We introduce a novel technique for efficiently cooling many-body quantum systems with unknown Hamiltonians down to their ground states with a high fidelity. This technique involves initially applying a strong external field followed by a sequence of single-degree-of-freedom (single-qubit) measurements and radio frequency pulses to polarize the system along the field direction. Subsequently, the field is adiabatically switched off, allowing the system to evolve toward its ground state as governed by the quantum adiabatic theorem. We present numerical simulation results demonstrating the effectiveness of the technique applied to quantum spin chains with long-range and short-range interactions as prototypes for many-body quantum systems.
We introduce a novel technique for efficiently cooling many-body quantum systems with unknown Hamiltonians down to their ground states with a high fidelity. This technique involves initially applying a strong external field followed by a sequence of single-degree-of-freedom (single-qubit) measurements and radio frequency pulses to polarize the system along the field direction. Subsequently, the field is adiabatically switched off, allowing the system to evolve toward its ground state as governed by the quantum adiabatic theorem. We present numerical simulation results demonstrating the effectiveness of the technique applied to quantum spin chains with long-range and short-range interactions as prototypes for many-body quantum systems.
A quantum resonator in a thermal-equilibrium state with a high temperature has a large average population and is featured with significant occupation over Fock states with a high excitation number. The resonator could be cooled down via continuous measurements on the ground state of a coupled two-level system (qubit). We find, however, that the measurement-induced cooling might become inefficient in the high-temperature regime. Beyond the conventional strategy, we introduce strong driving between the excited state of the qubit and an external level. It can remarkably broaden the cooling range in regard to the nonvanishing populated Fock states of the resonator. Without any precooling procedure, our strategy allows a significant reduction of the populations over Fock states with a high excitation number, giving rise to nondeterministic ground-state cooling after a sequence of measurements. The driving-induced fast transition constrains the resonator and the ancillary qubit at their ground state upon measurement and then simulates the quantum Zeno effect. Our protocol is applied to cool down a high-temperature magnetic resonator. Additionally, it is generalized to a hybrid cooling protocol by interpolating the methods with and without strong driving, which can accelerate the cooling process and increase the overlap between the final state of the resonator and its ground state.
Cooling a quantum system to its ground state is important for the characterization of nontrivial interacting systems and in the context of a variety of quantum information platforms. It can be achieved by employing measurement-based passive steering protocols, where the steering steps are predetermined and are not based on measurement readouts. However, measurements realized by coupling the system to auxiliary quantum degrees of freedom (“detectors”) are rather costly and protocols in which the number of detectors scales with system size will have limited practical applicability. Here, we identify conditions under which measurement-based cooling protocols can be taken to the ultimate dilute limit where the number of detectors is independent of system size. For two examples of frustration-free one-dimensional spin chains, we show that steering on a single link is sufficient to cool these systems into their unique ground states. We corroborate our analytical arguments with finite-size numerical simulations and discuss further applications of dilute cooling. Published by the American Physical Society 2024
We consider measurement-based quantum computation using the state of a spin-lattice system in equilibrium with a thermal bath and free to evolve under its own Hamiltonian. Any single qubit measurements disturb the system from equilibrium and, with adaptive measurements performed at a finite rate, the resulting dynamics reduces the fidelity of the computation. We show that it is possible to describe the loss in fidelity by a single quantum operation on the encoded quantum state that is independent of the measurement history. To achieve this simple description, we choose a particular form of spin-boson coupling to describe the interaction with the environment, and perform measurements periodically at a natural rate determined by the energy gap of the system. We found that an optimal cooling exists, which is a trade-off between keeping the system cool enough that the resource state remains close to the ground state, but also isolated enough that the cooling does not strongly interfere with the dynamics of the computation. For a sufficiently low temperature we obtain a fault-tolerant threshold for the couplings to the environment.
By coupling pairs of superconducting qubits through a small Josephson junction with a time-dependent flux bias, we show that arbitrary interactions involving any combination of Pauli matrices can be generated with a small number of drive tones applied through the flux bias of the coupling junction. We then demonstrate that similar (though not fully universal) results can be achieved in capacitively coupled qubits by exploiting the higher energy states of the devices through multiphoton drive signals applied to the qubits' flux degrees of freedom. By using this mechanism to couple a qubit to a detuned resonator, the qubit's rotating-frame state can be nondestructively measured along any direction on the Bloch sphere. Finally, we describe how the frequency-converting nature of the couplings can be used to engineer a mechanism analogous to dynamic nuclear polarization in NMR systems, capable of cooling an array of qubits well below the ambient temperature, and outline how higher-order interactions, such as local three-body terms, can be engineered through the same couplings. Our results demonstrate that a programmable quantum simulator for large classes of interacting spin models could be engineered with the same physical hardware.
Quantum mechanical ground states of many-body systems can be important resources for various investigations: for quantum sensing, for benchmarking quantum hardware with classically solvable states, as the initial states for nonequilibrium quantum dynamics following quenches, the simulation of quantum processes that start by coupling systems in ground states, eg, could be a process in quantum chemistry, while their approximations are required as inputs to quantum phase estimation algorithm. However, preparing ground states can be challenging; for example, it may require adiabatic switching of Hamiltonian terms slower than an inverse gap, which can be time consuming and bring in decoherence. Here we investigate the possibility of preparing a many-body entangled ground state of a certain Hamiltonian, which can be called a quantum ``problem'' Hamiltonian, using the time evolution of an initial fiducial state by another time independent ``solver'' Hamiltonian with couplings up to unit strength for a very short fixed (unit) time: a ``time efficient'' ansatz. The parameters of the solver Hamiltonian are optimised classically minimising energy as the cost function. We present a study of up to n=14 qubit many-body states prepared using this methodology. Importantly, we find that a strategy of combining a warm start (an already prepared ground state of a n−1 qubit Hamiltonian) and incrementally adding extra couplings of a qubit is the best scaling strategy to prepare the ground state of a n-qubit Hamiltonian.
Probing correlated states of many-body systems is one of the central tasks for quantum simulators and processors. A promising approach to state preparation is to realize desired correlated states as steady states of engineered dissipative evolution. A recent experiment with a Google superconducting quantum processor [X. Mi , Science 383, 1332 (2024)] demonstrated a cooling algorithm utilizing auxiliary degrees of freedom that are periodically reset to remove quasiparticles from the system, thereby driving it towards its ground state. In this work, we develop a kinetic-theory framework to describe quasiparticle cooling dynamics, and employ it to compare the efficiency of different cooling algorithms. In particular, we introduce a protocol where coupling to auxiliaries is modulated in time to minimize heating processes, and demonstrate that it allows a high-fidelity preparation of ground states in different quantum phases. We verify the validity of the kinetic-theory description by an extensive comparison with numerical simulations for the examples of a one-dimensional transverse-field Ising model, the transverse-field Ising model with an additional integrability-breaking field, and a nonintegrable antiferromagnetic Heisenberg spin ladder. In all cases, we are able to efficiently cool into the many-body ground state. The effects of noise, which limits efficiency of variational quantum algorithms in near-term quantum processors, are investigated through the lens of the kinetic theory: we show how the steady-state quasiparticle populations depend on the noise rate, and we establish maximum noise values for achieving high-fidelity ground states. This work establishes quasiparticle cooling algorithms as a practical, robust method for many-body state preparation on near-term quantum processors.