Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

International Conference on Microwaves, Radar & Wireless Communications

Millimeter and submillimeter wave mixers based on superconducting weak links

Janusz Konopka, I. Wolff

Published Nov 27, 2002• 0 citations
Publisher

Abstract

Principles of operation of superconducting mixers based on: Superconductor-Insulator-Superconductor (SIS) tunnel junctions, Josephson junctions in high temperature superconductors and on superconducting hot-electron-microbolometers are presented. Most recent results on all types of superconducting mixers, with special attention paid to noise properties is reviewed.

DOI
10.1109/mikon.1998.738477

Related papers

Low-Noise Superconducting Mixers for the Terahertz Frequency Range

Victor Y. Belitsky, Serguei Cherednichenko, Dag Winkler

This chapter discusses the high sensitivity superconducting mixers, i.e. detectors used in heterodyne receivers. Today, there are essentially two very successful concepts of superconducting mixers, or frequency down-converters, the superconductor-insulator-superconductor tunnel junction SIS mixer and the superconducting hot-electron bolometer mixer. Moving up to higher frequencies in the microwave and millimeter wave electromagnetic spectra makes it more and more difficult to retrieve a good signal-to-noise ratio with ordinary solid-state amplifiers. The driving force for using superconducting mixers is their excellent down-conversion efficiency and capability to down-convert RF signals from microwave frequencies up to the terahertz region. The main purpose of a receiver is to pick up and amplify a weak signal, which can then be accurately determined in amplitude and phase. The mixer noise temperature and conversion gain are the most important parameters for the mixing device. The Josephson junction mixer was one of the first suggested devices based on superconducting point contacts and later tunnel junctions.

CRC Press eBooks•May 17, 2022•1 citation

Millimeter and submillimeter wave detection and mixing with superconducting weak links

P. L. Richards, F. Auracher, T. Van Duzer

A weak link between two bulk superconductors can exhibit Josephson effects and can be used as a fast sensitive detector or mixer for electromagnetic radiation. Emphasis is placed on the millimeter and submillimeter range where such applications are potentially most important, though such devices should also work well at lower frequencies. The peculiar properties of the weak link make possible a variety of modes of operation including one in which it is both local oscillator and mixer. These modes of operation are analyzed and the pivotal experiments are reviewed. Noise and impedance matching are considered and comparison is made with other types of detectors of millimeter and submillimeter waves.

Proceedings of the IEEE•Jan 1, 1973•41 citations

Design considerations for high-gain SIS mixers

Larry R. D’Addario, Michael W. Cromar, F L Lloyd

It has been shown both theoretically [1] and experimentally [2,3] that the very sharp nonlinearity in the conductance of superconducting tunnel junctions can be used to implement millimeter wavelength mixers having high gain and very low noise, leading to the possibility of receivers that achieve the quantum noise limit. The junctions involved contain a thin insulating barrier between two superconductors, and are thus known as superconductor-insulator-superconductor (SIS) junctions. They are physically identical to Josephson junctions, but in this application the conductance is via the tunneling of quasiparticles (unpaired electrons), and so the Josephson effect is not involved.

International Conference on Infrared, Millimeter, and Terahertz Waves (IRMMW-THz)•Dec 1, 1985•0 citations

Millimeter wave superconducting receivers

Qing Hu, C. A. Mears, P. L. Richards

Recent work done at Berkeley on the development of millimeter-wave heterodyne mixers using superconductor-insulator-superconductor (SIS) junctions is reviewed. Two types of mixers have been developed; a conventional waveguide system using a resonant cavity and an open-structure quasioptical system using planar antennas and lenses. Using the waveguide system, the lowest mixer noise level yet obtained (within 25% of the quantum limit) at 95 GHz has been achieved. The quasioptical system has achieved a good mixer performance up to 200 GHz, and it has shown promise for use at submillimeter wavelengths.>

IEEE MTT-S International Microwave Symposium digest•Dec 9, 2002•0 citations

Superconductive devices for millimeter wave detection, mixing, and amplification

P. L. Richards, Tek-Ming Shen

Single-particle (quasi-particle) tunneling through an insulating barrier between two superconductors or between a superconductor and a normal conductor is being used to make very-low-noise detectors and mixers for millimeter wavelengths. The nonlinearity of theI-Vcurve obtained from tunneling between two superconductors can be so strong that classical theory breaks down and photon-assisted tunneling theory must be used to understand device performance. Quantum theory predicts that a quasi-particle tunnel junction can be operated as a microwave photon detector with quantum efficiency close to unity or as a heterodyne mixer with conversion gain and with mixer noise temperature comparable with the quantum noise limitT_{M} =\bar{h}\omega/k. Both of these predictions have been experimentally realized at 36 GHz using superconductor-insulator-superconductor (SIS) junctions. It appears probable that these quasi-particle detectors and mixers will supercede the corresponding Josephson-effect devices at millimeter wavelengths.

