Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:2208.04542 · Scientific Reports

Measurement-based preparation of stable coherent states of a Kerr parametric oscillator

Yuta Suzuki, Shohei Watabe, Shiro Kawabata, Shumpei Masuda

Published Jan 28, 2023• 6 citations
arXivHTMLPDF

Abstract

Kerr parametric oscillators (KPOs) have attracted increasing attention in terms of their application to quantum information processing and quantum simulations. The state preparation and measurement of KPOs are typical requirements when used as qubits. The methods previously proposed for state preparations of KPOs utilize modulation of external fields such as a pump and drive fields. We study the stochastic state preparation of stable coherent states of a KPO with homodyne detection, which does not require modulation of external fields, and thus can reduce experimental efforts and exclude unwanted effects of possible imperfection in control of external fields. We quantitatively show that the detection data, if averaged over an optimal averaging time to decrease the effect of measurement noise, has a strong correlation with the state of the KPO, and therefore can be used to estimate the state (stochastic state preparation). We examine the success probability of the state estimation taking into account the measurement noise and bit flips. Moreover, the proper range of the averaging time to realize a high success probability is obtained by developing a binomial-coherent-state model, which describes the stochastic dynamics of the KPO under homodyne detection.

DOI
10.1038/s41598-023-28682-1

Related papers

Quantum Gate for a Kerr Nonlinear Parametric Oscillator Using Effective Excited States

Taro Kanao, Shumpei Masuda, Shiro Kawabata +1 more

A Kerr nonlinear parametric oscillator (KPO) can stabilize a quantum superposition of two coherent states with opposite phases, which can be used as a qubit. In a universal gate set for quantum computation with KPOs, an ${R}_{x}$ gate, which interchanges the two coherent states, is relatively hard to perform owing to the stability of the two states. We propose a method for a high-fidelity ${R}_{x}$ gate by exciting the KPO outside the qubit space with parity-selective transitions, which can be implemented by only adding a driving field. In this method, the utilization of higher effective excited states leads to a faster ${R}_{x}$ gate, rather than states near the qubit space. The proposed method can realize a continuous ${R}_{x}$ gate and thus is expected to be useful for, e.g., recently proposed variational quantum algorithms.

arXiv:2108.03091•Physical Review Applied•Jul 8, 2022•39 citations

Three Strongly Coupled Kerr Parametric Oscillators Forming a Boltzmann Machine

Gabriel Margiani, Orjan Ameye, Oded Zilberberg +1 more

Coupled Kerr parametric oscillators (KPOs) are a promising resource for classical and quantum analog computation, for example to find the ground state of Ising Hamiltonians. Yet, the state space of strongly coupled KPO networks is very involved. As such, their phase diagram sometimes features either too few or too many states, including some that cannot be mapped to Ising spin configurations. This complexity makes it challenging to find and meet the conditions under which an analog optimization algorithm can be successful. Here, we demonstrate how to use three strongly coupled KPOs as a simulator for an Ising Hamiltonian, and estimate its ground state using a Boltzmann sampling measurement. While fully classical, our Letter is directly relevant for quantum systems operating on coherent states.

arXiv:2504.04254•Physical Review Letters•Jul 29, 2025•6 citations

Quantum State Tomography for Kerr Parametric Oscillators

Yuta Suzuki, Shiro Kawabata, Tsuyoshi Yamamoto +1 more

Kerr parametric oscillators (KPOs) implemented in the circuit quantum electrodynamic architecture can operate as qubits. Their applications to quantum annealing and universal quantum computation have been studied intensively. For these applications, the readout of the state of KPOs is of practical importance. We develop a scheme of state tomography for KPOs with reflection measurement. Although it is known that the reflection coefficient depends on the state of the KPO, it is unclear whether tomography of a qubit encoded into a KPO can be performed in a practical way mitigating decoherence during the measurement, and how accurate it is. We show that the reflection coefficient has a one-to-one correspondence with a diagonal element of the density matrix of the qubit when a probe frequency is properly chosen and an additional single-photon drive is introduced. Thus, our scheme offers a novel way to read out the qubit along an axis of the Bloch sphere, and therefore the reflection measurement and single-qubit gates can constitute state tomography.

arXiv:2212.14627•Physical Review Applied•Sep 14, 2023•8 citations

State Estimation and Control for Stochastic Quantum Dynamics With Homodyne Measurement: Stabilizing Qubits Under Uncertainty

