Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Applied Physics Letters

Diamond nitrogen-vacancy centers created by scanning focused helium ion beam and annealing

Zhihong Huang, W.-D. Li, Charles Santori, Víctor M. Acosta, Andrei Faraon, T. Ishikawa, Wenhao Wu, Donny Winston, Richard Stanley Williams, Raymond G. Beausoleil

Published Aug 19, 2013• 65 citations
Publisher

Abstract

We demonstrate a method to create nitrogen-vacancy (NV) centers in diamond using focused helium ion microscopy. Near-surface NV centers can be created with spatial resolution below 0.6 μm. We studied the density, creation efficiency, and spectral linewidths at optical and microwave frequencies for NV centers produced using various helium ion implantation doses. The optical linewidths are narrower than those of similar nitrogen-vacancy centers produced using nitrogen ion implantation.

DOI
10.1063/1.4819339

Related papers

Diamond Nitrogen-Vacancy Center Creation with Helium-Ion Microscope

Zhihong Huang, Wen‐Di Li, Charles Santori +4 more

We investigate a method to create nitrogen-vacancy (NV) centers in diamond using a focused-helium-ion-microscopy. Near-surface NV centers can be created with spatial resolution below 0.6μm. NV center spectral linewidths at various optical and microwave frequencies were also studied.

Conference on Lasers and Electro-Optics•Jan 1, 2013•0 citations

Nitrogen-vacancy center creation with helium-ion microscope

Zhihong Huang, Wen‐Di Li, Charles Santori +4 more

We investigate a method to create nitrogen-vacancy (NV) centers in diamond using a focused-heliu m-ion-microscopy. Near-surface NV centers can be created with spatial resolution below 0.6μm. NV center spectral line widths at various optical and microwave frequencies were also studied.

Conference on Lasers and Electro-Optics•Jun 9, 2013•0 citations

Optical coherence of diamond nitrogen-vacancy centers formed by ion implantation and annealing

Suzanne B. van Dam, Michael E. Walsh, Maarten J. Degen +8 more

Nitrogen-vacancy (NV) centers in diamond with coherent optical transitions are a promising candidate for quantum science and technology protocols. A widely used strategy for their creation is nitrogen-ion implantation and high-temperature annealing. The data presented in this work show that while low-strain, narrow-optical-linewidth NV centers are formed from naturally occurring ${}^{14}$N atoms, NV centers formed from the implanted ${}^{15}$N atoms show broadened optical transitions and experience higher strain. These results have immediate implications for the positioning accuracy of current NV center creation protocols.

arXiv:1812.11523•Physical review. B./Physical review. B•Apr 19, 2019•132 citations

Vertical distribution of nitrogen-vacancy centers in diamond formed by ion implantation and annealing

Charles Santori, Paul E. Barclay, Kai‐Mei C. Fu +1 more

Etching experiments were performed that reveal the vertical distribution of optically active nitrogen-vacancy (NV) centers in diamond created in close proximity to a surface through ion implantation and annealing. The NV distribution depends strongly on the native nitrogen concentration, and spectral measurements of the neutral and negatively charged NV peaks give evidence for electron depletion effects in lower-nitrogen material. The results are important for potential quantum information and magnetometer devices where NV centers must be created in close proximity to a surface for coupling to optical structures.

arXiv:0812.3905•Physical Review B•Mar 16, 2009•141 citations

Spectrally stable nitrogen-vacancy centers in diamond formed by carbon implantation into thin microstructures

Viktoria Yurgens, Andrea Corazza, Josh A. Zuber +6 more

The nitrogen-vacancy center (NV) in diamond, with its exceptional spin coherence and convenience in optical spin initialization and readout, is increasingly used both as a quantum sensor and as a building block for quantum networks. Employing photonic structures for maximizing the photon collection efficiency in these applications typically leads to broadened optical linewidths for the emitters, which are commonly created via nitrogen ion implantation. With studies showing that only native nitrogen atoms contribute to optically coherent NVs, a natural conclusion is to either avoid implantation completely or substitute nitrogen implantation by an alternative approach to vacancy creation. Here, we demonstrate that implantation of carbon ions yields a comparable density of NVs as implantation of nitrogen ions and that it results in NV populations with narrow optical linewidths and low charge-noise levels even in thin diamond microstructures. We measure a median NV linewidth of 150 MHz for structures thinner than 5 μm, with no trend of increasing linewidths down to the thinnest measured structure of 1.9 μm. We propose a modified NV creation procedure in which the implantation is carried out after instead of before the diamond fabrication processes and confirm our results in multiple samples implanted with different ion energies and fluences.

arXiv:2209.08111•Applied Physics Letters•Dec 5, 2022•12 citations

Nitrogen ion implantation for controlled nitrogen-vacancy center creation in single- and polycrystalline diamond