IEEE Transactions on Electron Devices•Oct 1, 1980•61 citations

Theoretical SIS mixer research

M. J. Feldman

Theoretical research has been conducted to elucidate the basic physics behind the properties of superconductor-insulator-superconductor (SIS) tunnel junction receiving devices. The properties of SIS mixers using nonideal junctions and finite LO power, were determined by analytic expansion of the equations of the quantum theory of mixing, and also by computer simulations of SIS receivers over the entire range of experimental parameters. The result is a new coherent and intuitive picture of SIS mixer behavior. Many of the outstanding mysteries and questions about SIS receivers are resolved, and this contributes greatly to the design and interpretation of SIS mixer experiments. Other calculations show how to achieve sub-quantum noise temperatures in the phase sensitive SIS mixer, an important step towards realization of ultra-low- noise detectors. A simplified model casts doubt on the superlative experimental results reported for the rf-series dc-parallel biased array SIS mixer. Superconductivity; SIS mixer; Submillimeter-wave detection.

Final Technical Report•Jun 1, 1993•0 citations
Principles of operation of superconducting mixers based on: Superconductor-Insulator-Superconductor (SIS) tunnel junctions, Josephson junctions in high temperature superconductors and on superconducting hot-electron-microbolometers are presented. Most recent results on all types of superconducting mixers, with special attention paid to noise properties is reviewed.
This chapter discusses the high sensitivity superconducting mixers, i.e. detectors used in heterodyne receivers. Today, there are essentially two very successful concepts of superconducting mixers, or frequency down-converters, the superconductor-insulator-superconductor tunnel junction SIS mixer and the superconducting hot-electron bolometer mixer. Moving up to higher frequencies in the microwave and millimeter wave electromagnetic spectra makes it more and more difficult to retrieve a good signal-to-noise ratio with ordinary solid-state amplifiers. The driving force for using superconducting mixers is their excellent down-conversion efficiency and capability to down-convert RF signals from microwave frequencies up to the terahertz region. The main purpose of a receiver is to pick up and amplify a weak signal, which can then be accurately determined in amplitude and phase. The mixer noise temperature and conversion gain are the most important parameters for the mixing device. The Josephson junction mixer was one of the first suggested devices based on superconducting point contacts and later tunnel junctions.
A weak link between two bulk superconductors can exhibit Josephson effects and can be used as a fast sensitive detector or mixer for electromagnetic radiation. Emphasis is placed on the millimeter and submillimeter range where such applications are potentially most important, though such devices should also work well at lower frequencies. The peculiar properties of the weak link make possible a variety of modes of operation including one in which it is both local oscillator and mixer. These modes of operation are analyzed and the pivotal experiments are reviewed. Noise and impedance matching are considered and comparison is made with other types of detectors of millimeter and submillimeter waves.
It has been shown both theoretically [1] and experimentally [2,3] that the very sharp nonlinearity in the conductance of superconducting tunnel junctions can be used to implement millimeter wavelength mixers having high gain and very low noise, leading to the possibility of receivers that achieve the quantum noise limit. The junctions involved contain a thin insulating barrier between two superconductors, and are thus known as superconductor-insulator-superconductor (SIS) junctions. They are physically identical to Josephson junctions, but in this application the conductance is via the tunneling of quasiparticles (unpaired electrons), and so the Josephson effect is not involved.
Recent work done at Berkeley on the development of millimeter-wave heterodyne mixers using superconductor-insulator-superconductor (SIS) junctions is reviewed. Two types of mixers have been developed; a conventional waveguide system using a resonant cavity and an open-structure quasioptical system using planar antennas and lenses. Using the waveguide system, the lowest mixer noise level yet obtained (within 25% of the quantum limit) at 95 GHz has been achieved. The quasioptical system has achieved a good mixer performance up to 200 GHz, and it has shown promise for use at submillimeter wavelengths.>
Single-particle (quasi-particle) tunneling through an insulating barrier between two superconductors or between a superconductor and a normal conductor is being used to make very-low-noise detectors and mixers for millimeter wavelengths. The nonlinearity of theI-Vcurve obtained from tunneling between two superconductors can be so strong that classical theory breaks down and photon-assisted tunneling theory must be used to understand device performance. Quantum theory predicts that a quasi-particle tunnel junction can be operated as a microwave photon detector with quantum efficiency close to unity or as a heterodyne mixer with conversion gain and with mixer noise temperature comparable with the quantum noise limitT_{M} =\bar{h}\omega/k. Both of these predictions have been experimentally realized at 36 GHz using superconductor-insulator-superconductor (SIS) junctions. It appears probable that these quasi-particle detectors and mixers will supercede the corresponding Josephson-effect devices at millimeter wavelengths.
Theoretical research has been conducted to elucidate the basic physics behind the properties of superconductor-insulator-superconductor (SIS) tunnel junction receiving devices. The properties of SIS mixers using nonideal junctions and finite LO power, were determined by analytic expansion of the equations of the quantum theory of mixing, and also by computer simulations of SIS receivers over the entire range of experimental parameters. The result is a new coherent and intuitive picture of SIS mixer behavior. Many of the outstanding mysteries and questions about SIS receivers are resolved, and this contributes greatly to the design and interpretation of SIS mixer experiments. Other calculations show how to achieve sub-quantum noise temperatures in the phase sensitive SIS mixer, an important step towards realization of ultra-low- noise detectors. A simplified model casts doubt on the superlative experimental results reported for the rf-series dc-parallel biased array SIS mixer. Superconductivity; SIS mixer; Submillimeter-wave detection.