Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:cond-mat/0302568 · Physical Review A

Nondestructive dynamic detectors for Bose-Einstein condensates

Jessica Lye, J. J. Hope, J. D. Close

Published Apr 22, 2003• 49 citations
arXivHTMLPDF

Abstract

We propose and analyze a series of nondestructive dynamic detectors for Bose-Einstein condensates based on photodetectors operating at the shot-noise limit. These detectors are compatible with real-time feedback to the condensate. The signal-to-noise ratio of different detection schemes are compared subject to the constraint of minimal heating due to photon absorption and spontaneous emission. This constraint leads to different optimal operating points for interference-based schemes. We find the somewhat counterintuitive result that without the presence of a cavity, interferometry causes as much destruction as absorption for optically thin clouds. For optically thick clouds, cavity-free interferometry is superior to absorption, but it still cannot be made arbitrarily nondestructive. We propose a cavity-based measurement of atomic density which can in principle be made arbitrarily nondestructive for a given signal-to-noise ratio.

DOI
10.1103/physreva.67.043609

Related papers

Demonstration and characterization of a detector for minimally destructive detection of Bose condensed atoms in real time

C. Figl, Laurent Longchambon, Matthew Jeppesen +4 more

We present the first detector that is capable of recording high-bandwidth atom number density measurements of a Bose-Einstein condensate, with a readout of the data in real time. It is based on a shot-noise-limited unbalanced Mach-Zehnder interferometer designed for a minimally destructive measurement of the atom column density of a Bose-Einstein condensate. The shot-noise limit is reached by phase modulating the laser in one arm and phase locking the interferometer with a second-color laser. The detector is characterized, and its sensitivity for a fractional change in the column density of a Bose-Einstein condensate is calculated. With this detection system it may be possible to implement feedback to stabilize a Bose-Einstein condensate or an atom laser.

arXiv:quant-ph/0508154•Applied Optics•May 17, 2006•3 citations

Limit to Minimally Destructive Optical Detection of Atoms

J. J. Hope, J. D. Close

All optical techniques used to probe the properties of Bose-Einstein condensates have been based on dispersion and absorption that can be described by a two-level atom. Both phenomena lead to spontaneous emission that is destructive at the low energies involved with ultracold atomic systems. Recently, both were shown to lead to the same limit to the signal to noise ratio for a given destruction. We develop a new method for calculating the phase shift of a laser beam and show that no single-pass optical technique using classical light and a three-level atom can exceed this limit. This puts significant restrictions on potential nondestructive measurement schemes.

arXiv:quant-ph/0308153•Physical Review Letters•Oct 25, 2004•37 citations

Optimization of Bose-Einstein Condensate Imaging Techniques

Wesley D Cox

Research into Bose-Einstein condensates is currently a thriving field in physics. Much of the experimental research involves the detection of cold atom clouds under various conditions. Consequently, the fundamental and technical limitations of the imaging techniques and technologies utilized will have a dramatic influence on the results of these experiments. Therefore a detailed analysis of the restrictions on a Bose-Einstein condensate imaging system is overdue and will facilitate further developments in the field due to an increase in the signal to noise ratio; hence a greater level of detail available in experimental images. ¶ The work carried out in this thesis focuses on the properties of absorption imaging techniques, in the quest for an optimized imaging system. Optimization was proposed to be achieved through maximization of the signal to noise ratio by any and all means available. A detailed investigation of the diverse influences on the signal to noise ratio was performed with a focus on eliminating technical restrictions and minimizing fundamental constraints. By studying a 2f - absorption imaging system the maximal signal to noise ratio of 35 was calculated. This corresponded to imaging a cloud of 105 87Rb atoms in a (50 micron) square box with a 31.8MHz detuned, 780nm laser at an intensity of 570W/(m.m) for 35 micro-s. These optimal imaging parameters correspond to our imaging system being limited by the well depth of our detector, not by a fundamental physical process. Furthermore, current experimental noise is identified as the most significant inhibitor to the achievement of an optimized absorption image. ¶ This study represents a first analysis of the quality of current Bose-Einstein condensate imaging techniques and limitations.

