Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Japanese Journal of Applied Physics

High Bias Frequency Operation of a Microwave SQUID at 35 GHz

Yukinobu Miki, Taizō Masumi

Published Aug 1, 1980• 0 citations
Publisher

Abstract

An rf-SQUID with the bias frequency raised to 35 GHz has been successfully operated for the first time. The principle of designing the SQUID is the naive extension of the SQUIDs at 10 GHz previously reported to the millimeter wave region. At present, the SQUID at 35 GHz has a slightly poorer signal-to-noise ratio than the SQUIDs at 10 GHz and also the highest limit of the output band-width is confined to about 1 MHz. However, several possibilities for improving the style and configuration remain for the future.

DOI
10.1143/jjap.19.l498

Related papers

An Ultrafast Operation of Microwave SQUID's Biased at 35 GHz

Hiroo Fuma, Yukinobu Miki, Taizō Masumi

A microwave SQUID biased at 35 GHz with a Nb point contact has been improved in its characteristic performance, by changing the configuration of a SQUID, from the 35 GHz size to the 9 GHz size which is oversize for the 35 GHz microwave. About a 10 times larger signal output and higher frequency response up to 100 MHz have been directly obtained. Further, it has been confirmed for the first time that the SQUID biased at 35 GHz does respond up to the 9 GHz input signal by using the Bessel function method.

Japanese Journal of Applied Physics•Oct 1, 1980•2 citations

A Simple and Stable Microwave SQUID

Yoshiko Kikuchi, Yukinobu Miki, Taizō Masumi

A new, simple and stable type of microwave SQUID has been developed successfully at 10 GHz by using a bridge type junction which can be fabricated very easily. In consequence of adopting a junction of this type, the microwave SQUID has the merit of being free from adjustment and endures several heating cycles between room and liquid He temperatures. This type of SQUID has a slightly poorer S/N ratio, to be improved in future, but has the same characteristics as previously reported SQUIDs with a point contact junction.

Japanese Journal of Applied Physics•May 1, 1980•2 citations

Radio-frequency amplifiers based on dc SQUIDs

Michael Mück, R. McDermott

SQUIDs are an attractive candidate for the amplification of low-level rf and microwave signals. Compared to semiconductor amplifiers, they offer lower noise and much lower power dissipation. Especially at frequencies below 1 GHz, the improvement in noise temperature compared to the best cold semiconductor amplifiers can be as high as 50; noise temperatures only slightly above the quantum limit have been achieved in this frequency range. This article will review the current status of radio-frequency amplifiers based on dc SQUIDs and provide detailed discussions of amplifier noise temperature, input and output impedance, and nonlinearities.

Superconductor Science and Technology•Jul 19, 2010•50 citations

Direct Observations of the 500 MHz Q-Patterns from the 10 and 35 GHz SQUID's

Yukinobu Miki, Hiroo Fuma, Taizō Masumi

The 500 MHz Quantum Interference patterns (Q-patterns) beyond 100 MHz previously reported have been directly observed for the first time from 10 and 35 GHz Superconducting Quantum Interference Devices (SQUID's). The observation was made by improving the bandwidth of the detection circuits, which was supposed to be the cause of the previous limitation on Q-patterns from the 10 and 35 GHz SQUID's. An improved system including a 10 or 35 GHz SQUID has possible applications to the measurement of signals due to even faster magnetic flux changes.

Japanese Journal of Applied Physics•May 1, 1982•3 citations

Planar microwave biased radio frequency SQUIDs with a cryogenic preamplifier

Michael Mück, G. Hallmanns, Christoph Heiden +4 more

We report on the design and performance of a planar microwave rf-SQUID readout by a cryogenic preamplifier. The SQUID-sensor consists of a planar half-wavelength microstrip resonator, into which the SQUID-loop is integrated. The pump frequency is 1.7 GHz. The cryogenic preamplifier employs a microwave high electron mobility transistor (HEMT), located close to the SQUID sensor. Measurements of the flux noise and the fractional step rise parameter were carried out in the temperature range between 4.2 and 1.5 K. In an open loop white flux noise values of 2×10−6 Φ0/√Hz were obtained at 4.2 K.

Applied Physics Letters•Sep 7, 1992•6 citations

Performance factors in rf SQUIDs--High frequency limit

Robert A. Buhrman, L. D. Jackel

The mode of operation of rf SQUIDs in the limit where the bias frequency ω exceeds the natural R/L frequency of the SQUID ring is analyzed. Optimum coupling conditions are presented and the intrinsic noise limits are discussed.

IEEE Transactions on Magnetics•Jan 1, 1977•24 citations
An rf-SQUID with the bias frequency raised to 35 GHz has been successfully operated for the first time. The principle of designing the SQUID is the naive extension of the SQUIDs at 10 GHz previously reported to the millimeter wave region. At present, the SQUID at 35 GHz has a slightly poorer signal-to-noise ratio than the SQUIDs at 10 GHz and also the highest limit of the output band-width is confined to about 1 MHz. However, several possibilities for improving the style and configuration remain for the future.
A microwave SQUID biased at 35 GHz with a Nb point contact has been improved in its characteristic performance, by changing the configuration of a SQUID, from the 35 GHz size to the 9 GHz size which is oversize for the 35 GHz microwave. About a 10 times larger signal output and higher frequency response up to 100 MHz have been directly obtained. Further, it has been confirmed for the first time that the SQUID biased at 35 GHz does respond up to the 9 GHz input signal by using the Bessel function method.
A new, simple and stable type of microwave SQUID has been developed successfully at 10 GHz by using a bridge type junction which can be fabricated very easily. In consequence of adopting a junction of this type, the microwave SQUID has the merit of being free from adjustment and endures several heating cycles between room and liquid He temperatures. This type of SQUID has a slightly poorer S/N ratio, to be improved in future, but has the same characteristics as previously reported SQUIDs with a point contact junction.
SQUIDs are an attractive candidate for the amplification of low-level rf and microwave signals. Compared to semiconductor amplifiers, they offer lower noise and much lower power dissipation. Especially at frequencies below 1 GHz, the improvement in noise temperature compared to the best cold semiconductor amplifiers can be as high as 50; noise temperatures only slightly above the quantum limit have been achieved in this frequency range. This article will review the current status of radio-frequency amplifiers based on dc SQUIDs and provide detailed discussions of amplifier noise temperature, input and output impedance, and nonlinearities.
The 500 MHz Quantum Interference patterns (Q-patterns) beyond 100 MHz previously reported have been directly observed for the first time from 10 and 35 GHz Superconducting Quantum Interference Devices (SQUID's). The observation was made by improving the bandwidth of the detection circuits, which was supposed to be the cause of the previous limitation on Q-patterns from the 10 and 35 GHz SQUID's. An improved system including a 10 or 35 GHz SQUID has possible applications to the measurement of signals due to even faster magnetic flux changes.
We report on the design and performance of a planar microwave rf-SQUID readout by a cryogenic preamplifier. The SQUID-sensor consists of a planar half-wavelength microstrip resonator, into which the SQUID-loop is integrated. The pump frequency is 1.7 GHz. The cryogenic preamplifier employs a microwave high electron mobility transistor (HEMT), located close to the SQUID sensor. Measurements of the flux noise and the fractional step rise parameter were carried out in the temperature range between 4.2 and 1.5 K. In an open loop white flux noise values of 2×10−6 Φ0/√Hz were obtained at 4.2 K.