We have built an atom interferometer and, by applying an electric field on one of the two interfering beams, we have measured the static electric polarizability of lithium $\ensuremath{\alpha}=(24.33\ifmmode\pm\else\textpm\fi{}0.16)\ifmmode\times\else\texttimes\fi{}{10}^{\ensuremath{-}30}\phantom{\rule{0.3em}{0ex}}{\mathrm{m}}^{3}$ with a 0.66% uncertainty. Our experiment is similar to an experiment done on sodium in 1995 by Pritchard and co-workers, with several improvements: the electric field can be calculated analytically and the interference signals have a large intensity and a high visibility, resulting in accurate phase measurements. This experiment illustrates the extreme sensitivity of atom interferometry: when the atom enters the electric field, its velocity increases and the fractional change, equal to $4\ifmmode\times\else\texttimes\fi{}{10}^{\ensuremath{-}9}$ for our largest field, is measured with a ${10}^{\ensuremath{-}3}$ accuracy.
Abstract. We have built an atom interferometer of the Mach-Zehnder type, operating with thermal lithium atoms [1]. Its design is largely inspired by previous works done by the groups of D. Pritchard [2], A. Zeilinger [3] and S.A. Lee [4]. In our apparatus, the atomic wave is diffracted in the Bragg regime by three laser sanding waves to achieve a Mach-Zehnder configuration. This paper briefly recalls the diffraction process and shows the experimental results obtained in our group. Our apparatus is able to achieve a high fringe contrast of 74 % with a large mean detected atom flux of 1.5 × 104 s-1. Finally, the paper ends with the measurement of the velocity distribution of our lithium beam using a light induced fluorescence technique. 1. DIFFRACTION OF THE LITHIUM ATOMIC WAVE IN THE BRAGG REGIME Diffraction of an atomic wave by a laser standing wave in the Bragg regime is in complete analogy with diffraction of x-rays by a crystal. The laser standing wave acts as a thick phase grating for the atomic wave with a periodicity of half the laser wavelength λ r. The diffraction process is governed by conservation of momentum and energy. With a thick laser wave, momentum is transferred from the laser to the incident atomic wave only when the Bragg condition λr sin(θB) = pλdB is fulfilled, where θB is the Bragg angle and p is the diffraction order. For lithium, λr = 671 nm, and the first order diffraction angle is θ1 = 2θB = 170 µrad. Diffraction of the lithium atomic wave is seen by tuning the angle i between the mirror and the atomic beam axis as shown in figure 1a. Figure 1b presents the zero-order beam intensity measured with our detector. This signal is symmetrical around the beam axis and the Bragg condition is fulfilled for ±1 diffraction orders. Figure 1a. Experimental set-up for Bragg diffraction. Figure 1b. Zero-order beam intensity as a function of the angle i between the mirror and the beam axis.
We have developed a Mach-Zehnder atom interferometer which uses elastic diffraction of lithium atom on laser standing waves for the coherent manipulation of the atom wave. The interference signal is of sufficient quality to achieve a phase sensitivity near 10 milliradians/. With this apparatus, we have recently measured the index of refraction of several gases for lithium waves. The interference signals give access to the real and imaginary parts of () and we have tested the linear dependence of these two quantities with gas density. The measured values of () are in good agreement with calculations and they exhibit glory oscillations, as predicted by theory.
