Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:2512.20367 · Conference on Precision Electromagnetic Measurements

Electrical drive of a Josephson junction array using a cryogenic BiCMOS pulse generator

Yerzhan Kudabay, Oliver Kieler, Michael Starkloff, Marco Schubert, Michael Haas, Johannes Kohlmann, Vadim Issakov, Mark Bieler

cond-mat.supr-conquant-phSubmitted Dec 23, 2025• Announced Dec 24, 2025• 2 citations• Revised Sep 16, 2026 (v2)
v1 · Dec 23, 2025v2 · Sep 16, 2026
arXivHTMLPDF

Abstract

We have combined a cryogenic BiCMOS integrated circuit with a superconducting Josephson junction array. The BiCMOS circuit serves as an on-chip pulse generator delivering return-to-zero pulses with pulse frequencies of up to 15 GHz. With this microwave drive, we observe wide and flat Shapiro steps in the voltage-versus-current characteristics of the Josephson junction array. To the best of our knowledge, this is the first integration of a Josephson junction array with a cryogenic BiCMOS chip. Our results pave the way to a hybrid and fully integrated Josephson arbitrary waveform synthesizer with possible applications in quantum electronics and quantum voltage metrology.

Comments
2 pages, 2 figures

Related papers

A Cross-Type SNS Junction Array for a Quantum-Based Arbitrary Waveform Synthesizer

M. Schubert, T. May, G. Wende +1 more

Central to quantum-based arbitrary waveform synthesizers is a Josephson junction array driven by short pulses. Its linear dimensions should be small compared to the line wavelength in order to generate an ac voltage with quantum accuracy. Therefore, we use coplanar strip transmission lines to integrate a large number of cross-type SNS Josephson junctions into multiple parallel arrays. First measurements show that a circuit with 1,760 junctions exhibits Shapiro steps over a large frequency range. By using pulse driving the chip generates unipolar voltages up to 6.4 mV at a clock frequency of 3.5 GHz, the maximum frequency of the available pulse pattern generator.

IEEE Transactions on Applied Superconductivity•Jun 1, 2005•19 citations

RF Josephson Arbitrary Waveform Synthesizer With Integrated Superconducting Diplexers

Akim A. Babenko, Nathan E. Flowers-Jacobs, Gregor Lasser +5 more

We present the design and characterization of a broadband RF Josephson arbitrary waveform synthesizer (RF-JAWS) with a series array of 4500 Josephson junctions (JJs) and integrated low-pass/high-pass five-pole superconducting diplexers. The integrated diplexers enable broadband filtering of the feedthrough signal components in the drive-current pulses with decade-wide instantaneous bandwidth. The diplexers have at least 30 GHz passband with less than 0.8 dB insertion loss. The JJ array is driven with a delta-sigma pulse sequence that encodes 10 kHz and 1.005 GHz tones, and generates an open-circuit voltage of 22 mV rms (−26.18 dBm available power assuming a 50$\mathrm{\Omega }$Thevenin equivalent source) at 1.005 GHz—a 25% increase compared to the state of the art. The drive current pulses undergo a three-step equalization to compensate for the linear distortion of the room-temperature electronics, the on-chip diplexers, and the remaining on- and off-chip components. The measured parasitic feedthrough voltages at 1.005 GHz are around −33 dBc, and their effect on the quantum locking ranges (QLRs) is quantified by measurements. The results demonstrated in this article show a significant step toward a broadband, integrated, quantum-based microwave voltage source with useful power above −30 dBm.

IEEE Transactions on Applied Superconductivity•Aug 24, 2022•9 citations

Josephson voltage standard microwave circuit driven at 10 GHz

H.‐G. Meyer, Heiner Kohler, G. Wende +5 more

We have investigated a new type of microwave circuit for the generation of frequency-scaled Josephson voltages useful for the representation of highly accurate reference voltages. The circuit consists of a superconducting microstrip resonator and series arrays of Josephson junctions integrated within its rf current antinodes. The circuit is designed to operate at low frequencies of about 10 GHz to simplify the microwave techniques. At a resonator circuit with four Josephson junctions driven at 10.9 GHz we have obtained stable overlapping Shapiro steps up to 4.6 mV at a step width of about 70 µA. A more advanced double-resonator circuit with altogether 216 junctions allows to generate scaled reference voltages up to 0.16 V at steps of about 25 µA in width and at a microwave frequency of 11.1 GHz.

