Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

International Meeting on Instabilities and Dynamics of Lasers and Nonlinear Optical Systems

Transient Bistability in a Laser Containing a Saturable Absorber

E. Arimondo, C. Gabbanini, E. Menchi, Didier Dangoisse, P. Glorieux

Published Jan 1, 1985• 0 citations
Publisher

Abstract

The question of the behaviour of the LSA when a control parameter is a slowly varying function of time, has recently been raised [1]. The investigation of the transient behaviour of a LSA is interesting not only in connection with the problem of the response time of optically bistable systems but also because in any real experiment, if one wants to explore a phase diagram, the parameters have to be changed in time. Although the relaxation times of the molecular medium and the cavity response time are of the order of 100μs or smaller, the time constants characterising the transient regime of the LSA may be much longer because of the critical slowing down which appears near the limit points of the hysteresis cycle[2]

DOI
10.1364/idlnos.1985.tud3

Related papers

Analytic Studies of the Laser With a Saturable Absorber

Thomas Erneux

In the laser with a saturable absorber (LSA), the spontaneous and stimulated emissions build up in the laser cavity but are restrained by the intracavity absorber. As a result, two new modes of operation are observed: optical bistability and time-periodic intensity pulses. These two behaviors are not observed in the usual laser under normal conditions. Thus, the LSA is an example of an active system displaying optical bistability. (See Ref. 1 for a general review).

International Meeting on Instabilities and Dynamics of Lasers and Nonlinear Optical Systems•Jan 1, 1985•0 citations

Hole burning effect and lasers containing saturable absorber with dominate inhomogeneous broadening

Dinh Van Hoang

In the last ten years lasers containing saturable absorber are considered widely theoretically and experimentally by many authors/1-4/, Un action of this laser containing saturable absorber (LSA) are shown different interseting effects like the optical bistability, the bifurrcation, the chaos regime etc...

[Conference Digest] International Conference on Millimeter Wave and Far-Infrared Technology: ICMWFT '90•Jan 1, 1989•0 citations

Dynamic behavior of bistability in a laser with a saturable absorber

E. Arimondo, Didier Dangoisse, C. Gabbanini +2 more

Optical bistability in a CO2 infrared laser containing SF6 as a saturable intracavity absorber has been studied under dynamic conditions as a function of a time-dependent laser control parameter. The width of the optical bistability region, the fluctuations in the bistability switching values, and the dependence on the initial conditions have been investigated in this transient optical bistability. A numerical solution of the laser rate equations provides a good interpretation of the experimental results, but some experimental observations cannot be completely explained.

Journal of the Optical Society of America B•Jun 1, 1987•32 citations

ANALYTICAL MODEL FOR OPTICAL BISTABILITY IN LASER WITH SATURABLE ABSORBER

Smail Djabi, H. Boudoukha, Saïd Meguellati

In this paper, we develop a theoretical model that accurately describes the nonlinear phenomenon of optical bistability in Fabry-Perot laser containing a saturable absorber "LSA". We present an analytical model for optical bistability in a LSA. The physics of optical bistability in a classical optical resonant system such as Fabry-Perot etalon has been well-established, and can be described by simple analytical models. The photon intensities were determined as a function of the pumping rate of the active medium, and we analyzed the linear stability of the stationary solutions obtained.

Journal of Nonlinear Optical Physics & Materials•Sep 1, 2011•1 citation

Precise Measurements of Bistability in a CO2 Laser with Intracavity Saturable Absorber

E. Arimondo, Bianca Maria Dinelli, E. Menehi

Optical bistability in a laser with an intracavity saturable absorber is a phenomenon theoretically investigated firstly by Lugiato et al(1). The experimental observations in CO2 lasers(2,3) have provided clear evidence of the bistability phenomenon and shown that the absorber parameters could be determined from these observations. In this work a quantitative comparison between a theoretical description of optical bistability and the experimental results is presented for the first time. The parameters defining the laser cavity and the CO2 amplifying medium were measured carefully, and the bistability was observed and analyzed quantitatively as a function of the laser parameters.

