arXiv:2609.23609
Casimir force in a water nanolayer confined by graphene sheets
Wijnand Broer, Jure Dobnikar
Abstract
Casimir forces, arising from quantum and thermal fluctuations, depend strongly on the electromagnetic susceptibilities of the interacting materials. Here, we theoretically investigate the Casimir force between two graphene sheets separated by a nanometer-thin layer of liquid water. We find that deviations from the bulk case can be as large as 24 \%, mostly due to the static susceptibility components. This effect does not decrease monotonically as a function of the layer thickness: it increases up to a maximum at 70 nm and it slowly declines to the bulk limit only at 1 micron. This is due to two competing effects: on one hand, the anisotropy decreases with the layer thickness; on the other hand, the relative contribution of the most anisotropic, static susceptibility components increases.
AI Summary
How does confinement-induced dielectric anisotropy of water modify the Casimir pressure between two graphene sheets? The paper calculates the pressure at $T=300\,\mathrm{K}$ for water-layer thicknesses from $0.7\,\mathrm{nm}$ to $2\,\mu\mathrm{m}$ using Lifshitz theory with an out-of-plane uniaxial dielectric tensor and a local Kubo conductivity for graphene. Material inputs combine measured static permittivities, molecular-dynamics frequency-dependent susceptibilities, and bulk-water optical data; thickness dependence is modeled phenomenologically where data are unavailable. Relative to treating the water as bulk and isotropic, the calculated attractive pressure is reduced, with bulk-model overestimates reaching about $20\%$ below $6\,\mathrm{nm}$ and $24\%$ overall. The discrepancy is nonmonotonic: it peaks near $70\,\mathrm{nm}$ and falls below $5\%$ only around $1\,\mu\mathrm{m}$. Above $6\,\mathrm{nm}$, modeled confinement effects enter only through the zero-frequency Matsubara term, for which $P_0=-k_BT\zeta(3)\varepsilon_\perp(0)/(8\pi a^3\varepsilon_\parallel(0))$. The maximum reflects competition between decreasing dielectric anisotropy and increasing relative importance of this thermal term. The magnitude and long-distance persistence depend strongly on the assumed series-capacitor model for the perpendicular static permittivity and lack direct experimental verification. Short-distance frequency-dependent inputs cover only three sampled thicknesses, and static values at $0.7\,\mathrm{nm}$ are extrapolated. The calculation assumes confinement leaves electronic polarization unchanged. The paper also identifies limitations of local graphene conductivity, notes that substrates or nonlocal response could change the results, and discusses ionic screening of the static contribution.
Error found: The abstract omits the body's explicit qualification that the predicted 24% maximum and long-ranged thickness dependence depend mainly on an experimentally unverified series-capacitor model for the static perpendicular permittivity. At 0.7 nm, the stated permittivities, zero-mode pressure formula, and approximately 20% bulk overestimate require nonzero Matsubara terms to supply at least approximately 99.75% of the confined pressure, contradicting the claim that they supply only a few percent.
Written by gpt-6.1-sol from the paper's full text. Automated: it can be wrong.
- Comments
- 8 pages, 6 figures