Journal de Physique IV (Proceedings)•Jun 1, 1994•0 citations

Precision Measurements Using a 300 mV Josephson Arbitrary Waveform Synthesizer

Samuel P. Benz, Paul D. Dresselhaus, Charles J. Burroughs +1 more

We have developed a Josephson digital-to-analog converter, otherwise know as a Josephson arbitrary waveform synthesizer, with 300 mV peak output voltage. This is the first system of its kind with demonstrated quantum accuracy. We show precision synthesized waveforms from dc to 100 kHz with measured distortion and harmonic content below 115 dBc (dB below the carrier or fundamental). The heart of the system is a superconducting microwave integrated circuit with two Josephson junction arrays biased in parallel for the microwave drive and connected in series to double the voltage for the audio frequency output waveforms. New superconducting integrated circuits with twice as many stacked junctions and improved microwave circuits have allowed us to more than double the output voltage of our recent system. We also demonstrate that quantum-based synthesized arbitrary waveforms (not just sine waves) can be used for precision measurements of a high-performance commercial analog-to-digital converter.

IEEE Transactions on Applied Superconductivity•Jun 1, 2007•52 citations

Improved design of superconductor/normal conductor/superconductor Josephson junction series arrays for an ac Josephson voltage standard

Oliver Kieler, J. Kohlmann, Franz Müller

Superconductor/normal conductor/superconductor (SNS) Josephson junction series arrays are the subject of research for the realization of a Josephson arbitrary waveform synthesizer (JAWS) based on pulse-driven Josephson junctions. Lumped arrays of SNS Josephson junctions are investigated for this application at the Physikalisch-Technische Bundesanstalt (PTB). The series arrays consisting of Nb/HfTi/Nb SNS junctions are embedded in the center line of a coplanar waveguide transmission line. To increase the ac output voltage, the Josephson junction series array is designed as a meander-like structure. A broadband response of the arrays is required for the complex pulse operation of the JAWS. The arrays are investigated by dc measurements and for test purposes under continuous microwave irradiation at different frequencies. Flat Shapiro steps were measured for meander-like series arrays with 21 parallel lines containing up to 10 752 junctions. A sine wave with a frequency of 2.5 kHz and a peak voltage of 214 mV Peak was synthesized under pulse mode operation.

Superconductor Science and Technology•Oct 18, 2007•28 citations

Pulsation of InGaAs Photodiodes in Liquid Helium for Driving Josephson Arrays in AC Voltage Realization

Bjørnar Karlsen, Oliver Kieler, Ralf Behr +4 more

A commercially available InGaAs p-i-n photodiode chip has been custom packaged and high-speed operated in liquid helium. The photodiode was driven by light pulses using a dc-biased 1310-nm laser, a Mach-Zehnder modulator, and a return-to-zero pulse pattern generator up to 15 GHz clock frequencies, which produced pulse widths down to 77 ps and maximum peak current heights above 10 mA. With the prospect of using this photodiode assembly to operate pulse-driven Josephson junction arrays for ac voltage realization, pulsation modes with constant pulse width and varying pulse density were applied to the diode, which resulted in consistent pulse shapes for bit rates as high as 7.5 Gb/s. This could yield realizable peak voltages as high as 15.525 μV per Josephson junction. Time-lapse pulse measurements were performed over the span of 90 min, which demonstrated good waveform stability. Using the measured current waveforms, the behavior of a typical Josephson junction was simulated according to the Stewart-McCumber model, which resulted in an operational margin of 2 mA for the first Shapiro step.

