Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:2503.12865 · Results in Physics

Single-photon-added coherent state-based postselected weak measurement

Yi-Fang Ren, Yusuf Turek

Published Jul 30, 2025• 1 citation
arXivHTMLPDF

Abstract

We investigated precision measurements in a two-level system coupled to a single-photon-added coherent state (SPACS) under postselected weak measurement. We analyzed strategies for improving measurement precision, including parameter estimation and the signal-to-noise ratio (SNR) in postselected weak measurements, using the photon statistics of SPACS as the meter. Our results demonstrate that SPACS-based postselected weak measurements can outperform conventional measurement schemes in terms of precision. Additionally, we explicitly introduced an alternative weak measurement method, which is commonly applied in dispersive light-atom interactions. Our work presents a novel approach to addressing fundamental issues in quantum precision measurement based on photon statistics, and it provides a method for extracting the photon and phase shifts of radiation fields through the weak values of system observables.

DOI
10.1016/j.rinp.2025.108367

Related papers

Improving the Precision of Weak Measurements by Postselection Measurement

Shengshi Pang, Todd A. Brun

Postselected weak measurement is a useful protocol for amplifying weak physical effects. However, there has recently been controversy over whether it gives any advantage in precision. While it is now clear that retaining failed postselections can yield more Fisher information than discarding them, the advantage of postselection measurement itself still remains to be clarified. In this Letter, we address this problem by studying two widely used estimation strategies: averaging measurement results, and maximum likelihood estimation, respectively. For the first strategy, we find a surprising result that squeezed coherent states of the pointer can give postselected weak measurements a higher signal-to-noise ratio than standard ones while all standard coherent states cannot, which suggests that raising the precision of weak measurements by postselection calls for the presence of "nonclassicality" in the pointer states. For the second strategy, we show that the quantum Fisher information of postselected weak measurements is generally larger than that of standard weak measurements, even without using the failed postselection events, but the gap can be closed with a proper choice of system state.

arXiv:1409.2567•Physical Review Letters•Sep 15, 2015•128 citations

Fisher information analysis on weak-value-amplification metrology using optical coherent states

Yingxin Liu, Lupei Qin, Xin-Qi Li

The weak-value-amplification (WVA) technique has been extensively considered and debated in the field of quantum precision measurement, largely owing to the reduced Fisher information caused by the low probability of successful postselection. In this work we show that, rather than the transverse-spatial-wave-function meter typically considered, using the optical coherent state as a meter, the WVA measurement can outperform the conventional measurement not involving the strategy of postselection. We also show that the postselection procedure involved in the WVA scheme can make a mixture of coherent states work better than a pure coherent state with identical average photon numbers. This is in contrast to the main result proved in the absence of postselection. The postselection strategy can also result in the precision of Heisenberg scaling with the photon numbers without using expensive quantum resources. The present work may stimulate further interest in postselection strategy for quantum precision measurements.

arXiv:2201.13016•Physical Review A•Aug 30, 2022•21 citations

Studying the squeezing effect and phase-space distribution of a single-photon-added coherent state using a postselected von Neumann measurement

Wen Jun Xu, Taximaiti Yusufu, Yusuf Turek

In this paper, ordinary and amplitude-squared squeezing as well as Wigner functions of single-photon-added coherent state after postselected von Neumann measurements are investigated. The analytical results show that the weak measurement procedure, which is characterized by postselection and weak value, can significantly change the principal squeezing feature of the single-photon-added coherent state. From the analysis of the Winger function we notice that in the strong measurement regime significant interference structures manifest and the negative regions become larger than the initial pointer state. Our results indicate that after postselected von Neumann measurement the degree of nonclassicality of single-photon-added coherent state is increased. It is anticipated that this work may provide alternate and effective methods for solving the state optimization problems based on the single-photon-added coherent state pointer via a postselected von Neumann measurement technique.

arXiv:2109.05423•Physical Review A•Feb 16, 2022•5 citations

Single-photon-added coherent states: estimation of parameters and fidelity of the optical homodyne detection

Sergey N. Filippov, Vladimir I. Man’ko, A S Coelho +2 more

The travelling modes of single-photon-added coherent states (SPACS) are characterized by using optical homodyne tomography. Given a set of experimentally measured quadrature distributions, we estimate parameters of the state and also extract information about the detector efficiency. The method used is minimal distance estimation between theoretical and experimental quantities, which additionally allows to evaluate the precision of the estimated parameters. Given the experimental data, we also estimate the lower and upper bounds on fidelity. The results are believed to encourage a more precise engineering and detection of SPACS.

arXiv:1301.2084•Physica Scripta•Mar 1, 2013•15 citations

Achieving metrological precision limits through postselection

G. B. Alves, Arthur Pimentel, Malena O. Hor-Meyll +3 more

Postselection strategies have been proposed with the aim of amplifying weak signals, which may help to overcome detection thresholds associated with technical noise in high-precision measurements. Here we use an optical setup to experimentally explore two different postselection protocols for the estimation of a small parameter: a weak-value amplification procedure and an alternative method that does not provide amplification but nonetheless is shown to be more robust for the sake of parameter estimation. Each technique leads approximately to the saturation of quantum limits for the estimation precision, expressed by the Cram\'er-Rao bound. For both situations, we show that parameter estimation is improved when the postselection statistics are considered together with the measurement device.

