Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Symposium on Frequency Standards and Metrology

PHASE NOISE IN ATOMIC INTERFEROMETER

Arnaud Landragin, J. Fils, F. Yver, David Holleville, N. Dimarcq, Andr  Clairon

Published May 1, 2002• 0 citations
Publisher

Abstract

A gyroscope based on de Broglie wave interferences of cold Caesium atoms is under construction. It uses stimulated Raman transitions to manipulate the atomic wave packets 1 . We address two possible sources of noise in the case of our setup: phase fluctuations due to propagation of the Raman lasers in optical fibres and geometrical wavefront aberrations on the same lasers.

DOI
10.1142/9789812777713_0071

Related papers

Dual-atomic-beam matter-wave gyroscope

T. L. Gustavson, Philippe Bouyer, Mark A. Kasevich

We report improvements to our atom-interferometer based Sagnac gyroscope which uses stimulated Raman transitions to manipulate atomic wavepackets of cesium atoms. Using counter-propagating high-flux atomic beams, we form two interferometers with opposite Sagnac phase shifts that share key components such as Raman atomic state manipulation beams. Subtracting the two interferometer signals allows the common-mode rejection of spurious noise sources and various systematic effects. Preliminary results indicate a short term sensitivity of 3 X 10-9 (rad/s) (root) Hz.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•May 15, 1998•15 citations

CHARACTERIZATION OF A COLD ATOM GYROSCOPE

Arnaud Landragin, A. Gauguet, Thomas Lévèque +1 more

We present the evaluation of the performances of our cold atom gyroscope. The gyroscope is based on two cold Cesium atom sources, which are manipulated thanks to Raman transitions. We show that the short term sensitivity is limited by the quantum projection noise and the long term sensitivity by wave front distortion of the Raman lasers. A study of the bias and scaling factor completes the characterization of the sensor.

Symposium on Frequency Standards and Metrology•May 1, 2009•0 citations

Reaching the quantum noise limit in a high-sensitivity cold-atom inertial sensor

Florence Leduc, Patrick Cheinet, J. Fils +5 more

In our high-precision atom interferometer, the measured atomic phase shift is sensitive to rotations and accelerations of the apparatus, and also to phase fluctuations of the Raman lasers. In this paper we study two principal noise sources affecting the atomic phase shift, induced by optical phase noise and vibrations of the setup. Phase noise is reduced by carrying out a phase lock of the Raman lasers after the amplification stages. We also present a new scheme to reduce noise due to accelerations by using a feed-forward on the phase of the Raman beams. With these methods, it should be possible to reach the range of the atomic quantum projection noise limit, which is about 1 mrad rms for our experiment, i.e. 30 nrad s-1 Hz-1/2 for a rotation measurement.

Journal of Optics B Quantum and Semiclassical Optics•Apr 1, 2003•52 citations

Atomic interferometry using stimulated Raman transitions

Mark A. Kasevich, Steven Chu

The mechanical effects of stimulated Raman transitions on atoms have been used to demonstrate a matter-wave interferometer with laser-cooled sodium atoms. Interference has been observed for wave packets that have been separated by as much as 2.4 mm. Using the interferometer as an inertial sensor, the acceleration of a sodium atom due to gravity has been measured with a resolution of 3\ifmmode\times\else\texttimes\fi{}${10}^{\mathrm{\ensuremath{-}}6}$ after 1000 sec of integration time.

Physical Review Letters•Jul 8, 1991•1,426 citations

A cold atom interferometer for high precision inertial measurements

B. Canuel, Florence Leduc, David Holleville +6 more

The authors are developing a high precision inertial sensor. This device uses cold Caesium atoms manipulated by stimulated Raman transitions (Berman, 1997). As this setup is sensitive to both acceleration and rotation, two counter-propagating beams of cold atoms are used to discriminate between the two contributions. The last experimental results will be presented here

Conference on Precision Electromagnetic Measurements•Jun 1, 2004•1 citation

A cold atom interferometer for high precision measurements

F. Yver, Arnaud Landragin, N. Dimarcq +6 more

We build a cold atom interferometer to be used as high precision inertial sensor. Our setup is sensitive both to rotations and accelerations. The interferometer configuration is similar to an optical Mach-Zehnder interferometer, and it uses stimulated Raman transitions to manipulate the atomic wave packets (total interferometer time of 90 ms).

European Quantum Electronics Conference (EQEC)•Jan 1, 2003•0 citations
A gyroscope based on de Broglie wave interferences of cold Caesium atoms is under construction. It uses stimulated Raman transitions to manipulate the atomic wave packets 1 . We address two possible sources of noise in the case of our setup: phase fluctuations due to propagation of the Raman lasers in optical fibres and geometrical wavefront aberrations on the same lasers.
We report improvements to our atom-interferometer based Sagnac gyroscope which uses stimulated Raman transitions to manipulate atomic wavepackets of cesium atoms. Using counter-propagating high-flux atomic beams, we form two interferometers with opposite Sagnac phase shifts that share key components such as Raman atomic state manipulation beams. Subtracting the two interferometer signals allows the common-mode rejection of spurious noise sources and various systematic effects. Preliminary results indicate a short term sensitivity of 3 X 10-9 (rad/s) (root) Hz.
In our high-precision atom interferometer, the measured atomic phase shift is sensitive to rotations and accelerations of the apparatus, and also to phase fluctuations of the Raman lasers. In this paper we study two principal noise sources affecting the atomic phase shift, induced by optical phase noise and vibrations of the setup. Phase noise is reduced by carrying out a phase lock of the Raman lasers after the amplification stages. We also present a new scheme to reduce noise due to accelerations by using a feed-forward on the phase of the Raman beams. With these methods, it should be possible to reach the range of the atomic quantum projection noise limit, which is about 1 mrad rms for our experiment, i.e. 30 nrad s-1 Hz-1/2 for a rotation measurement.
The mechanical effects of stimulated Raman transitions on atoms have been used to demonstrate a matter-wave interferometer with laser-cooled sodium atoms. Interference has been observed for wave packets that have been separated by as much as 2.4 mm. Using the interferometer as an inertial sensor, the acceleration of a sodium atom due to gravity has been measured with a resolution of 3\ifmmode\times\else\texttimes\fi{}${10}^{\mathrm{\ensuremath{-}}6}$ after 1000 sec of integration time.