Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:cond-mat/0211055 · Physical review. B, Condensed matter

Full-frequency voltage noise spectral density of a single-electron transistor

Andreas Käck, Goran P. Wendin, Göran Johansson

Published Jan 6, 2003• 24 citations
arXivHTMLPDF

Abstract

We calculate the full-frequency spectral density of voltage fluctuations in a single-electron transistor (SET), used as an electrometer biased above the Coulomb threshold so that the current through the SET is carried by sequential tunneling events. We consider both a normal-state SET and a superconducting SET. The whole spectrum, from low-frequency telegraph noise to quantum noise at frequencies comparable to the SET charging energy ${(E}_{C}/\ensuremath{\Elzxh})$ to high-frequency Nyquist noise, is described. We take the energy exchange between the SET and the measured system into account using a real-time diagrammatic Keldysh technique. The voltage fluctuations determine the backaction of the SET on the measured system, and we specifically discuss the case of superconducting charge qubit read-out and measuring the so-called Coulomb staircase of a single Cooper-pair box.

DOI
10.1103/physrevb.67.035301

Related papers

Full Frequency Back-Action Spectrum of a Single-Electron Transistor during Qubit Readout

Göran Johansson, Andreas Käck, Goran P. Wendin

We calculate the spectral density of voltage fluctuations in a single-electron transistor (SET), biased to operate in a transport mode where tunneling events are correlated due to Coulomb interaction. The whole spectrum from low frequency shot noise to quantum noise at frequencies comparable to the SET charging energy (EC/h) is considered. We discuss the back-action during readout of a charge qubit and conclude that single-shot readout is possible using the radio-frequency SET.

arXiv:cond-mat/0106650•Physical Review Letters•Jan 10, 2002•59 citations

Noise and measurement backaction in superconducting circuits: qubits as spectrometers of quantum noise

Robert J. Schoelkopf, Aashish A. Clerk, S. M. Girvin +2 more

Electrical engineers and physicists are naturally very interested in noise in circuits, amplifiers and detectors. With the advent of quantum computation and other high frequency electronics operating at low temperatures, we have entered a regime where quantum noise and quantum-limited detectors are important. Here we describe the general concept of a two-level system as a quantum spectrum analyzer and apply it to a simple superconducting qubit, the Cooper-pair box. We then discuss the coupling of a Cooper-pair box to its electromagnetic environment, whose noise leads to a finite polarization and excited-state lifetime of the qubit. Finally, we describe a theoretical technique for treating a qubit coupled to a measurement system, which allows one to calculate the full quantum noise of the measurement device. We present results for such a calculation for the case of a normal SET.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•May 9, 2003•8 citations

Double quantum dot coupled to a radio-frequency single-electron transistor: Quantum measurement and back action

Madhu Thalakulam

The radio-frequency superconducting single electron transistor (RF-SET) is a highly sensitive and fast electrometer operating near the quantum limit. The back-action current noise of the SET induces voltage fluctuations on the system it is coupled to, dephasing its charge states. Here we propose to study the back action of the RF-SET by means of a double quantum dot (DQD) and, an RF-SET electrostatically coupled to one of the two dots. The inelastic current through the DQD is very sensitive to the spectral density of the voltage fluctuations in the nearby environment. By properly choosing the dot size and inter-dot tunnel barrier thickness, one can cause inelastic process to dominate the transport processes. A measurement of the inelastic current through the double dot system can then be used to calculate the spectral density of noise associated with the RF-SET and hence its back action. The design, fabrication and characterization of an RF-SET/DQD system is discussed in this work. Real-time studies of electron dynamics in coupled dots are also addressed.

•Jan 1, 2004•0 citations

Resonant Cooper-Pair Tunneling: Quantum Noise and Measurement Characteristics

Aashish A. Clerk, S. M. Girvin, A. K. Nguyen +1 more

We study the quantum charge noise and measurement properties of the double Cooper-pair resonance point in a superconducting single-electron transistor (SSET) coupled to a Josephson charge qubit. Using a density-matrix approach for the coupled system, we obtain a full description of the measurement backaction; for weak coupling, this is used to extract the quantum charge noise. Unlike the case of a nonsuperconducting SET, the backaction here can induce population inversion in the qubit. We find that the Cooper-pair resonance process allows for a much better measurement than a similar nonsuperconducting SET, and can approach the quantum limit of efficiency.

arXiv:cond-mat/0203338•Physical Review Letters•Oct 8, 2002•90 citations

Single-electron transistor backaction on the single-electron box

Benjamin Turek, Konrad W. Lehnert, Aashish A. Clerk +4 more

We report an experimental observation of the backaction of a single-electron transistor (SET) measuring the Coulomb staircase of a single-electron box. As current flows through the SET, the charge state of the SET island fluctuates. These fluctuations capacitively couple to the box and cause changes in the position, width, and asymmetry of the Coulomb staircase. A sequential tunneling model accurately recreates these effects, confirming this mechanism of the backaction of a SET. This is a first step toward understanding the effects of quantum measurement on solid-state qubits.

