arXiv:2610.21437
Casimir forces on suspended thin dielectric membranes covered with graphene
Tze Ue Ngai, Zuocheng Zhang, Q. Zhang, Youssef Jeyar, Jingwei Li, Zhengtang Luo, Mauro Antezza, H. B. Chan
Abstract
We investigate the Casimir force on thin suspended dielectric layers covered with graphene, both theoretically and experimentally. Thermal effects of the Casimir force on graphene occur at separations significantly smaller compared to ordinary metals and dielectrics. At such small separations, the Casimir force is sufficiently strong to be measured experimentally. However, the presence of substrates to support the graphene significantly reduces the enhancement. We show theoretically that replacing the solid substrate beneath graphene with a thin dielectric membrane partially restores this strong thermal dependence. One of the interacting objects is a solid gold plate. The other object is a suspended dielectric membrane made of either 15 nm of silicon oxide or 13 nm silicon nitride, covered with graphene. At a separation of $\sim$500 nm, theoretical predictions yield changes in the Casimir pressure of up to 54 % and 40 % for silicon oxide and silicon nitride, respectively, when the temperature is increased from 10 K to 294 K. Measurements were performed for graphene on a suspended silicon nitride membrane at room temperature, using a gold-coated sphere attached to a cantilever as the force sensor. The measured force gradient is consistent with the theoretical prediction, although the thermal dependence could not be resolved, in part because of uncertainties in the optical properties of silicon nitride. Replacing a bulk substrate with a thin dielectric membrane covered with graphene provides a substantial reduction of the Casimir force, which may facilitate the stable operation of neutral nanomechanical elements at small separations.
AI Summary
The paper asks whether supporting graphene on a thin suspended dielectric membrane, rather than a bulk substrate, can recover its enhanced thermal Casimir response while providing sufficient mechanical stability for force measurements. Lifshitz-theory calculations combine a temperature-dependent graphene conductivity with dielectric response models for a gold plate and graphene-covered membranes. Near $500\,\mathrm{nm}$ separation, increasing temperature from $10$ to $294\,\mathrm{K}$ raises the predicted pressure by approximately $54\%$ for a $15\,\mathrm{nm}$ silicon-oxide membrane and $40\%$ for a $13\,\mathrm{nm}$ silicon-nitride membrane, compared with approximately $7\%$ and $5\%$ for the corresponding thick supported structures. Room-temperature measurements use a gold-coated sphere attached to a resonant cantilever facing graphene on a suspended, approximately $13\,\mathrm{nm}$-thick silicon-nitride membrane. Electrostatic calibration determines separation and force-gradient sensitivity; the proximity-force approximation connects measurements to planar calculations. The measured gradients are consistent with predictions within uncertainties. At $250\,\mathrm{nm}$, the sphere-radius-normalized gradient is about five times smaller than in previous gold-surface measurements and approximately $40\%$ smaller than previous measurements involving graphene-covered solid dielectrics. The experiment does not resolve the predicted thermal contribution. Stated limitations include incomplete knowledge of silicon-nitride optical properties, membrane thickness and nonuniformity, an unmeasured graphene chemical potential on nitride, and possible transfer residues and trapped charges. Calculations compensate missing silicon-nitride spectral weight with a constant permittivity shift. Silicon-oxide membranes proved too fragile for successful sample preparation; estimated nitride deformation under experimental forces is below $0.3\,\mathrm{nm}$.
Written by gpt-6.1-sol from the paper's full text. Automated: it can be wrong.
- Comments
- 9 pages, 5 figures