Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Pan Stanford Publishing eBooks

Low-Noise Current Measurements on Quantum Devices Operating at Cryogenic Temperature

Filippo Guagliardo, Giorgio Ferrari

Published Apr 17, 2013• 3 citations
Publisher
DOI
10.1201/b14792-9

Related papers

Fabrication and low-temperature measurement of quantum devices

Dublin M. Nichols

•May 10, 2019•0 citations

System for measuring auto- and cross correlation of current noise at low temperatures

L. DiCarlo, Y. Zhang, Douglas McClure +3 more

We describe the construction and operation of a two-channel noise detection system for measuring power and cross spectral densities of current fluctuations near 2MHz in electronic devices at low temperatures. The system employs cryogenic amplification and fast Fourier transform based spectral measurement. The gain and electron temperature are calibrated using Johnson noise thermometry. Full shot noise of 100pA can be resolved with an integration time of 10s. We report a demonstration measurement of bias-dependent current noise in a gate defined GaAs∕AlGaAs quantum point contact.

arXiv:cond-mat/0604018•Review of Scientific Instruments•Jul 1, 2006•79 citations

Design and Analysis on a Cryogenic Current Amplifier with a Superconducting Microwave Resonator

Yuma Okazaki, Nobu‐Hisa Kaneko

We propose a new type of cryogenic current amplifiers, in which low-frequency power spectrum of current can be measured through a measurement of microwave response of a superconducting resonant circuit shunted by a series array of Josephson junctions. From numerical analysis on the equivalent circuit, the numerical value of the input-referred current noise of the proposed amplifier is found to be two orders of magnitude lower than the noise floor measured with the conventional cryogenic current amplifiers based on high-electron-mobility transistors or superconducting quantum interference devices. Our proposal can open new avenues for investigating low-temperature solid-state devices that require lower noise and wider bandwidth power spectrum measurements of current.

arXiv:1508.03131•IEEE International Superconductive Electronics Conference (ISEC)•Jul 1, 2015•0 citations

PROPERTIES OF LOW TEMPERATURE QUANTUM NOISE

Roland Jung, Gert‐Ludwig Ingold, Peter SCHRAMM +1 more

Elsevier eBooks•Jan 1, 1986•0 citations

A Low‐Power Cryogenic Low‐Noise Amplifier for the Next‐Generation Quantum Computers

Nelson Rebelo, Johan Bergsten, Arsalan Pourkabirian +2 more

Next generation of quantum computers calls for reduced dc power dissipation of the cryogenic low‐noise amplifier (LNA) applied in reading out the superconducting qubits. This article reports on processing and evaluation of a 100‐nm gate length indium phosphide high electron mobility transistor (InP HEMT) technology used in the design of such LNAs. InP HEMTs with size of 4 × 50 µm were measured on‐wafer by DC and S‐parameter characterization. Device noise performance was indirectly evaluated by measuring and modeling the gain and noise of a three‐stage hybrid 4–8 GHz cryogenic LNA equipped with the InP HEMTs. When operating the LNA at a DC power of 2.1 mW, the InP HEMT LNA average noise temperature was 1.4 K with an average gain of 41.6 dB. The minimum noise temperature of the InP HEMT was estimated to be 1.1 K at 6 GHz. The performance achieved for the InP HEMT LNA is comparable to the LNAs currently used in quantum computing while requiring only 27% of the DC power consumption. Small‐signal modeling of the InP HEMT suggested that this was due to a low output conductance associated with a large gate‐recess length used in device fabrication.

physica status solidi (a)•May 23, 2026•1 citation

Noise in quantum devices

E. S. R. Gopal

IEE-IERE Proceedings - India•Jan 1, 1972•0 citations
We describe the construction and operation of a two-channel noise detection system for measuring power and cross spectral densities of current fluctuations near 2MHz in electronic devices at low temperatures. The system employs cryogenic amplification and fast Fourier transform based spectral measurement. The gain and electron temperature are calibrated using Johnson noise thermometry. Full shot noise of 100pA can be resolved with an integration time of 10s. We report a demonstration measurement of bias-dependent current noise in a gate defined GaAs∕AlGaAs quantum point contact.
We propose a new type of cryogenic current amplifiers, in which low-frequency power spectrum of current can be measured through a measurement of microwave response of a superconducting resonant circuit shunted by a series array of Josephson junctions. From numerical analysis on the equivalent circuit, the numerical value of the input-referred current noise of the proposed amplifier is found to be two orders of magnitude lower than the noise floor measured with the conventional cryogenic current amplifiers based on high-electron-mobility transistors or superconducting quantum interference devices. Our proposal can open new avenues for investigating low-temperature solid-state devices that require lower noise and wider bandwidth power spectrum measurements of current.
Next generation of quantum computers calls for reduced dc power dissipation of the cryogenic low‐noise amplifier (LNA) applied in reading out the superconducting qubits. This article reports on processing and evaluation of a 100‐nm gate length indium phosphide high electron mobility transistor (InP HEMT) technology used in the design of such LNAs. InP HEMTs with size of 4 × 50 µm were measured on‐wafer by DC and S‐parameter characterization. Device noise performance was indirectly evaluated by measuring and modeling the gain and noise of a three‐stage hybrid 4–8 GHz cryogenic LNA equipped with the InP HEMTs. When operating the LNA at a DC power of 2.1 mW, the InP HEMT LNA average noise temperature was 1.4 K with an average gain of 41.6 dB. The minimum noise temperature of the InP HEMT was estimated to be 1.1 K at 6 GHz. The performance achieved for the InP HEMT LNA is comparable to the LNAs currently used in quantum computing while requiring only 27% of the DC power consumption. Small‐signal modeling of the InP HEMT suggested that this was due to a low output conductance associated with a large gate‐recess length used in device fabrication.