Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Quantum Control over a Low Frequency Mechanical Oscillator Using a Superconducting Qubit

Xizheng Ma

Published Dec 1, 2020• 0 citations
OpenAlex

Abstract

The ability to access a broad range of quantum states with mechanical oscillators has many applications and is an enduring ambition in the fields of opto- and electromechanics. However, as mechanical oscillators are linear at the quantum scale, arbitrary quantum control over them requires an extrinsic nonlinearity. In this thesis, I aim to provide this extrinsic nonlinearity and establish quantum control over the motion of a suspended aluminum disk by coupling it strongly to a superconducting qubit. To this end, I design and fabricate a device, when operated at its maximum coupling strength, could enable phonon-number-resolved measurements and arbitrary quantum control over the mechanical motion. However, limited by unclear reasons that break the qubit readout, I operate at approximately a quarter of the maximum coupling strength. Nevertheless, at this smaller coupling strength, I demonstrate the preparation of a non-Gaussian nonclassical state of motion.Because of the large coupling achieved in this work, the sideband transitions are phonon-number-sensitive, selectively altering the phonon populations in only a few Fock states. Using these phonon-number-sensitive sideband transitions, I dissipatively stabilize the mechanical oscillator into a highly-energized sub-Poissonian state, where its energy fluctuations are below the classical limit. This result represents a major step toward the long-time ambition of accessing a broad range of nonclassical states with macroscopic mechanical oscillators. Moreover, requiring neither number-resolution nor coherent control of the qubit, the dissipative stabilization technique demonstrated in this work also provides an accessible path toward preparing nonclassical states in other harmonic oscillators coupled to qubits.

Related papers

Phonon-Number-Sensitive Electromechanics

J. J. Viennot, Xizheng Ma, Konrad W. Lehnert

We use the strong intrinsic nonlinearity of a microwave superconducting qubit with a 4 GHz transition frequency to directly detect and control the energy of a micromechanical oscillator vibrating at 25 MHz. The qubit and the oscillator are coupled electrostatically at a rate of approximately 2π×22 MHz. In this far off-resonant regime, the qubit frequency is shifted by 0.52 MHz per oscillator phonon, or about 14% of the 3.7 MHz qubit linewidth. The qubit behaves as a vibrational energy detector and from its line shape we extract the phonon number distribution of the oscillator. We manipulate this distribution by driving number state sensitive sideband transitions and creating profoundly nonthermal states. Finally, by driving the lower frequency sideband transition, we cool the oscillator and increase its ground state population up to 0.48±0.13, close to a factor of 8 above its value at thermal equilibrium. These results demonstrate a new class of electromechanics experiments that are a promising strategy for quantum nondemolition measurements and nonclassical state preparation.

arXiv:1808.02673•Physical Review Letters•Oct 29, 2018•71 citations

Phonon-number resolution of voltage-biased mechanical oscillators with weakly anharmonic superconducting circuits

Mario F. Gely, Gary Alexander Steele

Observing quantum phenomena in macroscopic objects, and the potential discovery of a fundamental limit in the applicability of quantum mechanics, has been a central topic of modern experimental physics. Highly coherent and heavy micromechanical oscillators controlled by superconducting circuits are a promising system for this task. Here we focus in particular on the electrostatic coupling of motion to a weakly anharmonic circuit, namely, the transmon qubit. In the case of a megahertz mechanical oscillator coupled to a gigahertz transmon, we explain the difficulties in bridging the large electromechanical frequency gap. To remedy this issue, we explore the requirements to reach phonon-number resolution in the resonant coupling of a megahertz transmon and a mechanical oscillator.

arXiv:2103.04829•Physical Review A•Nov 3, 2021•6 citations

Quantum acoustics with superconducting qubits

Yiwen Chu, Prashanta Kharel, William H. Renninger +4 more

Mechanical objects have important practical applications in the fields of quantum information and metrology as quantum memories or transducers for measuring and connecting different types of quantum systems. The field of electromechanics is in pursuit of a robust and highly coherent device that couples motion to nonlinear quantum objects such as superconducting qubits. Here, we experimentally demonstrate a high-frequency bulk acoustic wave resonator that is strongly coupled to a superconducting qubit using piezoelectric transduction with a cooperativity of 260. We measure qubit and mechanical coherence times on the order of 10 microseconds. Our device requires only simple fabrication methods and provides controllable access to a multitude of phonon modes. We demonstrate quantum control and measurement on gigahertz phonons at the single-quantum level.

arXiv:1703.00342•Science•Sep 22, 2017•502 citations

Interfacing Long-Lived Mechanical Oscillators and Superconducting Quantum Circuits

