Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Transactions on Electron Devices

Superconductive devices for millimeter wave detection, mixing, and amplification

P. L. Richards, Tek-Ming Shen

Published Oct 1, 1980• 61 citations
Publisher

Abstract

Single-particle (quasi-particle) tunneling through an insulating barrier between two superconductors or between a superconductor and a normal conductor is being used to make very-low-noise detectors and mixers for millimeter wavelengths. The nonlinearity of theI-Vcurve obtained from tunneling between two superconductors can be so strong that classical theory breaks down and photon-assisted tunneling theory must be used to understand device performance. Quantum theory predicts that a quasi-particle tunnel junction can be operated as a microwave photon detector with quantum efficiency close to unity or as a heterodyne mixer with conversion gain and with mixer noise temperature comparable with the quantum noise limitT_{M} =\bar{h}\omega/k. Both of these predictions have been experimentally realized at 36 GHz using superconductor-insulator-superconductor (SIS) junctions. It appears probable that these quasi-particle detectors and mixers will supercede the corresponding Josephson-effect devices at millimeter wavelengths.

DOI
10.1109/t-ed.1980.20128

Related papers

Quantum Limited Millimeter Wave Mixers and Detectors

P. L. Richards, T. M. Shen, R. Harris +1 more

We report operation of superconductor-insulator-superconductor quasiparticle tunnel junctions as mixers and detectors at millimeter wavelengths. The voltage scale of the nonlinearity in the I-V curve of such junctions can be small enough that classical device theory breaks down. Calculations based on photon assisted tunneling theory are then necessary to understand the observed performance. The performance predicted in this novel regime is sufficiently good that practical applications appear very promising. The best mixer result observed at 36 GHz is a double side-band mixer noise temperature Tm≤ 7 K which is about 4 times the photon noise limited value of hv/k. When operated as a direct detector, a current responsivity of 3,500 A/W was observed. This is half the quantum limited value e/hv, which corresponds to one tunneling electron for each incident microwave photon. The best observed NEP was 3 × 10-16W√Hz.

International Conference on Submillimeter Waves and Their Applications•Dec 1, 1979•0 citations

Quantum detection at millimeter wavelengths

John R. Tucker, M. J. Feldman

Photon-assisted tunneling of electrons through an insulating barrier may be used to detect long-wavelength radiation with a sensitivity approaching the limit imposed by the Heisenberg uncertainty principle. A new generation of ultra-low-noise millimeter-wave receivers, currently being developed for astronomical observation, utilizes the extremely sharp nonlinearity produced by single-electron quasiparticle tunneling between two superconductors in a superconductor-insulator-superconductor (SIS) tunnel junction. At millimeter wavelengths, the quantum energy $\frac{\ensuremath{\hbar}\ensuremath{\omega}}{e}$ may be larger than the voltage width for onset of quasiparticle tunneling in a SIS junction; and under these conditions the absorption of a single photon can cause one additional electron to tunnel through the barrier. Several newly discovered quantum effects become possible in this regime, including power amplification of an incoming signal during the process of frequency down-conversion in a heterodyne receiver. The experimental development of SIS millimeter-wave receivers is reviewed, along with the quantum theory of mixing which predicts their performance.

Reviews of Modern Physics•Oct 1, 1985•821 citations

Quasiparticle heterodyne mixing in SIS tunnel junctions

P. L. Richards, T. M. Shen, R. Harris +1 more

The rapid onset of quasiparitcle tunneling current in superconductor-insulator-superconductor (Josephson) junctions at voltages above 2Δ/e is being used for millimeter-wave heterodyne mixing. Junctions with a 2-μm diameter and RN=50 Ω have little capacitive shunting at the signal frequency of 36 GHz. Because there is no series resistance, residual capacitance can be tuned out. Double sideband conversion efficiencies of 0.32 and mixer noise temperatures as low as TM⩽7 K=4hν/k have been observed. The results are compared with shot-noise-limited mixer theory. Photon-assisted tunneling effects are seen which indicate the approach to photon-noise-limited operation.

