a dark state to produce a large splitting angle atomic interferometer that is capable of producing one dimensional gratings with spacings as small as 2 nm. Unlike other large angle interferometers, this technique is not sensitive to errors in optical pulse area and decoherence from excited state decay. This may lead to a nearly two orders of magnitude improvement in the sensitivity of devices such as atomic gyroscopes, which are already as good as the best laser gyroscopes. The second interferometer uses the technique of Raman pulses to produce a two-dimensional interferometer, with independent choice of grating spacings in each direction, each being as small as 2 nm. This scheme may enable one to produce uniform arrays of quantum dots with dimensions of only a few nm on each side. In addition, it may be possible to generalize this process to produce arbitrary patterns with the same type of resolution.
We have shown via explicit analysis as well as numerical simulation the design of two large angle interferometers employing two-photon pulses. The first one uses the technique of adiabatic following in a dark state to produce a large splitting angle atomic interferometer that is capable of producing one dimensional gratings with spacings as small as 2 nm. Unlike other large angle interferometers, this technique is not sensitive to errors in optical pulse area and decoherence from excited state decay. This may lead to a nearly two orders of magnitude improvement in the sensitivity of devices such as atomic gyroscopes, which are already as good as the best laser gyroscopes. The second interferometer uses the technique of Raman pulses to produce a two-dimensional interferometer, with independent choice of grating spacings in each direction, each being as small as 2 nm. This scheme may enable one to produce uniform arrays of quantum dots with dimensions of only a few nm on each side. In addition, it may be possible to generalize this process to produce arbitrary patterns with the same type of resolution.
We have investigated the use of two-photon induced spin excitation for applications to atom interferometry for lithography and rotation sensing. Our efforts have been grouped into two parts: theoretical study of schemes for nanolithography, and experimental investigation of novel schemes for rotation sensing. For lithography, we have concentrated on designing and studying theoretical models that would allow the creation of two-dimensional lithographic patterns with nanometer scale features. Specifically, We have developed a theoretical model for realizing a two-dimensional interferometer capable of producing periodic structures with a feature size of less than 10 nm. Fundamentally, this process uses the two-photon induced spin excitation for splitting atomic waves. We first extended this model to achieve a large degree of splitting via use of multiple pulses, and then showed how the process can be generalized to two orthogonal dimensions with independent controls. We have also designed a scheme for producing arbitrary two-dimensional features using atom interferometry. This process makes use of a phase mask imprinted on a laser pulse, guiding of atomic waves, and atom interferometry in order to produce any desired pattern, with features that can also be only a few nm's in size. For rotation sensing, we have realized experimentally a novel scheme that opens up a new way of controlling the interferometer contour. It may prove to be very robust for practical applications such as gravity gradiometry as well.
This cumulative thesis consists of four publications [1-4], presented as three contributions (I) - (III), where the second one (II) consists of the joint publications [2,3]. All publications were written during the author's research activities at the Institute of Quantum Physics under the supervision of Prof. Dr. W. P. Schleich. All of the presented publications consider light-matter interactions and their potential application in atom interferometry, a comparatively young and rapidly evolving technique. Atom interferometers find application in high-precision measurements, the determination of physical constants, the testing of fundamental physics, and the provision of gravimeters and gyroscopes. The advancement of technology and science has led to significant improvements in performance and the development of ambitious mobile and space-based devices. The recent success of several experiments has led to the proposal of further experiments with the aim of opening up new frontiers. However, the construction of future devices necessitates a decision regarding the employed diffraction mechanism and geometry, depending on the specific technical and scientific requirements. Furthermore, it is necessary to enhance the sensitivity of future devices. The contributions in this dissertation address these issues. The first contribution (I) focuses on the diffraction of atoms by laser pulses which can be employed to generate atom-optical diffraction elements like beam splitters and mirrors. These diffraction elements can be combined to construct atom interferometers, which have been successfully employed for precision measurements regarding fundamental physics as well as practical applications. The article presents a numerical comparison of two distinct diffraction mechanisms (Bragg and Raman) and diffraction geometries (single and double diffraction) in microgravity. It discusses the fundamental differences between the mechanisms and geometries with respect to the diffraction efficiency, taking into account the width of the initial wave function and the duration of the light pulse. Additionally, it explores the transition between the two diffraction geometries when starting from an atom initially at rest and increasing its momentum. The results may serve as a reference for experimentalists in selecting the most suitable configuration, based on their aims and requirements in the realization of more advanced atom interferometers. The second contribution (II) is a follow-up to the previous one, but focuses exclusively on a single diffraction type in microgravity, namely the so-called double Raman diffraction. In contrast to the previous article, where we only discussed single two-photon processes, we consider in this article a six-photon process, also known as third-order diffraction, as