Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Symposium on Frequency Standards and Metrology

CHARACTERIZATION OF A COLD ATOM GYROSCOPE

Arnaud Landragin, A. Gauguet, Thomas Lévèque, Walid Chaibi

Published May 1, 2009• 0 citations
Publisher

Abstract

We present the evaluation of the performances of our cold atom gyroscope. The gyroscope is based on two cold Cesium atom sources, which are manipulated thanks to Raman transitions. We show that the short term sensitivity is limited by the quantum projection noise and the long term sensitivity by wave front distortion of the Raman lasers. A study of the bias and scaling factor completes the characterization of the sensor.

DOI
10.1142/9789812838223_0063

Related papers

Characterization and limits of a cold-atom Sagnac interferometer

A. Gauguet, B. Canuel, Thomas Lévèque +2 more

We present the full evaluation of a cold-atom gyroscope based on atom interferometry. We have performed extensive studies to determine the systematic errors, scale factor and sensitivity. We demonstrate that the acceleration noise can be efficiently removed from the rotation signal, allowing us to reach the fundamental limit of the quantum projection noise for short term measurements. The technical limits to the long term sensitivity and accuracy have been identified, clearing the way for the next generation of ultrasensitive atom gyroscopes.

arXiv:0907.2580•Physical Review A•Dec 1, 2009•220 citations

High-performance gyroscope for rotational seismology.

Nathan Marliere, Mohamed Guessoum, Rémi Geiger +1 more

The Sagnac effect is at the heart of the modern precision inertial sensors. An interferometer with a physical area, when spun, exhibits a phase shift atits output. Measuring this phase-shift leads to a direct measurement of the rotation rate.The SYRTE dual-axis cold-atom gyroscope represents the state-of-art of atomic gyroscopes. With its large physical area (11cm2) and a long interrogation time of 800 ms, it offers both the sensitivity and stability 3 × 10^10 rad.s−1 to push the Sagnac measurement to an unprecedented accuracy level. Demonstrating such performance required the control and characterization of the experimental parameters and systematic effects and the precise knowledge of the scale factor. The cold-atom gyroscope experiment is based on atomic interferometry, where cooled Cesium-atoms (2μK) are launched vertically (∼ 5m/s) to be interrogated with a sequence of four Raman pulses (allowing an internal and external control over atomic states). The pulses play the role of atomic optics by splitting and guiding the matter-waves along the arms of the interferometer. By the end, transition probability measurement gives access to the phase-shift induced by rotation.I will present our recent work done to develop new methods that will improve the gyroscope sensitivity. The Double diffraction, atom diffraction inboth ±¯h⃗keff directions, should enables a measurement setup with no dead time based on the use of two correlated interleaved interferometers. Thus, the vibration and rotation noises that limits the sensitivity should average to achieve the detection noise, targeting the standard quantum projection noise.

•Sep 5, 2023•0 citations

Limits on the sensitivity of a cold atom interferometry gyroscope

Wenjie Xu, Lele Chen, Ming-Jie Nie +2 more

We present a precision atom interferometry gyroscope with a Sagnac area of 6.0 cm 2 . To drive the cold atom interferometry gyroscope, we utilize two sets of Raman beams with a pulse sequence of π /2- π - π - π /2. We present a procedure for aligning the two sets of Raman beams at the microradian level by making use of the atom interferometer itself in different configurations. Additionally, we measured the atomic cloud trajectory and implemented a spatial symmetry alignment for the atom interferometer. With these improvements, we construct a sensitive atom gyroscope with a stability of 1 nrad/s at an integration time of 10000 s. We analyzed the influence of Raman beams and the limitations of the system, and present the technical limits to the sensitivity and long-term stability. Finally, we point out the primary sources of noise in the atom interferometry gyroscope, clearing the way for the construction of further large-area atom gyroscopes.

Optics Express•Oct 28, 2024•7 citations

Dual-atomic-beam matter-wave gyroscope

T. L. Gustavson, Philippe Bouyer, Mark A. Kasevich

We report improvements to our atom-interferometer based Sagnac gyroscope which uses stimulated Raman transitions to manipulate atomic wavepackets of cesium atoms. Using counter-propagating high-flux atomic beams, we form two interferometers with opposite Sagnac phase shifts that share key components such as Raman atomic state manipulation beams. Subtracting the two interferometer signals allows the common-mode rejection of spurious noise sources and various systematic effects. Preliminary results indicate a short term sensitivity of 3 X 10-9 (rad/s) (root) Hz.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•May 15, 1998•15 citations

CONSTRUCTION AND CHARACTERIZATION OF A DUAL ATOMIC BEAM ACCELEROMETER/GYROSCOPE

Michael Manicchia

Current sensors used for inertial navigation are based on technology with inherent sensitivity limitations. Atom interferometry is a very promising replacement, which could yield many orders of magnitude of improvement in sensitivity, leading to more accurate navigation over longer periods of time relative to current technology. This research investigates the physics of atom interferometry through the construction and characterization of an atomic accelerometer/gyroscope combination. In contrast to current state-of-the-art atomic sensors, which use pulsed cold atom sources and pulsed laser beams, the apparatus investigated relies purely on continuous atomic and laser beams. These differences would result in a sensor that lends itself more readily to smaller sizing, lower power consumption, and reduced complexity. This change in approach to atomic interferometry also introduces challenges resulting from laser and atomic beam divergences and the velocity averaging due to both longitudinal and transverse temperature, which this dissertation shows how to overcome. The work contained herein explores many stages of construction of an atomic gyro including the demonstration and characterization of two-dimensional laser cooling of atoms, stimulated Raman transitions, and Ramsey and spin echo interference. The implications for future research are also outlined and discussed.

