Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Superconductor Science and Technology

Ultra-low-noise 100 GHz receiver based on parallel biased SIS arrays

S. V. Shitov, V. P. Koshelets, Sergey Kovtonyuk, An. B. Ermakov, Nick D. Whyborn, C -O Lindstrom

Published Sep 1, 1991• 14 citations
Publisher

Abstract

The possibility of overcoming the main drawbacks of the traditional series arrays by using a parallel connection of SIS junctions for DC and IF current has been experimentally demonstrated in full height 70-116 GHz waveguide mixers. This new array concept has been successfully developed to: (i) avoid the influence of junction non-uniformity in the array; (ii) provide optimal matching at both RF input and IF output even in the case of high gain, and (iii) tune out junction capacitance without any DC blocks. The experimentally tested arrays contain 10 or 11 trilayer 2.5 mu m 2 Nb-AlO x -Nb junctions. Best values of T r (DSB) as low as 20+or-2 K have been measured at the receiver room temperature horn in the 104-108 GHz LO range with a 4 GHz IF and at a mixer ambient temperature of 4.5-5.5 K. An SSB mixer noise temperature as low as 6+or-3 K was estimated. This value is very close to the quantum noise limit hf/k approximately=5 K.

DOI
10.1088/0953-2048/4/9/006

Related papers

Parallel biased SIS-arrays for mm wave mixers: main ideas and experimental verification

An. B. Ermakov, V. P. Koshelets, Sergey Kovtonyuk +1 more

The possibility of overcoming the main drawbacks of the traditional series arrays by parallel connection of the SIS (superconductor-insulator-superconductor) junctions for DC and IF are demonstrated experimentally. The proposed mixing elements avoid the influence of the junction nonuniformity in the array, provide the optimal matching on both RF input and IF output, and tune out junction capacitance. Experimentally tested arrays contained up to eight high-quality Nb-AlO/sub x/-Nb junctions with R/sub n/=20-70 Omega at junction area 8/14 mu m/sup 2/. The best values of T/sub r/ (SSB) were measured to as low as 5 K on the mixer cold input flange in the 45-55-GHz bandwidth at an ambient temperature of 4.2 K. A mixer gain of up to 10 dB was obtained. The gain values were limited by bias stability at very high or even negative array output impedance. An experimental receiver noise temperature (SSB) of less than 20 K has been achieved.

IEEE Transactions on Magnetics•Mar 1, 1991•19 citations

Perfectly matched SIS arrays for mm wave receivers

S. V. Shitov, V. P. Koshelets, Sergey Kovtonyuk +1 more

A novel conception of improved matching for both input and output mixer ports has been developed and confirmed successfully with experimental receivers in the 40-180-GHz frequency range. Parallel and parallel-series combinations integrated up to 11 Nb-AlO/sub x/-Nb type superconductor-insulator-superconductor (SIS) junctions have been tested in full-height waveguide mixers. Receivers' noise temperatures T/sub r/(DSB)>

IEEE Transactions on Applied Superconductivity•Mar 1, 1993•2 citations

Wide-Band, Ultra Low Noise MM-Wave Mixers with a Single Tuning Element

Antti V. Räisänen, Denis Crété, P. L. Richards +1 more

Several SIS quasiparticle mixers have been designed and tested for the frequency range from 80 to 115 GHz. The sliding back short is the only adjustable RF-tuning element. The RF-filter reactance is used a s a fixed RF-matching element. A mixer which uses a single 2 × 2 μm2Pb-alloy junction in a 1/4-height waveguide mount has a coupled conversion gain of GM(DSB) = 2.6 ± 0.5 dB with an associated noise temperature of TM(DSB) = 16.4 ± 1.8 K at the best DSB operation point. The receiver noise temperature TR(DSB) is 27.5 ± 0.8 K for the test apparatus. This mixer provides a SSB receiver noise temperature below 50 K over the frequency range from 91 to 96 GHz, the minimum being TR(SSB) = 44 ± 4 K. Another mixer with an array of five 5 × 5 μm2junctions in series has much lower noise TM(DSB) = 6.6 ± 1.6 K, but less gain GM(DSB) = -5.1 ± 0.5 dB.

