Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Superconducting Analog to Digital Converters

Joel M. Schoen

Published Sep 1, 1991• 0 citations
OpenAlex

Abstract

Contents: Superconducting Analog-to-Digital Converter Work at MITRE; Development of a Rapidly Tunable Microwave Source; Design and Evaluation of a Josephson Array Oscillator; Obtaining High-Accuracy Measurements from Low-Accuracy Measurements; Superconducting Microwave Transmission Lines; High Performance, Superconducting Analog-to-Digital Converter; Edge Sharpening with Josephson Junction; Design Evaluation of a Subranging Superconducting Analog-to-Digital Converter; Feasibility Study of a Superconducting Sigma-Delta Analog-to- Digital Converter, and VHDL Simulation Study of Superconducting Sigma Delta Modulators.

Related papers

Superconducting modulators for analog-to-digital converters

Peter Magnusson

The main topic of this thesis is the evaluation of performance of super-conducting rst- and second-order low-pass sigma-delta modulators. Superconducting electronics comprise characteristics such as very high switching speed, natural quantization, high sensitivity and low noise, proper-ties that are all essential for modulators used in high performance analog-to-digital converters (ADC). Sigma-delta modulators trade speed for improved resolution using feedback mechanisms making superconducting electronics an interesting alternative technology for the implementation. With linear models and device-level simulations the performance of these modulators have been evaluated. The linear model of the rst-order sigma-delta modulator shows that the performance, for a given oversampling ratio, only depends on the cut-o frequency of the RL-lter used. This is veried by device-level simulations and the results from the two methods are in good agreement. Device-level simulations of the second-order sigma-delta modu-

•Jan 1, 2005•1 citation

Design optimization for microwave coupling structures of a digital-to-analog converter based on series arrays of high-temperature superconducting Josephson junctions

K. Yu. Platov, Alexander M. Klushin, M. Yu. Kupriyanov +1 more

Physica C Superconductivity•Feb 1, 2001•0 citations

Superconductive Signal-Processing Circuits

T. Van Duzer

This work addresses new signal processing circuits using the special features of superconductivity. A novel flash-type analog-to-digital converter based on a comparator invented in the preceding contract period was demonstrated. The comparator was shown to be useful as a logic gate and an encoder was designed with it. A high-resolution delta-sigma analog-to-digital converter was devised with superconductive components in spite of the lack of an analog integrator in this technology. Positive theoretical results are being followed up experimentally. A simple flux-shuttle single-flux-quantum shift register was devised and several different readout schemes were studied. A six- bit-long version was successfully tested at 1 GHz. A decoder that takes in a five-bit word to select one of 32 output lines was completed. The design involved very tight limitations on current and power. The decoder was combined with a serial-to-parallel converter and operated at 2 GHz. A study of the appropriate architectures for various types of superconductive or Josephson digital technology was developed: an inductance-extraction program.

NASA STI/Recon Technical Report N•Aug 1, 1994•0 citations

Analysis of superconducting analog-to-digital converter front-end for improved resolution and large dynamic range

Pascal Febvre, Héla Gassara, Patricia Desgreys +1 more

Analog-to-digital converters (ADCs) are key components of most digital systems, as the necessary interface between the analogue world to send and receive signals. Semiconductor ADC systems are intrinsically limited to low frequency ranges of a few GHz and associated to dynamic ranges limited by linearity issues. Superconductor electronic ADCs rely on the magnetic flux quantization and do not suffer from the linearity issues. Moreover, the Rapid-Single-Flux Quantum (RSFQ) technique [1] allows the sampling of signals far in the microwave range, of the order of 100 GHz for the fastest circuits with state-of-the-art low critical temperature niobium-based technology.Two main applications require the use of fast and high dynamic range superconducting ADCs: future ground- or space-based telecommunication systems for software defined radio (SDR) and all systems requiring very high dynamic range in the 120-180 dB range. In this last category, one can find the digital Superconducting Quantum Interference Devices (SQUIDs) that combine the digitization due to the RSFQ technique, with the ultrasensitive sensing of magnetic fields, that are of interest for several applications, ranging from Non-Destructive Evaluation (NDE) to the detection of faint geomagnetic signatures [2].In this work, we will describe in details an analysis of performances of two different kinds of ADCs, respectively for space and geophysics applications. New designs with their electrical circuits will be described for operation in the microwave frequency band with a sigma-delta architecture, and for improved dynamic range with a delta design. The performance in terms of number of bits or dynamic range, frequency bandwidth and ultimate sampling speed will be compared with the ones of existing ADCs. Considerations about the layout due to technological considerations are taken into account in the design. Trade-offs between performance and technologies will be emphasized.[1] K. Likharev and V. Semenov, IEEE Trans. Appl. Supercond. 1, 3 (1991).[2] T. Reich, P. Febvre, T. Ortlepp, F. H. Uhlmann, J. Kunert, R. Stolz, and H.-G. Meyer, Journal of Applied Physics 104(2), 024509 (2008).

