Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:0705.0206 · Physical Review E

Displacement detection with a vibrating rf superconducting interference device: Beating the standard linear limit

Eyal Buks, Stav Zaitsev, Eran Segev, Baleegh Abdo, M. P. Blencowe

Published Aug 28, 2007• 22 citations
arXivHTMLPDF

Abstract

We study a configuration for displacement detection consisting of a nanomechanical resonator coupled to both a radio frequency superconducting interference device and to a superconducting stripline resonator. We employ an adiabatic approximation and rotating wave approximation and calculate the displacement sensitivity. We study the performance of such a displacement detector when the stripline resonator is driven into a region of nonlinear oscillations. In this region the system exhibits noise squeezing in the output signal when homodyne detection is employed for readout. We show that displacement sensitivity of the device in this region may exceed the upper bound imposed upon the sensitivity when operating in the linear region. On the other hand, we find that the high displacement sensitivity is accompanied by a slowing down of the response of the system, resulting in a limited bandwidth.

DOI
10.1103/physreve.76.026217

Related papers

Quantum nondemolition measurement of discrete Fock states of a nanomechanical resonator

Eyal Buks, Eran Segev, Stav Zaitsev +2 more

We study theoretically a radio frequency superconducting interference device integrated with a nanomechanical resonator and an LC resonator. By applying adiabatic and rotating-wave approximations, we obtain an effective Hamiltonian that governs the dynamics of the mechanical and LC resonators. Nonlinear terms in this Hamiltonian can be exploited for performing a quantum nondemolition measurement of Fock states of the nanomechanical resonator. We address the feasibility of experimental implementation and show that the nonlinear coupling can be made sufficiently strong to allow the detection of discrete mechanical Fock states.

arXiv:quant-ph/0610158•Europhysics Letters (EPL)•Nov 19, 2007•41 citations

dc SQUIDs as linear displacement detectors for embedded micromechanical resonators

Samir Etaki, Menno Poot, Koji Onomitsu +2 more

Superconducting quantum interference devices (SQUIDs) can detect tiny amounts of magnetic flux and are also used to study macroscopic quantum effects. We employ a dc SQUID as a linear detector of the displacement of an embedded micromechanical resonator with a femtometer sensitivity. We discuss the measurement method, including operation in high magnetic field and a cryogenic amplification scheme which allows us to reach a resolution which is only a factor 4.4 above the standard quantum limit.

Comptes Rendus Physique•Nov 9, 2011•17 citations

Dephasing due to intermode coupling in superconducting stripline resonators

Eyal Buks, Bernard Yurke

The nonlinearity exhibited by the kinetic inductance of a superconducting stripline couples stripline resonator modes together in a manner suitable for quantum nondemolition measurement of the number of photons in a given resonator mode. Quantum nondemolition measurement is accomplished by coherently driving another resonator mode, referred to as the detector mode, and measuring its response. We show that the sensitivity of such a detection scheme is directly related to the dephasing rate induced by such an intermode coupling. We show that high sensitivity is expected when the detector mode is driven into the nonlinear regime and operated close to a point where critical slowing down occurs.

arXiv:quant-ph/0511033•Physical Review A•Feb 17, 2006•20 citations

Quantum analysis of a nonlinear microwave cavity-embedded dc SQUID displacement detector

Paul D. Nation, M. P. Blencowe, Eyal Buks

We carry out a quantum analysis of a dc superconducting quantum interference device (SQUID) mechanical displacement detector, comprising a SQUID with mechanically compliant loop segment, which is embedded in a microwave transmission line resonator. The SQUID is approximated as a nonlinear current-dependent inductance, inducing an external flux tunable nonlinear Duffing self-interaction term in the microwave resonator mode equation. Motion of the compliant SQUID loop segment is transduced inductively through changes in the external flux threading SQUID loop, giving a ponderomotive radiation pressure-type coupling between the microwave and mechanical resonator modes. Expressions are derived for the detector signal response and noise, and it is found that a soft-spring Duffing self-interaction enables a closer approach to the displacement detection standard quantum limit, as well as cooling closer to the ground state.

arXiv:0806.4171•Physical Review B•Sep 17, 2008•40 citations

Utilizing Nonlinearity in a Superconducting NbN Stripline Resonator for Radiation Detection

Eran Segev, Baleegh Abdo, Oleg Shtempluck +1 more

We study a microwave superconducting stripline resonator made of NbN on a sapphire substrate. A radiation detector (RD) having a thin meander shape is integrated into the resonator. We harness an extremely strong nonlinear instability occurring in the device in order to enhance its sensitivity to infrared radiation impinging on the RD. Characterization measurements yield a noise equivalent power of 34 fW/radicHz at a modulation frequency of 7.74 GHz. Such a device may be exploited for fast and sensitive radiation detection.

