We present a simple graphical analysis of the dynamic response of optical bistable devices. This technique shows qualitatively how the switching time of a device is affected by optical bias and signal powers and initial bias voltage, and may be used to optimise the switching time of a device.
A graphical method is described where-by the important steady state and dynamic responses of an optical bistable device can be viewed simultaneously. This results in a set of ‘operating curves’ which indicate how well an optical bistable device satisfies the requirements to perform a particular logic function. The operating curves may be used to find the optimum conditions to perform a function and they also show how resilient this point is in the presence of fluctuations in operating conditions.
There is much interest in the use of optical bistable devices as logic gates for optical processors. Although desirable properties have been reported, it is difficult to see how these are offset by less desirable ones. All properties of the device can be controlled to a certain extent, principally by the bias conditions. Here we show how steady state and dynamic responses vary simultaneously with these parameters. These operating curves can be used to see the capabilities of a device or to choose the optimum bias conditions.
Effect of relaxation time on the performance of photonic crystal optical bistable switches based on Kerr nolinearity is discussed. This paper deals with optical pulses with the duration of about 50 ps. In such cases the steady state response of the optical device can be used to approximate the pulse evolution if the nonlinearity is assumed instantaneous, hence analytical solutions such as the coupled mode theory can be used to obtain the time evolution of the electromagnetic fields. However if the relaxation time of the material nonlinear response is also considered, changes in the power levels and in the shape of the hystersis loop is observed. In this case, we use the nonlinear finite difference time domain method (NL-FDTD) to follow the system dynamics and get the bistability hystersis loop. Codes are developed to analyze the instantaneous Kerr materials and the Kerr materials with finite response times. Depending on the material, the relaxation times of the order of 1-10fs should be considered in studying bistability to obtain the right shape of the output pulses. It is observed that the relaxation leads to larger input power and threshold and hence degrades the performance of the switch in pulse shaping.