well as three subsequent two-photon processes, which both lead to the same amount of transferred momentum and can both be used to realize large-momentum transfer (LMT). We demonstrate that third-order double Raman diffraction is a viable and advantageous method for the diffraction of small momentum distributions like Bose-Einstein condensates (BECs) compared to a sequence of three two-photon processes. Furthermore, we show that third-order Raman pulses can be successfully applied to create higher-order Raman atom interferometers. Third-order diffraction can be perfectly combined with other LMT techniques and, moreover, allows for a reduction in the overall duration of the diffraction process and the complexity of the experimental set-up, as only two distinct laser frequencies are required. Moreover, we present a third-order Mach-Zehnder interferometer with spurious paths being disregarded. As demonstrated later on in [3], this interferometer generates optimal contrast and a substantial amplitude. The third contribution (III) extends the semi-classical λ-scheme of single Raman diffraction, as discussed in detail in contribution (I), into a fully quantized multi-atom multi-λ configuration with center-of-mass motion inside a cavity. Therefore, the incorporation of an internal structure allows for a more realistic modeling of the atoms, which is relevant for multi-photon interaction or cooling processes. We use for our analysis the framework of second quantization, i.e., we take into account the field-theoretical nature of the multi-particle atomic field as well as of the diffracting light field. We reduce this model with a Hamiltonian averaging theory applied to the atomic field operators and obtain an effective Hamiltonian, which determines the time evolution of the system. We demonstrate the efficiency of our model by the application of a typical initial state. Moreover, for a specific input state, we obtain the Hong-Ou-Mandel effect simultaneously in the atomic and the optical system. Our many-body formalism is perfectly suited to theoretically describe contemporary high-precision atom interferometric experiments based on entanglement between the atoms, that aim to surpass the shot-noise limit.
We realize beam splitters and mirrors for atom waves by employing a sequence of light pulses rather than individual ones. In this way we can tailor atom interferometers with improved sensitivity and accuracy. We demonstrate our method of composite pulses by creating a symmetric matter-wave interferometer which combines the advantages of conventional Bragg- and Raman-type concepts. This feature leads to an interferometer with a high immunity to technical noise allowing us to devise a large-area Sagnac gyroscope yielding a phase shift of 6.5 rad due to the Earth's rotation. With this device we achieve a rotation rate precision of 120 nrad s(-1) Hz(-1/2) and determine the Earth's rotation rate with a relative uncertainty of 1.2%.
We present a precision atom interferometry gyroscope with a Sagnac area of 6.0 cm 2 . To drive the cold atom interferometry gyroscope, we utilize two sets of Raman beams with a pulse sequence of π /2- π - π - π /2. We present a procedure for aligning the two sets of Raman beams at the microradian level by making use of the atom interferometer itself in different configurations. Additionally, we measured the atomic cloud trajectory and implemented a spatial symmetry alignment for the atom interferometer. With these improvements, we construct a sensitive atom gyroscope with a stability of 1 nrad/s at an integration time of 10000 s. We analyzed the influence of Raman beams and the limitations of the system, and present the technical limits to the sensitivity and long-term stability. Finally, we point out the primary sources of noise in the atom interferometry gyroscope, clearing the way for the construction of further large-area atom gyroscopes.
The coherent control of atomic wave packets in multiple momentum dimensions is a central challenge in Raman atom optics and a key requirement for multidimensional atom interferometry. In this paper, a momentum-basis theoretical framework is developed for two-dimensional Raman interactions. We formulate the atom-laser interaction for two-dimensional Raman beams and obtain the effective two-level ground-state Hamiltonian after adiabatic elimination of the excited states. The resulted Hamiltonian is constructed on the reachable momentum-state lattice and includes AC Stark shifts, intra-dimensional Raman couplings, and cross-dimensional Raman coupling terms, thereby describing multidimensional Raman dynamics beyond a simple superposition of independent single-dimensional models. The framework is used to analyze the principles and operating conditions of two-dimensional atom interferometry. Cross-dimensional Raman coupling and sequential reverse Raman transitions are identified as the main mechanisms that redistribute atoms into non-target momentum states and reduce the contrast of atomic interferometer fringe. Experimentally, Ramsey fringes are observed in a cold-atom fountain interferometer, with a contrast of 14.8% at an interrogation time of T=10ms, in good agreement with the theoretical calculation. The conditions required for velocity-sensitive multidimensional atom interferometry are further clarified, including detuning control, velocity-class selection, and suppression of undesired inter-dimensional transitions. This work provides a theoretical and experimental basis for multidimensional Raman atom interferometry.
We report a demonstration of composite Raman pulses that achieve broadband population inversion and are used to increase the momentum splitting of an atom interferometer up to 18ℏk (corresponding to an increase in the inertial signal by a factor of nine). Composite Raman pulses suppress the effects of pulse length and detuning errors, providing higher transfer efficiency and velocity acceptance than single square pulses. We implement two composite pulse sequences, π/20°−π90°−π/20° and π/20°−π180°−3π/20°, and use the latter composite pulse to demonstrate large-area atom interferometry with stimulated Raman transitions. In addition to enabling larger momentum transfer and higher sensitivity, we argue that composite pulses can improve the robustness of atom interferometers operating in dynamic environments.