IEEE Transactions on Applied Superconductivity•Jun 1, 2007•3 citations

Suppressing Cavity Frequency Noise Using a Kerr Nonlinearity

J. P. van Soest, S. Meilof, G. L. Bhai +3 more

Resonance-frequency fluctuations can limit the sensitivity and stability of superconducting microwave cavities used for qubit readout, optomechanical displacement sensing, and magnetic flux detection. Here, we demonstrate the suppression of resonance-frequency fluctuations by locking a noisy nonlinear superconducting microwave cavity to a strong pump tone. The Kerr nonlinearity of this system, whereby the resonance frequency depends on the intracavity field amplitude, gives rise to an intrinsic feedback mechanism that enables passive stabilization without active external feedback. Using two-tone spectroscopy, we experimentally characterize the intrinsic nonlinear feedback mechanism and investigate its temporal stability through Allan deviation analysis. The frequency fluctuations of the locked cavity mode are reduced by nearly two orders of magnitude, reaching the $1/f$ noise floor, without continuous frequency tracking or active control. Kerr locking provides a general approach for self-stabilizing nonlinear microwave resonators by suppressing low-frequency cavity noise while preserving sensitivity to signals outside the locking bandwidth. This approach may benefit a broad range of systems, including SQUID-based resonators, optomechanical devices, and parametric amplifiers.

quant-pharXiv:2608.03440•Aug 5, 2026•0 citations
We study a configuration for displacement detection consisting of a nanomechanical resonator coupled to both a radio frequency superconducting interference device and to a superconducting stripline resonator. We employ an adiabatic approximation and rotating wave approximation and calculate the displacement sensitivity. We study the performance of such a displacement detector when the stripline resonator is driven into a region of nonlinear oscillations. In this region the system exhibits noise squeezing in the output signal when homodyne detection is employed for readout. We show that displacement sensitivity of the device in this region may exceed the upper bound imposed upon the sensitivity when operating in the linear region. On the other hand, we find that the high displacement sensitivity is accompanied by a slowing down of the response of the system, resulting in a limited bandwidth.
We study theoretically a radio frequency superconducting interference device integrated with a nanomechanical resonator and an LC resonator. By applying adiabatic and rotating-wave approximations, we obtain an effective Hamiltonian that governs the dynamics of the mechanical and LC resonators. Nonlinear terms in this Hamiltonian can be exploited for performing a quantum nondemolition measurement of Fock states of the nanomechanical resonator. We address the feasibility of experimental implementation and show that the nonlinear coupling can be made sufficiently strong to allow the detection of discrete mechanical Fock states.
The nonlinearity exhibited by the kinetic inductance of a superconducting stripline couples stripline resonator modes together in a manner suitable for quantum nondemolition measurement of the number of photons in a given resonator mode. Quantum nondemolition measurement is accomplished by coherently driving another resonator mode, referred to as the detector mode, and measuring its response. We show that the sensitivity of such a detection scheme is directly related to the dephasing rate induced by such an intermode coupling. We show that high sensitivity is expected when the detector mode is driven into the nonlinear regime and operated close to a point where critical slowing down occurs.
We carry out a quantum analysis of a dc superconducting quantum interference device (SQUID) mechanical displacement detector, comprising a SQUID with mechanically compliant loop segment, which is embedded in a microwave transmission line resonator. The SQUID is approximated as a nonlinear current-dependent inductance, inducing an external flux tunable nonlinear Duffing self-interaction term in the microwave resonator mode equation. Motion of the compliant SQUID loop segment is transduced inductively through changes in the external flux threading SQUID loop, giving a ponderomotive radiation pressure-type coupling between the microwave and mechanical resonator modes. Expressions are derived for the detector signal response and noise, and it is found that a soft-spring Duffing self-interaction enables a closer approach to the displacement detection standard quantum limit, as well as cooling closer to the ground state.
We study a microwave superconducting stripline resonator made of NbN on a sapphire substrate. A radiation detector (RD) having a thin meander shape is integrated into the resonator. We harness an extremely strong nonlinear instability occurring in the device in order to enhance its sensitivity to infrared radiation impinging on the RD. Characterization measurements yield a noise equivalent power of 34 fW/radicHz at a modulation frequency of 7.74 GHz. Such a device may be exploited for fast and sensitive radiation detection.
Resonance-frequency fluctuations can limit the sensitivity and stability of superconducting microwave cavities used for qubit readout, optomechanical displacement sensing, and magnetic flux detection. Here, we demonstrate the suppression of resonance-frequency fluctuations by locking a noisy nonlinear superconducting microwave cavity to a strong pump tone. The Kerr nonlinearity of this system, whereby the resonance frequency depends on the intracavity field amplitude, gives rise to an intrinsic feedback mechanism that enables passive stabilization without active external feedback. Using two-tone spectroscopy, we experimentally characterize the intrinsic nonlinear feedback mechanism and investigate its temporal stability through Allan deviation analysis. The frequency fluctuations of the locked cavity mode are reduced by nearly two orders of magnitude, reaching the 1/f1/f1/f noise floor, without continuous frequency tracking or active control. Kerr locking provides a general approach for self-stabilizing nonlinear microwave resonators by suppressing low-frequency cavity noise while preserving sensitivity to signals outside the locking bandwidth. This approach may benefit a broad range of systems, including SQUID-based resonators, optomechanical devices, and parametric amplifiers.