European Microwave Conference (EuMC)•Sep 1, 1986•2 citations

Nb-based SIS mixer in the 800 GHz band

Takashi Noguchi, Hiroyuki Maezawa, Sheng‐Cai Shi +1 more

We have built a waveguide SIS mixer with Nb-based parallel-connected twin junctions at 800 GHz which is above the gap frequency of Nb (690 GHz). Heterodyne mixing was performed at 810 GHz and a receiver noise temperature of 580 K (DSB), which includes noise contributions due to a vacuum window and a beam splitter, was achieved using Nb/AlO/sub x//Nb junctions with Nb striplines. The performance of this mixer is quite good and it is shown that efficient mixing in Nb-based SIS junctions is still possible above the gap frequency, SIS mixers with Al striplines have also been fabricated and good DC I-V characteristics have been observed. Heterodyne measurements of these mixers are now under preparation.

IEEE Transactions on Applied Superconductivity•Mar 1, 2001•6 citations

275–500-GHz Wideband Waveguide SIS Mixers

Takafumi Kojima, M. Kroug, Álvaro González +5 more

We have successfully demonstrated low-noise and wideband SIS mixers for the 275-500-GHz radio-frequency (RF) band, aiming to cover Atacama Large Millimeter/submillimeter Array band 7 (275-373 GHz) and band 8 (385-500 GHz) simultaneously. The waveguide SIS mixers integrate a multisection impedance transformer with a parallel-connected-twin-junction or single-junction circuits based on Nb/AlN/Nb trilayers with a critical current density of 31 kA/cm2. In order to achieve the targeted broadband performance, we designed an asymmetric one-side waveguide probe placed across a reduced height waveguide with dimensions 100 μm × 580 μm. The shape of the waveguide probe was optimized to have nearly constant impedance at around 35 Ω in the desired RF range. For evaluation of the receiver performance, we have established a dual-band noise temperature measurement system. The system implements a broadband corrugated horn antenna and a 15-dB RF/local oscillator (LO) waveguide coupler based on WR-2.3 (290 μm × 580 μm) waveguide size. The target bandwidth is too wide for typical LO sources at these high frequencies, and, therefore, we applied a dual-band LO injection system utilizing two different LO sources and an LO diplexer. The IF chain uses a cryogenic isolator and a low-noise amplifier with a typical noise temperature of 2.1 K over the 4-8-GHz range. The measured double sideband receiver noise temperature is two to three times the quantum noise at all LO frequencies for both the twin-junction and the single-junction circuits.

IEEE Transactions on Terahertz Science and Technology•Oct 1, 2018•23 citations

Low-noise SIS mixers with a parallel array of junctions at submillimeter wavelengths

