Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1912.07934 · Laser Physics Letters

On the continuous loading of a U-magneto-optical trap on an atom-chip in an ultra high vacuum

Vivek Singh, Vibhuti Bhushan Tiwari, Satya Ram Mishra

Published Jan 28, 2020• 10 citations
arXivHTMLPDF

Abstract

Abstract Here, we report our studies on the continuous loading of a U-magneto-optical trap (U-MOT) on an atom-chip with a rubidium-(Rb)-vapor-generated background using a dispenser source in an ultra high vacuum environment. Using the U-MOT loading curves, the partial pressure due to the Rb vapor and the pressure due to the background gas have been estimated near the MOT cloud position. The estimated pressure due to the Rb vapor increased from ∼ Torr to Torr as the Rb-dispenser current was increased from 2.8 to 3.4 A. The increase in dispenser current also resulted in a decrease in loading time as well as the lifetime of the MOT cloud. This study will be useful for magnetic trapping experiments where accurate information of the pressure in a chamber is important for the lifetime of the magnetic trap.

DOI
10.1088/1612-202x/ab6736

Related papers

Pulsed loading of a magneto-optical trap on an atom chip with fast recovery of ultrahigh vacuum

Vivek Singh, Vibhuti Bhushan Tiwari, A Chaudhary +2 more

Abstract Here, we present studies on pulsed loading of a rubidium (Rb) magneto-optical trap (MOT) in an ultra-high vacuum (UHV) environment on an atom chip. We have used a parallel combination of Rb dispensers for better heat dissipation to achieve fast UHV recovery in the chamber after the end of the current pulse to the dispensers. We have estimated the threshold heat energy required for activation of the dispensers for different values of current pulses. Although a pulse with a higher current value and shorter duration has a lower threshold heat energy, we operated the dispensers at moderate current pulse parameters (24 A, 10 s) for protection of the circuits. Nearly, 3 × 10 7 cold 87 Rb atoms were loaded in the MOT using this current pulse, with a UHV recovery time of ∼600 ms in the chamber. This fast recovery of UHV in the MOT chamber is useful for further experiments such as magnetic trapping and evaporative cooling of atoms in the same chamber.

arXiv:2403.11458•Laser Physics Letters•Dec 19, 2024•1 citation

Ultrahigh vacuum pressure measurement using magneto-optical trap on atom chip

S. Supakar, Vivek Singh, Vibhuti Bhushan Tiwari +1 more

In this work, the UHV background pressure as low as 1.1×10−10 Torr has been measured using the loss rate characteristics of a vapor-loaded magneto-optical trap (MOT) formed on an atom chip in a UHV chamber. The loss rate due to non-rubidium (Rb) gases in the background in the chamber has been estimated by operating the MOT in low cooling beam intensities and low Rb pressure regimes simultaneously. Using this approach, we minimized the contributions of the intra-trap collisions as well as background MOT species collisions to the measured trap loss rate in our setup. These results can be useful for development of cold-atom based UHV pressure standards.

arXiv:2302.14305•Journal of Applied Physics•Jul 10, 2023•6 citations

A method for loading magneto-optical trap in an ultrahigh vacuum environment

Kavish Bhardwaj, Sourabh Sarkar, Surjya Prakash Ram +2 more

We have developed a method that enables loading a magneto-optical trap (MOT) in an ultrahigh vacuum environment. Nearly 1.0 × 108 atoms of 87Rb are trapped in the MOT at ∼2.0×10−10 Torr base pressure in the chamber. After the MOT loading, we have successfully demonstrated the working of a quadrupole magnetic trap in this chamber with a lifetime of ∼15 s.

arXiv:2206.13271•AIP Advances•Jan 1, 2023•7 citations

Loading and Compression of a Large Number of Rubidium Atoms Using a Semi-Dark Type Magneto-Optical Trap

