Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

International Meeting on Instabilities and Dynamics of Lasers and Nonlinear Optical Systems

Analytic Studies of the Laser With a Saturable Absorber

Thomas Erneux

Published Jan 1, 1985• 0 citations
Publisher

Abstract

In the laser with a saturable absorber (LSA), the spontaneous and stimulated emissions build up in the laser cavity but are restrained by the intracavity absorber. As a result, two new modes of operation are observed: optical bistability and time-periodic intensity pulses. These two behaviors are not observed in the usual laser under normal conditions. Thus, the LSA is an example of an active system displaying optical bistability. (See Ref. 1 for a general review).

DOI
10.1364/idlnos.1985.tud1

Related papers

Investigations of intensity fluctuations in the laser with a saturable absorber

Mansour Mortazavi, Surendra Singh

The equation of motion for the slowly varying field amplitude of the laser containing an intracavity saturable absorber (LSA) is where a is the net gain (pump parameter) and b is a saturation parameter of the laser. In our experiment the absorber saturates faster than the amplifier and the parameter b is positive. q(t) is a complex Gaussian white noise random process representing spontaneous emission noise. From Eq. (1) we obtain for the steady-state probability density of light intensity I = | E |2. From this equation various moments of light intensity can be calculated and compared with experimentally measured quantities. For b > 0 the LSA exhibits bistability and a first order phase transition occurs at a = -3b2/16. For negative values of b there is a continuous transition at a = 0. Experiments were carried out on a He—Ne laser with an intracavity Ne absorber cell. The laser was operated close to the center of the absorption line. Slow drifts of light intensity were controlled by an electronic feedback loop. The parameter b was varied by changing the current in the absorber tube. Pump parameter a was then varied by changing passive losses in the cavity by means of an adjustable knife edge. The main beam from the LSA was allowed to fall on a detector/am- plifier combination. The voltage output from the detector was digitized by a multichannel analyzer and a histogram of voltage amplitudes was built up. Since the voltage output from the detector is directly proportional to the light intensity incident on the detector, voltage histogram is a direct representative of the intensity probability distribution. From the measured histogram moments of light intensity were calculated. These results are compared with the theoretical predictions.

Annual Meeting Optical Society of America•Jan 1, 1990•0 citations

ANALYTICAL MODEL FOR OPTICAL BISTABILITY IN LASER WITH SATURABLE ABSORBER

Smail Djabi, H. Boudoukha, Saïd Meguellati

In this paper, we develop a theoretical model that accurately describes the nonlinear phenomenon of optical bistability in Fabry-Perot laser containing a saturable absorber "LSA". We present an analytical model for optical bistability in a LSA. The physics of optical bistability in a classical optical resonant system such as Fabry-Perot etalon has been well-established, and can be described by simple analytical models. The photon intensities were determined as a function of the pumping rate of the active medium, and we analyzed the linear stability of the stationary solutions obtained.

Journal of Nonlinear Optical Physics & Materials•Sep 1, 2011•1 citation

Optical bistability of Fabry-Perot LSA with inhomogeneous broadening

Dinh Van Hoang, Phung Quoc Bao

The optical bistability (OB) behavior of single-mode Fabry- Perot lasers containing saturable absorber (LSA) is presented on the basis of the rate equations with allowance for spontaneous emission and spatial hole-burning. Special attention is paid to the case of dominant inhomogeneous broadening in both Lorentzian and Gaussian models. The OB occurrence conditions are clearly displayed in phase diagrams. The influence of the main LSA parameters on OB characteristics as well as on OB curves' stability are investigated in detail. Some practical suggestions for optimizing the bistable operation in LSA are also given.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Sep 8, 1999•3 citations

Characteristics of the mode intensity and optical bistability in multimode lasers with a saturable absorber. I. Single-mode operator

Dinh Van Hoang, Phan N Ha

The characteristics of the mode intensity and conditions for occurrence of optical bistability in a ring laser with a saturable absorber are considered. The rate equation approximation method is used to find analytic expressions for these characteristics. It is shown that changes in such physical parameters as the homogeneous and inhomogeneous broadening, coefficients of relaxation of amplifying and absorbing cells, etc. cause changes in the range of existence of optical bistability or a hysteresis cycle. The influence of inhomogeneous broadening and of spontaneous emission near the lasing threshold on the appearance of optical bistability is demonstrated for the single-mode regime.

Soviet Journal of Quantum Electronics•Mar 31, 1986•1 citation

Precise Measurements of Bistability in a CO2 Laser with Intracavity Saturable Absorber

E. Arimondo, Bianca Maria Dinelli, E. Menehi

Optical bistability in a laser with an intracavity saturable absorber is a phenomenon theoretically investigated firstly by Lugiato et al(1). The experimental observations in CO2 lasers(2,3) have provided clear evidence of the bistability phenomenon and shown that the absorber parameters could be determined from these observations. In this work a quantitative comparison between a theoretical description of optical bistability and the experimental results is presented for the first time. The parameters defining the laser cavity and the CO2 amplifying medium were measured carefully, and the bistability was observed and analyzed quantitatively as a function of the laser parameters.

