Cobalt disilicide provides a promising nearly epitaxial superconducting material on silicon, which is compatible with high-density integrated circuit technology. We have characterized CoSi2 superconducting microwave cavities around 5.5 GHz for resonance frequency fluctuations at temperatures of 10–200 mK. Comparing with materials used in kinetic inductance detectors, we found relatively weak fluctuations (δfr/f0)2 following the spectral density A/fγ, with A ≃ 6 × 10−16 and γ slightly below 1 at an average number of photons of 30; the noise decreased with measurement power as 1/P1/2. The connection of the frequency fluctuations to two-level states and kinetic inductance fluctuations due to resistance noise is discussed.
This thesis investigates fundamental properties of Josephson junctions embedded in microwave circuits, and an application arising from this hybrid approach. We used the versatility of superconducting coplanar DC bias cavities to extract previously inaccessible information on phase coherent and subgap mechanisms of graphene Josephson junctions. Chapter 1 gives an introduction to the technology of Josephson field effect transistors, among which graphene junctions show promise for future improvements in quantum computation. Together with an overview of the Josephson effect in superconducting-semiconducting systems, we introduce the concept of coplanar DC bias cavities for probing Josephson junctions at gigahertz frequencies. In chapter 2, we describe the experimental methods developed for carrying out the subsequent measurements. We include details on fabrication, material properties and measurement setup. Results of graphene Josephson junctions embedded in DC bias microwave resonators are presented in chapters 3 and 4. By following the resonance frequency and losses of the circuit, we are able to extract the junctions’ Josephson inductance and subgap resistance. Studying the nonlinear power and bias current response reveals further information on the underlying loss mechanisms and current phase relation. We turn to an application of our hybrid bias cavity – Josephson junction devices to detect small, low-frequency currents in chapter 5. Our device is competitive with state-of-the-art techniques for microwave radiation detection and, with minor modifications, should be able to outperform existing technologies by orders of magnitude. Finally, we conclude the presented work in chapter 6 and provide an outlook on potential future research.
For over three decades, the presence of magnetic flux noise with a power spectral density scaling roughly as
SPhi(f)propto1/falpha, where
alphalesssim1, has been known to limit the low-frequency performance of dc superconducting quantum interference devices (SQUIDs). In recent years, experiments indicate that this same noise persists to frequencies up to 1~GHz and is a dominant source of dephasing in flux-sensitive superconducting quantum bits (qubits). Thus, the reduction of flux noise presents a major hurdle towards the successful realization of scalable quantum computers that are based on flux-based qubits. In this thesis, we present experimental measurements, theoretical analyses, and numerical simulations that support a more detailed understanding of both the microscopic and macroscopic properties of flux noise.Our experimental work begins with flux noise measurements of a large number of SQUIDs in the temperature range from 0.1~K to 4~K. We report on measurements of ten SQUIDs with systematically varied geometries and show that
alpha increases as the temperature is lowered; in so doing, each spectrum pivots about a nearly constant frequency. The mean square flux noise, inferred by integrating the power spectra, grows rapidly with temperature and at a given temperature is approximately independent of the outer dimension of a given SQUID washer. We show that these results are incompatible with a model based on the random reversal of independent, spins that are located at the surface of the SQUID washer.In the course of our flux noise measurements, we became aware of a spurious contribution to low-frequency critical current noise in Josephson junctions---normally attributed to charge trapping in the barrier---arising from temperature instabilities inherent in cryogenic systems. These temperature fluctuations modify the critical current via its temperature dependence. By computing cross-correlations between measured temperature and critical current noise in Al-AlOx-Al junctions, we show that, despite excellent temperature stability, temperature fluctuations induce observable critical current fluctuations. Particularly, because
1/f critical current noise has decreased with improved fabrication techniques in recent years, it is important to understand and eliminate this additional noise source.Next, we introduce a numerical method of calculating the mean square flux noise
Phisq from independently fluctuating spins on the surface of thin-film loops of arbitrary geometry. By reciprocity,
Phisq is proportional to
langleBbf(rbf)2rangle, where
Bbf(rbf) is the magnetic field generated by a circulating current around the loop and
rbf varies over the loop surface. By discretizing the loop nonuniformly, we efficiently and accurately compute the current distribution and resulting magnetic field, which may vary rapidly across the loop. We use this method to compute
Phisq in a number of scenarios in which we systematically vary physical parameters of the loop. We compare our simulations to an earlier analytic result predicting that
PhisqproptoR/W in the limit where the loop radius
R is much greater than the linewidth
W. We further show that the previously neglected contribution of edge spins to
Phisq is significant---even dominant---in narrow-linewidth loops.To calculate theoretical dephasing rates in qubits, we consider flux noise with a spectral density
SPhi(f)=A2/(f/1 hboxHz)alpha, where
A is of the order of 1~
muPhi0,hboxHz−1/2 and
0.6leqalphaleq1.2;
Phi0 is the flux quantum. For a qubit with an energy level splitting linearly coupled to the applied flux, our calculations of the dependence of the pure dephasing time
tauphi of Ramsey and echo pulse sequences on
alpha for fixed
A show that
tauphi decreases rapidly as
alpha is reduced. We find that
tauphi is relatively insensitive to the noise bandwidth,
f1leqfleqf2, for all
alpha provided the ultraviolet cutoff frequency
f2>1/tauphi. We calculate the ratio
tauphi,E/tauphi,R of the echo (
E) and Ramsey (
R) sequences, and the dependence of the decay function on
alpha and
f2. We investigate the case in which
SPhi(f0) is fixed at the ``pivot frequency''
f0neq1~Hz while
alpha is varied, and find that the choice of
f0 can greatly influence the sensitivity of
tauphi,E and
tauphi,R to the value of
alpha.Finally, we conclude with a brief review of our principal results and conclusions. We also comment on promising avenues of future research.