•Jun 1, 2020•1 citation

Performance of a point source atom interferometer gyroscope

Azure Hansen, Yun Chen, M. Shuker +6 more

Point source atom interferometry, employing optical Raman pulses and a cold atom source, enables measurements of rotation and acceleration in a compact experimental package. This system is uniquely sensitive to rotations in the plane perpendicular to the Raman beamline. Here we discuss our experiment’s sensitivity, stability, systematic errors, and other performance-limiting factors both fundamentaland technical. Our current measurements for the sensitivity to the magnitude and direction of the rotation vector are 0.6 mrad/s and 5 mrad, respectively.

•Apr 14, 2019•0 citations
We present the evaluation of the performances of our cold atom gyroscope. The gyroscope is based on two cold Cesium atom sources, which are manipulated thanks to Raman transitions. We show that the short term sensitivity is limited by the quantum projection noise and the long term sensitivity by wave front distortion of the Raman lasers. A study of the bias and scaling factor completes the characterization of the sensor.
We present the full evaluation of a cold-atom gyroscope based on atom interferometry. We have performed extensive studies to determine the systematic errors, scale factor and sensitivity. We demonstrate that the acceleration noise can be efficiently removed from the rotation signal, allowing us to reach the fundamental limit of the quantum projection noise for short term measurements. The technical limits to the long term sensitivity and accuracy have been identified, clearing the way for the next generation of ultrasensitive atom gyroscopes.
The Sagnac effect is at the heart of the modern precision inertial sensors. An interferometer with a physical area, when spun, exhibits a phase shift atits output. Measuring this phase-shift leads to a direct measurement of the rotation rate.The SYRTE dual-axis cold-atom gyroscope represents the state-of-art of atomic gyroscopes. With its large physical area (11cm2) and a long interrogation time of 800 ms, it offers both the sensitivity and stability 3 × 10^10 rad.s−1 to push the Sagnac measurement to an unprecedented accuracy level. Demonstrating such performance required the control and characterization of the experimental parameters and systematic effects and the precise knowledge of the scale factor. The cold-atom gyroscope experiment is based on atomic interferometry, where cooled Cesium-atoms (2μK) are launched vertically (∼ 5m/s) to be interrogated with a sequence of four Raman pulses (allowing an internal and external control over atomic states). The pulses play the role of atomic optics by splitting and guiding the matter-waves along the arms of the interferometer. By the end, transition probability measurement gives access to the phase-shift induced by rotation.I will present our recent work done to develop new methods that will improve the gyroscope sensitivity. The Double diffraction, atom diffraction inboth ±¯h⃗keff directions, should enables a measurement setup with no dead time based on the use of two correlated interleaved interferometers. Thus, the vibration and rotation noises that limits the sensitivity should average to achieve the detection noise, targeting the standard quantum projection noise.
We present a precision atom interferometry gyroscope with a Sagnac area of 6.0 cm 2 . To drive the cold atom interferometry gyroscope, we utilize two sets of Raman beams with a pulse sequence of π /2- π - π - π /2. We present a procedure for aligning the two sets of Raman beams at the microradian level by making use of the atom interferometer itself in different configurations. Additionally, we measured the atomic cloud trajectory and implemented a spatial symmetry alignment for the atom interferometer. With these improvements, we construct a sensitive atom gyroscope with a stability of 1 nrad/s at an integration time of 10000 s. We analyzed the influence of Raman beams and the limitations of the system, and present the technical limits to the sensitivity and long-term stability. Finally, we point out the primary sources of noise in the atom interferometry gyroscope, clearing the way for the construction of further large-area atom gyroscopes.
We report improvements to our atom-interferometer based Sagnac gyroscope which uses stimulated Raman transitions to manipulate atomic wavepackets of cesium atoms. Using counter-propagating high-flux atomic beams, we form two interferometers with opposite Sagnac phase shifts that share key components such as Raman atomic state manipulation beams. Subtracting the two interferometer signals allows the common-mode rejection of spurious noise sources and various systematic effects. Preliminary results indicate a short term sensitivity of 3 X 10-9 (rad/s) (root) Hz.
Current sensors used for inertial navigation are based on technology with inherent sensitivity limitations. Atom interferometry is a very promising replacement, which could yield many orders of magnitude of improvement in sensitivity, leading to more accurate navigation over longer periods of time relative to current technology. This research investigates the physics of atom interferometry through the construction and characterization of an atomic accelerometer/gyroscope combination. In contrast to current state-of-the-art atomic sensors, which use pulsed cold atom sources and pulsed laser beams, the apparatus investigated relies purely on continuous atomic and laser beams. These differences would result in a sensor that lends itself more readily to smaller sizing, lower power consumption, and reduced complexity. This change in approach to atomic interferometry also introduces challenges resulting from laser and atomic beam divergences and the velocity averaging due to both longitudinal and transverse temperature, which this dissertation shows how to overcome. The work contained herein explores many stages of construction of an atomic gyro including the demonstration and characterization of two-dimensional laser cooling of atoms, stimulated Raman transitions, and Ramsey and spin echo interference. The implications for future research are also outlined and discussed.
Point source atom interferometry, employing optical Raman pulses and a cold atom source, enables measurements of rotation and acceleration in a compact experimental package. This system is uniquely sensitive to rotations in the plane perpendicular to the Raman beamline. Here we discuss our experiment’s sensitivity, stability, systematic errors, and other performance-limiting factors both fundamentaland technical. Our current measurements for the sensitivity to the magnitude and direction of the rotation vector are 0.6 mrad/s and 5 mrad, respectively.