Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE

Superconducting niobium nanowire single photon detectors

Anthony J. Annunziata, A. Frydman, Matthew O. Reese, Luigi Frunzio, Michael J. Rooks, D. E. Prober

Published Oct 18, 2006• 14 citations
Publisher

Abstract

We have fabricated and tested single photon detectors based on a current biased superconducting niobium nanowire patterned into a meander. The detectors are fabricated from high quality, ultra high vacuum sputtered niobium thin films on a sapphire substrate. For detection of single optical photons, we show that the superconductor's intrinsic kinetic inductance does not limit the reset time of the detector, which is ≈ 2 nanoseconds, in contrast to the longer reset times seen in niobium nitride detectors of similar size and geometry. We also describe a readout scheme for photon counting that is unique to Nb due to its lower resistivity. These detectors have applications in imaging of infrared photoemission from CMOS logic circuits as well as in optical communications and quantum information processing.

DOI
10.1117/12.686301

Related papers

Niobium Superconducting Nanowire Single-Photon Detectors

A.J. Annunziata, Daniel F. Santavicca, J.D. Chudow +4 more

We investigate the performance of superconducting nanowire photon detectors fabricated from ultra-thin Nb. A direct comparison is made between these detectors and similar nanowire detectors fabricated from NbN. We find that Nb detectors are significantly more susceptible than NbN to thermal instability (latching) at high bias. We show that the devices can be stabilized by reducing the input resistance of the readout. Nb detectors optimized in this way are shown to have approximately 2/3 the reset time of similar large-active-area NbN detectors of the same geometry, with approximately 6% detection efficiency for single photons at 470 nm.

arXiv:0901.1146•IEEE Transactions on Applied Superconductivity•Jun 1, 2009•57 citations

Simulation Of Superconducting Nanowire Single-Photon Detector With Circuit Modeling

Seyed Ali Sedigh Zyabari, Abbas Zarifkar

Single photon detectors have been fabricated NbN nano wire. These detectors are fabricated from high quality, ultra high vacuum sputtered NbN thin films on a sapphire substrate. In this work a typical schematic of the nanowire Single Photon Detector structure and then driving and measurement electronic circuit are shown. The response of superconducting nanowire single photon detectors during a photo detection event, is modeled by a special electrical circuits (two circuit). Finally, current through the wire is calculated by solving equations of models.

•Mar 27, 2008•0 citations

Epitaxial niobium nitride superconducting nanowire single-photon detectors

Risheng Cheng, John G. Wright, Huili Grace Xing +2 more

Superconducting nanowires used in single-photon detectors have been realized on amorphous or poly-crystalline films. Here, we report the first use of single-crystalline NbN thin films for superconducting nanowire single-photon detectors (SNSPDs). Grown by molecular beam epitaxy (MBE) at high temperature on nearly lattice-matched AlN-on-sapphire substrates, the NbN films exhibit a high degree of uniformity and homogeneity. Even with relatively thick films, the fabricated nanowire detectors show saturated internal efficiency at near-IR wavelengths, demonstrating the potential of MBE-grown NbN for realizing large arrays of on-chip SNSPDs and their integration with AlN-based χ(2) quantum photonic circuits.

arXiv:2006.09643•Applied Physics Letters•Sep 28, 2020•45 citations

Performances of NbTiN superconducting nanowire single photon detector

Shigehito Miki, Taro Yamashita, Hirotaka Terai +1 more

We present high performance fiber-coupled niobium titanium nitride superconducting nanowire single photon detectors fabricated on thermally oxidized silicon substrates. By applying a double sided cavity structure, simulated absorptance in the nanowire meander reached 97% at 1550 nm wavelength. The fabricated device showed a system detection efficiency (DE) of 74% at 1550 nm, dark count rate of 100 c/s, and a full width at half maximum timing jitter of 68 ps under a bias current of 18.0 μA with a practical Gifford-McMahon cryocooler system.

IEEE International Superconductive Electronics Conference (ISEC)•Jul 1, 2013•1 citation

Superconducting Nanowire Single-Photon Detector on Aluminum Nitride

Di Zhu, Hyeongrak Choi, Tsung‐Ju Lu +5 more

We report successful fabrication of niobium nitride single-photon detectors on aluminum nitride substrates. The fabricated detectors showed saturated detection efficiency at 2.45 K under 1550 nm illumination (indicating near-unity internal quantum efficiency), sub-60-ps jitter, and ∼6 ns reset time.