Topical Meeting on Optical Bistability (OB)•Jan 1, 1983•0 citations

Dynamic behavior of bistability in a laser with a saturable absorber

E. Arimondo, Didier Dangoisse, C. Gabbanini +2 more

Optical bistability in a CO2 infrared laser containing SF6 as a saturable intracavity absorber has been studied under dynamic conditions as a function of a time-dependent laser control parameter. The width of the optical bistability region, the fluctuations in the bistability switching values, and the dependence on the initial conditions have been investigated in this transient optical bistability. A numerical solution of the laser rate equations provides a good interpretation of the experimental results, but some experimental observations cannot be completely explained.

Journal of the Optical Society of America B•Jun 1, 1987•32 citations
In the laser with a saturable absorber (LSA), the spontaneous and stimulated emissions build up in the laser cavity but are restrained by the intracavity absorber. As a result, two new modes of operation are observed: optical bistability and time-periodic intensity pulses. These two behaviors are not observed in the usual laser under normal conditions. Thus, the LSA is an example of an active system displaying optical bistability. (See Ref. 1 for a general review).
The equation of motion for the slowly varying field amplitude of the laser containing an intracavity saturable absorber (LSA) is where a is the net gain (pump parameter) and b is a saturation parameter of the laser. In our experiment the absorber saturates faster than the amplifier and the parameter b is positive. q(t) is a complex Gaussian white noise random process representing spontaneous emission noise. From Eq. (1) we obtain for the steady-state probability density of light intensity I = | E |2. From this equation various moments of light intensity can be calculated and compared with experimentally measured quantities. For b > 0 the LSA exhibits bistability and a first order phase transition occurs at a = -3b2/16. For negative values of b there is a continuous transition at a = 0. Experiments were carried out on a He—Ne laser with an intracavity Ne absorber cell. The laser was operated close to the center of the absorption line. Slow drifts of light intensity were controlled by an electronic feedback loop. The parameter b was varied by changing the current in the absorber tube. Pump parameter a was then varied by changing passive losses in the cavity by means of an adjustable knife edge. The main beam from the LSA was allowed to fall on a detector/am- plifier combination. The voltage output from the detector was digitized by a multichannel analyzer and a histogram of voltage amplitudes was built up. Since the voltage output from the detector is directly proportional to the light intensity incident on the detector, voltage histogram is a direct representative of the intensity probability distribution. From the measured histogram moments of light intensity were calculated. These results are compared with the theoretical predictions.
In this paper, we develop a theoretical model that accurately describes the nonlinear phenomenon of optical bistability in Fabry-Perot laser containing a saturable absorber "LSA". We present an analytical model for optical bistability in a LSA. The physics of optical bistability in a classical optical resonant system such as Fabry-Perot etalon has been well-established, and can be described by simple analytical models. The photon intensities were determined as a function of the pumping rate of the active medium, and we analyzed the linear stability of the stationary solutions obtained.
The optical bistability (OB) behavior of single-mode Fabry- Perot lasers containing saturable absorber (LSA) is presented on the basis of the rate equations with allowance for spontaneous emission and spatial hole-burning. Special attention is paid to the case of dominant inhomogeneous broadening in both Lorentzian and Gaussian models. The OB occurrence conditions are clearly displayed in phase diagrams. The influence of the main LSA parameters on OB characteristics as well as on OB curves' stability are investigated in detail. Some practical suggestions for optimizing the bistable operation in LSA are also given.
The characteristics of the mode intensity and conditions for occurrence of optical bistability in a ring laser with a saturable absorber are considered. The rate equation approximation method is used to find analytic expressions for these characteristics. It is shown that changes in such physical parameters as the homogeneous and inhomogeneous broadening, coefficients of relaxation of amplifying and absorbing cells, etc. cause changes in the range of existence of optical bistability or a hysteresis cycle. The influence of inhomogeneous broadening and of spontaneous emission near the lasing threshold on the appearance of optical bistability is demonstrated for the single-mode regime.
Optical bistability in a laser with an intracavity saturable absorber is a phenomenon theoretically investigated firstly by Lugiato et al(1). The experimental observations in CO2 lasers(2,3) have provided clear evidence of the bistability phenomenon and shown that the absorber parameters could be determined from these observations. In this work a quantitative comparison between a theoretical description of optical bistability and the experimental results is presented for the first time. The parameters defining the laser cavity and the CO2 amplifying medium were measured carefully, and the bistability was observed and analyzed quantitatively as a function of the laser parameters.
Optical bistability in a CO2 infrared laser containing SF6 as a saturable intracavity absorber has been studied under dynamic conditions as a function of a time-dependent laser control parameter. The width of the optical bistability region, the fluctuations in the bistability switching values, and the dependence on the initial conditions have been investigated in this transient optical bistability. A numerical solution of the laser rate equations provides a good interpretation of the experimental results, but some experimental observations cannot be completely explained.