Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:quant-ph/0210090 · Physical Review A

Possibility of single-atom detection on a chip

Péter Horák, Bruce G. Klappauf, Albrecht Haase, R. Folman, Jörg Schmiedmayer, P. Domokos, Edward A. Hinds

Published Apr 11, 2003• 95 citations
arXivHTMLPDF

Abstract

We investigate the optical detection of single atoms held in a microscopic atom trap close to a surface. Laser light is guided by optical fibers or optical microstructures via the atom to a photodetector. Our results suggest that with present-day technology microcavities can be built around the atom with sufficiently high finesse to permit unambiguous detection of a single atom in the trap with $10\ensuremath{\mu}\mathrm{s}$ of integration. We compare resonant and nonresonant detection schemes and discuss the requirements for detecting an atom without causing it to undergo spontaneous emission.

DOI
10.1103/physreva.67.043806

Related papers

Detecting neutral atoms on an atom chip

M. Wilzbach, A. Haase, M. Schwarz +8 more

Abstract Detecting single atoms (qubits) is a key requirement for implementing quantum information processing on an atom chip. The detector should ideally be integrated on the chip. Here we present and compare different methods capable of detecting neutral atoms on an atom chip. After a short introduction to fluorescence and absorption detection we discuss cavity enhanced detection of single atoms. In particular we concentrate on optical fiber based detectors such as fiber cavities and tapered fiber dipole traps. We discuss the various constraints in building such detectors in detail along with the current implementations on atom chips. Results from experimental tests of fiber integration are also described. In addition we present a pilot experiment for atom detection using a concentric cavity to verify the required scaling.

arXiv:physics/0608189•Fortschritte der Physik•Aug 1, 2006•12 citations

Fiber optics for quantum computers

Steve Helsby, Hebe Powell, Péter Horák +2 more

Abstract: We describe schemes for the integration of miniature optical components onto Atom Chips, for the manipulation and detection of ultra-cold atoms. Our intention is to build detectors sensitive enough to accurately detect single atoms. Two approaches are discussed: simple fluorescence detection and the use of a resonant cavity. Theory predicts that cavities with F>100 should be sufficient to obtain signal to noise ratios high enough to detect single atoms. The first micro cavities were demonstrated using mirrors formed by cleaved fiber ends coated with a stick-on dielectric coating to give F ∼100. A more successful approach involves the full integration of the mirrors and fibers by using Bragg gratings written into the fiber core: it has been possible to form gap cavities with F ~ 150. 1.

•Jan 1, 2004•0 citations

PROGRESS IN ATOM CHIPS AND THE INTEGRATION OF OPTICAL MICROCAVITIES

E. A. HINDS, M. TRUPKE, Benoît Darquié +2 more

We review recent progress at the Centre for Cold Matter in developing atom chips. An important advantage of miniaturizing atom traps on a chip is the possibility of obtaining very tight trapping structures with the capability of manipulating atoms on the micron length scale. We recall some of the pros and cons of bringing atoms close to the chip surface, as is required in order to make small static structures, and we discuss the relative merits of metallic, dielectric and superconducting chip surfaces. We point out that the addition of integrated optical devices on the chip can enhance its capability through single atom detection and controlled photon production. Finally, we review the status of integrated microcavities that have recently been demonstrated at our Centre and discuss their prospects for future development.

arXiv:0802.0987•Laser Spectroscopy•Apr 1, 2008•2 citations

Design of a trapping potential for detecting single atoms by a microdisk resonator on a chip

Michael Rosenblit, Yonathan Japha, Péter Horák +1 more

We investigate simultaneous optical trapping and optical detection of a single Rb atom near the surface of a toroidal microdisk. Light is coupled into two high-Q whispering-gallery modes of the disk which provide attractive and repulsive potentials, respectively, via their evanescent fields. The sum potential including van-der-Waals and Casimir-Polder surface forces exhibits a minimum at distances of the order of 100 nm from the disk surface. The back-action of an atom held in this trap on the light fields is sufficiently strong to provide a measurable effect. We discuss atom trapping and detection properties in dependence on a variety of system parameters.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Apr 21, 2006•0 citations

Design of microcavity resonators for single-atom detection

Michael Rosenblit, Péter Horák, Eyal Fleminger +2 more

Whispering gallery modes of a microdisk resonator are useful for the optical detection of single rubidium and cesium atoms near the surface of a substrate. Light is coupled into two high-Q whispering-gallery modes of the disk which can provide attractive and/or repulsive potentials, respectively, via their evanescent fields. The sum potential, including van der Waals/Casimir-Polder surface forces, may be tuned to exhibit a minimum at distances on the order of 100 nm from the disk surface. Simultaneously optically trapping and detecting is possible, with the back-action of an atom held in this trap on the light fields being suffciently strong to provide a measurable effect. Atom trapping and detection depend on a variety of system parameters and experimental realizations differ for different atoms.