•Jan 1, 2006•0 citations

Rapid real-time detection of cold atoms with minimal destruction

Jessica Lye, J. J. Hope, J. D. Close

We present a minimally destructive interferometric measurement of the column density of cold atoms with a passively stabilized separated beam path interferometer. We achieve a heating rate of 4 (photons/sec)/atom. The interferometer employed in these measurements utilizes a photodiode rather than a charge-coupled device camera and is suitable for the measurement of fast dynamics in Bose-Einstein condensates and real-time feedback with atom lasers. The technique is compatible with modulation techniques employing squeezed light as the probe beam for sub-shot-noise-limited measurements.

Physical Review A•Feb 3, 2004•9 citations

Imaging Bose-Einstein condensates at ultra-low atom-numbers and time averaged adiabatic potentials

Melina Pappa

This thesis presents theoretical principles on laser cooling and trapping as well as magnetic trapping and evaporative cooling, methods necessary for Bose-Einstein condensation.It presents the construction of a very dependable BEC machine.We demonstrate a novel class of trapping potentials, time-averaged adiabatic potentials (TAAP) which allows the generation of a large variety of traps and waveguides for ultracold atoms.The ring-geometry is of particular interest for guided matter-wave interferometry as it provides a perfectly smooth waveguide of controllable diameter, and thus a tunable sensitivity of the interferometer.In addition we report the experimental realization of double-well traps based on TAAP traps.Quantum degenerate Fermi gases and Bose-Einstein condensates give access to a vast new class of quantum states.The resulting multi-particle correlations places extreme demands on the detection schemes.Here we introduce diffractive darkground imaging as a novel ultra-sensitive imaging technique.We detect clouds with less than 30 atoms with near atom shot-noise limited signal to noise ratio.This presents an improvement of about one order of magnitude when compared to our standard absorption imaging.We also examine the optimal conditions for absorption imaging including saturation and fluorescence contributions.

•Jan 1, 2011•0 citations

Optically trapped atom interferometry using the clock transition of large87Rb Bose–Einstein condensates

P. A. Altin, Gordon McDonald, D. Döring +7 more

We present a Ramsey-type atom interferometer operating with an optically trapped sample of 10 6 Bose-condensed 87 Rb atoms. We investigate this interferometer experimentally and theoretically with an eye to the construction of future high precision atomic sensors. Our results indicate that, with further experimental refinements, it will be possible to produce and measure the output of a sub-shot-noise-limited, large atom number BEC-based interferometer. The optical trap allows us to couple the | F =1, m F =0⟩→| F =2, m F =0⟩ clock states using a single photon 6.8 GHz microwave transition, while state selective readout is achieved with absorption imaging. We analyse the process of absorption imaging and show that it is possible to observe atom number variance directly, with a signal-to-noise ratio ten times better than the atomic projection noise limit on 10 6 condensate atoms. We discuss the technical and fundamental noise sources that limit our current system, and present theoretical and experimental results on interferometer contrast, de-phasing and miscibility.