Applied Physics Letters•Mar 1, 1979•163 citations

Predicted conversion gain in superconductor-insulator-superconductor quasiparticle mixers

John R. Tucker

A computer simulation is constructed to describe the performance of superconductor-insulator-superconductor (SIS) quasiparticle heterodyne receivers in terms of photon-assisted tunneling theory. The results predict that conversion efficiencies greater than unity can be realized at millimeter wave frequencies, with noise temperatures approaching the fundamental quantum limit. The nonlinearity responsible for the mixing is the extremely rapid onset of quasiparticle tunneling current in SIS junctions near the full gap voltage 2Δ/e, and is independent of the Josephson pair currents. Substantial gain is expected under a variety of conditions and for a wide range of source and load impedances.

Applied Physics Letters•Mar 15, 1980•107 citations

Design considerations for high-gain SIS mixers

Larry R. D’Addario, Michael W. Cromar, F L Lloyd

It has been shown both theoretically [1] and experimentally [2,3] that the very sharp nonlinearity in the conductance of superconducting tunnel junctions can be used to implement millimeter wavelength mixers having high gain and very low noise, leading to the possibility of receivers that achieve the quantum noise limit. The junctions involved contain a thin insulating barrier between two superconductors, and are thus known as superconductor-insulator-superconductor (SIS) junctions. They are physically identical to Josephson junctions, but in this application the conductance is via the tunneling of quasiparticles (unpaired electrons), and so the Josephson effect is not involved.

International Conference on Infrared, Millimeter, and Terahertz Waves (IRMMW-THz)•Dec 1, 1985•0 citations

Low-Noise Superconducting Mixers for the Terahertz Frequency Range

Victor Y. Belitsky, Serguei Cherednichenko, Dag Winkler

This chapter discusses the high sensitivity superconducting mixers, i.e. detectors used in heterodyne receivers. Today, there are essentially two very successful concepts of superconducting mixers, or frequency down-converters, the superconductor-insulator-superconductor tunnel junction SIS mixer and the superconducting hot-electron bolometer mixer. Moving up to higher frequencies in the microwave and millimeter wave electromagnetic spectra makes it more and more difficult to retrieve a good signal-to-noise ratio with ordinary solid-state amplifiers. The driving force for using superconducting mixers is their excellent down-conversion efficiency and capability to down-convert RF signals from microwave frequencies up to the terahertz region. The main purpose of a receiver is to pick up and amplify a weak signal, which can then be accurately determined in amplitude and phase. The mixer noise temperature and conversion gain are the most important parameters for the mixing device. The Josephson junction mixer was one of the first suggested devices based on superconducting point contacts and later tunnel junctions.