•Apr 25, 2010•0 citations

Superconductor analog-to-digital converters and their applications

Deepnarayan Gupta, Amol Inamdar, Dmitri E. Kirichenko +2 more

A wide variety of applications, ranging from radio-frequency (RF) receivers for broadband communications and signal detection, on earth and in space, would benefit from high-performance superconductor analog-to-digital converters (ADCs), based on magnetic flux quantization and fast switching Josephson junctions. Superconductor ADCs are capable of very high sample rates (100 GHz or more), very high linearity, and high sensitivity. Nyquist-rate ADCs use the high sample rate to digitize a wide instantaneous bandwidth (tens of GHz) and are useful for wideband spectrum monitoring as well as high-end scientific instrumentation. Delta and delta-sigma oversampling ADCs use the high linearity to achieve programmable trade-off between dynamic range and instantaneous bandwidth. These lowpass and bandpass ADCs have been used for direct digitization of narrower (tens to hundreds of MHz) RF bands in the 1-20 GHz range for a variety of communications, intelligence, electronic warfare, and radar applications. Another application area of these cryogenic ADCs is for outputs of cryogenic sensor arrays and terahertz mixers. Recent advances in various classes of ADCs for different applications are described.

IEEE MTT-S International Microwave Symposium digest•Jun 1, 2011•23 citations

Superconducting modulators for high dynamic range delta-sigma analog-to-digital converters

A. Hodge Worsham, Donald L. Miller, Paul D. Dresselhaus +2 more

Superconducting digital circuits are capable of producing high dynamic range analog-to-digital converters (ADCs). We present sigma-delta architectures using large (>100) oversampling ratios to give signal-to-noise ratios of greater than 100 dB in simulation. Three distinct designs, using two distinct mechanisms for feedback, are presented. All of the designs use only shunted junctions, and are therefore compatible with HTS SNS junctions. Simulations are presented for a modulator which creates feedback pulses by SQUID lobe-crossings, a modulator which uses the transresistance of a SQUID for feedback, and a modulator which uses threshold crossings in both the first and second loops for feedback.