Ushered forth by advances in time and frequency metrology, atom interferometry remains an indispensable measurement tool in atomic physics due to its precision and versatility. A sequence of four
pi/2 beam splitter pulses can create either an interferometer sensitive to the atom's recoil frequency when the momentum imparted by the light reverses direction between pulse pairs or, when constructed from pulses without such reversal, sensitive to the perturbing potential from an external optical field. Here, we demonstrate the first atom interferometer with laser-cooled lithium, advantageous for its low mass and simple atomic structure. We study both a recoil-sensitive Ramsey-Bord\\'e interferometer and interferometry sensitive to the dynamic polarizability of the ground state of lithium. Recoil-sensitive Ramsey-Bord\\'e interferometry benefits from lithium's high recoil frequency, a consequence of its low mass. At an interrogation time of 10 ms, a Ramsey-Bord\\'e lithium interferometer could achieve sensitivities comparable to those realized at much longer times with heavier alkali atoms. However, in contrast with other atoms that are used for atom interferometry, lithium's unresolved excited-state hyperfine structure precludes the the cycling transition necessary for efficient cooling. Without sub-Doppler cooling techniques. As as result, a lithium atomic gas is typically laser cooled to temperatures around 300
muK, above the Doppler limit, and well above the recoil temperature of 6
muK. This higher temperature gas expands rapidly during the operation of an atom interferometer, limiting the experimental interrogation time and preventing spatially resolved detection. In this work, a light-pulse lithium matter-wave interferometer is demonstrated in spite of these limitation. Two-photon Raman interferometer pulses coherently couple the atom's spin and momentum and are thus able to spectrally resolve the outputs. These fast pulses drive conjugate interferometers simultaneously which beat with a fast frequency component proportional to the atomic recoil frequency and an envelope modulated by the two-photon detuning of the Raman transition. We detect the summed signal at short experimental times, preventing perturbation of the signal from vibration noise. This demonstration of a sub-recoil measurement with a super-recoil sample opens the door to similar scheme with other particles that are difficult to trap and cool well, like electrons. An interferometer instead composed of
pi/2-pulses with a single direction of momentum transfer, can be sensitive to the dynamic polarizability of the atomic ground state. By scanning the frequency of an external driving field, such a measurement can be used to determine the atom's tune-out wavelength. This is the wavelength at which the frequency-dependent polarizability vanishes due to compensating ac-Stark shifts from other atomic states. Lithium's simple atomic structure allows for a precise computation of properties with only {\\em ab initio} wave functions and spectroscopic data. A direct interferometric measurement of lithium's red tune-out wavelength at 670.971626(1) nm, is a precise comparison to existing `all-order' atomic theory computations. It also provides another way to experimentally determine the
S− to
P− transitions matrix elements, for which large correlations and small values complicate computations. Finally, a future measurement of lithium's ultraviolet tune-out wavelength of at 324.192(2) nm would be sensitive to relativistic approximations in the atomic structure description.Atom interferometry simultaneously verifies existing atomic theory with measurements of atomic properties and searches for exotic physics lurking in plain sight. The techniques developed here broaden the applicability of interferometry and increase measurement sensitivity by simplifying cooling, increasing atom number and reducing the cycle time. Overcoming the current experimental limitations on interrogation time would allow for ultra-precise measurements of both the tune-out wavelength and the fine structure constant.
Light pulses have proven to be a powerful and versatile tool to implement beam splitters and mirrors for matter waves enabling atom interferometers. However, for high-precision measurements with such devices the specific realization is crucial and novel techniques might increase the sensitivity. To illustrate the diversity of light-pulse beam splitting and the subtle differences between the diffraction mechanisms, we study atomic Raman, Bragg, and the new method of double Bragg diffraction in a coherent way. Moreover, we introduce a versatile formalism to determine the interference signal of a Mach-Zehnder geometry and give an interpretation in terms of proper-time difference. In addition, we explore the feasibility of a specular mirror for atoms, which might lead to an interferometer testing the equivalence principle.
We have constructed an atom interferometer using three 200 nm period transmission gratings. The two interfering portions of each atom’s wave pass on opposite sides of a stretched metal foil. A fringe amplitude of up to 900 cps is observed, which allows us to determine the phase to 15 milliradians in 1 minute. By applying different interactions to the two sides of the interferometer, we have determined the electric polarizability of the ground state of sodium, the coherence length of our beam, and the differential phase shifts and coherences of the different Zeeman ground states in a magnetic field. Some future prospects of separated beam experiments are discussed.