IEEE Transactions on Applied Superconductivity•Apr 22, 2019•14 citations
We have combined a cryogenic BiCMOS integrated circuit with a superconducting Josephson junction array. The BiCMOS circuit serves as an on-chip pulse generator delivering return-to-zero pulses with pulse frequencies of up to 15 GHz. With this microwave drive, we observe wide and flat Shapiro steps in the voltage-versus-current characteristics of the Josephson junction array. To the best of our knowledge, this is the first integration of a Josephson junction array with a cryogenic BiCMOS chip. Our results pave the way to a hybrid and fully integrated Josephson arbitrary waveform synthesizer with possible applications in quantum electronics and quantum voltage metrology.
Central to quantum-based arbitrary waveform synthesizers is a Josephson junction array driven by short pulses. Its linear dimensions should be small compared to the line wavelength in order to generate an ac voltage with quantum accuracy. Therefore, we use coplanar strip transmission lines to integrate a large number of cross-type SNS Josephson junctions into multiple parallel arrays. First measurements show that a circuit with 1,760 junctions exhibits Shapiro steps over a large frequency range. By using pulse driving the chip generates unipolar voltages up to 6.4 mV at a clock frequency of 3.5 GHz, the maximum frequency of the available pulse pattern generator.
We present the design and characterization of a broadband RF Josephson arbitrary waveform synthesizer (RF-JAWS) with a series array of 4500 Josephson junctions (JJs) and integrated low-pass/high-pass five-pole superconducting diplexers. The integrated diplexers enable broadband filtering of the feedthrough signal components in the drive-current pulses with decade-wide instantaneous bandwidth. The diplexers have at least 30 GHz passband with less than 0.8 dB insertion loss. The JJ array is driven with a delta-sigma pulse sequence that encodes 10 kHz and 1.005 GHz tones, and generates an open-circuit voltage of 22 mV rms (−26.18 dBm available power assuming a 50Ω\mathrm{\Omega }ΩThevenin equivalent source) at 1.005 GHz—a 25% increase compared to the state of the art. The drive current pulses undergo a three-step equalization to compensate for the linear distortion of the room-temperature electronics, the on-chip diplexers, and the remaining on- and off-chip components. The measured parasitic feedthrough voltages at 1.005 GHz are around −33 dBc, and their effect on the quantum locking ranges (QLRs) is quantified by measurements. The results demonstrated in this article show a significant step toward a broadband, integrated, quantum-based microwave voltage source with useful power above −30 dBm.
We have investigated a new type of microwave circuit for the generation of frequency-scaled Josephson voltages useful for the representation of highly accurate reference voltages. The circuit consists of a superconducting microstrip resonator and series arrays of Josephson junctions integrated within its rf current antinodes. The circuit is designed to operate at low frequencies of about 10 GHz to simplify the microwave techniques. At a resonator circuit with four Josephson junctions driven at 10.9 GHz we have obtained stable overlapping Shapiro steps up to 4.6 mV at a step width of about 70 µA. A more advanced double-resonator circuit with altogether 216 junctions allows to generate scaled reference voltages up to 0.16 V at steps of about 25 µA in width and at a microwave frequency of 11.1 GHz.
We have developed a Josephson digital-to-analog converter, otherwise know as a Josephson arbitrary waveform synthesizer, with 300 mV peak output voltage. This is the first system of its kind with demonstrated quantum accuracy. We show precision synthesized waveforms from dc to 100 kHz with measured distortion and harmonic content below 115 dBc (dB below the carrier or fundamental). The heart of the system is a superconducting microwave integrated circuit with two Josephson junction arrays biased in parallel for the microwave drive and connected in series to double the voltage for the audio frequency output waveforms. New superconducting integrated circuits with twice as many stacked junctions and improved microwave circuits have allowed us to more than double the output voltage of our recent system. We also demonstrate that quantum-based synthesized arbitrary waveforms (not just sine waves) can be used for precision measurements of a high-performance commercial analog-to-digital converter.
Superconductor/normal conductor/superconductor (SNS) Josephson junction series arrays are the subject of research for the realization of a Josephson arbitrary waveform synthesizer (JAWS) based on pulse-driven Josephson junctions. Lumped arrays of SNS Josephson junctions are investigated for this application at the Physikalisch-Technische Bundesanstalt (PTB). The series arrays consisting of Nb/HfTi/Nb SNS junctions are embedded in the center line of a coplanar waveguide transmission line. To increase the ac output voltage, the Josephson junction series array is designed as a meander-like structure. A broadband response of the arrays is required for the complex pulse operation of the JAWS. The arrays are investigated by dc measurements and for test purposes under continuous microwave irradiation at different frequencies. Flat Shapiro steps were measured for meander-like series arrays with 21 parallel lines containing up to 10 752 junctions. A sine wave with a frequency of 2.5 kHz and a peak voltage of 214 mV Peak was synthesized under pulse mode operation.
A commercially available InGaAs p-i-n photodiode chip has been custom packaged and high-speed operated in liquid helium. The photodiode was driven by light pulses using a dc-biased 1310-nm laser, a Mach-Zehnder modulator, and a return-to-zero pulse pattern generator up to 15 GHz clock frequencies, which produced pulse widths down to 77 ps and maximum peak current heights above 10 mA. With the prospect of using this photodiode assembly to operate pulse-driven Josephson junction arrays for ac voltage realization, pulsation modes with constant pulse width and varying pulse density were applied to the diode, which resulted in consistent pulse shapes for bit rates as high as 7.5 Gb/s. This could yield realizable peak voltages as high as 15.525 μV per Josephson junction. Time-lapse pulse measurements were performed over the span of 90 min, which demonstrated good waveform stability. Using the measured current waveforms, the behavior of a typical Josephson junction was simulated according to the Stewart-McCumber model, which resulted in an operational margin of 2 mA for the first Shapiro step.