Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:cond-mat/0601634 · Physical Review Letters

High-Contrast Dispersive Readout of a Superconducting Flux Qubit Using a Nonlinear Resonator

Adrian Lupaşcu, E. F. C. Driessen, Leif Roschier, C. J. P. M. Harmans, Johan E. Mooij

Published Mar 28, 2006• 116 citations
arXivHTMLPDF

Abstract

We demonstrate high-contrast state detection of a superconducting flux qubit. Detection is realized by probing the microwave transmission of a nonlinear resonator, based on a SQUID. Depending on the driving strength of the resonator, the detector can be operated in the monostable or the bistable mode. The bistable operation combines high-sensitivity with intrinsic latching. The measured contrast of Rabi oscillations is as high as 87%; of the missing 13%, only 3% of the loss of contrast is unaccounted for. Experiments involving two consecutive detection pulses are consistent with preparation of the qubit state by the first measurement.

DOI
10.1103/physrevlett.96.127003

Related papers

Superconducting non-linear resonator for non-destructive readout of a flux qubit

K. Inomata, 道生 渡部, Tsuyoshi Yamamoto +3 more

We have investigated microwave response of a λ/4 superconducting coplanar waveguide resonator which is terminated by a DC-SQUID coupled with a flux qubit. The circuit is designed for non-destructive single-shot readout of a flux qubit based on dispersive interaction between the qubit and the resonator and switching between bistable states of the driven nonlinear resonator. A high-frequency (∼ 10 GHz) resonator is exploited for suppressing photon-number fluctuations which cause qubit dephasing even when the readout circuit is not activated. We observed bifurcation of the resonator in the nonlinear driving regime. In the linear regime, the degeneracy point of the qubit was detected as a shift of the resonant frequency.

Journal of Physics Conference Series•Mar 1, 2009•4 citations

Dispersive readout of a flux qubit at the single-photon level

Jedediah E Johnson, Emile Hoskinson, Chris Macklin +3 more

A superconducting flux qubit is inductively coupled to a superconducting quantum interference device (SQUID) magnetometer, capacitively shunted to form a 1.294-GHz resonator. The qubit-state-dependent resonator frequency is weakly probed with a microwave signal and detected with a microstrip SQUID amplifier. At a mean resonator occupation $\overline{n}=1.5$ photons, the readout visibility is increased by a factor of 4.5 over that using a cryogenic semiconductor amplifier. As $\overline{n}$ is increased from 0.008 to 0.1, no reduction in ${T}_{1}$ is observed, potentially enabling continuous monitoring of the qubit state.

arXiv:1109.2858•Physical Review B•Dec 15, 2011•20 citations

Dispersive readout scheme for a Josephson phase qubit

Wirth, Tobias

We present experimental results on a dispersive scheme for reading out a Josephson phase qubit. A capacitively shunted dc-SQUID is used as a nonlinear resonator which is inductively coupled to the qubit. We detect the flux state of the qubit by measuring the amplitude and phase of a microwave pulse reflected from the SQUID resonator. By this low-dissipative method, we reduce the qubit state measurement time down to 25 microseconds, which is much faster than using the conventional readout performed by switching the SQUID to its non-zero dc voltage state. The demonstrated readout scheme allows for reading out multiple qubits using a single microwave line by employing frequency-division multiplexing.

Verhandlungen der Deutschen Physikalischen Gesellschaft•Jan 1, 2011•0 citations

Nonlinear resonant behavior of a dispersive readout circuit for a superconducting flux qubit

Janice C. Lee, William D. Oliver, Karl K. Berggren +1 more

A nonlinear resonant circuit comprising a SQUID magnetometer and a shunting capacitor is studied as a readout scheme for a persistent-current qubit. The flux state of the qubit is detected as a change in the Josephson inductance of the SQUID magnetometer, which in turn mediates a shift in the resonant frequency of the readout circuit. The nonlinearity and resulting hysteresis in the resonant behavior are characterized as a function of the power of both the input drive and the associated resonance-peak response. Numerical simulations based on a nonlinear circuit model shows that the observed nonlinearity is dominated by the effect due to an ac flux rather than current bias through the Josephson inductor.

arXiv:cond-mat/0609561•Physical Review B•Apr 11, 2007•23 citations

Time-resolved qubit readout via nonlinear Josephson inductance

Georg M Reuther, David Zueco, Peter Hänggi A +1 more

We propose a generalization of dispersive qubit readout that provides the time evolution of a flux qubit observable.Our proposal relies on the nonlinear coupling of the qubit to a harmonic oscillator with high frequency, representing a dc superconducting quantum interference device.Information about the qubit dynamics is obtained by recording the oscillator response to resonant driving and subsequent lock-in detection.The measurement process is simulated for the example of coherent qubit oscillations.This corroborates the underlying measurement relation and also reveals that the measurement scheme possesses low backaction and high fidelity.

