A dense thermal beam of titanium atoms has been realized using a tungsten crucible inside a high temperature oven (≤2300 K). Its flux (≈1014 atom/cm2/s) and its long term stability have been measured by means of a quartz balance, its angular divergence has been evaluated from the size of a metallic spot deposited on a glass plate. A spectroscopic investigation performed via the laser-induced fluorescence technique has led to the measurement of the isotope shifts between 46Ti, 48Ti and 50Ti, for six visible 3d2 4s2 a 3FJ↦3d2 4s4p z 5DJ' transitions. This beam offers the characteristics required to apply high resolution laser techniques to reaction dynamics crossed-beam experiments.
A dense thermal beam of titanium atoms has been realized using a tungsten crucible inside a high temperature oven (≤2300 K). Its flux (≈1014 atom/cm2/s) and its long term stability have been measured by means of a quartz balance, its angular divergence has been evaluated from the size of a metallic spot deposited on a glass plate. A spectroscopic investigation performed via the laser-induced fluorescence technique has led to the measurement of the isotope shifts between 46Ti, 48Ti and 50Ti, for six visible 3d2 4s2 a 3FJ↦3d2 4s4p z 5DJ' transitions. This beam offers the characteristics required to apply high resolution laser techniques to reaction dynamics crossed-beam experiments.
We generate an atomic beam of titanium (Ti) using a "Ti-ball" Ti-sublimation pump, which is a common getter pump used in ultrahigh vacuum systems. We show that the sublimated atomic beam can be optically pumped into the metastable 3d3(4F)4s a5F5 state, which is the lower energy level in a cycling optical transition that can be used for laser cooling. We measure the atomic density and transverse and longitudinal velocity distributions of the beam through laser fluorescence spectroscopy. We find a metastable atomic flux density of 4.3(2) × 109 s-1 cm-2 with a mean forward velocity of 773(8) m/s at 2.55 cm directly downstream of the center of the Ti-ball. Owing to the details of optical pumping, the beam is highly collimated along the transverse axis parallel to the optical pumping beam and the flux density falls off as 1/r. We discuss how this source can be used to load atoms into a magneto-optical trap.
We realize a magneto-optical trap (MOT) of titanium (Ti) atoms, performing laser cooling on the 498 nm transition between the long-lived 3 d 3 ( F 4 ) 4 s a 5 F 5 metastable state and the 3 d 3 ( F 4 ) 4 p y 5 G 6 o excited state. Without the addition of any repumping light, we observe MOTs of the three stable, I = 0 bosonic isotopes, Ti 46 , Ti 48 , and Ti 50 . Up to 8.30 ( 26 ) × 10 5 Ti 48 atoms are trapped at a maximum density of 1.3 ( 4 ) × 10 11 cm − 3 and at a temperature of 90 ( 15 ) µ K . By measuring the decay of the MOT, we constrain the leakage branching ratio of the cooling transition ( ≤ 2.5 × 10 − 6 ) and the two-body loss coefficient ( ≤ 2 × 10 − 10 cm 3 s − 1 ). Our approach to laser cooling Ti can be applied to other transition metals, enabling a significant expansion of the elements that can be laser cooled.
We report on magneto-optical trapping of the two fermionic isotopes of atomic titanium, 47Ti and 49Ti. Unlike the even mass-number isotopes, which were recently laser cooled, 47Ti and 49Ti have nonzero nuclear spins and, consequently, their atomic levels are split by hyperfine structure. Combining and comparing theoretical calculations and atomic beam-spectroscopy measurements, we determine the hyperfine structures and isotope shifts of the 3d24s2a3F4→3d2(3P)4s4p(3Po)y5D4o optical-pumping transition at optical wavelength 391nm and the 3d3(4F)4sa5F5→3d3(4F)4py5G6o laser-cooling transition at wavelength 498nm. With this information, we produce magneto-optical traps of both 47Ti and 49Ti by applying two additional tones of light to repump atoms to the maximum-spin states on the laser-cooling transition. Directly loading from the atomic flux of a titanium sublimation pump, we produce 47Ti and 49Ti traps with 731(190) and 1142(240) atoms, and with lifetimes of 330(15)ms and 310(8)ms, respectively.