In this thesis, we first demonstrate that a disordered superconductor with high kinetic inductance can realise a microwave low-loss, non-dissipative circuit element with impedance greater than the quantum resistance. This element, known as a superinductor, can suppress the fluctuations of charge in a quantum circuit.For this purpose, we fabricated and characterised 20 nm thick, 40 nm wide niobium-nitride nanowires and determined the impedance to 6.795 kΩ. We demonstrate internal quality factors Qi = 2.5e4 in nanowire resonators at single photon excitation, which is significantly higher than values reported in devices with similar materials and geometries. Moreover, we show that the dominant dissipation in our nanowires is not an intrinsic property of the disordered films, but can instead be fully understood within the framework of two-level systems.To further characterise these losses, we then explore the geometrical scaling, toward nanowire dimensions, of dielectric losses in superconducting microwave resonators fabricated with the same techniques and from the same NbN thin-film as the nanowire superinductors. For this purpose, we perform an experimental and numerical study of dielectric loss at low temperatures. Using 3D finite-element simulation of the Maxwell--London equations, we compute the geometric filling factors of the lossy regions in our resonator structures and fit the experimental data to determine the intrinsic loss tangents of its interfaces and dielectrics. Finally, we study the effect of two-level systems on the performance of various superconducting quantum circuits. For this purpose, we measure coherence-time fluctuations in qubits and frequency fluctuations in resonators. In all devices, through statistical analysis, we identify the signature of individual Lorentzian fluctuators in the noise. We find that fluctuations in qubit relaxation are local to the qubit and are caused by instabilities of near-resonant two-level-systems. Furthermore, when examining the low-frequency noise of three different types of superconducting resonator - one NbN nanowire, one Al coplanar waveguide, and one Al 3D cavity - we observe a similar power-law dependence of the Lorentzian switching time and amplitude on the circulating power in the resonators, suggesting a common noise mechanism in the three different types of devices.
The subject of electronic noise in high- superconducting Josephson devices and in their applications is considered. Several types of grain boundary junctions, prepared in different ways by four separate international laboratories, are fully characterized in terms of their electrical and noise properties at a range of temperatures, frequencies, magnetic fields and in the presence of microwaves. Similar characterization is carried out for multijunction Josephson flux-flow arrays, and bi-epitaxial SQUIDs. The theory of Likharev and Semenov for thermal noise in low- junctions is adopted as a reference against which excess noise can be identified in high- junctions. It is combined with theoretical models of excess noise based on fluctuations of critical current and resistance to provide accurate fitting of the observed noise curves. It is shown that the normalized levels of critical current and normal resistance fluctuations for all of the junction types examined are remarkably close (typically around and at 100 Hz) and are nearly independent of temperature in the range T = 30 - 80 K. The frequency dependence is close to the universal 1/f law with some deviations due to trapping of charge carriers at discrete states in the tunnelling barrier. Measurements of voltage noise levels and critical current fluctuations in multijunction flux-flow amplifiers, reported for the first time, are consistent with levels in single junctions of the same type. Excess noise is studied as a function of external magnetic field, in a way that has not been previously described. A new interpretation of the magnetic field-dependent noise data indicates that absolute levels of critical current fluctuations are nearly independent of applied magnetic field. This observation does not appear to have been reported elsewhere. It has important implications for the operation of grain boundary Josephson devices in real applications. Voltage noise in the presence of microwave irradiation, at operating points between Shapiro steps, is consistent with a modified form of the Likharev - Semenov equation which takes into account the known level of critical current fluctuations as measured in field-free conditions. The implications of these results for further improvements in device performance are discussed, and directions for further work are suggested.
This thesis work deals with a range of superconducting devices operated near the fundamental performance limits set by quantum mechanics along with the nature of quantum vacuum itself when perturbed by such devices. These devices are operated in a dilution refrigerator cooled down to sub-Kelvin temperatures. Low temperature is absolutely essential for quantum behavior of these devices and the minimal inherent noise contribution. Biased, selectively damped superconducting tunnel junction, (also known as the Josephson junction) displaying negative differential resistance, was employed to construct a device capable of amplifying weak microwave signal reflections from it. This device can be operated near the intrinsic precision limits set by the Heisenberg's uncertainty principle. Arrays of Superconducting Quantum Interference Devices (SQUIDs), operated below the critical current, can be used for metamaterial resonators whose resonant frequency can be quickly modulated by magnetic flux. These devices are operated as parametric amplifiers and they are capable of amplifying weak microwave signals near the quantum limit of noise. But more importantly, they are capable of perturbing the vacuum itself, which creates correlated photon pairs seeded by vacuum fluctuations. This effect is known as the dynamical Casimir effect (DCE) and is demonstrated in this thesis work by using power and correlation measurements at microwave frequencies. Furthermore, investigations on the DCE have been extended using a double modulation scheme yielding vacuum-induced coherence and tripartite correlations. Nanocarbon devices have also been studied in this thesis, in particular a wideband low noise nanotube electrometer constructed from a nanotube with proximity induced superconductivity. This device has certain unique benefits when operated in a microwave environment which are discussed in the thesis. Another nanocarbon device, a double quantum dot constructed from graphene and superconducting leads has been used to demonstrate Cooper-pair splitting. This device operates as a tunable source of entangled electrons.