arXiv:1105.1105•New Journal of Physics•Sep 12, 2011•6 citations

Microwave readout scheme for a Josephson phase qubit

Tobias Wirth, Jürgen Lisenfeld, Alexander V. Lukashenko +1 more

We present experimental results on a microwave scheme for reading out a Josephson phase qubit. A capacitively shunted superconducting quantum interference device (SQUID) is used as a nonlinear resonator which is inductively coupled to the qubit. The flux state of the qubit is detected by measuring the amplitude and phase of a microwave pulse reflected from the SQUID resonator. By this low-dissipative method, the qubit state measurement time is reduced to 25 μs, which is much faster than the conventional readout performed by switching the SQUID to its nonzero dc voltage state. The readout scheme presented here allows for reading out multiple qubits using a single microwave line by employing frequency-division multiplexing.

arXiv:1010.0954•Applied Physics Letters•Dec 27, 2010•14 citations
We demonstrate high-contrast state detection of a superconducting flux qubit. Detection is realized by probing the microwave transmission of a nonlinear resonator, based on a SQUID. Depending on the driving strength of the resonator, the detector can be operated in the monostable or the bistable mode. The bistable operation combines high-sensitivity with intrinsic latching. The measured contrast of Rabi oscillations is as high as 87%; of the missing 13%, only 3% of the loss of contrast is unaccounted for. Experiments involving two consecutive detection pulses are consistent with preparation of the qubit state by the first measurement.
We have investigated microwave response of a λ/4 superconducting coplanar waveguide resonator which is terminated by a DC-SQUID coupled with a flux qubit. The circuit is designed for non-destructive single-shot readout of a flux qubit based on dispersive interaction between the qubit and the resonator and switching between bistable states of the driven nonlinear resonator. A high-frequency (∼ 10 GHz) resonator is exploited for suppressing photon-number fluctuations which cause qubit dephasing even when the readout circuit is not activated. We observed bifurcation of the resonator in the nonlinear driving regime. In the linear regime, the degeneracy point of the qubit was detected as a shift of the resonant frequency.
A superconducting flux qubit is inductively coupled to a superconducting quantum interference device (SQUID) magnetometer, capacitively shunted to form a 1.294-GHz resonator. The qubit-state-dependent resonator frequency is weakly probed with a microwave signal and detected with a microstrip SQUID amplifier. At a mean resonator occupation n‾=1.5\overline{n}=1.5n=1.5 photons, the readout visibility is increased by a factor of 4.5 over that using a cryogenic semiconductor amplifier. As n‾\overline{n}n is increased from 0.008 to 0.1, no reduction in T1{T}_{1}T1​ is observed, potentially enabling continuous monitoring of the qubit state.
We present experimental results on a dispersive scheme for reading out a Josephson phase qubit. A capacitively shunted dc-SQUID is used as a nonlinear resonator which is inductively coupled to the qubit. We detect the flux state of the qubit by measuring the amplitude and phase of a microwave pulse reflected from the SQUID resonator. By this low-dissipative method, we reduce the qubit state measurement time down to 25 microseconds, which is much faster than using the conventional readout performed by switching the SQUID to its non-zero dc voltage state. The demonstrated readout scheme allows for reading out multiple qubits using a single microwave line by employing frequency-division multiplexing.
A nonlinear resonant circuit comprising a SQUID magnetometer and a shunting capacitor is studied as a readout scheme for a persistent-current qubit. The flux state of the qubit is detected as a change in the Josephson inductance of the SQUID magnetometer, which in turn mediates a shift in the resonant frequency of the readout circuit. The nonlinearity and resulting hysteresis in the resonant behavior are characterized as a function of the power of both the input drive and the associated resonance-peak response. Numerical simulations based on a nonlinear circuit model shows that the observed nonlinearity is dominated by the effect due to an ac flux rather than current bias through the Josephson inductor.
We propose a generalization of dispersive qubit readout that provides the time evolution of a flux qubit observable.Our proposal relies on the nonlinear coupling of the qubit to a harmonic oscillator with high frequency, representing a dc superconducting quantum interference device.Information about the qubit dynamics is obtained by recording the oscillator response to resonant driving and subsequent lock-in detection.The measurement process is simulated for the example of coherent qubit oscillations.This corroborates the underlying measurement relation and also reveals that the measurement scheme possesses low backaction and high fidelity.
We present experimental results on a microwave scheme for reading out a Josephson phase qubit. A capacitively shunted superconducting quantum interference device (SQUID) is used as a nonlinear resonator which is inductively coupled to the qubit. The flux state of the qubit is detected by measuring the amplitude and phase of a microwave pulse reflected from the SQUID resonator. By this low-dissipative method, the qubit state measurement time is reduced to 25 μs, which is much faster than the conventional readout performed by switching the SQUID to its nonzero dc voltage state. The readout scheme presented here allows for reading out multiple qubits using a single microwave line by employing frequency-division multiplexing.