arXiv:1606.03478•Physical Review A•Jan 6, 2017•16 citations

Quantum measurements with preselection and postselection

Xuanmin Zhu, Yu-Xiang Zhang, Shengshi Pang +3 more

We study quantum measurement with preselection and postselection, and derive the precise expressions of the measurement results without any restriction on the coupling strength between the system and the measuring device. For a qubit system, we derive the maximum pointer shifts by choosing appropriate initial and finial states. A significant amplification effect is obtained when the interaction between the system and the measuring device is very weak, and typical ideal quantum measurement results are obtained when the interaction is strong. The improvement of the signal-to-noise ratio (SNR) and the enhancement of the measurement sensitivity (MS) by weak measurements are studied. Without considering the probability decrease due to postselection, the SNR and the MS can be both significantly improved by weak measurements; however, neither SNR nor MS can be effectively improved when the probability decrease is considered.

arXiv:1108.1608•Physical Review A•Nov 16, 2011•110 citations
We investigated precision measurements in a two-level system coupled to a single-photon-added coherent state (SPACS) under postselected weak measurement. We analyzed strategies for improving measurement precision, including parameter estimation and the signal-to-noise ratio (SNR) in postselected weak measurements, using the photon statistics of SPACS as the meter. Our results demonstrate that SPACS-based postselected weak measurements can outperform conventional measurement schemes in terms of precision. Additionally, we explicitly introduced an alternative weak measurement method, which is commonly applied in dispersive light-atom interactions. Our work presents a novel approach to addressing fundamental issues in quantum precision measurement based on photon statistics, and it provides a method for extracting the photon and phase shifts of radiation fields through the weak values of system observables.
Postselected weak measurement is a useful protocol for amplifying weak physical effects. However, there has recently been controversy over whether it gives any advantage in precision. While it is now clear that retaining failed postselections can yield more Fisher information than discarding them, the advantage of postselection measurement itself still remains to be clarified. In this Letter, we address this problem by studying two widely used estimation strategies: averaging measurement results, and maximum likelihood estimation, respectively. For the first strategy, we find a surprising result that squeezed coherent states of the pointer can give postselected weak measurements a higher signal-to-noise ratio than standard ones while all standard coherent states cannot, which suggests that raising the precision of weak measurements by postselection calls for the presence of "nonclassicality" in the pointer states. For the second strategy, we show that the quantum Fisher information of postselected weak measurements is generally larger than that of standard weak measurements, even without using the failed postselection events, but the gap can be closed with a proper choice of system state.
The weak-value-amplification (WVA) technique has been extensively considered and debated in the field of quantum precision measurement, largely owing to the reduced Fisher information caused by the low probability of successful postselection. In this work we show that, rather than the transverse-spatial-wave-function meter typically considered, using the optical coherent state as a meter, the WVA measurement can outperform the conventional measurement not involving the strategy of postselection. We also show that the postselection procedure involved in the WVA scheme can make a mixture of coherent states work better than a pure coherent state with identical average photon numbers. This is in contrast to the main result proved in the absence of postselection. The postselection strategy can also result in the precision of Heisenberg scaling with the photon numbers without using expensive quantum resources. The present work may stimulate further interest in postselection strategy for quantum precision measurements.
In this paper, ordinary and amplitude-squared squeezing as well as Wigner functions of single-photon-added coherent state after postselected von Neumann measurements are investigated. The analytical results show that the weak measurement procedure, which is characterized by postselection and weak value, can significantly change the principal squeezing feature of the single-photon-added coherent state. From the analysis of the Winger function we notice that in the strong measurement regime significant interference structures manifest and the negative regions become larger than the initial pointer state. Our results indicate that after postselected von Neumann measurement the degree of nonclassicality of single-photon-added coherent state is increased. It is anticipated that this work may provide alternate and effective methods for solving the state optimization problems based on the single-photon-added coherent state pointer via a postselected von Neumann measurement technique.
The travelling modes of single-photon-added coherent states (SPACS) are characterized by using optical homodyne tomography. Given a set of experimentally measured quadrature distributions, we estimate parameters of the state and also extract information about the detector efficiency. The method used is minimal distance estimation between theoretical and experimental quantities, which additionally allows to evaluate the precision of the estimated parameters. Given the experimental data, we also estimate the lower and upper bounds on fidelity. The results are believed to encourage a more precise engineering and detection of SPACS.
Postselection strategies have been proposed with the aim of amplifying weak signals, which may help to overcome detection thresholds associated with technical noise in high-precision measurements. Here we use an optical setup to experimentally explore two different postselection protocols for the estimation of a small parameter: a weak-value amplification procedure and an alternative method that does not provide amplification but nonetheless is shown to be more robust for the sake of parameter estimation. Each technique leads approximately to the saturation of quantum limits for the estimation precision, expressed by the Cram\'er-Rao bound. For both situations, we show that parameter estimation is improved when the postselection statistics are considered together with the measurement device.
We study quantum measurement with preselection and postselection, and derive the precise expressions of the measurement results without any restriction on the coupling strength between the system and the measuring device. For a qubit system, we derive the maximum pointer shifts by choosing appropriate initial and finial states. A significant amplification effect is obtained when the interaction between the system and the measuring device is very weak, and typical ideal quantum measurement results are obtained when the interaction is strong. The improvement of the signal-to-noise ratio (SNR) and the enhancement of the measurement sensitivity (MS) by weak measurements are studied. Without considering the probability decrease due to postselection, the SNR and the MS can be both significantly improved by weak measurements; however, neither SNR nor MS can be effectively improved when the probability decrease is considered.