Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:cond-mat/0009163 · Europhysics Letters (EPL)

Quantum-efficient charge detection using a single-electron transistor

Alec Maassen van den Brink

Published May 1, 2002• 21 citations
arXivHTMLPDF

Abstract

We evaluate the detector nonideality (and energy sensitivity) of a normal-state single-electron transistor in the cotunneling regime in a two-charge-state approximation. The (symmetrized) current-charge cross-correlation vanishes for low frequencies, causing two different definitions of detector nonideality to agree. The result, a universal one-parameter function, shows that near-ideal, quantum-limited measurement of a charge qubit is possible for a wide range of small bias voltages. However, near the threshold voltage for crossover to sequential tunneling, the device becomes strongly nonideal. Interpretations of these findings are discussed.

DOI
10.1209/epl/i2002-00432-x

Related papers

Measuring charge-based quantum bits by a superconducting single-electron transistor

J. J. Kinnunen, Päivi Törmä, Jukka P Pekola

Single-electron transistors have been proposed to be used as a read-out device for Cooper pair charge qubits. Here we show that a coupled superconducting transistor at a threshold voltage is much more effective in measuring the state of a qubit than a normal-metal transistor at the same voltage range. The effect of the superconducting gap is to almost completely block the current through the transistor when the qubit is in the logical state 1, compared to the mere diminishment of the current in the normal-metal case. The time evolution of the system is solved when the measuring device is driven out of equilibrium, the effect of higher-order contributions is examined and the setting is analyzed numerically for parameters accessible by lithographic aluminum structures.

arXiv:cond-mat/0211154•Physical review. B, Condensed matter•Jul 30, 2003•5 citations

Resonant Tunneling through a Macroscopic Charge State in a Superconducting Single Electron Transistor

D. V. Averin, A. N. Korotkov, Antti J. Manninen +1 more

We predict theoretically and observe in experiment that the differential conductance of a superconducting single electron transistor exhibits a peak which is a complete analog, in a macroscopic system, of a standard resonant tunneling peak associated with tunneling through a single quantum state. In particular, in a symmetric transistor, the peak height is universal and equal to ${e}^{2}/2\ensuremath{\pi}\ensuremath{\Elzxh}$. Away from the resonance we clearly observe the cotunneling current which, in contrast to the normal-metal transistor, varies linearly with the bias voltage.

arXiv:cond-mat/9701213•Physical Review Letters•Jun 23, 1997•28 citations

Nonadiabatic Charge Pumping in a Hybrid Single-Electron Transistor

D. V. Averin, Jukka P Pekola

We study theoretically current quantization in the charge turnstile based on the superconductor-normal-metal single-electron transistor. The quantization accuracy is limited by either Andreev reflection or by Cooper-pair-electron cotunneling. The rates of these processes are calculated in the "above-the-threshold" regime when they compete directly with the lowest-order tunneling. By shaping the ac gate voltage drive it should be possible to achieve the metrological accuracy of 10;{-8}, while maintaining the quantized current on the level of 30 pA, just by one turnstile with realistic parameters using aluminum as a superconductor.

arXiv:0802.1364•Physical Review Letters•Aug 4, 2008•81 citations

Weak measurement of qubit oscillations with strong response detectors: Violation of the fundamental bound imposed on linear detectors

HuJun Jiao, Feng Li, Shi-Kuan Wang +1 more

Qubit measurement by mesoscopic charge detectors has received great interest in the community of mesoscopic transport and solid-state quantum computation, and some controversial issues still remain unresolved. In this work, we revisit the continuous weak measurement of a solid-state qubit by single electron transistors (SETs) in nonlinear-response regime. For two SET models typically used in the literature, we find that the signal-to-noise ratio can violate the universal upper bound ``4,'' which is imposed quantum mechanically on linear-response detectors. This different result can be understood by means of the cross correlation of the detector currents by viewing the two junctions of the single SET as two detectors. Possible limitation of the potential-scattering approach to this result is also discussed.

arXiv:0806.2502•Physical Review B•Feb 24, 2009•9 citations

Simultaneous readout of two charge qubits

Jian Li, Göran Johansson

We consider a system of two solid state charge qubits, coupled to a single readout device, consisting of a single-electron transistor (SET). The conductance of each tunnel junction is influenced by its neighboring qubit, and thus the current through the transistor is determined by the qubits' state. The full counting statistics of the electrons passing the transistor is calculated, and we discuss qubit dephasing, as well as the quantum efficiency of the readout. The current measurement is then compared to readout using real-time detection of the SET island's charge state. For the latter method we show that the quantum efficiency is always unity. Comparing the two methods a simple geometrical interpretation of the quantum efficiency of the current measurement appears. Finally, we note that full quantum efficiency in some cases can be achieved measuring the average charge of the SET island, in addition to the average current.

