With their shielded 4f orbitals, rare-earth ions (REIs) offer optical and electron spin transitions with good coherence properties even when embedded in a host crystal matrix, highlighting their utility as promising quantum emitters and memories for quantum information processing. Among REIs, trivalent erbium (Er3+) uniquely has an optical transition in the telecom C-band, ideal for transmission over optical fibers, making it well suited for applications in quantum communication. The deployment of Er3+ emitters into a thin film TiO2 platform has been a promising step toward scalable integration; however, like many solid-state systems, the deterministic spatial placement of quantum emitters remains an open challenge. We investigate laser annealing as a means to locally tune the optical resonance of Er3+ emitters in TiO2 thin films on Si. Using both nanoscale x-ray diffraction measurements and cryogenic photoluminescence spectroscopy, we show that tightly focused below-gap laser annealing can induce anatase to rutile phase transitions in a nearly diffraction-limited area of the films and improve local crystallinity through grain growth. As a percentage of Er:TiO2 is converted to rutile, the Er3+ optical transition blueshifts by 13 nm. We explore the effects of changing laser annealing time and show that the amount of optically active Er:rutile increases linearly with laser power. We additionally demonstrate local phase conversion on microfabricated Si structures, which holds significance for quantum photonics.
With their shielded 4f orbitals, rare-earth ions (REIs) offer optical and electron spin transitions with good coherence properties even when embedded in a host crystal matrix, highlighting their utility as promising quantum emitters and memories for quantum information processing. Among REIs, trivalent erbium (Er3+) uniquely has an optical transition in the telecom C-band, ideal for transmission over optical fibers, making it well suited for applications in quantum communication. The deployment of Er3+ emitters into a thin film TiO2 platform has been a promising step toward scalable integration; however, like many solid-state systems, the deterministic spatial placement of quantum emitters remains an open challenge. We investigate laser annealing as a means to locally tune the optical resonance of Er3+ emitters in TiO2 thin films on Si. Using both nanoscale x-ray diffraction measurements and cryogenic photoluminescence spectroscopy, we show that tightly focused below-gap laser annealing can induce anatase to rutile phase transitions in a nearly diffraction-limited area of the films and improve local crystallinity through grain growth. As a percentage of Er:TiO2 is converted to rutile, the Er3+ optical transition blueshifts by 13 nm. We explore the effects of changing laser annealing time and show that the amount of optically active Er:rutile increases linearly with laser power. We additionally demonstrate local phase conversion on microfabricated Si structures, which holds significance for quantum photonics.
Rare-earth ions (REIs) doped into solid-state crystal hosts offer an attractive platform for realizing quantum interconnects that can function as quantum memories and quantum repeaters. The 4f valence electrons of REIs are shielded by 5s and 5p electrons and undergo highly coherent transitions even when embedded in host crystals. In particular, Er3+ has an optical transition in the telecom band that is suitable for low-loss communication. Recently, REIs in thin film systems have gained interest due to potential advantages in providing a flexible host crystal environment, enabling scalable on-chip integration with other quantum devices. Here, we investigate the structural and optical properties of Er-doped anatase TiO2 thin films on LaAlO3 (001) substrates. By choosing a system with minimal lattice mismatch and adjusting Er-dopant concentration, we achieve optical inhomogeneous linewidths of 5 GHz at 4.5 K. We show that 9 nm-thick buffer and capping layers can reduce the linewidth by more than 40%, suggesting a pathway to further narrowing linewidths in this system. We also identify that Er3+ ions mainly incorporate into substitutional Ti4+ sites with non-polar D2d symmetry, which makes Er dopants insensitive to the first order to local electric fields from impurities and is desirable for coherence properties of Er3+ spins.
Rare-earth ion doped oxide thin films integrated on silicon substrates provide a route toward scalable, chip-scale platforms for quantum coherent devices. Erbium-doped TiO2 is an attractive candidate: the Er3+ optical transition is compatible with C-band optical fiber communications, while TiO2 is an insulating dielectric compatible with silicon process technology. Through structural and optical studies of Er-doped TiO2 thin films grown via molecular beam deposition on silicon, SrTiO3, and sapphire substrates, we have explored the impact of polycrystallinity and microstructure on the optical properties of the Er emission. Comparing polycrystalline TiO2(rutile)/Si with single-crystalline TiO2(rutile)/r-sapphire and polycrystalline TiO2(anatase)/Si with single-crystalline TiO2(anatase)/SrTiO3, we observe that the inhomogeneous linewidth (Γinh) of the most prominent peak in the Er spectrum (the Y1–Z1 transition, 1520 and 1533 nm in rutile and anatase TiO2) is significantly narrower in the polycrystalline case. This implies a relative insensitivity to extended structural defects and grain boundaries in such films (as opposed to, e.g., point defects). We show that the growth of an undoped, underlying TiO2 buffer on Si can reduce Γinh by a factor of 4–5. Expectedly, Γinh also reduces with decreasing Er concentrations: we observe a ∼2 order of magnitude reduction from ∼1000 ppm Er to ∼10 ppm Er. Γinh then gets limited to a residual value of ∼5 GHz that is insensitive to further reduction in the Er concentration. Based upon the above results, we argue that the optical properties in these thin films are limited by the presence of high “grown-in” point defect concentrations.
