To address the requirements for broadband sensing in the VHF band (30–300 MHz), this paper proposes and experimentally verifies a multi-frequency collaborative Rydberg-atom heterodyne receiver. By integrating the far-detuned AC Stark effect with a microwave frequency comb (MFC) mechanism, the system utilizes a seven-tooth MFC with a 50 MHz center frequency and 10 MHz comb spacing as a multi-point local oscillator to achieve broadband signal capture from 55 to 85 MHz. Experimental results demonstrate that at the 85 MHz target frequency (representing a 35 MHz frequency offset for the single-LO system), the signal-to-noise ratio (SNR) is improved from 0.3 dB to 4.3 dB. This study verifies the possibility of achieving wideband measurement in the VHF band by combining far-detuning with an MFC mechanism, serving as a critical experimental and technical reference for the engineering implementation of high-performance broadband quantum receivers.
To address the requirements for broadband sensing in the VHF band (30–300 MHz), this paper proposes and experimentally verifies a multi-frequency collaborative Rydberg-atom heterodyne receiver. By integrating the far-detuned AC Stark effect with a microwave frequency comb (MFC) mechanism, the system utilizes a seven-tooth MFC with a 50 MHz center frequency and 10 MHz comb spacing as a multi-point local oscillator to achieve broadband signal capture from 55 to 85 MHz. Experimental results demonstrate that at the 85 MHz target frequency (representing a 35 MHz frequency offset for the single-LO system), the signal-to-noise ratio (SNR) is improved from 0.3 dB to 4.3 dB. This study verifies the possibility of achieving wideband measurement in the VHF band by combining far-detuning with an MFC mechanism, serving as a critical experimental and technical reference for the engineering implementation of high-performance broadband quantum receivers.
Microwave frequency combs (MFCs) significantly enhance the instantaneous bandwidth of Rydberg-atom quantum sensors but introduce a persistent digital signal processing (DSP) bottleneck: frequency ambiguity. While single-comb systems lack absolute reference, dual-comb architectures exhibit residual mode ambiguity at specific frequency points, particularly under demanding wideband conditions (50 MHz–5 GHz). To address this, this article proposes a tri-comb constrained hierarchical search (TC-CHS) algorithm, which leverages hierarchical constraint logic to decouple computational complexity from the expansion of the search space. Numerical simulations demonstrate that the TC-CHS maintains nearly invariant algorithmic processing latency (~0.015 ms per point). Consequently, the computational advantage expands with the search space, reaching a peak speedup of$737.87\times $at the maximum tested comb-tooth count (40). Experimental validation on a Rydberg-atom sensing platform confirms the method’s efficacy, yielding a mean absolute frequency error of 0.791 Hz. The algorithm employs tri-comb redundancy as a tolerance-based error-correction mechanism, enabling robust operation under low signal-to-noise-ratio (low-SNR) conditions and immunity to frequency drifts up to 5 kHz/s. This approach achieves a five-order-of-magnitude improvement in reliability compared to traditional dual-comb schemes, eliminating the need for per-band recalibration. This work provides a computationally efficient and metrologically robust solution for high-precision frequency measurement in wideband spectrum monitoring and quantum receiver systems.
Studying Rydberg microwave frequency comb (MFC) spectroscopy helps increase the working bandwidth of the Rydberg receiver.This Letter demonstrates off-resonant Rydberg MFC spectroscopy in a meta-waveguide-coupled Rydberg atomic system.An off-resonant MFC field couples with the Rydberg atoms through a meta-waveguide.The system can receive the microwave field in the working band from 0.5 GHz to 13.5 GHz, and the MFC spectroscopy covers a span of 36 MHz at three different arbitrarily-chosen frequencies of 2 GHz, 3 GHz, and 5.8 GHz.The MFC spectrum that covers a wide range of 125 MHz is also verified.This work is significant for tunable wide-band instant microwave signal detection in the Rydberg atomic system, which is useful in microwave frequency metrology, communication, and radar.