arXiv:cond-mat/0611143•Physical Review B•Feb 9, 2007•8 citations

Full-frequency voltage noise spectral density of a single-electron transistor

Andreas Käck, Goran P. Wendin, Göran Johansson

We calculate the full-frequency spectral density of voltage fluctuations in a single-electron transistor (SET), used as an electrometer biased above the Coulomb threshold so that the current through the SET is carried by sequential tunneling events. We consider both a normal-state SET and a superconducting SET. The whole spectrum, from low-frequency telegraph noise to quantum noise at frequencies comparable to the SET charging energy ${(E}_{C}/\ensuremath{\Elzxh})$ to high-frequency Nyquist noise, is described. We take the energy exchange between the SET and the measured system into account using a real-time diagrammatic Keldysh technique. The voltage fluctuations determine the backaction of the SET on the measured system, and we specifically discuss the case of superconducting charge qubit read-out and measuring the so-called Coulomb staircase of a single Cooper-pair box.

arXiv:cond-mat/0211055•Physical review. B, Condensed matter•Jan 6, 2003•24 citations
We evaluate the detector nonideality (and energy sensitivity) of a normal-state single-electron transistor in the cotunneling regime in a two-charge-state approximation. The (symmetrized) current-charge cross-correlation vanishes for low frequencies, causing two different definitions of detector nonideality to agree. The result, a universal one-parameter function, shows that near-ideal, quantum-limited measurement of a charge qubit is possible for a wide range of small bias voltages. However, near the threshold voltage for crossover to sequential tunneling, the device becomes strongly nonideal. Interpretations of these findings are discussed.
Single-electron transistors have been proposed to be used as a read-out device for Cooper pair charge qubits. Here we show that a coupled superconducting transistor at a threshold voltage is much more effective in measuring the state of a qubit than a normal-metal transistor at the same voltage range. The effect of the superconducting gap is to almost completely block the current through the transistor when the qubit is in the logical state 1, compared to the mere diminishment of the current in the normal-metal case. The time evolution of the system is solved when the measuring device is driven out of equilibrium, the effect of higher-order contributions is examined and the setting is analyzed numerically for parameters accessible by lithographic aluminum structures.
We predict theoretically and observe in experiment that the differential conductance of a superconducting single electron transistor exhibits a peak which is a complete analog, in a macroscopic system, of a standard resonant tunneling peak associated with tunneling through a single quantum state. In particular, in a symmetric transistor, the peak height is universal and equal to ${e}^{2}/2\ensuremath{\pi}\ensuremath{\Elzxh}$. Away from the resonance we clearly observe the cotunneling current which, in contrast to the normal-metal transistor, varies linearly with the bias voltage.
We study theoretically current quantization in the charge turnstile based on the superconductor-normal-metal single-electron transistor. The quantization accuracy is limited by either Andreev reflection or by Cooper-pair-electron cotunneling. The rates of these processes are calculated in the "above-the-threshold" regime when they compete directly with the lowest-order tunneling. By shaping the ac gate voltage drive it should be possible to achieve the metrological accuracy of 10;{-8}, while maintaining the quantized current on the level of 30 pA, just by one turnstile with realistic parameters using aluminum as a superconductor.
Qubit measurement by mesoscopic charge detectors has received great interest in the community of mesoscopic transport and solid-state quantum computation, and some controversial issues still remain unresolved. In this work, we revisit the continuous weak measurement of a solid-state qubit by single electron transistors (SETs) in nonlinear-response regime. For two SET models typically used in the literature, we find that the signal-to-noise ratio can violate the universal upper bound ``4,'' which is imposed quantum mechanically on linear-response detectors. This different result can be understood by means of the cross correlation of the detector currents by viewing the two junctions of the single SET as two detectors. Possible limitation of the potential-scattering approach to this result is also discussed.
We consider a system of two solid state charge qubits, coupled to a single readout device, consisting of a single-electron transistor (SET). The conductance of each tunnel junction is influenced by its neighboring qubit, and thus the current through the transistor is determined by the qubits' state. The full counting statistics of the electrons passing the transistor is calculated, and we discuss qubit dephasing, as well as the quantum efficiency of the readout. The current measurement is then compared to readout using real-time detection of the SET island's charge state. For the latter method we show that the quantum efficiency is always unity. Comparing the two methods a simple geometrical interpretation of the quantum efficiency of the current measurement appears. Finally, we note that full quantum efficiency in some cases can be achieved measuring the average charge of the SET island, in addition to the average current.
We calculate the full-frequency spectral density of voltage fluctuations in a single-electron transistor (SET), used as an electrometer biased above the Coulomb threshold so that the current through the SET is carried by sequential tunneling events. We consider both a normal-state SET and a superconducting SET. The whole spectrum, from low-frequency telegraph noise to quantum noise at frequencies comparable to the SET charging energy ${(E}_{C}/\ensuremath{\Elzxh})$ to high-frequency Nyquist noise, is described. We take the energy exchange between the SET and the measured system into account using a real-time diagrammatic Keldysh technique. The voltage fluctuations determine the backaction of the SET on the measured system, and we specifically discuss the case of superconducting charge qubit read-out and measuring the so-called Coulomb staircase of a single Cooper-pair box.