We realize narrow-linewidth magneto-optical traps of 46Ti, 48Ti and 50Ti atoms based on a 1040 nm-wavelength transition, cooling atoms to a minimum temperature in one dimension of Tz=990(20) nK and a three-dimensional temperature of T3D=1.28(7)μK. Atoms are pre-cooled in a broad-line magneto-optical trap and then transferred with about 25% efficiency to the narrow-line trap. We operate the narrow-line trap in two stages over 85 ms. First, a single cooling beam, blue-detuned from the narrow-linewidth atomic resonance, optically pumps and traps the atoms on a two-dimensional surface where the Zeeman shift from the applied spherical quadrupole magnetic field brings the light nearly to resonance. Second, four additional beams, counter-propagating in the transverse directions, cool and compress the atoms in all dimensions. The high magnetic moment of the laser cooling state makes the dynamics of the narrow-line titanium trap similar to those of other magnetic atoms. We measure the lifetime of the excited state of the transition to be τ=8.2(9)μs, indicating a transition linewidth of γ/2π=20(2) kHz, and also measure isotope shifts on the narrow-line transition. We use Stern-Gerlach separation on the ultracold Ti gas to measure the mJ-distribution in the narrow-line magneto-optical trap, finding over 98% of the atoms in the stretched spin state.
Atomic oven generating controllable atomic beam flux plays a fundamental role in quantum gas experiments. Here, we report a new heater design that can heat up an high temperature atomic oven with fast thermal response. The new heater shows a heating rate improved by 7.65 times comparing to that of the conventional resistive heater while the crucible temperature can heated up to 1200K. With this oven, we generated a collimated ytterbium beam with flux exceeding 1014 atoms/s at 823 K. We believe that our design offers a promising solution for shortening experimental dead time and improve the experiment efficiency in cold atom researches.
A high-flux compact source of strontium atoms has been designed and built. We have investigated the feasibility of direct trapping of cold atoms from the atomic flux out of a hot oven. Our design uses a two-dimensional magneto-optical trap (MOT) with an additional laser beam that exerts a radiation force that is not counterbalanced to eject atoms (so-called ‘push’ beam), which is known as a 2D+ MOT configuration. This approach has been previously used for sodium, and has been extended to strontium in this work. Laser cooling of strontium typically requires multiple stages: effusion of atoms from an oven to produce an atomic beam, transverse collimation, a Zeeman slower and deflection before finally collecting atoms in a 3D MOT. A 2D+ MOT combines the Zeeman slowing, transverse collimation, and deflection into a single compact stage to provide a high-flux source suitable for applications such as matter-wave interferometry, atomic clocks and experimental studies of degenerate quantum gases. This thesis reports experimental work that has been carried out to develop and test an oven and the associated laser cooling apparatus for producing a source of cold strontium atoms which is straightforward to manufacture. We test the oven up to a temperature of To = 642 °C and measure a peak intensity of 6.8 × 1016 s−1 sr−1 and a flux of 2.9 × 1016 s−1. We typically operate the oven at To = 502 °C, for which the peak intensity and flux are 2.2 × 1015 s−1 sr−1 and 7.5 × 1014 s−1. A multi-channel nozzle made of graphite gives an angular divergence of 0.17 rad (10°) for the atomic beam. Trapping atoms directly from the thermal atomic beam into the MOT gives a maximum loading rate of 7.1 × 1010 s−1, without any laser light to repump atoms into the cooling cycle. We demonstrated a novel frequency stabilising technique for the laser by developing Zeeman-tunable modulation transfer spectroscopy in strontium with an inaccuracy of ±3.5 MHz and a frequency tuning range of 160 MHz. The initial aim of this thesis was to make a compact, high-flux strontium source suitable for quantum technology applications. During the course of this research, we participated in the preparation of a proposal for the construction of a large-scale atom interferometer based on the clock transition in strontium (87Sr) for the exploration of dark matter and gravitational waves (a project known as the Atom Interferometer Observatory and Network, AION). This changed the design requirements towards producing a higher flux (in particular of the isotope 87Sr), with compactness of the source being less important in ∼10 m scale apparatus.