We characterize single nitrogen-vacancy (NV) centers created by 10-keVN+ ion implantation into diamond via thin SiO2 layers working as screening masks. Despite the relatively high acceleration energy compared with standard ones (<5keV) used to create near-surface NV centers, the screening masks modify the distribution of N+ ions to be peaked at the diamond surface [Ito et al., Appl. Phys. Lett. 110, 213105 (2017)]. We examine the relation between coherence times of the NV electronic spins and their depths, demonstrating that a large portion of NV centers are located within 10 nm from the surface, consistent with Monte Carlo simulations. The effect of the surface on the NV spin coherence time is evaluated through noise spectroscopy, surface topography, and x-ray photoelectron spectroscopy.
Negatively charged nitrogen-vacancy (NV
−) centers located a few nanometers below the diamond surface are key quantum defects for nanoscale sensing of external spins. However, the creation of shallow NV
− centers with high yield remains a materials challenge. Here, we demonstrate that high-angle ion implantation enhances the creation efficiency of shallow NV
− centers. By implanting
15N ions at angles exceeding 60
∘, we achieve high NV
− yields approaching 10% with effective NV
− depths below 10 nm. These yields are significantly higher than those typically reported for shallow NV
− creation. The enhanced NV
− yield is consistent with an increased vacancy-to-nitrogen ratio in the near-surface region, which is expected to promote NV formation during annealing. The created NV
− ensembles show coherence properties comparable to those of single shallow NV
− centers at similar depths, and allow detection of nuclear spins in van der Waals materials attached to the diamond surface. Our results establish geometric control of ion implantation as a simple and broadly applicable approach to engineer shallow vacancy-related quantum defects.
We present an experimental study of the longitudinal and transverse relaxation of ensembles of negatively charged nitrogen-vacancy (NV-) centers in a diamond monocrystal prepared by 1.8 MeV proton implantation. The focused proton beam was used to introduce vacancies at a 20 µµm depth layer. Applied doses were in the range of 1.5×1013 to 1.5×1017 ions/cm2. The samples were subsequently annealed in vacuum which resulted in a migration of vacancies and their association with the nitrogen present in the diamond matrix. The proton implantation technique proved versatile to control production of nitrogen-vacancy color centers in thin films.
Precise control over the spatial distribution and charge state of nitrogen-vacancy (NV) centers in diamond is a key requirement for further advancing this platform in quantum sensing and photonic applications. Here, we investigate nitrogen ion implantation as a scalable method to engineer NV centers in bulk single-crystalline (SC) and a 5 μ m -thick polycrystalline (PC) diamond membrane. Nitrogen-doped regions (1–80 ppm) were fabricated using a 0.7 MeV ion beam and high-temperature annealing, with NV center formation verified by confocal fluorescence imaging and spectral analysis. In SC bulk diamond, we estimate the NV concentration from spectral analysis and model the fluorescence response as a function of implantation dose, capturing both the initial increase at low concentrations and a saturation behavior at higher doses due to quenching mechanisms. In contrast, PC diamond membranes show a weaker dependence at low implantation fluences, consistent with pre-existing nitrogen impurities, thus making a statistical model significantly more complex. The activation yield is found to be of order of 1%, which is lower than in N-rich diamond samples, as implanted N is predominantly interstitial. Photoluminescence spectroscopy indicates that NV 0 is the dominant charge state in both materials, with a laser-power-dependent redistribution between neutral and negative charge states. Optically detected magnetic resonance (ODMR) measurements in SC bulk diamond resolve the hyperfine structure and allow extraction of the dephasing time ( T 2 ∗ ), while in PC diamond membranes, where NV centers tend do form near the grain boundaries, the ODMR signals are observed but spectral resolution is currently limited by impurities, grain-dependent NV orientations, and photoluminescence background.
We demonstrate highly tunable formation of nitrogen-vacancy (NV) centers using 20 keV 15N+ ion implantation through arrays of high-resolution apertures fabricated with electron beam lithography. By varying the aperture diameters from 80 to 240 nm, as well as the average ion fluences from 5×1010 to 2 × 1011 ions/cm2, we can control the number of ions per aperture. We analyze the photoluminescence on multiple sites with different implantation parameters and obtain ion-to-NV conversion yields of 6%–7%, consistent across all ion fluences. The implanted NV centers have spin dephasing times T2* ∼ 3 μs, comparable to naturally occurring NV centers in high purity diamond with natural abundance 13C. With this technique, we can deterministically control the population distribution of NV centers in each aperture, allowing for the study of single or coupled NV centers and their integration into photonic structures.