The active modulation of optical response of quantum emitters at the nanoscale is of paramount importance to realize tunable light sources for nanophotonic devices. Herein, a thin film of phase‐change material (VO2) is coupled to a 20 nm‐thick silica layer embedding Er3+ ions, and it is demonstrated how the active tuning of the local density of optical states near the erbium emitters provided by the thermally induced semiconductor‐to‐metal transition of VO2 can be used to dynamically control the Er3+ emission lifetime at telecom wavelength (1.54 μm). A decay rate contrast of a factor 2 is obtained between high temperature (90 °C), when VO2 is metallic, and room temperature, when VO2 is semiconductor, in agreement with calculations performed with the classical dipole oscillator analytical model. A hysteretic behavior is observed by measuring the Er3+ lifetime as a function of the temperature, whose parameters are consistent with those of grazing incidence X‐ray diffraction and optical transmittance measurements. The fractions of Er3+ ions that couple with VO2 in each phase at the different temperatures are determined by the analysis of the temporal decays. The results make the investigated system an optimal candidate for the development of tunable photon sources at telecom wavelength.
The active modulation of optical response of quantum emitters at the nanoscale is of paramount importance to realize tunable light sources for nanophotonic devices. Herein, a thin film of phase‐change material (VO2) is coupled to a 20 nm‐thick silica layer embedding Er3+ ions, and it is demonstrated how the active tuning of the local density of optical states near the erbium emitters provided by the thermally induced semiconductor‐to‐metal transition of VO2 can be used to dynamically control the Er3+ emission lifetime at telecom wavelength (1.54 μm). A decay rate contrast of a factor 2 is obtained between high temperature (90 °C), when VO2 is metallic, and room temperature, when VO2 is semiconductor, in agreement with calculations performed with the classical dipole oscillator analytical model. A hysteretic behavior is observed by measuring the Er3+ lifetime as a function of the temperature, whose parameters are consistent with those of grazing incidence X‐ray diffraction and optical transmittance measurements. The fractions of Er3+ ions that couple with VO2 in each phase at the different temperatures are determined by the analysis of the temporal decays. The results make the investigated system an optimal candidate for the development of tunable photon sources at telecom wavelength.
We investigate the spontaneous emission of a two-level quantum emitter in the vicinity of a vanadium dioxide (VO2) thin film. By taking advantage of effective medium techniques to describe the dielectric constant of the VO2, we demonstrate that, in the near-field regime, the spontaneous emission rate of both electric and magnetic dipole emitters can be maximized at the insulator-to-metal phase transition temperature of the film. We find that VO2’s thermal hysteresis curve produces clear fingerprints in the emitter’s decay process, offering a new degree of freedom to dynamically control light emission at the nanoscale. We also find that the spontaneous emission rate is a non-monotonic function of the emitter transition wavelength, presenting a pronounced peak at infrared frequencies. Altogether, our results reveal that VO2 phase transition is a promising mechanism to achieve on-demand tuning of an emitter’s lifetime.
Modulation is a cornerstone of optical communication, and as such, governs the overall speed of data transmission. Currently, the two main strategies for modulating light are direct modulation of the excited emitter population (for example, using semiconductor lasers) and external optical modulation (for example, using Mach-Zehnder interferometers or ring resonators). However, recent advances in nanophotonics offer an alternative approach to control spontaneous emission through modifications to the local density of optical states. Here, by leveraging the phase-change of a vanadium dioxide nanolayer, we demonstrate broadband all-optical direct modulation of 1.5 μm emission from trivalent erbium ions more than three orders of magnitude faster than their excited state lifetime. This proof-of-concept demonstration shows how integration with phase-change materials can transform widespread phosphorescent materials into high-speed optical sources that can be integrated in monolithic nanoscale devices for both free-space and on-chip communication.
With their shielded 4f orbitals, rare-earth ions (REIs) offer optical and electron spin transitions with good coherence properties even when embedded in a host crystal matrix, highlighting their utility as promising quantum emitters and memories for quantum information processing. Among REIs, trivalent erbium (Er3+) uniquely has an optical transition in the telecom C-band, ideal for transmission over optical fibers, making it well suited for applications in quantum communication. The deployment of Er3+ emitters into a thin film TiO2 platform has been a promising step toward scalable integration; however, like many solid-state systems, the deterministic spatial placement of quantum emitters remains an open challenge. We investigate laser annealing as a means to locally tune the optical resonance of Er3+ emitters in TiO2 thin films on Si. Using both nanoscale x-ray diffraction measurements and cryogenic photoluminescence spectroscopy, we show that tightly focused below-gap laser annealing can induce anatase to rutile phase transitions in a nearly diffraction-limited area of the films and improve local crystallinity through grain growth. As a percentage of Er:TiO2 is converted to rutile, the Er3+ optical transition blueshifts by 13 nm. We explore the effects of changing laser annealing time and show that the amount of optically active Er:rutile increases linearly with laser power. We additionally demonstrate local phase conversion on microfabricated Si structures, which holds significance for quantum photonics.
