Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Conference on Lasers and Electro-Optics

Measurement of sub-pulse-width temporal delays via spectral interference induced by weak value amplification

Luis José Salazar-Serrano, Davide Janner, Nicolas Brunner, Valerio Pruneri, Juan P. Torres

Published Jan 1, 2014• 2 citations
Publisher

Abstract

We present experimental results of a scheme based on the concepts of weak measurements and weak value amplification to measure temporal delays, much smaller than the pulse width, by means of spectral interference
DOI
10.1364/cleo_at.2014.jtu4a.51

Related papers

Observation of spectral interference for any path difference in an interferometer

Luis José Salazar-Serrano, Alejandra Valencia, Juan P. Torres

We report experimental observation of spectral interference in a Michelson interferometer, regardless of the relationship between the temporal path difference and the spectral width of an input pulse, by using a weak value amplification scheme.

Frontiers in Optics•Jan 1, 2014•1 citation

Amplification of Optical Pulse Delays using Weak Measurements

Mohammad Mirhosseini, Omar S. Magaña‐Loaiza, Mehul Malik +1 more

A novel scheme for super-sensitive measurement of optical pulse delays is proposed based on the concept of weak-value amplification. We discuss an experimental implementation of this technique utilizing a Mach-Zehnder interferometer.

The Rochester Conferences on Coherence and Quantum Optics and the Quantum Information and Measurement meeting•Jan 1, 2013•1 citation

Measuring Ultrasmall Time Delays of Light by Joint Weak Measurements

Grégory Strübi, Christoph Bruder

We propose to use weak measurements away from the weak-value amplification regime to carry out precision measurements of time delays of light. Our scheme is robust to several sources of noise that are shown to only limit the relative precision of the measurement. Thus, they do not set a limit on the smallest measurable phase shift, contrary to standard interferometry and weak-value-based measurement techniques. Our idea is not restricted to phase-shift measurements and could be used to measure other small effects using a similar protocol.

arXiv:1301.5846•Physical Review Letters•Feb 22, 2013•135 citations

Weak interference in the high-signal regime

Juan P. Torres, Graciana Puentes, Nathaniel Hermosa +1 more

Weak amplification is a signal enhancement technique which is used to measure tiny changes that otherwise cannot be determined because of technical limitations. It is based on: a) the existence of a weak interaction which couples a property of a system (the system) with a separate degree of freedom (the pointer), and b) the measurement of an anomalously large mean value of the pointer state (weak mean value), after appropriate pre-and post-selection of the state of the system. Unfortunately, the weak amplification process is generally accompanied by severe losses of the detected signal, which limits its applicability. However, we will show here that since weak amplification is essentially the result of an interference phenomena, it should be possible to use the degree of interference (weak interference) to get relevant information about the physical system under study in a more general scenario, where the signal is not severely depleted (high-signal regime).

arXiv:1204.6701•Optics Express•Aug 2, 2012•10 citations

Measurement of sub-pulse-width temporal delays via spectral interference induced by weak value amplification

Luis José Salazar-Serrano, Davide Janner, Nicolas Brunner +2 more

We demonstrate experimentally a scheme to measure small temporal delays, much smaller than the pulse width, between optical pulses. Specifically, we observe an interference effect, based on the concepts of quantum weak measurements and weak value amplification, through which a sub-pulse-width temporal delay between two femtosecond pulses induces a measurable shift of the central frequency of the pulse. The amount of frequency shift, and the accompanying losses of the measurement, can be tailored by postselecting different states of polarization. Our scheme requires only spectrum measurements and linear optics elements, hence greatly facilitating its implementation. Thus it appears to be a promising technique for measuring small and rapidly varying temporal delays.

arXiv:1312.4469•Physical Review A•Jan 27, 2014•62 citations

Two-photon interference measurement of laser pulse

Masaahiro Matsuoka, Y. Miyamoto, T. Kuga +1 more

A new two-photon interference method to measure coherence time and pulse width of ultrashort pulses is proposed. Experiments are performed on cw-modelocked dye-laser pulses.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Oct 28, 1992•0 citations
We propose to use weak measurements away from the weak-value amplification regime to carry out precision measurements of time delays of light. Our scheme is robust to several sources of noise that are shown to only limit the relative precision of the measurement. Thus, they do not set a limit on the smallest measurable phase shift, contrary to standard interferometry and weak-value-based measurement techniques. Our idea is not restricted to phase-shift measurements and could be used to measure other small effects using a similar protocol.
Weak amplification is a signal enhancement technique which is used to measure tiny changes that otherwise cannot be determined because of technical limitations. It is based on: a) the existence of a weak interaction which couples a property of a system (the system) with a separate degree of freedom (the pointer), and b) the measurement of an anomalously large mean value of the pointer state (weak mean value), after appropriate pre-and post-selection of the state of the system. Unfortunately, the weak amplification process is generally accompanied by severe losses of the detected signal, which limits its applicability. However, we will show here that since weak amplification is essentially the result of an interference phenomena, it should be possible to use the degree of interference (weak interference) to get relevant information about the physical system under study in a more general scenario, where the signal is not severely depleted (high-signal regime).
We demonstrate experimentally a scheme to measure small temporal delays, much smaller than the pulse width, between optical pulses. Specifically, we observe an interference effect, based on the concepts of quantum weak measurements and weak value amplification, through which a sub-pulse-width temporal delay between two femtosecond pulses induces a measurable shift of the central frequency of the pulse. The amount of frequency shift, and the accompanying losses of the measurement, can be tailored by postselecting different states of polarization. Our scheme requires only spectrum measurements and linear optics elements, hence greatly facilitating its implementation. Thus it appears to be a promising technique for measuring small and rapidly varying temporal delays.