Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:physics/0507060 · The European Physical Journal D

Influence of optical aberrations in an atomic gyroscope

J. Fils, Florence Leduc, Philippe Bouyer, David Holleville, N. Dimarcq, Andr  Clairon, Arnaud Landragin

Published Sep 19, 2005• 38 citations
arXivHTMLPDF
DOI
10.1140/epjd/e2005-00255-9

Related papers

Towards a high-precision atomic gyroscope

Van Camp, A. Stanley Mackenzie

•Jan 1, 2013•0 citations

PHASE NOISE IN ATOMIC INTERFEROMETER

Arnaud Landragin, J. Fils, F. Yver +3 more

A gyroscope based on de Broglie wave interferences of cold Caesium atoms is under construction. It uses stimulated Raman transitions to manipulate the atomic wave packets 1 . We address two possible sources of noise in the case of our setup: phase fluctuations due to propagation of the Raman lasers in optical fibres and geometrical wavefront aberrations on the same lasers.

Symposium on Frequency Standards and Metrology•May 1, 2002•0 citations

The quantum limit in optical gyroscopes

Claude Fabre

•Jan 1, 1990•0 citations

Influence of optical aberrations on the accuracy of an atomic gravimeter

Louis Pagot, Sébastien Merlet, Franck Pereira dos Santos

We present numerical simulations of the impact of laser beam wavefront aberrations in cold atom interferometers. We demonstrate that to reach accuracy at the mrad level, it is insufficient to base simulations on a description of retroreflective optics using only low-order Zernike polynomials, as the results will then depend on the decomposition order and the decomposition technique chosen. Moreover, simulations with high-order Zernike polynomials or equivalently high spatial frequency components require the propagation of aberrations to be taken into account, rather than adding them to the ideally propagated beam. Finally, we examine the impact of the parameters of the atomic source and show that the use of a delta-kicked atomic cloud would efficiently mitigate the impact of this systematic effect.

arXiv:2410.07720•Optics Express•Dec 15, 2024•5 citations

The effect of wavefront aberrations in atom interferometry

V. Schkolnik, B. Leykauf, M. Hauth +2 more

arXiv:1411.7914•Applied Physics B•Jun 1, 2015•117 citations

Aberration analysis of atom lens generated by a laser standing wave

Zhang Chunmei

Atom lens generated by a laser standing wave can be used to focus an atomic beam to nanometer dimensions. Aberrations exist in atom lens owing to the influence of velocity spread, beam spread, wave nature of atoms and so on. Two theoretical models were built to describe atom lens. Spherical aberration, chromatic aberration and the aberration caused by angular spread were analyzed with semi-classical model, and diffractive aberration was analyzed using quantum model. Simulation results show that aberration originates mainly from beam spread, and diffractive aberration is larger than spherical aberration and chromatic aberration. Three solutions of optimization of experimental parameters, adding beam mask and using etching technologies for improving atom lithography quality are presented.

High Power Laser and Particle Beams•Jan 1, 2004•0 citations
We present numerical simulations of the impact of laser beam wavefront aberrations in cold atom interferometers. We demonstrate that to reach accuracy at the mrad level, it is insufficient to base simulations on a description of retroreflective optics using only low-order Zernike polynomials, as the results will then depend on the decomposition order and the decomposition technique chosen. Moreover, simulations with high-order Zernike polynomials or equivalently high spatial frequency components require the propagation of aberrations to be taken into account, rather than adding them to the ideally propagated beam. Finally, we examine the impact of the parameters of the atomic source and show that the use of a delta-kicked atomic cloud would efficiently mitigate the impact of this systematic effect.
Atom lens generated by a laser standing wave can be used to focus an atomic beam to nanometer dimensions. Aberrations exist in atom lens owing to the influence of velocity spread, beam spread, wave nature of atoms and so on. Two theoretical models were built to describe atom lens. Spherical aberration, chromatic aberration and the aberration caused by angular spread were analyzed with semi-classical model, and diffractive aberration was analyzed using quantum model. Simulation results show that aberration originates mainly from beam spread, and diffractive aberration is larger than spherical aberration and chromatic aberration. Three solutions of optimization of experimental parameters, adding beam mask and using etching technologies for improving atom lithography quality are presented.