We generate an atomic beam of titanium (Ti) using a "Ti-ball" Ti-sublimation pump, which is a common getter pump used in ultrahigh vacuum systems. We show that the sublimated atomic beam can be optically pumped into the metastable 3d3(4F)4s a5F5 state, which is the lower energy level in a cycling optical transition that can be used for laser cooling. We measure the atomic density and transverse and longitudinal velocity distributions of the beam through laser fluorescence spectroscopy. We find a metastable atomic flux density of 4.3(2) × 109 s-1 cm-2 with a mean forward velocity of 773(8) m/s at 2.55 cm directly downstream of the center of the Ti-ball. Owing to the details of optical pumping, the beam is highly collimated along the transverse axis parallel to the optical pumping beam and the flux density falls off as 1/r. We discuss how this source can be used to load atoms into a magneto-optical trap.
We generate an atomic beam of titanium (Ti) using a "Ti-ball" Ti-sublimation pump, which is a common getter pump used in ultrahigh vacuum systems. We show that the sublimated atomic beam can be optically pumped into the metastable 3d3(4F)4s a5F5 state, which is the lower energy level in a cycling optical transition that can be used for laser cooling. We measure the atomic density and transverse and longitudinal velocity distributions of the beam through laser fluorescence spectroscopy. We find a metastable atomic flux density of 4.3(2) × 109 s-1 cm-2 with a mean forward velocity of 773(8) m/s at 2.55 cm directly downstream of the center of the Ti-ball. Owing to the details of optical pumping, the beam is highly collimated along the transverse axis parallel to the optical pumping beam and the flux density falls off as 1/r. We discuss how this source can be used to load atoms into a magneto-optical trap.
We produce beams of neutral titanium (Ti) atoms in their metastable 3d3(F4)4sa5F5 state by laser ablation into He, N2, and Ar buffer gases. The high temperatures associated with the ablation process populate the a5F5 level without the need for optical pumping. Remarkably, we observe that Ti atoms in the a5F5 state survive thousands of collisions with He and Ar buffer gas atoms without being quenched to lower-energy states. We study the yield of Ti atoms when ablated into buffer gases of varying species and pressure, quantify quenching rates and diffusion cross sections based on simple models, and provide insight into optimal design parameters for an ablation cell. Using a 3.3 cm ablation cell with interchangeable exit apertures, we produce metastable atom beams and quantify their brilliance and velocity distributions as functions of buffer gas pressure.
We realize a magneto-optical trap (MOT) of titanium (Ti) atoms, performing laser cooling on the 498 nm transition between the long-lived 3 d 3 ( F 4 ) 4 s a 5 F 5 metastable state and the 3 d 3 ( F 4 ) 4 p y 5 G 6 o excited state. Without the addition of any repumping light, we observe MOTs of the three stable, I = 0 bosonic isotopes, Ti 46 , Ti 48 , and Ti 50 . Up to 8.30 ( 26 ) × 10 5 Ti 48 atoms are trapped at a maximum density of 1.3 ( 4 ) × 10 11 cm − 3 and at a temperature of 90 ( 15 ) µ K . By measuring the decay of the MOT, we constrain the leakage branching ratio of the cooling transition ( ≤ 2.5 × 10 − 6 ) and the two-body loss coefficient ( ≤ 2 × 10 − 10 cm 3 s − 1 ). Our approach to laser cooling Ti can be applied to other transition metals, enabling a significant expansion of the elements that can be laser cooled.
We report on magneto-optical trapping of the two fermionic isotopes of atomic titanium, 47Ti and 49Ti. Unlike the even mass-number isotopes, which were recently laser cooled, 47Ti and 49Ti have nonzero nuclear spins and, consequently, their atomic levels are split by hyperfine structure. Combining and comparing theoretical calculations and atomic beam-spectroscopy measurements, we determine the hyperfine structures and isotope shifts of the 3d24s2a3F4→3d2(3P)4s4p(3Po)y5D4o optical-pumping transition at optical wavelength 391nm and the 3d3(4F)4sa5F5→3d3(4F)4py5G6o laser-cooling transition at wavelength 498nm. With this information, we produce magneto-optical traps of both 47Ti and 49Ti by applying two additional tones of light to repump atoms to the maximum-spin states on the laser-cooling transition. Directly loading from the atomic flux of a titanium sublimation pump, we produce 47Ti and 49Ti traps with 731(190) and 1142(240) atoms, and with lifetimes of 330(15)ms and 310(8)ms, respectively.
Metastable noble gas atomic beam is widely used in atomic and molecular physics studies.Using radio-frequency discharge and transverse laser cooling, we produced a well-collimated intense meta-stable Krypton beam.Numerical simulation is also used to analyze the trajectories of atoms in an optic field produced by transverse cooling laser beams.The charactersisticl of the atomic beam are determined by measuring the laser induced fluorescence.The atomic beam flux measured at 230 cm downstream is 1.61016 atoms/(s*sr), which is enhanced by two orders of magnitude.The Kr atoms are finally trapped in a magneto-optic trap.A total of 1.31010 meta-stable 84Kr atoms can be simultaneously trapped with a loading rate of 3.01011 atoms/s.The same setup is also successfully used to obtain a bright metastable atomic argon beam and trap.
We discuss the implementation and characterization of the source of a slow, intense, and collimated beam of rubidium atoms. The cold atomic beam is produced by two-dimensional magneto-optical trapping in directions transverse to the atomic beam axis and unbalanced Doppler cooling in the axial direction. The vacuum design allows use of relatively low laser power and a considerably simplified assembly. The atomic beam has a high flux of about $2\ifmmode\times\else\texttimes\fi{}{10}^{10}\phantom{\rule{0.3em}{0ex}}\mathrm{atoms}∕\mathrm{s}$ at a total cooling laser power of 55mW. It has a narrow longitudinal velocity distribution with mean velocity 15m∕s with full width at half maximum 3.5m∕s and has a low divergence of 26mrad. The high flux enables ultrafast loading of about 1010 atoms into a three-dimensional (3D) magneto-optical trap within 500 ms. The variation of the atomic beam flux was studied as a function of the rubidium vapor pressure, cooling laser power, transverse cooling laser beam length, detuning of the cooling laser, and relative intensities of the cooling beams along the atomic beam axis. We also discuss a detailed comparison of our measurements of the cold atomic beam with a 3D numerical simulation.
We realize narrow-linewidth magneto-optical traps of 46Ti, 48Ti and 50Ti atoms based on a 1040 nm-wavelength transition, cooling atoms to a minimum temperature in one dimension of Tz=990(20) nK and a three-dimensional temperature of T3D=1.28(7)μK. Atoms are pre-cooled in a broad-line magneto-optical trap and then transferred with about 25% efficiency to the narrow-line trap. We operate the narrow-line trap in two stages over 85 ms. First, a single cooling beam, blue-detuned from the narrow-linewidth atomic resonance, optically pumps and traps the atoms on a two-dimensional surface where the Zeeman shift from the applied spherical quadrupole magnetic field brings the light nearly to resonance. Second, four additional beams, counter-propagating in the transverse directions, cool and compress the atoms in all dimensions. The high magnetic moment of the laser cooling state makes the dynamics of the narrow-line titanium trap similar to those of other magnetic atoms. We measure the lifetime of the excited state of the transition to be τ=8.2(9)μs, indicating a transition linewidth of γ/2π=20(2) kHz, and also measure isotope shifts on the narrow-line transition. We use Stern-Gerlach separation on the ultracold Ti gas to measure the mJ-distribution in the narrow-line magneto-optical trap, finding over 98% of the atoms in the stretched spin state.