Topical Meeting on Optical Bistability (OB)•Jan 1, 1983•0 citations

Single- and two-mode models

Luigi A. Lugiato, Franco Prati, Massimo Brambilla

In the first section we discuss the stationary solutions for a laser with an injected signal, the active counterpart of the optical bistability analyzed in Chapter 11. Next, in Section 13.2 we consider another very interesting system, namely a laser with a saturable absorber, a free-running laser in which the optical cavity contains a passive medium in addition to the active medium. The single-mode model for this system can be constructed by combining the single-mode models for the free-running laser and for optical bistability. The discussion is then focussed on its stationary states. In Section 13.3 we return to the single-mode model for optical bistability and, by introducing an appropriate “cubic limit” on the parameters in play, we derive a cubic model for dispersive optical bistability with two-level atoms. The stationary equation for such a model formally coincides with that derived and discussed for a Kerr medium in Section 11.2. In the last section we start from the equations for a quadratic nonlinear medium in the degenerate configuration derived in Chapter 6 and combine them with the appropriate boundary conditions for the two field envelopes in play, assuming that the quadratic medium is contained in a ring cavity as happens in an optical parametric oscillator or in second-harmonic generation in a cavity. Next, by introducing the low-transmission limit and the single-mode limit we derive a two-mode model that describes the dynamics of a degenerate optical parametric oscillator or of second-harmonic generation in a cavity. Finally, for the case of a parametric oscillator we illustrate extensively the stationary solutions of the equations. A laser with an injected signal From a technical point of view, this system is interesting because of the possibility of stabilizing the frequency and the phase of separate lasers by taking advantage of the known affinity of nonlinear oscillators to lock onto a periodic forcing element. In 1972 Spencer and Lamb [125] predicted the possibility of bistable behavior in a laser with an injected signal before the surge of interest in optical bistability in the passive configuration.

Cambridge University Press eBooks•Feb 28, 2015•0 citations
The question of the behaviour of the LSA when a control parameter is a slowly varying function of time, has recently been raised [1]. The investigation of the transient behaviour of a LSA is interesting not only in connection with the problem of the response time of optically bistable systems but also because in any real experiment, if one wants to explore a phase diagram, the parameters have to be changed in time. Although the relaxation times of the molecular medium and the cavity response time are of the order of 100μs or smaller, the time constants characterising the transient regime of the LSA may be much longer because of the critical slowing down which appears near the limit points of the hysteresis cycle[2]
Optical bistability in a CO2 infrared laser containing SF6 as a saturable intracavity absorber has been studied under dynamic conditions as a function of a time-dependent laser control parameter. The width of the optical bistability region, the fluctuations in the bistability switching values, and the dependence on the initial conditions have been investigated in this transient optical bistability. A numerical solution of the laser rate equations provides a good interpretation of the experimental results, but some experimental observations cannot be completely explained.
In this paper, we develop a theoretical model that accurately describes the nonlinear phenomenon of optical bistability in Fabry-Perot laser containing a saturable absorber "LSA". We present an analytical model for optical bistability in a LSA. The physics of optical bistability in a classical optical resonant system such as Fabry-Perot etalon has been well-established, and can be described by simple analytical models. The photon intensities were determined as a function of the pumping rate of the active medium, and we analyzed the linear stability of the stationary solutions obtained.
Optical bistability in a laser with an intracavity saturable absorber is a phenomenon theoretically investigated firstly by Lugiato et al(1). The experimental observations in CO2 lasers(2,3) have provided clear evidence of the bistability phenomenon and shown that the absorber parameters could be determined from these observations. In this work a quantitative comparison between a theoretical description of optical bistability and the experimental results is presented for the first time. The parameters defining the laser cavity and the CO2 amplifying medium were measured carefully, and the bistability was observed and analyzed quantitatively as a function of the laser parameters.
In the first section we discuss the stationary solutions for a laser with an injected signal, the active counterpart of the optical bistability analyzed in Chapter 11. Next, in Section 13.2 we consider another very interesting system, namely a laser with a saturable absorber, a free-running laser in which the optical cavity contains a passive medium in addition to the active medium. The single-mode model for this system can be constructed by combining the single-mode models for the free-running laser and for optical bistability. The discussion is then focussed on its stationary states. In Section 13.3 we return to the single-mode model for optical bistability and, by introducing an appropriate “cubic limit” on the parameters in play, we derive a cubic model for dispersive optical bistability with two-level atoms. The stationary equation for such a model formally coincides with that derived and discussed for a Kerr medium in Section 11.2. In the last section we start from the equations for a quadratic nonlinear medium in the degenerate configuration derived in Chapter 6 and combine them with the appropriate boundary conditions for the two field envelopes in play, assuming that the quadratic medium is contained in a ring cavity as happens in an optical parametric oscillator or in second-harmonic generation in a cavity. Next, by introducing the low-transmission limit and the single-mode limit we derive a two-mode model that describes the dynamics of a degenerate optical parametric oscillator or of second-harmonic generation in a cavity. Finally, for the case of a parametric oscillator we illustrate extensively the stationary solutions of the equations. A laser with an injected signal From a technical point of view, this system is interesting because of the possibility of stabilizing the frequency and the phase of separate lasers by taking advantage of the known affinity of nonlinear oscillators to lock onto a periodic forcing element. In 1972 Spencer and Lamb [125] predicted the possibility of bistable behavior in a laser with an injected signal before the surge of interest in optical bistability in the passive configuration.