arXiv:1011.4713•New Journal of Physics•Jun 28, 2011•43 citations
We propose and analyze a series of nondestructive dynamic detectors for Bose-Einstein condensates based on photodetectors operating at the shot-noise limit. These detectors are compatible with real-time feedback to the condensate. The signal-to-noise ratio of different detection schemes are compared subject to the constraint of minimal heating due to photon absorption and spontaneous emission. This constraint leads to different optimal operating points for interference-based schemes. We find the somewhat counterintuitive result that without the presence of a cavity, interferometry causes as much destruction as absorption for optically thin clouds. For optically thick clouds, cavity-free interferometry is superior to absorption, but it still cannot be made arbitrarily nondestructive. We propose a cavity-based measurement of atomic density which can in principle be made arbitrarily nondestructive for a given signal-to-noise ratio.
We present the first detector that is capable of recording high-bandwidth atom number density measurements of a Bose-Einstein condensate, with a readout of the data in real time. It is based on a shot-noise-limited unbalanced Mach-Zehnder interferometer designed for a minimally destructive measurement of the atom column density of a Bose-Einstein condensate. The shot-noise limit is reached by phase modulating the laser in one arm and phase locking the interferometer with a second-color laser. The detector is characterized, and its sensitivity for a fractional change in the column density of a Bose-Einstein condensate is calculated. With this detection system it may be possible to implement feedback to stabilize a Bose-Einstein condensate or an atom laser.
All optical techniques used to probe the properties of Bose-Einstein condensates have been based on dispersion and absorption that can be described by a two-level atom. Both phenomena lead to spontaneous emission that is destructive at the low energies involved with ultracold atomic systems. Recently, both were shown to lead to the same limit to the signal to noise ratio for a given destruction. We develop a new method for calculating the phase shift of a laser beam and show that no single-pass optical technique using classical light and a three-level atom can exceed this limit. This puts significant restrictions on potential nondestructive measurement schemes.
Research into Bose-Einstein condensates is currently a thriving field in physics. Much of the experimental research involves the detection of cold atom clouds under various conditions. Consequently, the fundamental and technical limitations of the imaging techniques and technologies utilized will have a dramatic influence on the results of these experiments. Therefore a detailed analysis of the restrictions on a Bose-Einstein condensate imaging system is overdue and will facilitate further developments in the field due to an increase in the signal to noise ratio; hence a greater level of detail available in experimental images. ¶ The work carried out in this thesis focuses on the properties of absorption imaging techniques, in the quest for an optimized imaging system. Optimization was proposed to be achieved through maximization of the signal to noise ratio by any and all means available. A detailed investigation of the diverse influences on the signal to noise ratio was performed with a focus on eliminating technical restrictions and minimizing fundamental constraints. By studying a 2f - absorption imaging system the maximal signal to noise ratio of 35 was calculated. This corresponded to imaging a cloud of 105 87Rb atoms in a (50 micron) square box with a 31.8MHz detuned, 780nm laser at an intensity of 570W/(m.m) for 35 micro-s. These optimal imaging parameters correspond to our imaging system being limited by the well depth of our detector, not by a fundamental physical process. Furthermore, current experimental noise is identified as the most significant inhibitor to the achievement of an optimized absorption image. ¶ This study represents a first analysis of the quality of current Bose-Einstein condensate imaging techniques and limitations.
We present a minimally destructive interferometric measurement of the column density of cold atoms with a passively stabilized separated beam path interferometer. We achieve a heating rate of 4 (photons/sec)/atom. The interferometer employed in these measurements utilizes a photodiode rather than a charge-coupled device camera and is suitable for the measurement of fast dynamics in Bose-Einstein condensates and real-time feedback with atom lasers. The technique is compatible with modulation techniques employing squeezed light as the probe beam for sub-shot-noise-limited measurements.
This thesis presents theoretical principles on laser cooling and trapping as well as magnetic trapping and evaporative cooling, methods necessary for Bose-Einstein condensation.It presents the construction of a very dependable BEC machine.We demonstrate a novel class of trapping potentials, time-averaged adiabatic potentials (TAAP) which allows the generation of a large variety of traps and waveguides for ultracold atoms.The ring-geometry is of particular interest for guided matter-wave interferometry as it provides a perfectly smooth waveguide of controllable diameter, and thus a tunable sensitivity of the interferometer.In addition we report the experimental realization of double-well traps based on TAAP traps.Quantum degenerate Fermi gases and Bose-Einstein condensates give access to a vast new class of quantum states.The resulting multi-particle correlations places extreme demands on the detection schemes.Here we introduce diffractive darkground imaging as a novel ultra-sensitive imaging technique.We detect clouds with less than 30 atoms with near atom shot-noise limited signal to noise ratio.This presents an improvement of about one order of magnitude when compared to our standard absorption imaging.We also examine the optimal conditions for absorption imaging including saturation and fluorescence contributions.
We present a Ramsey-type atom interferometer operating with an optically trapped sample of 10 6 Bose-condensed 87 Rb atoms. We investigate this interferometer experimentally and theoretically with an eye to the construction of future high precision atomic sensors. Our results indicate that, with further experimental refinements, it will be possible to produce and measure the output of a sub-shot-noise-limited, large atom number BEC-based interferometer. The optical trap allows us to couple the | F =1, m F =0⟩→| F =2, m F =0⟩ clock states using a single photon 6.8 GHz microwave transition, while state selective readout is achieved with absorption imaging. We analyse the process of absorption imaging and show that it is possible to observe atom number variance directly, with a signal-to-noise ratio ten times better than the atomic projection noise limit on 10 6 condensate atoms. We discuss the technical and fundamental noise sources that limit our current system, and present theoretical and experimental results on interferometer contrast, de-phasing and miscibility.