CRC Press eBooks•May 17, 2022•1 citation
Single-particle (quasi-particle) tunneling through an insulating barrier between two superconductors or between a superconductor and a normal conductor is being used to make very-low-noise detectors and mixers for millimeter wavelengths. The nonlinearity of theI-Vcurve obtained from tunneling between two superconductors can be so strong that classical theory breaks down and photon-assisted tunneling theory must be used to understand device performance. Quantum theory predicts that a quasi-particle tunnel junction can be operated as a microwave photon detector with quantum efficiency close to unity or as a heterodyne mixer with conversion gain and with mixer noise temperature comparable with the quantum noise limitT_{M} =\bar{h}\omega/k. Both of these predictions have been experimentally realized at 36 GHz using superconductor-insulator-superconductor (SIS) junctions. It appears probable that these quasi-particle detectors and mixers will supercede the corresponding Josephson-effect devices at millimeter wavelengths.
We report operation of superconductor-insulator-superconductor quasiparticle tunnel junctions as mixers and detectors at millimeter wavelengths. The voltage scale of the nonlinearity in the I-V curve of such junctions can be small enough that classical device theory breaks down. Calculations based on photon assisted tunneling theory are then necessary to understand the observed performance. The performance predicted in this novel regime is sufficiently good that practical applications appear very promising. The best mixer result observed at 36 GHz is a double side-band mixer noise temperature Tm≤ 7 K which is about 4 times the photon noise limited value of hv/k. When operated as a direct detector, a current responsivity of 3,500 A/W was observed. This is half the quantum limited value e/hv, which corresponds to one tunneling electron for each incident microwave photon. The best observed NEP was 3 × 10-16W√Hz.
Photon-assisted tunneling of electrons through an insulating barrier may be used to detect long-wavelength radiation with a sensitivity approaching the limit imposed by the Heisenberg uncertainty principle. A new generation of ultra-low-noise millimeter-wave receivers, currently being developed for astronomical observation, utilizes the extremely sharp nonlinearity produced by single-electron quasiparticle tunneling between two superconductors in a superconductor-insulator-superconductor (SIS) tunnel junction. At millimeter wavelengths, the quantum energy $\frac{\ensuremath{\hbar}\ensuremath{\omega}}{e}$ may be larger than the voltage width for onset of quasiparticle tunneling in a SIS junction; and under these conditions the absorption of a single photon can cause one additional electron to tunnel through the barrier. Several newly discovered quantum effects become possible in this regime, including power amplification of an incoming signal during the process of frequency down-conversion in a heterodyne receiver. The experimental development of SIS millimeter-wave receivers is reviewed, along with the quantum theory of mixing which predicts their performance.
The rapid onset of quasiparitcle tunneling current in superconductor-insulator-superconductor (Josephson) junctions at voltages above 2Δ/e is being used for millimeter-wave heterodyne mixing. Junctions with a 2-μm diameter and RN=50 Ω have little capacitive shunting at the signal frequency of 36 GHz. Because there is no series resistance, residual capacitance can be tuned out. Double sideband conversion efficiencies of 0.32 and mixer noise temperatures as low as TM⩽7 K=4hν/k have been observed. The results are compared with shot-noise-limited mixer theory. Photon-assisted tunneling effects are seen which indicate the approach to photon-noise-limited operation.
A computer simulation is constructed to describe the performance of superconductor-insulator-superconductor (SIS) quasiparticle heterodyne receivers in terms of photon-assisted tunneling theory. The results predict that conversion efficiencies greater than unity can be realized at millimeter wave frequencies, with noise temperatures approaching the fundamental quantum limit. The nonlinearity responsible for the mixing is the extremely rapid onset of quasiparticle tunneling current in SIS junctions near the full gap voltage 2Δ/e, and is independent of the Josephson pair currents. Substantial gain is expected under a variety of conditions and for a wide range of source and load impedances.
It has been shown both theoretically [1] and experimentally [2,3] that the very sharp nonlinearity in the conductance of superconducting tunnel junctions can be used to implement millimeter wavelength mixers having high gain and very low noise, leading to the possibility of receivers that achieve the quantum noise limit. The junctions involved contain a thin insulating barrier between two superconductors, and are thus known as superconductor-insulator-superconductor (SIS) junctions. They are physically identical to Josephson junctions, but in this application the conductance is via the tunneling of quasiparticles (unpaired electrons), and so the Josephson effect is not involved.
This chapter discusses the high sensitivity superconducting mixers, i.e. detectors used in heterodyne receivers. Today, there are essentially two very successful concepts of superconducting mixers, or frequency down-converters, the superconductor-insulator-superconductor tunnel junction SIS mixer and the superconducting hot-electron bolometer mixer. Moving up to higher frequencies in the microwave and millimeter wave electromagnetic spectra makes it more and more difficult to retrieve a good signal-to-noise ratio with ordinary solid-state amplifiers. The driving force for using superconducting mixers is their excellent down-conversion efficiency and capability to down-convert RF signals from microwave frequencies up to the terahertz region. The main purpose of a receiver is to pick up and amplify a weak signal, which can then be accurately determined in amplitude and phase. The mixer noise temperature and conversion gain are the most important parameters for the mixing device. The Josephson junction mixer was one of the first suggested devices based on superconducting point contacts and later tunnel junctions.