Erbium (Er) is a lanthanide element, mainly used in its trivalent ionic form (Er3+), as an active dopant in optical devices, for light amplification or generation. The luminescence of Er3+ lies within the conventional wavelength band, 1530-1565 nm, for fiber-optic communication. The low noise, linear response, and stability of the optical gain provided by the Er3+ luminescence are ideal for applications in photonic systems that operate in the fiber-optic frequency. While much research has been done to understand the Er3+ luminescence in various lasing media, few studies have been conducted to tap the potential of Er for applications other than amplifiers or lasers. This thesis delves into two new areas, namely optical modulation and quantum computation, where the Er3+ luminescence may be able to be applied in a novel way. \n \nBy incorporating Er3+ into a switchable optical material, an optical modulator could potentially be made that is capable of not only switching but also amplifying signal transmission or sustaining the signal intensity from propagation losses. This integrated approach could reduce device footprint and latency for on-chip as well as synchronous applications. Successful integration of Er, however, has never been demonstrated in conventional optical modulators because their reliance on electro-optic effects conflicts with the carrier-sensitive mechanism of the Er3+ luminescence. The compatibility between Er and a recently advocated optical material, namely vanadium dioxide (VO2), is examined in the first part of this thesis. VO2 exhibits a hysteretic, bistable phase transition that is accompanied by a high-contrast optical switching in infrared, including the fiber-optic, wavelength band. The phase transition can be triggered thermally as well as optically. When triggered optically, it can occur in picosecond timescale, making VO2 a promising material for ultrafast optical switching applications. \n \nExperimental characterizations of the Er3+ luminescence and the optical switching were performed on selectively prepared thin-film samples of VO2. The Er3+ luminescence could be observed after the samples were implanted with Er and then annealed between 800*C and 1000*C. The optical switching could also be measured in the implanted and annealed samples as they were thermally heated up and then cooled down past the critical temperature of the phase transition. The Er-implanted samples, however, were found to have broader hysteresis and lower switching contrasts than the pure VO2 samples. It is concluded that although Er-implanted VO2 could probably work as a combined optical switch and amplifier, the poorer switching qualities do not guarantee that a device based on the material could provide better utility than a separated system of optical switches and Er amplifiers. \n \nThe Er3+ luminescence could also be utilized for quantum frequency conversion, for implementation in interconnects that interface superconducting quantum computers to a fiber-optic quantum network. For two superconducting quantum computers to be able to communicate over a fiber-optic quantum network, the frequency of the signals transmitted from either computer needs to be converted into the fiber-optic frequency, and then back into the microwave frequency upon receipt at the other computer. Early proposals suggested that the interconnect be at least comprised of Er3+ ions, a microwave resonator, and an optical resonator. The realization of this system has been attempted recently in basic experiments, but the conversion efficiency was found to be too low. The weak couplings between the Er3+ ions and the two resonators were identified as one of the main reasons for the low conversion efficiency. One way to mitigate the weak coupling in the microwave part is to have a superconducting flux qubit bridge the interaction between the Er3+ ions and the microwave resonator. \n \nThe second part of this thesis presents a theoretical and simulation study of the dynamics of a coupled system consisting of Er3+ ions, a superconducting microwave resonator, an optical resonator, and a superconducting flux qubit. It is shown that quantum information can be exchanged between the Er3+ ions and the microwave resonator with a high fidelity via the qubit coupling, and the exchange process is controllable by changing the frequency of the qubit. The frequency conversion between the microwave and the optical regime is shown to be infeasible to be realized at the limit where the number of optical excitations (n) is much less than the number of ions (N). A high-efficiency frequency down-conversion is demonstrated to be achievable in the case where there is no decoherence, and both n and N are small. However, the time it takes to complete the down-conversion is very long, leaving the efficiency prone to decoherence. It is argued that for the frequency conversion to be able to be accomplished in a typical decoherent environment, both n and N need to be large. The study of the dynamics, in this case, is left for future research.
Single quantum emitters embedded in solid-state hosts are an ideal platform for realizing quantum information processors and quantum network nodes. Among the currently investigated candidates, Er^{3+} ions are particularly appealing due to their 1.5 μm optical transition in the telecom band as well as their long spin coherence times. However, the long lifetimes of the excited state-generally in excess of 1 ms-along with the inhomogeneous broadening of the optical transition result in significant challenges. Photon emission rates are prohibitively small, and different emitters generally create photons with distinct spectra, thereby preventing multiphoton interference-a requirement for building large-scale, multinode quantum networks. Here we solve this challenge by demonstrating for the first time linear Stark tuning of the emission frequency of a single Er^{3+} ion. Our ions are embedded in a lithium niobate crystal and couple evanescently to a silicon nanophotonic crystal cavity that provides a strong increase of the measured decay rate. By applying an electric field along the crystal c axis, we achieve a Stark tuning greater than the ion's linewidth without changing the single-photon emission statistics of the ion. These results are a key step towards rare earth ion-based quantum networks.
Atomic layer deposited (ALD) Y 2 O 3 thin films have been thoroughly investigated for optical or electronic applications. The coherent spectroscopy of lanthanide ions doped into this material has also recently attracted increasing interest in the field of quantum technologies for which they are considered promising candidates in quantum memories or as spin–photon interfaces. However, these most demanding applications require a deep control over the local positioning of the ions and their close environment in the crystalline matrix. This study focuses on the structural as well as optical properties of Eu 3+ and Er 3+ dopants in Y 2 O 3 using photoluminescence (PL), luminescence decay times, and inhomogeneous line width (Γ inh ) measurements within this particular context. While as-grown ALD films do not provide an ideal host for the emitters, we demonstrate that by optimizing the deposition conditions and using appropriate annealing post treatments narrow inhomogeneous lines can be obtained for the 7 F 0 ↔ 5 D 0 transition of Eu 3+ even for nanoscale films. Furthermore, about 1.5 ms lifetime has been measured for the infrared telecom transition of Er in ultrathin films (<10 nm), which is an order of magnitude higher than in nanoparticles of the same size. These results validate optimized rare-earth-doped ALD Y 2 O 3 films as a suitable platform for photonics applications where few-nanometer-thick films with well-localized emitters are mandatory. This approach provides the first building blocks toward the development of more complex devices for quantum sensing or hybrid structures coupled with other systems such as two-dimensional materials.