Communication technologies advance toward secure communication, with frequency hopping communication (FH-C) widely used. However, traditional FH-C is limited by slow hopping speed, narrow bandwidth, and a few hopping points. Rydberg atoms offer a solution but face challenges like poor non-resonant microwave sensitivity and local oscillator synchronization limits. Here, we propose a frequency-hopping receiver based on atomic heterodyne detection that employs high orbital angular momentum (high-OAM) Rydberg states for resonant detection of rapidly hopping radio-frequency signals across multiple, widely separated frequency bands. The high-OAM Rydberg atoms ( l =3,4,5) resonantly detect 315 MHz, 1.7 GHz, and 29.74 GHz RF hopping signals (spanning 6 octaves). With heterodyne detection and a continuous excitation scheme, the system eliminates spectral establishment time, achieving 60 khops/s without transmitter-receiver synchronization, and uses frequency combs to extend hopping points to 5 MHz around resonant frequencies. These advances demonstrate the potential of Rydberg-atom–based receivers for high-speed and wide-band frequency-hopping communication.
Rydberg-atomic receivers exhibit exceptional sensitivity yet are fundamentally constrained by the narrow instantaneous bandwidth, limiting their practical deployment in broadband scenarios. Prior approaches typically expand the bandwidth by physically broadening the atomic response, which usually requires auxiliary electromagnetic fields or stringent parameter tuning, thereby increasing overall system complexity. Here, we propose a compressive spectral multiplexing framework implemented in a waveguide-coupled Rydberg atomic receiver using a frequency-modulated local oscillator (FMLO). The FMLO creates multiple parallel sensing channels that collectively constitute a physical compressive sensing matrix, generating multiple narrowband intermediate-frequency replicas of the input signal. Thus, a broadband microwave spectrum is projected onto a set of narrowband atomic responses. It is demonstrated that spectral information spanning a bandwidth of over 640 MHz can be effectively compressed into the intrinsic atomic bandwidth of 126 kHz, achieving a spectrum compression ratio exceeding 1000. Furthermore, these output replicas offer intrinsic measurement redundancy and facilitate signal-to-noise ratio enhancement. An approximate 10 dB gain is achieved in the required bit-energy-to-noise-power-density ratio for multi-channel communication via maximal-ratio combining. This approach requires no auxiliary fields or broadband electronics, providing a simple and scalable pathway for chip-scale quantum receivers, latency-critical sensing, and next-generation wireless communications.
While Rydberg atoms have shown tremendous potential to serve as accurate and sensitive detectors of microwaves and millimeter waves, their response is generally limited to a single, narrow frequency band around a chosen transition. As a result, their potential to serve as agile and wideband electromagnetic receivers has not been fully realized. Here we demonstrate the use of a mid-infrared, frequency agile optical frequency comb as the coupling laser for three-photon Rydberg atom electrometry. This approach allows for rapid switching between as many as seven individual Rydberg states, allowing for multichannel detection across a frequency range from 1 GHz to 40 GHz. The generality and flexibility of this method for wideband multiplexing is anticipated to have transformative effects in the field of Rydberg electrometry, paving the way for advanced information coding, arbitrary signal detection, and the simultaneous detection of ultra-broadband radiofrequency radiation. Rydberg atoms have the potential to serve as broadband receivers but require lasers with > 100 GHz scan ranges to observe multiple states. We bridge this major gap with an optical frequency comb for rapid preparation of over 7 Rydberg states.
We present a characterization of the sensitivity of broadband electric field measurements in the Very High Frequency (VHF) and Ultra High Frequency (UHF) bands using AC stark shifting of Rydberg states. The dependence of the sensitivity and dynamic range of the field measurements using nD5/2 states of cesium for principal quantum numbers n= 60, 70, 80, 90 and 100 is presented, detailing the intricacies involved. The frequencies considered for the measurement range from 50 MHz to 900 MHz for which a transverse electromagnetic (TEM) cell is used to excite the Rydberg atoms with the RF fields. The relative sensitivities achieved for various principal quantum numbers are presented. A general trend of better sensitivity for higher principal quantum numbers is observed. This work paves the way for a better understanding of the AC Stark dependent field measurements using Rydberg sensors.