Alkim Bozkurt

Mechanical oscillators in the quantum regime hold promise for quantum sensing, frequency conversion and information processing. Because mechanical motion is linear, coupling to an external nonlinear system, such as a qubit, is essential for these applications. Recent advances in piezoelectric interfaces between mechanical oscillators and superconducting qubits have successfully demonstrated precise control of non-classical states of motion. However, challenges associated with heterogeneous integration of piezoelectric materials have limited mechanical quality factors in these systems to around one million, constraining their broader utility. In this thesis, we explore an alternative approach that harnesses the nonlinearity of electrostatic forces to engineer interactions between superconducting circuits and mechanical oscillators. This strategy allows us to employ mechanical oscillators made of silicon, a non-piezoelectric material with extremely low acoustic loss. We reach the strong coupling regime between a superconducting qubit and a long-lived mechanical oscillator with a quality-factor of around a billion. We employ this system to generate non-classical states of motion that exhibit clear signatures of quantum behavior. Furthermore, we explore the origins of acoustic decoherence and implement strategies to mitigate its impact. The mechanical lifetimes, which exceed those of best superconducting qubits, open new possibilities for storing and processing microwave quantum information in motional states. Furthermore, our material-agnostic approach is broadly applicable to a variety of material platforms that possess significance for quantum science but lack a piezoelectric response.

•Jan 27, 2026•0 citations

Quantum squeezing in a nonlinear mechanical oscillator

Stefano Marti, Uwe von Lüpke, Om Joshi +5 more

Abstract Mechanical degrees of freedom are natural candidates for continuous-variable quantum information processing and bosonic quantum simulations. However, these applications require the engineering of squeezing and nonlinearities in the quantum regime. Here we demonstrate squeezing below the zero-point fluctuations of a gigahertz-frequency mechanical resonator coupled to a superconducting qubit. This is achieved by parametrically driving the qubit, which results in an effective two-phonon drive. In addition, we show that the resonator mode inherits a nonlinearity from the off-resonant coupling with the qubit, which can be tuned by controlling the detuning. We, thus, realize a mechanical squeezed Kerr oscillator, in which we demonstrate the preparation of non-Gaussian quantum states of motion with Wigner function negativities and high quantum Fisher information. This shows that our results can also have applications in quantum metrology and sensing.

arXiv:2312.16169•Nature Physics•Jun 21, 2024•71 citations

Creating arbitrary quantum vibrational states in a carbon nanotube

Heng Wang, Guido Burkard

Due to their small mass and large mechanical stiffness, free-standing carbon nanotubes turn out to be superb high-frequency mechanical resonators that could find applications in mass and force sensing. With resonance frequencies up to the gigahertz regime, one can envision cooling the mechanical motion of such nanotubes to its quantum mechanical ground state at cryogenic temperatures. This opens the possibility to generate highly nonclassical states of the mechanical motion, similar to those created several years ago with electromagnetic radiation in superconducting microwave resonators. Such states are interesting from a fundamental physics point of view, but potentially also for quantum information and sensing applications. While classical activation of a harmonic oscillator will always produce ``quasiclassical'' coherent states, a necessary ingredient for the production of nonclassical states such as Fock states is a nonlinear element, e.g., superconducting qubits in the case of microwaves. This work predicts that for mechanical oscillations, the spin-orbit coupling of the mechanical motion to a single localized electron spin can do the trick by acting as a nonlinear element for phonons.