Journal of Nanophotonics•Dec 1, 2007•4 citations

Single atom detection on an atom chip with integrated optics

Marco Wilzbach

The subject of this thesis is the miniaturization and integration of detectors for the detection of single rubidium atoms on an atom chip. For this purpose three different detectors were developed for atom detection by absorption or fluorescence: i) A fluorescence detector was realized by mounting a tapered lensed fiber perpendicular to a collection fiber. ii) An absorption detector was built by placing a multi-mode fiber in-line with a tapered lensed fiber. iii) A tunable cavity detector was built from two single mode fibers mounted on the chip surface. To mount the detectors on the planar surface of the atom chip retaining structures by means of lithographical techniques were developed. Those structures allow a very accurate and stable passive fiber alignment. To test the individual detectors an atomic ensemble of thermal rubidium atoms was prepared in a magneto-optical trap. Then the atoms were transferred into magnetic micro-traps of the atom chip and were guided to one of the detectors. Each integrated detector has been evaluated by several characterization measurements. With the fluorescence detector the highest single atom detection efficiency of 54\\% was attained. Thereby it was possible to perform quantitative measurements for the magnetically guided atoms on a single atom level and to study fundamental properties of the confined atoms.

•Jan 1, 2007•0 citations
We investigate the optical detection of single atoms held in a microscopic atom trap close to a surface. Laser light is guided by optical fibers or optical microstructures via the atom to a photodetector. Our results suggest that with present-day technology microcavities can be built around the atom with sufficiently high finesse to permit unambiguous detection of a single atom in the trap with 10\ensuremathμs10\ensuremath{\mu}\mathrm{s}10\ensuremathμs of integration. We compare resonant and nonresonant detection schemes and discuss the requirements for detecting an atom without causing it to undergo spontaneous emission.
Abstract Detecting single atoms (qubits) is a key requirement for implementing quantum information processing on an atom chip. The detector should ideally be integrated on the chip. Here we present and compare different methods capable of detecting neutral atoms on an atom chip. After a short introduction to fluorescence and absorption detection we discuss cavity enhanced detection of single atoms. In particular we concentrate on optical fiber based detectors such as fiber cavities and tapered fiber dipole traps. We discuss the various constraints in building such detectors in detail along with the current implementations on atom chips. Results from experimental tests of fiber integration are also described. In addition we present a pilot experiment for atom detection using a concentric cavity to verify the required scaling.
Abstract: We describe schemes for the integration of miniature optical components onto Atom Chips, for the manipulation and detection of ultra-cold atoms. Our intention is to build detectors sensitive enough to accurately detect single atoms. Two approaches are discussed: simple fluorescence detection and the use of a resonant cavity. Theory predicts that cavities with F>100 should be sufficient to obtain signal to noise ratios high enough to detect single atoms. The first micro cavities were demonstrated using mirrors formed by cleaved fiber ends coated with a stick-on dielectric coating to give F ∼100. A more successful approach involves the full integration of the mirrors and fibers by using Bragg gratings written into the fiber core: it has been possible to form gap cavities with F ~ 150. 1.
We review recent progress at the Centre for Cold Matter in developing atom chips. An important advantage of miniaturizing atom traps on a chip is the possibility of obtaining very tight trapping structures with the capability of manipulating atoms on the micron length scale. We recall some of the pros and cons of bringing atoms close to the chip surface, as is required in order to make small static structures, and we discuss the relative merits of metallic, dielectric and superconducting chip surfaces. We point out that the addition of integrated optical devices on the chip can enhance its capability through single atom detection and controlled photon production. Finally, we review the status of integrated microcavities that have recently been demonstrated at our Centre and discuss their prospects for future development.
We investigate simultaneous optical trapping and optical detection of a single Rb atom near the surface of a toroidal microdisk. Light is coupled into two high-Q whispering-gallery modes of the disk which provide attractive and repulsive potentials, respectively, via their evanescent fields. The sum potential including van-der-Waals and Casimir-Polder surface forces exhibits a minimum at distances of the order of 100 nm from the disk surface. The back-action of an atom held in this trap on the light fields is sufficiently strong to provide a measurable effect. We discuss atom trapping and detection properties in dependence on a variety of system parameters.
Whispering gallery modes of a microdisk resonator are useful for the optical detection of single rubidium and cesium atoms near the surface of a substrate. Light is coupled into two high-Q whispering-gallery modes of the disk which can provide attractive and/or repulsive potentials, respectively, via their evanescent fields. The sum potential, including van der Waals/Casimir-Polder surface forces, may be tuned to exhibit a minimum at distances on the order of 100 nm from the disk surface. Simultaneously optically trapping and detecting is possible, with the back-action of an atom held in this trap on the light fields being suffciently strong to provide a measurable effect. Atom trapping and detection depend on a variety of system parameters and experimental realizations differ for different atoms.
The subject of this thesis is the miniaturization and integration of detectors for the detection of single rubidium atoms on an atom chip. For this purpose three different detectors were developed for atom detection by absorption or fluorescence: i) A fluorescence detector was realized by mounting a tapered lensed fiber perpendicular to a collection fiber. ii) An absorption detector was built by placing a multi-mode fiber in-line with a tapered lensed fiber. iii) A tunable cavity detector was built from two single mode fibers mounted on the chip surface. To mount the detectors on the planar surface of the atom chip retaining structures by means of lithographical techniques were developed. Those structures allow a very accurate and stable passive fiber alignment. To test the individual detectors an atomic ensemble of thermal rubidium atoms was prepared in a magneto-optical trap. Then the atoms were transferred into magnetic micro-traps of the atom chip and were guided to one of the detectors. Each integrated detector has been evaluated by several characterization measurements. With the fluorescence detector the highest single atom detection efficiency of 54\\% was attained. Thereby it was possible to perform quantitative measurements for the magnetically guided atoms on a single atom level and to study fundamental properties of the confined atoms.