Takashi Noguchi, Sheng‐Cai Shi, Hiroyuki Iwashita +1 more

A Superconductor-Insulator-Superconductor (SIS) mixer using parallel array of N junctions have been studied. It has been shown by theoretical analysis that the performance of this type of device is excellent and that nearly quantum-limited performance of the mixer can be obtained. It has been demonstrated that the double sideband (DSB) noise temperature of a receiver employing parallel array of twin junctions, which is the most simplest case in the parallel array of N junctions, was approximately 3 to 5 times as large as the quantum limited photon noise up to the gap frequency of Nb (approximately 700 GHz). It has been also shown that the bandwidth performance of parallel junction arrays can be improved significantly with a large number of SIS junctions even if SIS junctions with a relatively low current density or a large (omega) RNCJ product are adopted in the arrays.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Jul 3, 2000•2 citations
The possibility of overcoming the main drawbacks of the traditional series arrays by using a parallel connection of SIS junctions for DC and IF current has been experimentally demonstrated in full height 70-116 GHz waveguide mixers. This new array concept has been successfully developed to: (i) avoid the influence of junction non-uniformity in the array; (ii) provide optimal matching at both RF input and IF output even in the case of high gain, and (iii) tune out junction capacitance without any DC blocks. The experimentally tested arrays contain 10 or 11 trilayer 2.5 mu m 2 Nb-AlO x -Nb junctions. Best values of T r (DSB) as low as 20+or-2 K have been measured at the receiver room temperature horn in the 104-108 GHz LO range with a 4 GHz IF and at a mixer ambient temperature of 4.5-5.5 K. An SSB mixer noise temperature as low as 6+or-3 K was estimated. This value is very close to the quantum noise limit hf/k approximately=5 K.
The possibility of overcoming the main drawbacks of the traditional series arrays by parallel connection of the SIS (superconductor-insulator-superconductor) junctions for DC and IF are demonstrated experimentally. The proposed mixing elements avoid the influence of the junction nonuniformity in the array, provide the optimal matching on both RF input and IF output, and tune out junction capacitance. Experimentally tested arrays contained up to eight high-quality Nb-AlO/sub x/-Nb junctions with R/sub n/=20-70 Omega at junction area 8/14 mu m/sup 2/. The best values of T/sub r/ (SSB) were measured to as low as 5 K on the mixer cold input flange in the 45-55-GHz bandwidth at an ambient temperature of 4.2 K. A mixer gain of up to 10 dB was obtained. The gain values were limited by bias stability at very high or even negative array output impedance. An experimental receiver noise temperature (SSB) of less than 20 K has been achieved.
Several SIS quasiparticle mixers have been designed and tested for the frequency range from 80 to 115 GHz. The sliding back short is the only adjustable RF-tuning element. The RF-filter reactance is used a s a fixed RF-matching element. A mixer which uses a single 2 × 2 μm2Pb-alloy junction in a 1/4-height waveguide mount has a coupled conversion gain of GM(DSB) = 2.6 ± 0.5 dB with an associated noise temperature of TM(DSB) = 16.4 ± 1.8 K at the best DSB operation point. The receiver noise temperature TR(DSB) is 27.5 ± 0.8 K for the test apparatus. This mixer provides a SSB receiver noise temperature below 50 K over the frequency range from 91 to 96 GHz, the minimum being TR(SSB) = 44 ± 4 K. Another mixer with an array of five 5 × 5 μm2junctions in series has much lower noise TM(DSB) = 6.6 ± 1.6 K, but less gain GM(DSB) = -5.1 ± 0.5 dB.
We have built a waveguide SIS mixer with Nb-based parallel-connected twin junctions at 800 GHz which is above the gap frequency of Nb (690 GHz). Heterodyne mixing was performed at 810 GHz and a receiver noise temperature of 580 K (DSB), which includes noise contributions due to a vacuum window and a beam splitter, was achieved using Nb/AlO/sub x//Nb junctions with Nb striplines. The performance of this mixer is quite good and it is shown that efficient mixing in Nb-based SIS junctions is still possible above the gap frequency, SIS mixers with Al striplines have also been fabricated and good DC I-V characteristics have been observed. Heterodyne measurements of these mixers are now under preparation.
We have successfully demonstrated low-noise and wideband SIS mixers for the 275-500-GHz radio-frequency (RF) band, aiming to cover Atacama Large Millimeter/submillimeter Array band 7 (275-373 GHz) and band 8 (385-500 GHz) simultaneously. The waveguide SIS mixers integrate a multisection impedance transformer with a parallel-connected-twin-junction or single-junction circuits based on Nb/AlN/Nb trilayers with a critical current density of 31 kA/cm2. In order to achieve the targeted broadband performance, we designed an asymmetric one-side waveguide probe placed across a reduced height waveguide with dimensions 100 μm × 580 μm. The shape of the waveguide probe was optimized to have nearly constant impedance at around 35 Ω in the desired RF range. For evaluation of the receiver performance, we have established a dual-band noise temperature measurement system. The system implements a broadband corrugated horn antenna and a 15-dB RF/local oscillator (LO) waveguide coupler based on WR-2.3 (290 μm × 580 μm) waveguide size. The target bandwidth is too wide for typical LO sources at these high frequencies, and, therefore, we applied a dual-band LO injection system utilizing two different LO sources and an LO diplexer. The IF chain uses a cryogenic isolator and a low-noise amplifier with a typical noise temperature of 2.1 K over the 4-8-GHz range. The measured double sideband receiver noise temperature is two to three times the quantum noise at all LO frequencies for both the twin-junction and the single-junction circuits.
A Superconductor-Insulator-Superconductor (SIS) mixer using parallel array of N junctions have been studied. It has been shown by theoretical analysis that the performance of this type of device is excellent and that nearly quantum-limited performance of the mixer can be obtained. It has been demonstrated that the double sideband (DSB) noise temperature of a receiver employing parallel array of twin junctions, which is the most simplest case in the parallel array of N junctions, was approximately 3 to 5 times as large as the quantum limited photon noise up to the gap frequency of Nb (approximately 700 GHz). It has been also shown that the bandwidth performance of parallel junction arrays can be improved significantly with a large number of SIS junctions even if SIS junctions with a relatively low current density or a large (omega) RNCJ product are adopted in the arrays.