Conference on Lasers and Electro-Optics•Jan 1, 2016•14 citations

Superconducting single photon detectors for ultrasensitive visible and IR detection

R. Espiau de Lamaëstre, L. Maingault, Laurent Frey +5 more

Superconducting single photons detectors (SSPDs) have emerged in recent years as a promising alternative for fast and sensitive infrared detectors working in the photon counting mode. In particular, those detectors combine very low dark count rates (below 1 Hz), high speed (above 1GHz), photon number resolution and reasonable quantum efficiency (10 % at telecom wavelengths). They already found applications in quantum cryptography systems and integrated circuit failure analysis, but could also be used as ultimate sensors in matrix configurations. We show here the optimization of SSPD fabrication and their optical metrology at CEA. SSPD are fabricated by patterning a 80 nm wide nanowire in a very thin (4 nm) NbN film on sapphire, forming a pixel of several microns size. A cryogenic all-fibered optoelectronic system has been developed and allows precise metrology of the optical performances of SSPD. When biasing near the critical current of the nanowire, we demonstrate a detection quantum efficiency of 8 % at 1.55 μm, which is also found to be strongly polarization dependent. This quantum efficiency being limited by optical absorption, we propose a prism coupling based absorption enhancing structure that allows reaching 100 % quantum efficiency.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Jan 22, 2009•4 citations
We have fabricated and tested single photon detectors based on a current biased superconducting niobium nanowire patterned into a meander. The detectors are fabricated from high quality, ultra high vacuum sputtered niobium thin films on a sapphire substrate. For detection of single optical photons, we show that the superconductor's intrinsic kinetic inductance does not limit the reset time of the detector, which is ≈ 2 nanoseconds, in contrast to the longer reset times seen in niobium nitride detectors of similar size and geometry. We also describe a readout scheme for photon counting that is unique to Nb due to its lower resistivity. These detectors have applications in imaging of infrared photoemission from CMOS logic circuits as well as in optical communications and quantum information processing.
We investigate the performance of superconducting nanowire photon detectors fabricated from ultra-thin Nb. A direct comparison is made between these detectors and similar nanowire detectors fabricated from NbN. We find that Nb detectors are significantly more susceptible than NbN to thermal instability (latching) at high bias. We show that the devices can be stabilized by reducing the input resistance of the readout. Nb detectors optimized in this way are shown to have approximately 2/3 the reset time of similar large-active-area NbN detectors of the same geometry, with approximately 6% detection efficiency for single photons at 470 nm.
Single photon detectors have been fabricated NbN nano wire. These detectors are fabricated from high quality, ultra high vacuum sputtered NbN thin films on a sapphire substrate. In this work a typical schematic of the nanowire Single Photon Detector structure and then driving and measurement electronic circuit are shown. The response of superconducting nanowire single photon detectors during a photo detection event, is modeled by a special electrical circuits (two circuit). Finally, current through the wire is calculated by solving equations of models.
Superconducting nanowires used in single-photon detectors have been realized on amorphous or poly-crystalline films. Here, we report the first use of single-crystalline NbN thin films for superconducting nanowire single-photon detectors (SNSPDs). Grown by molecular beam epitaxy (MBE) at high temperature on nearly lattice-matched AlN-on-sapphire substrates, the NbN films exhibit a high degree of uniformity and homogeneity. Even with relatively thick films, the fabricated nanowire detectors show saturated internal efficiency at near-IR wavelengths, demonstrating the potential of MBE-grown NbN for realizing large arrays of on-chip SNSPDs and their integration with AlN-based χ(2) quantum photonic circuits.
We present high performance fiber-coupled niobium titanium nitride superconducting nanowire single photon detectors fabricated on thermally oxidized silicon substrates. By applying a double sided cavity structure, simulated absorptance in the nanowire meander reached 97% at 1550 nm wavelength. The fabricated device showed a system detection efficiency (DE) of 74% at 1550 nm, dark count rate of 100 c/s, and a full width at half maximum timing jitter of 68 ps under a bias current of 18.0 μA with a practical Gifford-McMahon cryocooler system.
Superconducting single photons detectors (SSPDs) have emerged in recent years as a promising alternative for fast and sensitive infrared detectors working in the photon counting mode. In particular, those detectors combine very low dark count rates (below 1 Hz), high speed (above 1GHz), photon number resolution and reasonable quantum efficiency (10 % at telecom wavelengths). They already found applications in quantum cryptography systems and integrated circuit failure analysis, but could also be used as ultimate sensors in matrix configurations. We show here the optimization of SSPD fabrication and their optical metrology at CEA. SSPD are fabricated by patterning a 80 nm wide nanowire in a very thin (4 nm) NbN film on sapphire, forming a pixel of several microns size. A cryogenic all-fibered optoelectronic system has been developed and allows precise metrology of the optical performances of SSPD. When biasing near the critical current of the nanowire, we demonstrate a detection quantum efficiency of 8 % at 1.55 μm, which is also found to be strongly polarization dependent. This quantum efficiency being limited by optical absorption, we propose a prism coupling based absorption enhancing structure that allows reaching 100 % quantum efficiency.