Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEE-IERE Proceedings - India

Noise in quantum devices

E. S. R. Gopal

Published Jan 1, 1972• 0 citations
Publisher
DOI
10.1049/iipi.1972.0017

Related papers

Noise of Quantum-Mechanical Amplifiers

M. W. P. Strandberg

Physical Review•Sep 15, 1957•7 citations

A deep learning model for noise prediction on near-term quantum devices

Alexander Zlokapa, Alexandru Gheorghiu

We present an approach for a deep-learning compiler of quantum circuits, designed to reduce the output noise of circuits run on a specific device. We train a convolutional neural network on experimental data from a quantum device to learn a hardware-specific noise model. A compiler then uses the trained network as a noise predictor and inserts sequences of gates in circuits so as to minimize expected noise. We tested this approach on the IBM 5-qubit devices and observed a reduction in output noise of 12.3% (95% CI [11.5%, 13.0%]) compared to the circuits obtained by the Qiskit compiler. Moreover, the trained noise model is hardware-specific: applying a noise model trained on one device to another device yields a noise reduction of only 5.2% (95% CI [4.9%, 5.6%]). These results suggest that device-specific compilers using machine learning may yield higher fidelity operations and provide insights for the design of noise models.

arXiv:2005.10811•May 21, 2020•55 citations

Towards noise engineering: Recent insights in low-frequency excess flux noise of superconducting quantum devices

Sebastian Kempf, Anna Ferring, C. Enss

The comprehensive analysis of low-frequency excess flux noise both in terms of magnetic flux noise SΦ,1/f and energy sensitivity ϵ1∕f of 84 superconducting quantum devices studied at temperatures below 1 K reveals a universal behavior. When analyzing data in terms of ϵ1∕f, we find that noise spectra of independent devices cross each other all at certain crossing frequencies fc. Besides this main result of our paper, we further show that superconducting quantum interference device (SQUID) arrays systematically feature higher noise exponents than single SQUIDs and give evidence for a material and device type dependence of low-frequency excess flux noise. The latter results facilitate to engineer the shape of magnetic flux noise spectra and thus to experimentally modify key properties such as coherence or measurement times of superconducting quantum devices.

Applied Physics Letters•Oct 17, 2016•7 citations

Radiation and noise in quantum electronics

William H. Louisell

•Jan 1, 1964•344 citations

Quantum Noise in Conventional Optical Heterodyne Devices

Dechao He, Boya Xie, Xiao, Yu +1 more

By invoking the quantum theory of optical coherence, we theoretically show that the quantum noise in conventional optical heterodyne devices, which were previously identified as usual phase-insensitive amplifiers with additional quantum noise, is similar to that in optical homodyne devices, as verified by experimental data. Albeit more study is demanded to understand this result, it is certain that neither the uncertainty principle nor Caves's theorem for quantum noise of linear amplifiers sets a limit to the quantum noise of heterodyne devices.

arXiv:1301.4787•Jan 21, 2013•0 citations

Device-Agnostic Microwave Noise Metrology for Nonlinear Cryogenic Quantum Devices

Andrea Celotto, Alessandro Alocco, Bernardo Galvano +6 more

Microwave devices capable of near-quantum-limited signal processing are essential components in the toolbox of solid-state quantum technologies. The manipulation and readout of single-photon microwave signals through amplifiers, mixers, isolators, etc. must fulfill strict requirements in terms of signal integrity to ensure reliable operation. These active microwave quantum devices operate in complex cryo-electronic setups. This poses challenges to their characterization, since all relevant figures of merit must be expressed at the reference planes of their ports. Even though cryogenic S-parameter calibration is non-trivial, metrological approaches are converging toward rigorous methods. Furthermore, preserving signal integrity must be quantified via absolute noise levels at the ports of the Device Under Test (DUT), requiring an absolute power reference. In this work, we present an in situ noise metrology protocol based on substituting a controllable noise source for the DUT. We motivate this choice by showing that placing the noise source at the DUT input impacts the separability of the calibration from the DUT characteristics. Our proposed architecture combines Planck spectroscopy using a Variable Temperature Stage with Short-Open-Load-Reciprocal scattering-parameter calibration, so that noise and scattering quantities are referred to the same cryogenic reference planes. In this configuration, the readout-chain calibration is separated from the internal dynamics of the DUT. As a demanding use case, we apply the protocol to a Josephson Traveling Wave Parametric Amplifier and extract its gain and input-referred added noise under pump conditions activating multimode nonlinear behavior. This illustrates how our device-agnostic protocol supports portable noise characterization of nonlinear cryogenic microwave devices.