Nahid Binandeh Dehaghani, A. Pedro Aguiar, Rafał Wiśniewski

This paper introduces a Lyapunov-based control strategy alongside two filtering methods for controlling and estimating the evolution of coherence vector elements from sequential homodyne measurements. The methods include traditional quantum filtering and a novel extended Kalman filter, which explicitly addresses the dynamics of a stochastic master equation with correlated noise, thereby ensuring the quantum properties of the estimated state variable by design. We also explore scenarios where the system’s Hamiltonian is unknown, demonstrating that both filters exhibit reduced performance with increased estimation errors. To address this, we propose a multiple model estimation scheme applicable to either filter. The estimated density operator is then controlled using the proposed switching-based Lyapunov scheme, which guarantees noise-to-state practical stability in probability. We demonstrate the effectiveness of our approach in stabilizing a qubit coupled to a leaky cavity under homodyne detection, even with uncertainty in the resonance frequency.

arXiv:2403.07021•IEEE Access•Jan 1, 2024•2 citations

Fast elementary gates for universal quantum computation with Kerr parametric oscillator qubits

Taro Kanao, Hayato Goto

Kerr parametric oscillators (KPOs) can stabilize the superpositions of coherent states, which can be utilized as qubits, and are promising candidates for realizing hardware-efficient quantum computers. Although elementary gates for universal quantum computation with KPO qubits have been proposed, these gates are usually based on adiabatic operations and thus need long gate times, which result in errors caused by photon loss in KPOs realized by, e.g., superconducting circuits. In this work we accelerate the elementary gates by experimentally feasible control methods, which are based on numerical optimization of pulse shapes for shortcuts to adiabaticity. By numerical simulations, we show that the proposed methods can achieve speedups compared to adiabatic ones by up to six times with high gate fidelities of 99.9%. These methods are thus expected to be useful for quantum computers with KPOs.

arXiv:2310.20108•Physical Review Research•Feb 22, 2024•10 citations

Change in bit-flip times of Kerr parametric oscillators caused by their interactions

Yuya Kano, Yohei Kawakami, Shumpei Masuda +8 more

We experimentally investigate how interactions between Kerr parametric oscillators (KPOs) degrade their bit-flip times, where a bit flip is defined as a transition between the two degenerate ground states of a KPO. Interactions between KPOs cause quantum states of KPOs to leak outside the computational subspace, leading to bit flips. Bit flips degrade fidelity and pose a significant problem for KPO-based quantum information processing. We performed an experiment in which a weak microwave signal is injected into one KPO to emulate photon injection from another KPO, and find that the bit-flip time decreases by an order of magnitude due to induced excitations, depending on the frequency and power of the injected signal. Methods to mitigate the decrease in bit-flip times caused by interactions between KPOs are discussed, including adjusting the pump frequencies, coherent-state amplitudes, and couplings between KPOs. These findings provide valuable insights for scaling up KPO-based quantum computers.