Lan‐Sheng Yang, Bai-Tzeng Han, De-Sheng Hong +2 more

We have built an apparatus for setting up a double magneto-optical trap (double MOT) which allows more than 10 Rb atoms to be loaded in 15 seconds. This compact system consists mainly of a stainless steel chamber and a homemade glass cell. The two chambers are spatially separated by a small diameter transfer tube for differential pumping. The stainless steel chamber is maintained at a pressure of 10 Torr, enabling fast capturing of background Rb atoms. The optically cooled atomic clouds are pushed by a laser beam towards the glass cell which is in a much higher vacuum. Under this condition, the glass cell provides a rather long life time for holding the atoms. After the atoms are loaded in the temporarily bright MOT, a semi-dark type MOT compression is employed to reach a spatial density of 1×10 atoms/cm. The compressed atom clouds are further cooled by polarization gradient cooling to a temperature of 30 μK. The high phase space density cloud is suitable for experiments related to ultracold atoms.

Chinese Journal of Physics•Dec 1, 2007•3 citations

Loading of a Rb magneto-optic trap from a getter source

Umakant D. Rapol, Ajay Wasan, Vasant Natarajan A

We study the properties of a Rb magneto-optic trap loaded from a commercial getter source. The source provides a large flux of atoms for the trap along with the capability of rapid turn off necessary for obtaining long trap lifetimes. We have studied the trap loading at two different values of background pressure to determine the cross section for $\mathrm{Rb}\ensuremath{-}{\mathrm{N}}_{2}$ collisions to be $3.5(4)\ifmmode\times\else\texttimes\fi{}{10}^{\ensuremath{-}14}{\mathrm{cm}}^{2}$ and that for Rb-Rb collisions to be of order $3\ifmmode\times\else\texttimes\fi{}{10}^{\ensuremath{-}13}{\mathrm{cm}}^{2}$. At a background pressure of $1.3\ifmmode\times\else\texttimes\fi{}{10}^{\ensuremath{-}9}$ torr, we load more than ${10}^{8}$ atoms into the trap with a time constant of 3.3 s. The $1/e$ lifetime of trapped atoms is 13 s limited only by background collisions.

arXiv:physics/0204022•Physical Review A•Jun 28, 2001•54 citations

Improved transfer efficiency with pulsed atom transfer between two magneto-optical traps

Surjya Prakash Ram, Tiwari, S K, Satya Ram Mishra

In our double magneto-optical trap (MOT) setup containing a vapor chamber MOT (VC-MOT) and an ultra high vacuum MOT (UHV-MOT) for $^{87}$Rb atoms, we find that transfer of atoms from VC-MOT to UHV-MOT can be enhanced by employing a pulsed VC-MOT loading followed by a pulsed push beam, as compared to that obtained by focusing a continuous wave (CW) push beam on a continuously loaded VC-MOT. By choosing appropriately the VC-MOT duration and push beam duration, the number of atoms in UHV-MOT was $\sim$3-times the number obtained with a continuous VC-MOT and a CW push beam of optimized power. The processes affecting the pulsed transfer have been studied.