quant-pharXiv:2605.28808•May 28, 2026•1 citation
We present an approach for a deep-learning compiler of quantum circuits, designed to reduce the output noise of circuits run on a specific device. We train a convolutional neural network on experimental data from a quantum device to learn a hardware-specific noise model. A compiler then uses the trained network as a noise predictor and inserts sequences of gates in circuits so as to minimize expected noise. We tested this approach on the IBM 5-qubit devices and observed a reduction in output noise of 12.3% (95% CI [11.5%, 13.0%]) compared to the circuits obtained by the Qiskit compiler. Moreover, the trained noise model is hardware-specific: applying a noise model trained on one device to another device yields a noise reduction of only 5.2% (95% CI [4.9%, 5.6%]). These results suggest that device-specific compilers using machine learning may yield higher fidelity operations and provide insights for the design of noise models.
The comprehensive analysis of low-frequency excess flux noise both in terms of magnetic flux noise SΦ,1/f and energy sensitivity ϵ1∕f of 84 superconducting quantum devices studied at temperatures below 1 K reveals a universal behavior. When analyzing data in terms of ϵ1∕f, we find that noise spectra of independent devices cross each other all at certain crossing frequencies fc. Besides this main result of our paper, we further show that superconducting quantum interference device (SQUID) arrays systematically feature higher noise exponents than single SQUIDs and give evidence for a material and device type dependence of low-frequency excess flux noise. The latter results facilitate to engineer the shape of magnetic flux noise spectra and thus to experimentally modify key properties such as coherence or measurement times of superconducting quantum devices.
By invoking the quantum theory of optical coherence, we theoretically show that the quantum noise in conventional optical heterodyne devices, which were previously identified as usual phase-insensitive amplifiers with additional quantum noise, is similar to that in optical homodyne devices, as verified by experimental data. Albeit more study is demanded to understand this result, it is certain that neither the uncertainty principle nor Caves's theorem for quantum noise of linear amplifiers sets a limit to the quantum noise of heterodyne devices.
Microwave devices capable of near-quantum-limited signal processing are essential components in the toolbox of solid-state quantum technologies. The manipulation and readout of single-photon microwave signals through amplifiers, mixers, isolators, etc. must fulfill strict requirements in terms of signal integrity to ensure reliable operation. These active microwave quantum devices operate in complex cryo-electronic setups. This poses challenges to their characterization, since all relevant figures of merit must be expressed at the reference planes of their ports. Even though cryogenic S-parameter calibration is non-trivial, metrological approaches are converging toward rigorous methods. Furthermore, preserving signal integrity must be quantified via absolute noise levels at the ports of the Device Under Test (DUT), requiring an absolute power reference. In this work, we present an in situ noise metrology protocol based on substituting a controllable noise source for the DUT. We motivate this choice by showing that placing the noise source at the DUT input impacts the separability of the calibration from the DUT characteristics. Our proposed architecture combines Planck spectroscopy using a Variable Temperature Stage with Short-Open-Load-Reciprocal scattering-parameter calibration, so that noise and scattering quantities are referred to the same cryogenic reference planes. In this configuration, the readout-chain calibration is separated from the internal dynamics of the DUT. As a demanding use case, we apply the protocol to a Josephson Traveling Wave Parametric Amplifier and extract its gain and input-referred added noise under pump conditions activating multimode nonlinear behavior. This illustrates how our device-agnostic protocol supports portable noise characterization of nonlinear cryogenic microwave devices.