arXiv:2609.19784 · Physical Review A
Transduction-Enabled Superconducting Quantum Repeater: Toward Deterministic Entanglement Distribution with High-Fidelity Gates
Francesco Fiorini, Jing Wu, Andrew Cameron, Changqing Wang, Doga M. Kurkcuoglu, Rosario G. Garroppo, Michele Pagano, Silvia Zorzetti
Abstract
Long-distance entanglement distribution is hindered by photon loss in optical fibers and the nocloning theorem. Optical quantum repeater (QR) protocols rely on Bell state measurements (BSMs), they are intrinsically limited to probabilistic photon operations and fail 50% of the time. We propose a hybrid approach to building quantum repeaters that combines the high transmission speed of photonic qubits in optical fiber with the high-fidelity quantum processing capabilities enabled by superconducting circuits. The transduction-enabled superconducting QR (TESQR) architecture eliminates the need for probabilistic BSMs and allows deterministic processing operations. The TESQR framework always yields a final state at the remote nodes rather than aborting on photon loss, manifesting deterministic entanglement distribution within certain parameter regimes. We evaluate the performance by assessing output-state fidelities and success probabilities of entanglement distribution using realistic noise models. Additionally, we integrate an entanglement purification scheme and evaluate the performance through numerical simulations in QuTiP environment. Our results show that, for entanglement swapping, the proposed scheme improves the entanglement distribution rate by an average of 63% and by up to 159% compared with photonic-only architectures. Moreover, after purification, the end-to-end fidelities exceed 0.8 over distances up to 20 km.
AI Summary
The paper examines whether microwave–optical transduction can enable superconducting repeater nodes to replace probabilistic linear-optical Bell-state measurements with deterministic local gates and readout. It considers a single midpoint node: each endpoint generates a single-rail photonic–superconducting Bell pair, sends the photonic mode through fiber, and transfers it via transduction and coupling to a superconducting qubit for gate-based entanglement swapping. An analytical noise model combines fiber attenuation, thermal-loss transduction, imperfect photon–qubit transfer, depolarizing gate errors, and readout errors. Success is defined as the summed probability of measurement outcomes whose remote-state Bell fidelity exceeds $0.5$. Under this criterion, all outcomes are successful over a parameter-dependent short-distance regime; for transduction efficiency $\eta_t=0.99$, this extends to approximately $14$ km per fiber segment. Across the tested scenarios, success probability improves by an average of $63\%$ and a maximum of $159\%$ relative to a single-rail photonic swapping benchmark with equal detection and transduction efficiencies. These are per-attempt success-probability comparisons, rather than timing-based rate estimates. QuTiP Monte Carlo simulations additionally evaluate one or two rounds of bilateral purification before swapping, reporting end-to-end fidelities above $0.8$ over total distances up to $20$ km, with reduced yield and additional pair consumption. The analysis assumes ideal sources and memories, omits resource-cost accounting, and uses a truncated photonic Hilbert space. Current transduction demonstrations have not reached the efficiencies required for deployment. Always obtaining an output state does not ensure entanglement outside the identified operating regimes, and purification remains probabilistic.
Central claim may not hold: The reported 63% and 159% advantages are calculated as per-attempt success-probability gains, without the timing and resource analysis needed to establish entanglement-distribution-rate gains. The fixed extraction efficiencies in the stated transducer model impose eta_t <= 0.81, excluding the eta_t = 0.99–1 operating points used for the strongest performance claims. The analytical post-transduction matrix omits higher-photon sectors and is subnormalized at nonzero added thermal noise, leaving those events unaccounted for in the subsequent success probabilities. Local S gates correct the Bell-pair phase but do not prepare the noisy inputs in Werner form, so the stated BBPSSW preparation and its general threshold justification are incorrect.
Written by gpt-6.1-sol from the paper's full text. Automated: it can be wrong.