arXiv:1003.5519•Mar 29, 2010•1 citation
Abstract Here, we report our studies on the continuous loading of a U-magneto-optical trap (U-MOT) on an atom-chip with a rubidium-(Rb)-vapor-generated background using a dispenser source in an ultra high vacuum environment. Using the U-MOT loading curves, the partial pressure due to the Rb vapor and the pressure due to the background gas have been estimated near the MOT cloud position. The estimated pressure due to the Rb vapor increased from ∼ Torr to Torr as the Rb-dispenser current was increased from 2.8 to 3.4 A. The increase in dispenser current also resulted in a decrease in loading time as well as the lifetime of the MOT cloud. This study will be useful for magnetic trapping experiments where accurate information of the pressure in a chamber is important for the lifetime of the magnetic trap.
Abstract Here, we present studies on pulsed loading of a rubidium (Rb) magneto-optical trap (MOT) in an ultra-high vacuum (UHV) environment on an atom chip. We have used a parallel combination of Rb dispensers for better heat dissipation to achieve fast UHV recovery in the chamber after the end of the current pulse to the dispensers. We have estimated the threshold heat energy required for activation of the dispensers for different values of current pulses. Although a pulse with a higher current value and shorter duration has a lower threshold heat energy, we operated the dispensers at moderate current pulse parameters (24 A, 10 s) for protection of the circuits. Nearly, 3 × 10 7 cold 87 Rb atoms were loaded in the MOT using this current pulse, with a UHV recovery time of ∼600 ms in the chamber. This fast recovery of UHV in the MOT chamber is useful for further experiments such as magnetic trapping and evaporative cooling of atoms in the same chamber.
In this work, the UHV background pressure as low as 1.1×10−10 Torr has been measured using the loss rate characteristics of a vapor-loaded magneto-optical trap (MOT) formed on an atom chip in a UHV chamber. The loss rate due to non-rubidium (Rb) gases in the background in the chamber has been estimated by operating the MOT in low cooling beam intensities and low Rb pressure regimes simultaneously. Using this approach, we minimized the contributions of the intra-trap collisions as well as background MOT species collisions to the measured trap loss rate in our setup. These results can be useful for development of cold-atom based UHV pressure standards.
We have built an apparatus for setting up a double magneto-optical trap (double MOT) which allows more than 10 Rb atoms to be loaded in 15 seconds. This compact system consists mainly of a stainless steel chamber and a homemade glass cell. The two chambers are spatially separated by a small diameter transfer tube for differential pumping. The stainless steel chamber is maintained at a pressure of 10 Torr, enabling fast capturing of background Rb atoms. The optically cooled atomic clouds are pushed by a laser beam towards the glass cell which is in a much higher vacuum. Under this condition, the glass cell provides a rather long life time for holding the atoms. After the atoms are loaded in the temporarily bright MOT, a semi-dark type MOT compression is employed to reach a spatial density of 1×10 atoms/cm. The compressed atom clouds are further cooled by polarization gradient cooling to a temperature of 30 μK. The high phase space density cloud is suitable for experiments related to ultracold atoms.
We study the properties of a Rb magneto-optic trap loaded from a commercial getter source. The source provides a large flux of atoms for the trap along with the capability of rapid turn off necessary for obtaining long trap lifetimes. We have studied the trap loading at two different values of background pressure to determine the cross section for $\mathrm{Rb}\ensuremath{-}{\mathrm{N}}_{2}$ collisions to be $3.5(4)\ifmmode\times\else\texttimes\fi{}{10}^{\ensuremath{-}14}{\mathrm{cm}}^{2}$ and that for Rb-Rb collisions to be of order $3\ifmmode\times\else\texttimes\fi{}{10}^{\ensuremath{-}13}{\mathrm{cm}}^{2}$. At a background pressure of $1.3\ifmmode\times\else\texttimes\fi{}{10}^{\ensuremath{-}9}$ torr, we load more than 108{10}^{8}108 atoms into the trap with a time constant of 3.3 s. The 1/e1/e1/e lifetime of trapped atoms is 13 s limited only by background collisions.
In our double magneto-optical trap (MOT) setup containing a vapor chamber MOT (VC-MOT) and an ultra high vacuum MOT (UHV-MOT) for 87^{87}87Rb atoms, we find that transfer of atoms from VC-MOT to UHV-MOT can be enhanced by employing a pulsed VC-MOT loading followed by a pulsed push beam, as compared to that obtained by focusing a continuous wave (CW) push beam on a continuously loaded VC-MOT. By choosing appropriately the VC-MOT duration and push beam duration, the number of atoms in UHV-MOT was $\sim$3-times the number obtained with a continuous VC-MOT and a CW push beam of optimized power. The processes affecting the pulsed transfer have been studied.