IEEE Transactions on Applied Superconductivity•Jun 1, 1999•26 citations
Contents: Superconducting Analog-to-Digital Converter Work at MITRE; Development of a Rapidly Tunable Microwave Source; Design and Evaluation of a Josephson Array Oscillator; Obtaining High-Accuracy Measurements from Low-Accuracy Measurements; Superconducting Microwave Transmission Lines; High Performance, Superconducting Analog-to-Digital Converter; Edge Sharpening with Josephson Junction; Design Evaluation of a Subranging Superconducting Analog-to-Digital Converter; Feasibility Study of a Superconducting Sigma-Delta Analog-to- Digital Converter, and VHDL Simulation Study of Superconducting Sigma Delta Modulators.
The main topic of this thesis is the evaluation of performance of super-conducting rst- and second-order low-pass sigma-delta modulators. Superconducting electronics comprise characteristics such as very high switching speed, natural quantization, high sensitivity and low noise, proper-ties that are all essential for modulators used in high performance analog-to-digital converters (ADC). Sigma-delta modulators trade speed for improved resolution using feedback mechanisms making superconducting electronics an interesting alternative technology for the implementation. With linear models and device-level simulations the performance of these modulators have been evaluated. The linear model of the rst-order sigma-delta modulator shows that the performance, for a given oversampling ratio, only depends on the cut-o frequency of the RL-lter used. This is veried by device-level simulations and the results from the two methods are in good agreement. Device-level simulations of the second-order sigma-delta modu-
This work addresses new signal processing circuits using the special features of superconductivity. A novel flash-type analog-to-digital converter based on a comparator invented in the preceding contract period was demonstrated. The comparator was shown to be useful as a logic gate and an encoder was designed with it. A high-resolution delta-sigma analog-to-digital converter was devised with superconductive components in spite of the lack of an analog integrator in this technology. Positive theoretical results are being followed up experimentally. A simple flux-shuttle single-flux-quantum shift register was devised and several different readout schemes were studied. A six- bit-long version was successfully tested at 1 GHz. A decoder that takes in a five-bit word to select one of 32 output lines was completed. The design involved very tight limitations on current and power. The decoder was combined with a serial-to-parallel converter and operated at 2 GHz. A study of the appropriate architectures for various types of superconductive or Josephson digital technology was developed: an inductance-extraction program.
Analog-to-digital converters (ADCs) are key components of most digital systems, as the necessary interface between the analogue world to send and receive signals. Semiconductor ADC systems are intrinsically limited to low frequency ranges of a few GHz and associated to dynamic ranges limited by linearity issues. Superconductor electronic ADCs rely on the magnetic flux quantization and do not suffer from the linearity issues. Moreover, the Rapid-Single-Flux Quantum (RSFQ) technique [1] allows the sampling of signals far in the microwave range, of the order of 100 GHz for the fastest circuits with state-of-the-art low critical temperature niobium-based technology.Two main applications require the use of fast and high dynamic range superconducting ADCs: future ground- or space-based telecommunication systems for software defined radio (SDR) and all systems requiring very high dynamic range in the 120-180 dB range. In this last category, one can find the digital Superconducting Quantum Interference Devices (SQUIDs) that combine the digitization due to the RSFQ technique, with the ultrasensitive sensing of magnetic fields, that are of interest for several applications, ranging from Non-Destructive Evaluation (NDE) to the detection of faint geomagnetic signatures [2].In this work, we will describe in details an analysis of performances of two different kinds of ADCs, respectively for space and geophysics applications. New designs with their electrical circuits will be described for operation in the microwave frequency band with a sigma-delta architecture, and for improved dynamic range with a delta design. The performance in terms of number of bits or dynamic range, frequency bandwidth and ultimate sampling speed will be compared with the ones of existing ADCs. Considerations about the layout due to technological considerations are taken into account in the design. Trade-offs between performance and technologies will be emphasized.[1] K. Likharev and V. Semenov, IEEE Trans. Appl. Supercond. 1, 3 (1991).[2] T. Reich, P. Febvre, T. Ortlepp, F. H. Uhlmann, J. Kunert, R. Stolz, and H.-G. Meyer, Journal of Applied Physics 104(2), 024509 (2008).
A wide variety of applications, ranging from radio-frequency (RF) receivers for broadband communications and signal detection, on earth and in space, would benefit from high-performance superconductor analog-to-digital converters (ADCs), based on magnetic flux quantization and fast switching Josephson junctions. Superconductor ADCs are capable of very high sample rates (100 GHz or more), very high linearity, and high sensitivity. Nyquist-rate ADCs use the high sample rate to digitize a wide instantaneous bandwidth (tens of GHz) and are useful for wideband spectrum monitoring as well as high-end scientific instrumentation. Delta and delta-sigma oversampling ADCs use the high linearity to achieve programmable trade-off between dynamic range and instantaneous bandwidth. These lowpass and bandpass ADCs have been used for direct digitization of narrower (tens to hundreds of MHz) RF bands in the 1-20 GHz range for a variety of communications, intelligence, electronic warfare, and radar applications. Another application area of these cryogenic ADCs is for outputs of cryogenic sensor arrays and terahertz mixers. Recent advances in various classes of ADCs for different applications are described.
Superconducting digital circuits are capable of producing high dynamic range analog-to-digital converters (ADCs). We present sigma-delta architectures using large (>100) oversampling ratios to give signal-to-noise ratios of greater than 100 dB in simulation. Three distinct designs, using two distinct mechanisms for feedback, are presented. All of the designs use only shunted junctions, and are therefore compatible with HTS SNS junctions. Simulations are presented for a modulator which creates feedback pulses by SQUID lobe-crossings, a modulator which uses the transresistance of a SQUID for feedback, and a modulator which uses threshold crossings in both the first and second loops for feedback.