High Resolution Image Download MS PowerPoint Slide The use of trivalent erbium (Er 3+ ), typically embedded as an atomic defect in the solid-state, has widespread adoption as a dopant in telecommunication devices and shows promise as a spin-based quantum memory for quantum communication. In particular, its natural telecom C-band optical transition and spin-photon interface make it an ideal candidate for integration into existing optical fiber networks without the need for quantum frequency conversion. However, successful scaling requires a host material with few intrinsic nuclear spins, compatibility with semiconductor foundry processes, and straightforward integration with silicon photonics. Here, we present Er-doped titanium dioxide (TiO 2 ) thin film growth on silicon substrates using a foundry-scalable atomic layer deposition process with a wide range of doping controls over the Er concentration. Even though the as-grown films are amorphous after oxygen annealing, they exhibit relatively large crystalline grains, and the embedded Er ions exhibit the characteristic optical emission spectrum from anatase TiO 2 . Critically, this growth and annealing process maintains the low surface roughness required for nanophotonic integration. Finally, we interface Er ensembles with high quality factor Si nanophotonic cavities via evanescent coupling and demonstrate a large Purcell enhancement (≈300) of their optical lifetime. Our findings demonstrate a low-temperature, nondestructive, and substrate-independent process for integrating Er-doped materials with silicon photonics. At high doping densities this platform can enable integrated photonic components such as on-chip amplifiers and lasers, while dilute concentrations can realize single ion quantum memories.
Defects and dopant atoms in solid state materials are a promising platform for realizing single photon sources and quantum memories, which are the basic building blocks of quantum repeaters needed for long distance quantum networks. In particular, trivalent erbium (Er3+) is of interest because it couples C-band telecom optical transitions with a spin-based memory platform. In order to produce quantum repeaters at the scale required for quantum networks it is imperative to integrate these necessary building blocks with mature and scalable semiconductor processes. In this work, we demonstrate the optical isolation of single Er3+ ions in CMOS-compatible titanium dioxide (TiO2) thin films monolithically integrated on a silicon-on-insulator photonics platform. Our results demonstrate an initial step toward the realization of a monolithically integrated and scalable quantum photonics package based on Er3+ doped thin films.
Rare-earth ions (REIs) have incomplete 4f shells and possess narrow optical intra-4f transitions due to shielding from electrons in the 5s and 5p orbitals, making them good candidates for solid-state optical quantum memory. The emission of Er3+ in the telecom C-band (1530 nm–1565 nm) makes it especially attractive for this application. In order to build practical, scalable devices, the REI needs to be embedded in a non-interacting host material, preferably one that can be integrated with silicon. In this paper, we show that Er3+ can be isovalently incorporated into epitaxial Y2O3 thin films on Si (111). We report on the synthesis of epitaxial, single-crystalline Er:Y2O3 on Si with a narrow inhomogeneous linewidth in the photoluminescence (PL) spectra, 5.1 GHz (<100 mK), and an optical excited state lifetime of 8.1 ms. The choice of Y2O3 was driven by its low nuclear spin and small lattice mismatch with Si. Using PL and electron paramagnetic resonance, we show that Er3+ substitutes for Y in the crystal lattice. The role of interfacial SiOx, diffusion of silicon into the film, and the effect of buffer layers on the inhomogeneous PL linewidth are examined. We also find that the linewidth decreased monotonically with film thickness but surprisingly exhibits no correlation with the film crystalline quality, as measured by the x-ray rocking curve scans, suggesting other factors at play that limit the inhomogeneous broadening in Y2O3 films.
Controlled growth of rare-earth-doped TiO2 thin films on III-V semiconductors for hybrid quantum photonic interfaces
Quantum photonic networks require two distinct functionalities: bright single-photon sources and long-lived quantum memories. III-V semiconductor quantum dots excel as deterministic and coherent photon emitters, while rare-earth ions such as erbium (Er3+) in crystalline oxides offer exceptional spin and optical coherence at telecom wavelengths. Combining these systems and their functionalities via direct epitaxy is challenging due to lattice mismatch and incompatible growth conditions. Here we demonstrate low-temperature pulsed laser deposition of Er3+-doped TiO2 thin films directly on GaAs and GaSb substrates. Controlled surface preparation with an arsenic cap and an oxygen-deficient buffer layer enables the growth of epitaxial anatase TiO2 (001) at 390oC with sub-300 pm surface roughness, while avoiding interface degradation. In contrast, high-temperature oxide desorption or growth temperatures drive the transition to rough, polycrystalline rutile film, as confirmed by transmission electron microscopy. Minimal coincident interface area (MCIA) modeling explains the orientation-selective growth on GaAs and GaSb. Raman and cryogenic photoluminescence excitation spectroscopy verify the crystal phase and optical activation of Er3+ ions. This multi-parameter growth strategy helps preserve III-V quantum dot functionality and yields smooth surfaces suitable for low-loss nanophotonic structures. Our results establish a materials platform for monolithically integrating rare-earth quantum memories with semiconductor photon sources, paving the way toward scalable hybrid quantum photonic chips.