arXiv:cond-mat/0501504•Physical Review B•May 26, 2005•22 citations

Towards the quantum limit: A Single Electron Transistor analysis

Zhongqing Ji

The Single Electron Transistor (SET), especially its variation the radio frequency single electron transistor (RF-SET), is a fast and ultra-sensitive electrometer working in the vicinity of the quantum limit. In this thesis, the theory and techniques related to the SET in the normal state and the superconducting state are introduced The thesis focuses especially on our efforts of improving the sensitivity of superconducting RF-SET, including: the design and fabrication of an all superconducting near loss-less matching network for improving the RF modulation, our early investigation of the sensitivity and linearity of a superconducting SET (S-SET) subject to quantum fluctuations of quasiparticles and Cooper pairs under different tunneling mechanisms, and our recent work approaching the quantum sensitivity limit using a double Josephson quasiparticle (DJQP) cycle of a S-SET. Using an effective bath description, we have found that the S-SET provides damping of the resonator modes proportional to its differential conductance, and has an effective temperature that can be well below both the ambient temperature and the energy scale of the bias voltage. In the region of negative differential conductance (NDC), the S-SET shows negative damping and a negative temperature. In the final part of the thesis, I have demonstrated our first application of an RF-SET for real-time detection of electron tunneling through a quantum dot.

•Jan 1, 2008•1 citation
We calculate the full-frequency spectral density of voltage fluctuations in a single-electron transistor (SET), used as an electrometer biased above the Coulomb threshold so that the current through the SET is carried by sequential tunneling events. We consider both a normal-state SET and a superconducting SET. The whole spectrum, from low-frequency telegraph noise to quantum noise at frequencies comparable to the SET charging energy (EC/\ensuremath\Elzxh){(E}_{C}/\ensuremath{\Elzxh})(EC​/\ensuremath\Elzxh) to high-frequency Nyquist noise, is described. We take the energy exchange between the SET and the measured system into account using a real-time diagrammatic Keldysh technique. The voltage fluctuations determine the backaction of the SET on the measured system, and we specifically discuss the case of superconducting charge qubit read-out and measuring the so-called Coulomb staircase of a single Cooper-pair box.
Electrical engineers and physicists are naturally very interested in noise in circuits, amplifiers and detectors. With the advent of quantum computation and other high frequency electronics operating at low temperatures, we have entered a regime where quantum noise and quantum-limited detectors are important. Here we describe the general concept of a two-level system as a quantum spectrum analyzer and apply it to a simple superconducting qubit, the Cooper-pair box. We then discuss the coupling of a Cooper-pair box to its electromagnetic environment, whose noise leads to a finite polarization and excited-state lifetime of the qubit. Finally, we describe a theoretical technique for treating a qubit coupled to a measurement system, which allows one to calculate the full quantum noise of the measurement device. We present results for such a calculation for the case of a normal SET.
The radio-frequency superconducting single electron transistor (RF-SET) is a highly sensitive and fast electrometer operating near the quantum limit. The back-action current noise of the SET induces voltage fluctuations on the system it is coupled to, dephasing its charge states. Here we propose to study the back action of the RF-SET by means of a double quantum dot (DQD) and, an RF-SET electrostatically coupled to one of the two dots. The inelastic current through the DQD is very sensitive to the spectral density of the voltage fluctuations in the nearby environment. By properly choosing the dot size and inter-dot tunnel barrier thickness, one can cause inelastic process to dominate the transport processes. A measurement of the inelastic current through the double dot system can then be used to calculate the spectral density of noise associated with the RF-SET and hence its back action. The design, fabrication and characterization of an RF-SET/DQD system is discussed in this work. Real-time studies of electron dynamics in coupled dots are also addressed.
We study the quantum charge noise and measurement properties of the double Cooper-pair resonance point in a superconducting single-electron transistor (SSET) coupled to a Josephson charge qubit. Using a density-matrix approach for the coupled system, we obtain a full description of the measurement backaction; for weak coupling, this is used to extract the quantum charge noise. Unlike the case of a nonsuperconducting SET, the backaction here can induce population inversion in the qubit. We find that the Cooper-pair resonance process allows for a much better measurement than a similar nonsuperconducting SET, and can approach the quantum limit of efficiency.
We report an experimental observation of the backaction of a single-electron transistor (SET) measuring the Coulomb staircase of a single-electron box. As current flows through the SET, the charge state of the SET island fluctuates. These fluctuations capacitively couple to the box and cause changes in the position, width, and asymmetry of the Coulomb staircase. A sequential tunneling model accurately recreates these effects, confirming this mechanism of the backaction of a SET. This is a first step toward understanding the effects of quantum measurement on solid-state qubits.
The Single Electron Transistor (SET), especially its variation the radio frequency single electron transistor (RF-SET), is a fast and ultra-sensitive electrometer working in the vicinity of the quantum limit. In this thesis, the theory and techniques related to the SET in the normal state and the superconducting state are introduced The thesis focuses especially on our efforts of improving the sensitivity of superconducting RF-SET, including: the design and fabrication of an all superconducting near loss-less matching network for improving the RF modulation, our early investigation of the sensitivity and linearity of a superconducting SET (S-SET) subject to quantum fluctuations of quasiparticles and Cooper pairs under different tunneling mechanisms, and our recent work approaching the quantum sensitivity limit using a double Josephson quasiparticle (DJQP) cycle of a S-SET. Using an effective bath description, we have found that the S-SET provides damping of the resonator modes proportional to its differential conductance, and has an effective temperature that can be well below both the ambient temperature and the energy scale of the bias voltage. In the region of negative differential conductance (NDC), the S-SET shows negative damping and a negative temperature. In the final part of the thesis, I have demonstrated our first application of an RF-SET for real-time detection of electron tunneling through a quantum dot.