arXiv:1608.03068•Physical review. B./Physical review. B•Nov 10, 2016•6 citations
The ability to access a broad range of quantum states with mechanical oscillators has many applications and is an enduring ambition in the fields of opto- and electromechanics. However, as mechanical oscillators are linear at the quantum scale, arbitrary quantum control over them requires an extrinsic nonlinearity. In this thesis, I aim to provide this extrinsic nonlinearity and establish quantum control over the motion of a suspended aluminum disk by coupling it strongly to a superconducting qubit. To this end, I design and fabricate a device, when operated at its maximum coupling strength, could enable phonon-number-resolved measurements and arbitrary quantum control over the mechanical motion. However, limited by unclear reasons that break the qubit readout, I operate at approximately a quarter of the maximum coupling strength. Nevertheless, at this smaller coupling strength, I demonstrate the preparation of a non-Gaussian nonclassical state of motion.Because of the large coupling achieved in this work, the sideband transitions are phonon-number-sensitive, selectively altering the phonon populations in only a few Fock states. Using these phonon-number-sensitive sideband transitions, I dissipatively stabilize the mechanical oscillator into a highly-energized sub-Poissonian state, where its energy fluctuations are below the classical limit. This result represents a major step toward the long-time ambition of accessing a broad range of nonclassical states with macroscopic mechanical oscillators. Moreover, requiring neither number-resolution nor coherent control of the qubit, the dissipative stabilization technique demonstrated in this work also provides an accessible path toward preparing nonclassical states in other harmonic oscillators coupled to qubits.
We use the strong intrinsic nonlinearity of a microwave superconducting qubit with a 4 GHz transition frequency to directly detect and control the energy of a micromechanical oscillator vibrating at 25 MHz. The qubit and the oscillator are coupled electrostatically at a rate of approximately 2π×22 MHz. In this far off-resonant regime, the qubit frequency is shifted by 0.52 MHz per oscillator phonon, or about 14% of the 3.7 MHz qubit linewidth. The qubit behaves as a vibrational energy detector and from its line shape we extract the phonon number distribution of the oscillator. We manipulate this distribution by driving number state sensitive sideband transitions and creating profoundly nonthermal states. Finally, by driving the lower frequency sideband transition, we cool the oscillator and increase its ground state population up to 0.48±0.13, close to a factor of 8 above its value at thermal equilibrium. These results demonstrate a new class of electromechanics experiments that are a promising strategy for quantum nondemolition measurements and nonclassical state preparation.
Observing quantum phenomena in macroscopic objects, and the potential discovery of a fundamental limit in the applicability of quantum mechanics, has been a central topic of modern experimental physics. Highly coherent and heavy micromechanical oscillators controlled by superconducting circuits are a promising system for this task. Here we focus in particular on the electrostatic coupling of motion to a weakly anharmonic circuit, namely, the transmon qubit. In the case of a megahertz mechanical oscillator coupled to a gigahertz transmon, we explain the difficulties in bridging the large electromechanical frequency gap. To remedy this issue, we explore the requirements to reach phonon-number resolution in the resonant coupling of a megahertz transmon and a mechanical oscillator.
Mechanical objects have important practical applications in the fields of quantum information and metrology as quantum memories or transducers for measuring and connecting different types of quantum systems. The field of electromechanics is in pursuit of a robust and highly coherent device that couples motion to nonlinear quantum objects such as superconducting qubits. Here, we experimentally demonstrate a high-frequency bulk acoustic wave resonator that is strongly coupled to a superconducting qubit using piezoelectric transduction with a cooperativity of 260. We measure qubit and mechanical coherence times on the order of 10 microseconds. Our device requires only simple fabrication methods and provides controllable access to a multitude of phonon modes. We demonstrate quantum control and measurement on gigahertz phonons at the single-quantum level.
Mechanical oscillators in the quantum regime hold promise for quantum sensing, frequency conversion and information processing. Because mechanical motion is linear, coupling to an external nonlinear system, such as a qubit, is essential for these applications. Recent advances in piezoelectric interfaces between mechanical oscillators and superconducting qubits have successfully demonstrated precise control of non-classical states of motion. However, challenges associated with heterogeneous integration of piezoelectric materials have limited mechanical quality factors in these systems to around one million, constraining their broader utility. In this thesis, we explore an alternative approach that harnesses the nonlinearity of electrostatic forces to engineer interactions between superconducting circuits and mechanical oscillators. This strategy allows us to employ mechanical oscillators made of silicon, a non-piezoelectric material with extremely low acoustic loss. We reach the strong coupling regime between a superconducting qubit and a long-lived mechanical oscillator with a quality-factor of around a billion. We employ this system to generate non-classical states of motion that exhibit clear signatures of quantum behavior. Furthermore, we explore the origins of acoustic decoherence and implement strategies to mitigate its impact. The mechanical lifetimes, which exceed those of best superconducting qubits, open new possibilities for storing and processing microwave quantum information in motional states. Furthermore, our material-agnostic approach is broadly applicable to a variety of material platforms that possess significance for quantum science but lack a piezoelectric response.
Abstract Mechanical degrees of freedom are natural candidates for continuous-variable quantum information processing and bosonic quantum simulations. However, these applications require the engineering of squeezing and nonlinearities in the quantum regime. Here we demonstrate squeezing below the zero-point fluctuations of a gigahertz-frequency mechanical resonator coupled to a superconducting qubit. This is achieved by parametrically driving the qubit, which results in an effective two-phonon drive. In addition, we show that the resonator mode inherits a nonlinearity from the off-resonant coupling with the qubit, which can be tuned by controlling the detuning. We, thus, realize a mechanical squeezed Kerr oscillator, in which we demonstrate the preparation of non-Gaussian quantum states of motion with Wigner function negativities and high quantum Fisher information. This shows that our results can also have applications in quantum metrology and sensing.
Due to their small mass and large mechanical stiffness, free-standing carbon nanotubes turn out to be superb high-frequency mechanical resonators that could find applications in mass and force sensing. With resonance frequencies up to the gigahertz regime, one can envision cooling the mechanical motion of such nanotubes to its quantum mechanical ground state at cryogenic temperatures. This opens the possibility to generate highly nonclassical states of the mechanical motion, similar to those created several years ago with electromagnetic radiation in superconducting microwave resonators. Such states are interesting from a fundamental physics point of view, but potentially also for quantum information and sensing applications. While classical activation of a harmonic oscillator will always produce ``quasiclassical'' coherent states, a necessary ingredient for the production of nonclassical states such as Fock states is a nonlinear element, e.g., superconducting qubits in the case of microwaves. This work predicts that for mechanical oscillations, the spin-orbit coupling of the mechanical motion to a single localized electron spin can do the trick by acting as a nonlinear element for phonons.