Zeeshan Rashid, Nemanja Markešević, S. Lagomarsino +11 more

Precise control over the spatial distribution and charge state of nitrogen-vacancy (NV) centers in diamond is a key requirement for further advancing this platform in quantum sensing and photonic applications. Here, we investigate nitrogen ion implantation as a scalable method to engineer NV centers in bulk single-crystalline (SC) and a 5 μ m -thick polycrystalline (PC) diamond membrane. Nitrogen-doped regions (1–80 ppm) were fabricated using a 0.7 MeV ion beam and high-temperature annealing, with NV center formation verified by confocal fluorescence imaging and spectral analysis. In SC bulk diamond, we estimate the NV concentration from spectral analysis and model the fluorescence response as a function of implantation dose, capturing both the initial increase at low concentrations and a saturation behavior at higher doses due to quenching mechanisms. In contrast, PC diamond membranes show a weaker dependence at low implantation fluences, consistent with pre-existing nitrogen impurities, thus making a statistical model significantly more complex. The activation yield is found to be of order of 1%, which is lower than in N-rich diamond samples, as implanted N is predominantly interstitial. Photoluminescence spectroscopy indicates that NV 0 is the dominant charge state in both materials, with a laser-power-dependent redistribution between neutral and negative charge states. Optically detected magnetic resonance (ODMR) measurements in SC bulk diamond resolve the hyperfine structure and allow extraction of the dephasing time ( T 2 ∗ ), while in PC diamond membranes, where NV centers tend do form near the grain boundaries, the ODMR signals are observed but spectral resolution is currently limited by impurities, grain-dependent NV orientations, and photoluminescence background.

Diamond and Related Materials•Sep 12, 2026•0 citations
We demonstrate a method to create nitrogen-vacancy (NV) centers in diamond using focused helium ion microscopy. Near-surface NV centers can be created with spatial resolution below 0.6 μm. We studied the density, creation efficiency, and spectral linewidths at optical and microwave frequencies for NV centers produced using various helium ion implantation doses. The optical linewidths are narrower than those of similar nitrogen-vacancy centers produced using nitrogen ion implantation.
Nitrogen-vacancy (NV) centers in diamond with coherent optical transitions are a promising candidate for quantum science and technology protocols. A widely used strategy for their creation is nitrogen-ion implantation and high-temperature annealing. The data presented in this work show that while low-strain, narrow-optical-linewidth NV centers are formed from naturally occurring 14{}^{14}14N atoms, NV centers formed from the implanted 15{}^{15}15N atoms show broadened optical transitions and experience higher strain. These results have immediate implications for the positioning accuracy of current NV center creation protocols.
Etching experiments were performed that reveal the vertical distribution of optically active nitrogen-vacancy (NV) centers in diamond created in close proximity to a surface through ion implantation and annealing. The NV distribution depends strongly on the native nitrogen concentration, and spectral measurements of the neutral and negatively charged NV peaks give evidence for electron depletion effects in lower-nitrogen material. The results are important for potential quantum information and magnetometer devices where NV centers must be created in close proximity to a surface for coupling to optical structures.
The nitrogen-vacancy center (NV) in diamond, with its exceptional spin coherence and convenience in optical spin initialization and readout, is increasingly used both as a quantum sensor and as a building block for quantum networks. Employing photonic structures for maximizing the photon collection efficiency in these applications typically leads to broadened optical linewidths for the emitters, which are commonly created via nitrogen ion implantation. With studies showing that only native nitrogen atoms contribute to optically coherent NVs, a natural conclusion is to either avoid implantation completely or substitute nitrogen implantation by an alternative approach to vacancy creation. Here, we demonstrate that implantation of carbon ions yields a comparable density of NVs as implantation of nitrogen ions and that it results in NV populations with narrow optical linewidths and low charge-noise levels even in thin diamond microstructures. We measure a median NV linewidth of 150 MHz for structures thinner than 5 μm, with no trend of increasing linewidths down to the thinnest measured structure of 1.9 μm. We propose a modified NV creation procedure in which the implantation is carried out after instead of before the diamond fabrication processes and confirm our results in multiple samples implanted with different ion energies and fluences.
Precise control over the spatial distribution and charge state of nitrogen-vacancy (NV) centers in diamond is a key requirement for further advancing this platform in quantum sensing and photonic applications. Here, we investigate nitrogen ion implantation as a scalable method to engineer NV centers in bulk single-crystalline (SC) and a 5 μ m -thick polycrystalline (PC) diamond membrane. Nitrogen-doped regions (1–80 ppm) were fabricated using a 0.7 MeV ion beam and high-temperature annealing, with NV center formation verified by confocal fluorescence imaging and spectral analysis. In SC bulk diamond, we estimate the NV concentration from spectral analysis and model the fluorescence response as a function of implantation dose, capturing both the initial increase at low concentrations and a saturation behavior at higher doses due to quenching mechanisms. In contrast, PC diamond membranes show a weaker dependence at low implantation fluences, consistent with pre-existing nitrogen impurities, thus making a statistical model significantly more complex. The activation yield is found to be of order of 1%, which is lower than in N-rich diamond samples, as implanted N is predominantly interstitial. Photoluminescence spectroscopy indicates that NV 0 is the dominant charge state in both materials, with a laser-power-dependent redistribution between neutral and negative charge states. Optically detected magnetic resonance (ODMR) measurements in SC bulk diamond resolve the hyperfine structure and allow extraction of the dephasing time ( T 2 ∗ ), while in PC diamond membranes, where NV centers tend do form near the grain boundaries, the ODMR signals are observed but spectral resolution is currently limited by impurities, grain-dependent NV orientations, and photoluminescence background.