quant-pharXiv:2603.29308•Apr 1, 2026•0 citations
Kerr parametric oscillators (KPOs) have attracted increasing attention in terms of their application to quantum information processing and quantum simulations. The state preparation and measurement of KPOs are typical requirements when used as qubits. The methods previously proposed for state preparations of KPOs utilize modulation of external fields such as a pump and drive fields. We study the stochastic state preparation of stable coherent states of a KPO with homodyne detection, which does not require modulation of external fields, and thus can reduce experimental efforts and exclude unwanted effects of possible imperfection in control of external fields. We quantitatively show that the detection data, if averaged over an optimal averaging time to decrease the effect of measurement noise, has a strong correlation with the state of the KPO, and therefore can be used to estimate the state (stochastic state preparation). We examine the success probability of the state estimation taking into account the measurement noise and bit flips. Moreover, the proper range of the averaging time to realize a high success probability is obtained by developing a binomial-coherent-state model, which describes the stochastic dynamics of the KPO under homodyne detection.
A Kerr nonlinear parametric oscillator (KPO) can stabilize a quantum superposition of two coherent states with opposite phases, which can be used as a qubit. In a universal gate set for quantum computation with KPOs, an Rx{R}_{x}Rx​ gate, which interchanges the two coherent states, is relatively hard to perform owing to the stability of the two states. We propose a method for a high-fidelity Rx{R}_{x}Rx​ gate by exciting the KPO outside the qubit space with parity-selective transitions, which can be implemented by only adding a driving field. In this method, the utilization of higher effective excited states leads to a faster Rx{R}_{x}Rx​ gate, rather than states near the qubit space. The proposed method can realize a continuous Rx{R}_{x}Rx​ gate and thus is expected to be useful for, e.g., recently proposed variational quantum algorithms.
Coupled Kerr parametric oscillators (KPOs) are a promising resource for classical and quantum analog computation, for example to find the ground state of Ising Hamiltonians. Yet, the state space of strongly coupled KPO networks is very involved. As such, their phase diagram sometimes features either too few or too many states, including some that cannot be mapped to Ising spin configurations. This complexity makes it challenging to find and meet the conditions under which an analog optimization algorithm can be successful. Here, we demonstrate how to use three strongly coupled KPOs as a simulator for an Ising Hamiltonian, and estimate its ground state using a Boltzmann sampling measurement. While fully classical, our Letter is directly relevant for quantum systems operating on coherent states.
Kerr parametric oscillators (KPOs) implemented in the circuit quantum electrodynamic architecture can operate as qubits. Their applications to quantum annealing and universal quantum computation have been studied intensively. For these applications, the readout of the state of KPOs is of practical importance. We develop a scheme of state tomography for KPOs with reflection measurement. Although it is known that the reflection coefficient depends on the state of the KPO, it is unclear whether tomography of a qubit encoded into a KPO can be performed in a practical way mitigating decoherence during the measurement, and how accurate it is. We show that the reflection coefficient has a one-to-one correspondence with a diagonal element of the density matrix of the qubit when a probe frequency is properly chosen and an additional single-photon drive is introduced. Thus, our scheme offers a novel way to read out the qubit along an axis of the Bloch sphere, and therefore the reflection measurement and single-qubit gates can constitute state tomography.
This paper introduces a Lyapunov-based control strategy alongside two filtering methods for controlling and estimating the evolution of coherence vector elements from sequential homodyne measurements. The methods include traditional quantum filtering and a novel extended Kalman filter, which explicitly addresses the dynamics of a stochastic master equation with correlated noise, thereby ensuring the quantum properties of the estimated state variable by design. We also explore scenarios where the system’s Hamiltonian is unknown, demonstrating that both filters exhibit reduced performance with increased estimation errors. To address this, we propose a multiple model estimation scheme applicable to either filter. The estimated density operator is then controlled using the proposed switching-based Lyapunov scheme, which guarantees noise-to-state practical stability in probability. We demonstrate the effectiveness of our approach in stabilizing a qubit coupled to a leaky cavity under homodyne detection, even with uncertainty in the resonance frequency.
Kerr parametric oscillators (KPOs) can stabilize the superpositions of coherent states, which can be utilized as qubits, and are promising candidates for realizing hardware-efficient quantum computers. Although elementary gates for universal quantum computation with KPO qubits have been proposed, these gates are usually based on adiabatic operations and thus need long gate times, which result in errors caused by photon loss in KPOs realized by, e.g., superconducting circuits. In this work we accelerate the elementary gates by experimentally feasible control methods, which are based on numerical optimization of pulse shapes for shortcuts to adiabaticity. By numerical simulations, we show that the proposed methods can achieve speedups compared to adiabatic ones by up to six times with high gate fidelities of 99.9%. These methods are thus expected to be useful for quantum computers with KPOs.
We experimentally investigate how interactions between Kerr parametric oscillators (KPOs) degrade their bit-flip times, where a bit flip is defined as a transition between the two degenerate ground states of a KPO. Interactions between KPOs cause quantum states of KPOs to leak outside the computational subspace, leading to bit flips. Bit flips degrade fidelity and pose a significant problem for KPO-based quantum information processing. We performed an experiment in which a weak microwave signal is injected into one KPO to emulate photon injection from another KPO, and find that the bit-flip time decreases by an order of magnitude due to induced excitations, depending on the frequency and power of the injected signal. Methods to mitigate the decrease in bit-flip times caused by interactions between KPOs are discussed, including adjusting the pump frequencies, coherent-state amplitudes, and couplings between KPOs. These findings provide valuable insights for scaling up KPO-based quantum computers.